• Journal of Sensor Science and Technology
• /
• v.6 no.3
• /
• pp.180-187
• /
• 1997

We demonstrate the improvement of sensitivity and analysis of operating characteristics of the piezoelectric pressure sensor using ZnO piezoelectric thin film and FET(field effect transistor) for sensing applied pressure and transforming the pressure into electrical signals, respectively. The sensitivity of the PSFET(pressure sensitive field effect transistor) was improved by using highly-oriented ZnO film perpendicular to the substrate surface and the operating characteristics was investigated by monitoring output voltage with time in various static pressure levels.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.5
• /
• pp.635-640
• /
• 2016

Tunnel field-effect transistor (TFET) is a promising candidate for the next-generation electron device. However, technical issues remain for their practical application: poor current drivability, shor-tchannel effect and ambipolar behavior. We propose herein a novel recessed-channel TFET (RTFET) with the asymmetric source and drain. The specific design parameters are determined by technology computer-aided design (TCAD) simulation for high on-current and low S. The designed RTFET provides ${\sim}446{\times}$ higher on-current than a conventional planar TFET. And, its average value of the S is 63 mV/dec.

• Proceedings of the IEEK Conference
• /
• 2002.07b
• /
• pp.1050-1053
• /
• 2002

In this paper, Amorphous silicon on glass substrate was recrystallized to poly-crystalline silicon by solid phase crystallization (SPC) technology. The active region of thin film transistor (TFT) was fabricated by amorphous silicon. The output and transfer characteristics of thin film transistor with lightly doped drain (LDD) structure was measured and analyzed. As a results, analyzed TFTs reliability with LDD's length by various kinds argument such as sub-threshold swing coefficient, mobility and threshold voltages were evaluated. Stress effects in TFT were able to improve to the characteristics of turn-on current and hot carrier effects by LDD's length variations.

• Proceedings of the IEEK Conference
• /
• 2002.06b
• /
• pp.185-188
• /
• 2002

In this paper, Amorphous silicon on glass substrate was recrytallized to poly-crystalline silicon by solid phase crystallization(SPC) technology The active region of thin film transistor(TFT) was fabricated by amorphous silicon. The output and transfer characteristics of thin film transistor with lightly doped drain(LDD) structure was measured and analyzed. As a results, analyzed TFT's reliability with LDD's length by various kinds argument such as sub-threshold swing coefficient, mobility and threshold voltages were evaluated. Stress effects in TFT were able to improve to the characteristics of turn-on current and hot carrier effects by LDD's length variations

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.3 no.3
• /
• pp.139-144
• /
• 2003

We report the results of extensive mixed mode simulations and theoretical analysis to quantify the contribution of the edge direct tunneling (EDT) current on the total gate leakage current of 80nm NMOSFET with SiO2 gate dielectric. It is shown that EDT has a profound impact on basic analog circuit building blocks such as sample-hold (S/H) circuit and the current mirror circuit. A transistor design methodology with zero gate-source/drain overlap is proposed to mitigate the EDT effect. This results in lower voltage droop in S/H application and better current matching in current mirror application. It is demonstrated that decreasing the overlap length also improves the basic analog circuit performance metrics of the transistor. The transistor with zero gate-source/drain overlap, results in better transconductance, input resistance, output resistance, intrinsic gain and unity gain transition frequency.

• Journal of Sensor Science and Technology
• /
• v.26 no.4
• /
• pp.292-296
• /
• 2017

It has become ever harder to design reliable circuits with each nanometer technology node under normal operation conditions, a transistor device can be affected by various aging effects resulting in performance degradation and eventually design failure. The reliability (aging) effect has traditionally been the area of process engineers. However, in the future, even the smallest of variations can slow down a transistor's switching speed, and an aging device may not perform adequately at a very low voltage. Because of such dilemmas, the transistor aging is emerging as a circuit designer's problem. Therefore, in this paper, the impact of aging effects on the delay and power dissipation of digital circuits by using nanomneter MOSFET power gating structure has been analyzed.. Based on this analyzed aging models, a reliable digital circuits can be designed.

• Journal of the Semiconductor & Display Technology
• /
• v.3 no.4
• /
• pp.29-32
• /
• 2004

Fully depleted Silicon-on-Insulator (FD-SOI) devices lead to better electrical characteristics than bulk CMOS devices. However, the presence of a thin top silicon layer and a buried SiO2 layer causes self-heating due to the low thermal conductivity of the buried oxide. The electrical characteristics of FDSOI devices strongly depend on the path of heat dissipation. In this paper, we present a new three-dimensional (3-D) analysis technique for the self-heating effect of the finger-type and bar-type transistors. The 3-D analysis results show that the drain current of the finger-type transistor is 14.7% smaller than that of the bar-type transistor due to the 3-D self-heating effect. We have learned that the rate of current degradation increases significantly when the width of a transistor is smaller that a critical value in a finger-type layout. The current degradation fro the 3-D structures of the finger-type and bar-type transistors is investigated and the design issues are also discussed.

• Journal of the Semiconductor & Display Technology
• /
• v.13 no.1
• /
• pp.63-66
• /
• 2014

ZnO is a wide bandgap (3.3 eV) semiconductor with high mobility and good optical transparency. However, off-current characteristics of ZnO thin-film transistor (TFT) need improvements. In this work we studied the variation in ZnO TFT current under different annealing conditions. Annealing usually modifies gas adsorption at grain boundaries of ZnO. When oxygen is adsorbed, electron density decreases due to strong electronegativity of the oxygen, and TFT current decreases as a result. Our experiments showed that current increased after vacuum annealing and decreased after air annealing. We explain that the change of off-current is caused by the desorption and adsorption of oxygen at the grain boundaries.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.16 no.2
• /
• pp.159-165
• /
• 2016

Recently, active efforts are being made for future Si CMOS technology by various researches on emerging devices and materials. Capability of low power consumption becomes increasingly important criterion for advanced logic devices in extending the Si CMOS. In this work, a junctionless field-effect transistor (JLFET) with ultra-thin poly-Si (UTP) channel is designed aiming the sub-10-nm technology for low-power (LP) applications. A comparative study by device simulations has been performed for the devices with crystalline and polycrystalline Si channels, respectively, in order to demonstrate that the difference in their performances becomes smaller and eventually disappears as the 10-nm regime is reached. The UTP JLFET would be one of the strongest candidates for advanced logic technology, with various virtues of high-speed operation, low power consumption, and low-thermal-budget process integration.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2005.07b
• /
• pp.1103-1107
• /
• 2005

Single-crystal silicon thin films on glass (SOG) and on fused-quartz (SOQ) were prepared using wafer bonding and hydrogen-induced layer transfer. Thinfilm transistors (TFTs) were subsequently fabricated. The high-temperature processed SOQ TFTs show better device performance than the low-temperature processed SOG TFTs. Tensile and compressive strain was measured respectively on SOQ and SOG. Consistent with the tensile strain, enhanced electron effective mobility was measured on the SOQ TFTs.