• 한국농공학회논문집
• /
• 제59권6호
• /
• pp.61-71
• /
• 2017

The tracer gas method has an advantage that can estimate total and local ventilation rate by tracing air flow. However, the field measurement using tracer gas has disadvantages such as danger, inefficiency, and high cost. Therefore, the aim of this study was to evaluate ventilation rate in pig house by using the thermal distribution data rather than tracer gas. Especially, LMA (Local Mean Age), which is an index based on the age of air theory, was used to evaluate the ventilation rate in pig house. Firstly, the field experiment was conducted to measure micro-climate inside pig house, such as the air temperature, $CO_2$ concentration and wind velocity. And then, LMA was calculated based on the decay of $CO_2$ concentration and air temperature, respectively. This study compared between LMA determined by $CO_2$ concentration and air temperature; the average error and root mean square error were 3.76 s and 5.34 s. From these results, it was determined that thermal distribution data could be used for estimation of LMA. Finally, CFD (Computational fluid dynamic) model was validated using LMA and wind velocity. The mesh size was designed to be 0.1 m based on the grid independence test, and the Standard $k-{\omega}$ model was eventually chosen as the proper turbulence model. The developed CFD model was highly appropriate for evaluating the ventilation rate in pig house.

• 토지주택연구
• /
• 제14권4호
• /
• pp.111-120
• /
• 2023

주거 공간에서의 시간 증가와 외부 미세먼지, 황사 등의 영향 그리고 코로나 19 이후에 실내 공기질에 대한 중요성이 점차 중요해지고 있다. 이를 해결하기 위해 주거 공간에서 기계환기의 영향이 중요해지고 있고, 국내에서는 시간당 환기횟수 0.5회에 대한 법적 기준이 있다. 하지만, 급배기구의 위치는 구체적인 기준이 없어서 관습적으로 사용되고 있다. 본 연구에서는 급배기구 위치에 따른 주거 공간의 환기 성능 영향을 분석하고자 하였다. 실험은 외부 영향을 최소화할 수 있는 대형 챔버안에 있는 목업주택에서 추적가스법 중 농도감소법을 이용해서 실제 현장시험을 진행하여 실험을 진행했다. 실험 결과 거실 공간에서 일반적으로 사용하는 급기구 2개, 배기구 2개 조합은 급기 1개 배기 2개 조합보다 공기연령이 낮았으며, 급기와 배기를 1개씩 사용하는 것보다 급기나 배기를 여러개 사용하는 것이 측정점에서 오차율이 적어 실내 환기성능이 유사한 것을 확인했다.

• Journal of Advanced Marine Engineering and Technology
• /
• 제36권5호
• /
• pp.609-617
• /
• 2012

The flow characteristics of polluted air are analysed by comparing the results obtained from PIV(Particle Image Velocimetry) experiment and CFD(Computational Fluid Dynamics) commercial code. In order to simulate the polluted air flow, the olive oil has been used as tracer particles with the kinematic viscosity of air, $1.51{\times}10^{-5}m^2/s$. The investigation has done in the range of Reynolds numbers of 870, 1730 and 2890 due to the inlet flow velocities of 0.3, 0.6, and 1.0 m/s, respectively. The average velocity and the pressure distributions are comparatively discussed with respect to the three different Reynolds numbers. The results show that the outlet flow rates at three different Reynolds numbers are equivalent of 165 to 167 percent of the inlet ones. The pressure drop occurs in the model closed at both end sides and the highest pressures at each Reynolds number are positioned at the top of the tunnel between the inlet and outlet.

• 한국수자원학회:학술대회논문집
• /
• 한국수자원학회 2009년도 학술발표회 초록집
• /
• pp.1971-1973
• /
• 2009

본 연구에서는 하천에 유입된 오염물질의 거동 및 확산 특성을 파악하기 위하여 하천에서 추적자를 이용한 현장실험을 실시하였으며, 실험구간은 경상북도 경주시 에 위치한 하천으로 총 길이 2km, 평균폭 25m로 이루어진 대종천이다. 현장실험에서의 추적자 실험결과를 수치모형과 비교하기 위해 2차원 수심적분 모형인 RMA2, RMA4를 이용하였다. 2차원 동수역학적인 모형인 RMA2를 사용하여 흐름장을 모의한 후 계산결과를 2차원 수질모형인 RMA4에 입력하여 농도자료를 모의하였으며 상 하류단의 경계조건은 현장 실험시 실측한 상류단의 유량과 하류단의 수위를 적용하였다. 실측한 자료를 경계조건으로 모형에 적용하여 시간에 따른 농도값을 계산하였으며, 그 계산값을 추적자의 농도 관측값과 비교하였다. 계산결과는 서로 잘 일치하였다.

• 한국연소학회:학술대회논문집
• /
• 한국연소학회 2005년도 제31회 KOSCO SYMPOSIUM 논문집
• /
• pp.93-96
• /
• 2005

High temperature furnace such as Steam power plant and incinerator contribute considerable part of NOx generation and face urgent demand of De-NOx system. Reducing agents are necessary to use De-NOx system. In this study mixing caused by direct injection of reducing agent solution spray into flue gas duct was measured. Carbonated water was used as tracer and simulated agent because ammonia as a reducing agent is not proper to experiment. Mixing and evaporation must occur simultaneously and quickly enough to achieve desirable efficiency. To achieve that, the angle of attack of static mixer and the location is simulated and $CO_2$ concentration is measured.

• Journal of Advanced Marine Engineering and Technology
• /
• 제32권6호
• /
• pp.886-892
• /
• 2008

The development of fluid mechanics is briefly reviewed and the importance of fluid flows to heat and mass transfer in nature as well as to science and engineering is outlined. This paper presents the experimental results of air flow in the rectangular tunnel which has four different exhaust outlets, each distance of which from the inlet is 0, 30, 60 and 90mm respectively. This experiment is conducted by using the olive oil as the tracer particles and the kinematic viscosity of the air flow is $1.51{\times}10^{-5}\;m^2$/s. The flow is tested at the flow rate of 1.3 $m^3$/h and the velocity of 0.3 m/s. PIV technology can be used to make a good description of the smoke flow characteristics in the tunnel.

• 대한설비공학회:학술대회논문집
• /
• 대한설비공학회 2005년도 하계학술발표대회
• /
• pp.143-143
• /
• 2005

• 한국자동차공학회논문집
• /
• 제7권5호
• /
• pp.81-88
• /
• 1999

In order to understand the relationship between the phase angle of piston ring and oil consumption was measured by analyzing $CO_2$concentration in exhaust gas. The use of hydrogen fuel not gasoline makes this possible because all of the carbon component in exhaust gas can be assumed to be produced from oil. As a result of experiment, it is known that the oil consumption varies periodically and a specific location of ring end gap was found at each peak of oil consumption. Therefore, it was found that the oil consumption was not constant even at the same operating conditions and this is because the relative locations of top and 2'nd ring end gap change arbitrarily.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2008년도 추계학술대회B
• /
• pp.2700-2703
• /
• 2008

An experiment on bubble-driven flow was performed in order to understand fundamental knowledge of flow structure around a rising bubble in a stagnant fluid. The measurement technique consists of a combination of the three most often used PIV techniques in multiphase flows: PIV with fluorescent tracer particles, the digital phase separation with a masking technique and a shadowgraphy. The key point of the measurement is that the background intensity of a PIV recording can be shifted to a higher level than a bubble region using a shadowgraphy in order to distinguish from fluorescent particles and a bubble as well. Flow fields were measured without an inaccurate analysis around a fluid-bubble interface by using only one camera simply.

• Nuclear Engineering and Technology
• /
• 제52권1호
• /
• pp.170-177
• /
• 2020

A mixer with a new concept design has been adapted into water treatment plants. It reportedly cuts down the energy consumption of the mixer by the new mixer, which moves vertically and creates internal flows toward its bottom. However, no experimental observations have been made on the internal flow caused by a vertical impeller. In this study, a radiotracer experiment, radioactive particle tracking (RPT) technique, and particle image velocimetry (PIV) were carried out to visualize the flow in the mixer, and compared to each other. The results show that the flow patterns from these techniques are very similar to each other, and the performance of the mixer was good enough to mix the inner materials.