• 한국동물학회지
• /
• 제33권1호
• /
• pp.94-102
• /
• 1990

무미 양서류발생중에 근절 예정 부위의 최전방에 나타나는 cranial myotomes인 W, X, Y, Z는 후기 배 발생중에 "reduction"을 나타내는 특이한 체절이다. Cranial Myotome이 programmed autonomous death를 수행하는지 또는 otic vesicle과 같은 주위 조직의 영향에 의해 reduction을 일으키는지에 대한 가설을 검증하기 위해 Xenopus를 재료로 하여 서술적인 면과 조직이식을 통한 발생학적 실험을 수행하였다. 먼저 주위의 otic vesicle을 제거하여도 W, X, Y, Z degeneration에는 아무런 영향도 없었으며 otic vesicle을 체절을 따라 새로운 지역으로 이식하여도 그 부위에서 체절이 사라지는 현상이 유도되지 않았다. 한편, WXYZ형성 예정지역을 trunk somite 부위로 이식한 결과 원래대로 reduction을 나타내었고 truck somite 형성조직을 WXYZ 부위로 이식하여도 원래의 운명대로 분화하였다. 따라서 cranial myotome은 근육이 분절되는 발생시기에 도달하면 주위의 조직에 상관없이 예정된 운명에 따라 자동적으로 소멸되는 것으로 결론지을 수 있다.결론지을 수 있다.

• 대한기계학회논문집
• /
• 제18권1호
• /
• pp.139-149
• /
• 1994

A numerical simulation of unsteady axisymmetric turbulent flow was performed for a reciprocating engine including port/valve assembly. The governing equations based on a nonorthogonal coordinate formulation with Cartesian velocity components were used and discretised by the finite volume method with non-staggered variable arrangements. The modified $\kappa-\xi$. turbulence model which included the effect of compressibility was used. The results of twodimensional transient calculation for the axisymmetric configuration were compared with the experimental data. Although slightly low rms velocity was predicted compared to the experimental data, predicted velocity distributions at the valve exit and in-cylinder region showed good agreements with the experimental data. The flow at the valve exit was separated at the same valve lift position with the experimental data. Two vortices incylinder region were generated during the initial intake process. The clockwise main vortex became strong and moved upward to the top wall. The counter-clockwise second vortex became weak and stick to the upper left corner of the cylinder. After middle intake process, new vortex adjacent to upper cylinder wall appeared by the piston motion and therefore, the in-cylinder flow was formed into three vortices. The cylinder pressure just before bottom dead center of piston was higher than inlet pressure and then the reverse flow occured at the valve exit. The in-cylinder flow characteristics were strongly dependent on piston motion, but insensitive to valve motion.

• International Journal of Industrial Entomology and Biomaterials
• /
• 제9권2호
• /
• pp.235-239
• /
• 2004

Drosophila melanogaster heat shock protein 70 gene promoter (Dhsp70p) is widely used in transgenic insect to drive exogenous gene, and the homologous region 3 from Bombyx mori nucleopolyhedrovirus (BmNPVhr3) functions as an enhancer for several promoters. To test whether BmNPVhr3 can enhance the Dhsp70ps transcriptional activity, the reporter plasmids, which contain the Dhsp70p, the reporter $\beta$-galactosidase gene with SV40 terminator and BmNPVhr3 fragment, are constructed and transfected into the insect cell lines (Bm-N cells and Sf-21 cells) by lipofectin-mediated method. The results from the transient expression assay show that BmNPVhr3 significantly increases transcriptional activity of Dhsp70p both under the normal condition and under the heat-shock treatment, although the effects are significantly different between in Bm-N cells and in sf-21 cells. The enhancing behavior of BmNPVhr3 on the Dhsp70p is in an orientation-independent manner. Meanwhile, the effects of heat-shock treatment on Dhsp70p alone or Dhsp70p/BmNPVhr3 combination present no significant difference, indicating that BmNPVhr3 only enhances the transcriptional activity of Dhsp70p, but cant alter its characteristic of the response to the heat-shock stress. The above results suggest that the Dhsp70p/BmNPVhr3 combination is more effective one to drive exogenous gene for transgene or stable cell expression system in insects.

• 응용통계연구
• /
• 제34권4호
• /
• pp.537-556
• /
• 2021

통계적 공정관리절차의 특성은 해석적 해를 얻기가 어려운 경우가 많이 있으나 Markov연쇄를 적용하면 가능한 경우가 많이 있다. 이 논문에서는 공정 통계량이 Markov특성을 따르는 경우, Markov연쇄를 생성하는 방법과 이를 이용한 공정관리 절차의 특성을 도출하는 방법에 대해 설명하고 있다. 관리도의 통계적 설계, 경제적 설계 및 변량표본 추출비 설계 등의 특성 규명을 위한 Markov연쇄의 적용에 대한 기존의 알려진 방법을 복습하고 또한 새로운 공정관리 분야인 재조정 관리도에의 적용방법에 대한 연구결과도 보여주고 있다. 공정관리의 특성연구에서 해석적 해가 가능한 경우에도 이 과정이 복잡하여 Markov연쇄를 병행 사용하면 특성 규명이 명확해지며, 모의실험보다는 짧은 시간에 더 정밀한 결과를 얻을 수 있어 널리 이용되고 있다.

• 한국음향학회지
• /
• 제27권2호
• /
• pp.66-74
• /
• 2008

본 논문에서는 HE-AAC (High Efficiency Advanced Audio Coding) 오디오 부호화기의 저주파 대역과 고주파 대역을 담당하고 있는 AAC부호화기와 SBR (Spectral Band Replication) 부호화기에 대해 낮은 비트율에서 효과적인 개선 방법을 제안한다. AAC 부호화기가 담당하는 저주파 대역에서 과도신호가 발생하는 부분의 프리에코를 줄이기 위하여 적용 주파수범위가 저주파 대역 방향으로 선택적으로 확장되는 eTNS (exteded Temporal Noise Shaping) 방법을 고안하였다. 또한 SBR에 의해 부호화되는 고주파 대역에서 톤 성분 복원 시에 잡음층 (Noise floor)이 추가 발생되지 않도록 정현파 모델을 통해 톤을 사전 인지하고 인지된 톤들의 주파수를 QMF 밴드의 중앙으로 재배치하여 성능 향상을 이루었다. 제안한 방법들을 사용하여 복호화한 샘플 음원들에 대해 주/객관적 음질평가를 실시한 결과, 표준 HE-AAC에 비해 향상된 결과를 보여주었다.

• 대기
• /
• 제19권1호
• /
• pp.79-91
• /
• 2009

Seoul National University General Circulation Model (SNUGCM) has been run for 100 years to obtain daily temperature and meridional velocity at the Northern lower stratosphere. The model results are compared with the NCEP/NCAR reanalysis data. The polar temperature and the eddy heat flux from the model show that the model-produced climatology has well-known cold bias and weaker planetary wave activities. The model climatology also has a lag in the seasonal evolution. The relationship between the model-produced polar temperature and the eddy heat flux is investigated with respect to the interannual and decadal time scales. The interannual variation of the polar temperature is related with both total and stationary eddy heat flux in January and March, which is in agreement with observation. The model, however, does not reproduce the relationship between the decadal variation of the polar temperature and transient eddy heat flux, which is revealed in the observed data.

• Journal of Power Electronics
• /
• 제12권1호
• /
• pp.40-48
• /
• 2012

This paper proposes the State-of-charge (SOC) estimator of a LiPB Battery using the Extended Kalman Filter (EKF). EKF can work properly only with an accurate model. Therefore, the high accuracy electrical battery model for EKF state is discussed in this paper, which is focused on high-capacity LiPB batteries. The battery model is extracted from a single cell of LiPB 40Ah, 3.7V. The dynamic behavior of single cell battery is modeled using a bulk capacitance, two series RC networks, and a series resistance. The bulk capacitance voltage represents the Open Circuit Voltage (OCV) of battery and other components represent the transient response of battery voltage. The experimental results show the strong relationship between OCV and SOC without any dependency on the current rates. Therefore, EKF is proposed to work by estimating OCV, and then is converted it to SOC. EKF is tested with the experimental data. To increase the estimation accuracy, EKF is improved with a single dominant varying parameter of bulk capacitance which follows the SOC value. Full region of SOC test is done to verify the effectiveness of EKF algorithm. The test results show the error of estimation can be reduced up to max 5%SOC.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2001년도 춘계학술대회논문집D
• /
• pp.201-207
• /
• 2001

We modeled the liquid film dryout(LFD) process for both tube and annulus which have uniformly heated vertical channels. We set phenomenological initial conditions in the model. The initial void fraction on the onset of the annular flow location is derived from the physical chum-to-annular flow criterion with the help of the drift-flux-model. The initial thermodynamic-equilibrium-quality is calculated by iteration with the flow quality to find the onset of the annular-flow location. Present model tends to predict very well at the lower exit quality but under-estimates at the higher exit quality. We found that the prediction error of the present model is gradually bigger as the inlet subcooling approaches near the saturation. We obtained excellent results for both tube and annulus channels as the mean of 0.97 and root-mean-square error of 11% for the number of 3883 experimental data on tubes, and of 0.96 and of 12% for 593 on annuli. The present model extended the applicable range to the relatively low exit quality region than previous LFD models.

• 대한조선학회논문집
• /
• 제44권1호
• /
• pp.40-47
• /
• 2007

This study is focused on developing a software that predicts the temperature distribution and infrared Emission from 30 objects considering the solar radiation through the atmosphere. The solar radiation through the atmosphere is modeled by using the well-known LOWTRAN7 code. Surface temperature information is essential for generating the infrared scene of the object. Predictions of the transient surface temperature and the infrared emission from a naval ship by using the software developed here show fairly good results by representing the typical temperature and emitted radiance distributions expected for the naval ship considered in mid latitude. Emissivity of each material is appeared to be an important parameter for recognizing the target in Infrared band region. The numerical results also show that the low emissivity surface on the heat source can be helpful in reducing the IR image contrast as compared to the background sea.

• Journal of Advanced Marine Engineering and Technology
• /
• 제8권1호
• /
• pp.85-99
• /
• 1984

The stability of the two-phase flow in a heated channel is of great importance in the design and operation of the boilers and light water nuclear reactors, because it can cause flow oscillations and lead to a violation of thermal limits with resultant overheating of the channels and cladding. This paper presents a systematic evaluation to the variation effects of the basic four (4) dimensionless parameters in a homogeneous equilibrium model. The flow stability is examined on the ground of static characteristic curves. The complicated transfer function of flow dynamics which gives consideration to the transport lag of density wave is derived, and the transient flow stability is analysed by applying the Nyquist stability criterion in control engineering. The analysis results summed up as follows 1. The coolant flow becomes stable in large friction number and specific flow, while it is unstabale in small friction number and flow. 2. Large phase-change number and Froude number destabilize the two-phase flow, but small numbers stabilize it. The effect to variation of phase-change number is more dominant compared with Froude number. 3. The dynamic analysis is required to hold the sufficient safety of heated channels since only static results does not keep it. The special attention could be payed in the design and operation of heat engines, because the unstaable region exists within the stable boundary at small and middle phase-change number and Froude number.