• Journal of the Korean Society for Geothermal and Hydrothermal Energy
• /
• v.14 no.4
• /
• pp.27-34
• /
• 2018

This study compared constant water bath performances of conventional water-cooled refrigerator and electric heater with an air-cooled VRF chiller and electric heater equipped with optimal control algorithm. In heating mode, the air cooled VRF chiller and electric heater combination reduced the set temperature arrival time by an average of 42 minutes, and energy was also reduced by 18%. In cooling mode, the two systems took 70 minutes to reach the set temperature and showed no difference. Energy was reduced by 33.5% with the new system. For constant temperature maintaining experiment, after reaching the set temperature of $15^{\circ}C$, $20^{\circ}C$ and $22^{\circ}C$, temperature deviations were all in the range of $-0.2^{\circ}C$ to $+0.1^{\circ}C$. Energy was reduced by an average of 84.9%. Through this study, possibility of precise temperature control by an air cooled VRF chiller system was confirmed.

• Journal of Institute of Control, Robotics and Systems
• /
• v.18 no.4
• /
• pp.375-383
• /
• 2012

Together with the GPS-based approach, geolocation through mobile communication networks is a key technology for location-based service. Since the Mobile WiMAX system is considered as a candidate for fourth-generation mobile systems, it is important to investigate its location capability. The geolocation of Mobile WiMAX can be realized when the preamble symbols in the down-link channel are appropriately used for a TDOA (Time-Difference-of-Arrival) approach. However, the cellular structure of Mobile WiMAX inevitably generates co-channel interference, and it is difficult for the mobile terminal to acquire distance measurements from multiple base stations. Therefore, for geolocation via multilateration using the Mobile WiMAX network, it is very important to increase hearability. This paper proposes a geolocation method for Mobile WiMAX which employs interference cancellation and preamble signal overlapping for the enhancement of hearability. A novel interference cancellation strategy for complex-valued Mobile WiMAX signals is presented which has an iterative structure. Simulation results show that the proposed geolocation method provides the user's position with an accuracy of less than 20 m through the Mobile WiMAX cellular network if there is no multi-path or NLOS (None-Line-of-Sight).

• ETRI Journal
• /
• v.39 no.2
• /
• pp.264-274
• /
• 2017

Recently, mobile positioning enhancement has attracted much attention in the 3rd generation partnership project long-term evolution system. In particular, for urban canyon environments, the need for three-dimensional (3D) positioning has increased to enable the altitude of users to be measured. For several decades, several time difference of arrival (TDOA-) based 3D positioning methods have been studied; however, they are only available when at least four evolved Node Bs (eNBs) exist nearby or when all eNBs have the same height. Therefore, in this paper, we propose a new 3D positioning method that estimates the 3D coordinates of a user using three types of two-dimensional (2D) TDOAs. However, the give inaccurate results owing to the undefined axis of the 2D coordinate plane. Therefore, we propose a novel derivation of the hyperbola equation, which includes the undefined axis coordinate in the 2D hyperbola equation. Then, we propose an interaction algorithm that mutually supplies the undefined axis coordinate of users among 2D TDOAs. By performing extensive simulations, we verify that the proposed method is the only solution applicable by using three eNBs with different heights.

• Journal of the Korea Institute of Military Science and Technology
• /
• v.14 no.4
• /
• pp.590-597
• /
• 2011

The IDRS provides detection, classification and bearing/range estimation by performing wavefront curvature analysis on an intercepted active transmission from target. Especially, a estimate of the target bearing/range that significantly affects the optimal operation of own submarine is required. Target bearing/range can be estimated by wavefront curvature ranging which use the difference of time arrival at sensors. But estimation ambiguity occur in bearing/range estimation due to a number of peaks caused by high center frequency and limited bandwidth of the intercepted active transmission and distortion caused by noise. As a result the bearing/range estimation performance is degraded. To estimate target bearing/range correctly, bearing/range estimation method that eliminate estimation ambiguity is required. In this paper, therefore, for wavefront curvature ranging, NLS cost function with curve fitting method is proposed, which provide robust bearing/range estimation performance by eliminating estimation ambiguity. Through simulation the performance of the proposed bearing/range estimation methods are verified.

• Proceedings of the Acoustical Society of Korea Conference
• /
• autumn
• /
• pp.213-216
• /
• 2000

본 연구에서는 마이크로폰 어레이를 이용하여 화자의 음성신호로부터 화자의 위치를 추정하는 기존의 대표적인 알고리듬인 CPSP(Cross Power Spectrum Phase)로부터 보다 반향에 강인한 알고리듬인 저주파 위상 복원 알고리듬을 제안한다. CPSP 함수는 상호 상관관계(Cross Correlation)가 정규화 되어있는 형태를 갖는데, CPSP 함수의 최대 값 인덱스로부터 화자의 공간정보인 TDOA(Time Difference Of Arrival)를 추출한다. 그러나 CPSP 함수를 이용한 공간정보 추정 알고리듬은 실내환경에서 심각하게 일어나는 반향신호에 대해서 취약한 단점을 갖고 있다. 본 논문에서 제안하는 저주파 위상복원 알고리듬은 주파수 측면에서 반향신호가 CPSP 함수에 미치는 영향을 분석하여 반향으로 인하여 왜곡된 위상 성분을 복원함으로써 보다 신뢰도 있는 TDOA 추정을 가능하게 한다. 반향신호로 인한 CPSP의 위상은 저주파보다 고주파에서 심하게 왜곡되는데, 각각의 반향신호의 도달 시간을 기하학적 분포를 갖는 확률변수로 모델링하여 이를 수학적으로 증명하였다. 또한 실제 환경에서 채집한 음성신호를 이용한 모의 실험을 통해 개선된 알고리듬의 성능 개선을 확인하였다.

• Journal of the Korea Society of Computer and Information
• /
• v.14 no.2
• /
• pp.149-155
• /
• 2009

The frequency is widely used to measure the distance. In the warehouse, however, the frequency is apt to be interrupted by various unmade stuffs and cannot be easily applied to that kind of environment. This study will suggest the method to localize a worker in the warehouse exactly with calculating the time difference of arrival from the base position to a node or between each node and with 3-points pin pointer. This study will propose the localizing method using RFID tag and analyze the result using the suggested method. Also, the efficiency of suggested method will be increased with the simulation based on the information from the RFID tag.

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.1
• /
• pp.120-127
• /
• 2019

Passive source depth discrimination has been studied for decades since the source depth can be used for discriminating whether the target is near the surface or submerged. In this thesis, an algorithm for source depth discrimination is proposed based on CIR (Channel Impulse Response) from target-radiated noise (or signal). In order to extract CIR without a known source signal, Ray-based blind deconvolution is used. Subsequently, intersections of CIR pattern, which is characterized by ray arrival time difference, is utilized for discriminating source depth. The proposed algorithm is demonstrated through numerical simulation in ocean waveguide, and verified via the experimental data.

• Journal of KIISE:Computer Systems and Theory
• /
• v.36 no.2
• /
• pp.94-101
• /
• 2009

We introduce a user authentication system using distance estimation and a simple challenge response protocol based on a pre-established key. Using the time difference of arrival between an RF signal and an ultrasonic signal, an authenticator verifies if a user's authentication token is within its threshold distance, and it also verifies if the token's response to its random challenge is valid. We implement our authentication system and we analyze the success rates for authentication according to the variations in the distances and facing angles between the authenticator and the token. Our experimental results show that the token is authenticated with very high probability in reasonable settings.

• Journal of the Korean Society of Fisheries and Ocean Technology
• /
• v.47 no.3
• /
• pp.183-193
• /
• 2011

This study made a comparative analysis of behavioral reaction of squid to red (624nm), green (524nm), blue (460nm) & white LED light, its arrival time for the shadow section by making the shadow section in the central section of a water tank just like the bottom part of a squid jigging vessel, and on-site catching efficiency of LED fishing lamp with control fishing vessel. The color LED light showing the highest squidgathering rate as against the shadow section was found to be blue LED light with 39.3% rate under the dark (0.05lx) condition. Under the brighter condition than 0.05lx, white LED light was found to have the highest gathering rate of 41.5%. In addition, it was found that squid gathering rate was high at the shadow section which showed 6.3-fold brightness difference between the shadow section and bright section. As for the arrival time for the shadow section, blue LED light was found to be the fastest in attracting squids in 192.7 seconds under the dark condition while the red LED light was the fastest in luring squids in 164.6 seconds under the bright condition. The ratio of the squid-jigging operation and sailing in fuel consumption of the fishing vessel loaded with LED fishing lamp is about 7 to 1, showing most of the fuel is consumed more in sailing than in squid-jigging operation. As for a catch of squid, the control vessel loaded with MH (Metal Halide) fishing lamp had more catch of 600-7,080 squids than the vessel loaded with LED fishing lamp having a catch of 260-1,700 squids. In addition, even in the comparison of a catch per automatic jigging machine, the catch of the vessel loaded with MH fishing lamp excelled that of the vessel loaded with LED fishing lamp in 6 operations of squid jigging out of 9 operations. The ratio of hand-jigging and automatic jigging machine (one line) in the LED fishing lamp vessel was 1:1.1 excepting the case of having a catch only using an automatic jigging machine, showing almost the same with each other in catches, while in case of a MH fishing lamp vessel, its ratio against hand-jigging was 1 to 5.8, showing hand-jigging excelled in catches.

• Korean Journal of Agricultural and Forest Meteorology
• /
• v.23 no.4
• /
• pp.222-234
• /
• 2021

Airborne-pests can be introduced into Korea from overseas areas by wind, which can cause considerable damage to major crops. Meteorological models have been used to estimate the wind trajectories of airborne insects. The objective of this study is to analyze the effect of input settings on the prediction of areas where airborne pests arrive by wind. The wind trajectories were predicted using the HYbrid Single-Particle Lagrangian Integrated Trajectory (HYSPLIT) model. The HYSPLIT model was used to track the wind dispersal path of particles under the assumption that brown plant hopper (Nilaparvata lugens) was introduced into Korea from sites where the pest was reported in China. Meteorological input data including instantaneous and average wind speed were generated using meso-scale numerical weather model outputs for the domain where China, Korea, and Japan were included. In addition, the calculation time intervals were set to 1, 30, and 60 minutes for the wind trajectory calculation during early June in 2019 and 2020. It was found that the use of instantaneous and average wind speed data resulted in a considerably large difference between the arrival areas of airborne pests. In contrast, the spatial distribution of arrival areas had a relatively high degree of similarity when the time intervals were set to be 1 minute. Furthermore, these dispersal patterns predicted using the instantaneous wind speed were similar to the regions where the given pest was observed in Korea. These results suggest that the impact assessment of input settings on wind trajectory prediction would be needed to improve the reliability of an approach to predict regions where airborne-pest could be introduced.