• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.16 no.8
• /
• pp.1631-1641
• /
• 2012

A TDMA system in satellite communication has been utilized. Especially DVB-S2 was standardized and now operated in satellite broadcasting system. In this paper, we propose a TDMA frame structure appropriate for special purpose which has the good reliablilty in a poor RF environment even if frequency efficiency is decreased. TDMA frame duration is 12 seconds which is long duration in comparison with general TDMA system with several ms. Designing the frame structure, time and frequency shift in single frame duration are considered. Simulation results show that the proposed frame structure and synchronization method has robust synchronization performance when the terminal is even in low SNR as well as 25 kHz frequency offsets.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.29 no.2C
• /
• pp.247-254
• /
• 2004

We introduce a new space-time signal processing scheme that uses both transmitter diversity technique and transmitter beamforming technique for code-division multiple access (CDMA) systems. Over complex Gaussian Rayleigh channel, the introduced scheme achieves the diveristy gain through the transmitter diversity technique. and the SNR gain by th transmitter beamforming technique. Bit error rate (BER) analyses are given to each of the three cases in which the transmitter diversity scheme, the transmitter beamforming scheme and the introduced scheme are used, in the slowly varying Rayleigh frequency nonselective fading channel. The Monte-Carlo simulation results are shown to match to the analytic results. When the channels between distant antennas are independent, analytic results show that the introduced scheme achieves the lowest $E_{b/}$ $N_{0}$ at target BER 10$^{-6}$ . When the channels between distant antennas are correlated, analytic and simulation results show that the introduced scheme is more robust to the change of channel correlation.n.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.7 no.6
• /
• pp.81-91
• /
• 2008

In this study, data collection delay time generated in bus information system is analysed and improvement on system reliability by minimizing the delay time is suggested. To minimize the data collection delay time (call setup time), factors on data collection phase are analyzed. Each connecting time that it occurs from wireless communication during data collection phase, is selected as a main effective variable and a model for selecting an optimum communication point to minimize the effect of data delay time by each connecting time is suggested. In this model, minimization of the point between the time carrying out wireless communication and vehicle moving time, is calculated and the difference between the bus arrival time and information delivered time to the passenger is reduced. The test results for the proposed model in BIS using a CDMA (Code Division Multiple Access) communication show that delay time in real system operation has been improved. The minimum data collection delay time based on optimal communication position leads to the better reliability for Bus Information System. This study can be applied to the selection of optimal communication position and detection position instead of empirical methods.

• Journal of the Korea Society of Computer and Information
• /
• v.16 no.6
• /
• pp.21-30
• /
• 2011

In the global IT market, a lot of issues for responding to various environmental regulations emerged. In case of the data centers, it is consuming huge amounts of energy to maintain. So there have been various technical attempts as Consolidation, Virtualization, Optimization to efficiently manage energy and data storage to fix the problems. In this paper, we propose a new RAID(Redundant Array of Independent Disks) mechanism which is differing the intensity of power consumption and works to provide data protection and disaster recovery(backup, mirroring etc.) to stratify multiple volumes. G-RAID minimize the power consumption and the lower of I/O performance by selecting the volume depending on the frequency of data access while classifying the power consumption between volumes in storage system. Also, it is possible that a filesystem and block map information of G-RAID is processed by basic unit which is group located in a row for the blocks to work efficiently and can minimize the performance degradation of block mapping load by the access frequency in each groups. As a result, we obtained to elevate a little bit of response time caused by block relocation work, but showed the decrease of power consumption by 38%.

• Korean journal of applied entomology
• /
• v.52 no.4
• /
• pp.341-348
• /
• 2013

We desinged and evaluated a remote-sensing sex pheromone trap for real-time monitoring of Mythimna separata (Lepidoptera: Noctuidae), a migratory insect in Korea. The system consisted of a modified cone-trap with a sex pheromone lure, a sensing module based on light interruption, a signal transmission module based on code division multiple access, a main electronic board for system control, a power supply based on a solar collector, a stainless steel-pole supporting the system, and a signal collection and display system based on an internet web page. The ratio (>92%) of the actual number of insects to the signal number in the remote-sensing trap was improved by sensing only within a limited period at night on the basis of the insect's circadian rhythm, control of signal sensitivity on the basis of sensing software programming, 1-h interval for signal transmission, and adjustment of the signal transmission program. The signal occurrence pattern in the remote-sensing trap was conclusively similar (correlation coefficient, >0.98) to the actual pattern of adult occurrence in the trap. The result indicated that the remote-sensing trap based on the attraction of the sex pheromone lure for M. separata has a promising potential for practical use. Occurrence of M. separata adults was observed several times in 2011 and 2012, and the peaks were sharp.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.50 no.4
• /
• pp.17-25
• /
• 2013

In this paper, a coding algorithm is proposed for multi-user multi-input multi-output (MU-MIMO) systems to improve the reception performance in fading conditions without reducing the bandwidth efficiency. The space division multiple access (SDMA) scheme that is one of the commonly used for MU-MIMO systems is vulnerable to the fading. The space time block code (STBC) scheme that is used to overcome the fading has a disadvantage of reduced throughput. The proposed MU-MIMO system first encodes transmitted symbols by linear dispersion code (LDC) which is less vulnerable to the fading and increases the throughput in proportional to the number of transmit antennas. Then, the LDC coded symbols are pre-coded by the result of singular value decomposition (SVD) of the estimated channel gain. We evaluate the performance of the proposed scheme compared with the conventional algorithms by computer simulations.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.4
• /
• pp.470-476
• /
• 2008

In this paper, we describe the cause of TDMA noise and distinction method of TDMA noise source in a GSM mobile phone. The causes of TDMA noise are composed of RF(Radio Frequency) energy coupling and low frequency energy coupling by burst ripple. We propose the distinction method of TDMA noise source from output(TDMA noise measurement) and frequency response of a system(audio path). Especially we propose a method of insertion loss($S_{21}$) analysis and the improvement method for RF energy coupling. Capacitor(40 pF) is a solution to reduce RF energy coupling and therefore TDMA noise was reduced by 10 dB.

• Journal of Advanced Navigation Technology
• /
• v.20 no.6
• /
• pp.528-538
• /
• 2016

In this paper, an extend kalman filter based relative navigation algorithm is proposed for Link-K based relative navigation. Link-K is a tactical data link system for joint operation capability upgrade of ROK forces. Link-K is inter-operable with Link-16 and transmit and received information of operations and target. In Link-K communication channel, PPLI message including transmitter position and TOA measurement can be used for relative navigation. Therefore Link-K based relative navigation system can be operated. In this paper, software based simulations were carried out for operational feasibility test and performance verification as error factors of proposed Link-K based relative navigation system.

• Journal of the Institute of Electronics and Information Engineers
• /
• v.51 no.6
• /
• pp.124-131
• /
• 2014

This paper describes a design of an adaptive baseband modem based on TDMA(time division multiple access) with a relay protocol function for wireless personal area networks. The designed baseband modem is controlled by a master synchronization signal and can be configured a relay network up to 14 hops. For efficient data relay communications, the internal buffer design is optimized by implementing a priority memory bus controller to a single port memory. And the priority memory bus controller is also designed to minimize the number of synthesized logic gates. To implement the synchronization function of the narrowband TDMA relay communication, the number of gates has been reduced by dividing the frame synchronization circuits and the network slot synchronization circuits. By using these methods, the number of gates are used about 37%(34,000 gates) on Xilinx FPGA XC6SLX9 which has 90,000 gates. For the 1024-bit frame size with a 32-bit synchronization word, the communication reception rate is 96.4%. The measured maximum transmission delay of the designed baseband modem is 230.4 msec for the 14-hop relay communication.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.10 no.1
• /
• pp.99-108
• /
• 1999

In this paper, we propose $\pi$/4 QPSK scheme with block modulation algorithm, which can reduce preamble in order to transmit ATM cell efficiently in the uplink channel of LMDS, and also designed a new carrier recovery circuit which can improve carrier synchronization performance of block demodulation algorithm. The $\pi$/4 QPSK scheme employing the proposed block modulation algorithm achieved efficient frame transmission by making use of a few preamble when carrier synchronization, symbol timing synchronization and slot timing synchronization were performed by burst data of ATM cell in LMDS environment. For performance evaluation of the proposed method, a simulation analyzing the variation of carrier synchronization, symbol timing synchronization and slot timing synchronization using LMDS environment and burst mode condition was executed. In the simulation, the proposed method showed a good performance even though the reduced preamble as a few aspossible when carrier synchronization, symbol timing synchronization and slot timing synchronization is performed.