• 새물리
• /
• 제68권12호
• /
• pp.1378-1383
• /
• 2018

Multi-wavelength holography has a better axial range than single-wavelength holography, thus allowing unambiguous phase imaging. Noise amplification is the limiting factor in multi-wavelength holography as noise is amplified by a factor equivalent to the magnification of the wavelengths. Here, we propose a new algorithm to remove noise amplification in multi-wavelength holography. The proposed method does not use phase unwrapping and removes $2{\pi}$ ambiguities. Experiments and numerical simulations indicated that the proposed method is fast, has low noise, and is useful for measuring samples with arbitrary step heights.

• 공업화학
• /
• 제10권8호
• /
• pp.1147-1154
• /
• 1999

솔라 시뮬레이터의 핵심이라 말할 수 있는 삼파장 솔라뱅크를 산업용으로 사용화된 수은등과 할로겐 램프를 조합하여 개발하였다. 이 솔라뱅크는 하절기 태양 빛의 최대 복사조도값인 $1120W/m^2$과 각 파장영역에서의 복사조도량 및 조사면적에 대한 복사조도의 ${\pm}10%$의 균일도 3가지를 동시에 만족하도록 고안되어졌다. 분광 복사조도의 측정을 위한 표준을 정하는 방법은 분광 복사휘도를 이용하였고, 측정된 분광 복사조도값을 토대로 솔라뱅크의 방향성, 입사거리, 램프간의 간격, 램프조합, 랩프개수 등을 고려하여 완전한 삼파장 솔라뱅크를 구현하였다. 삼파장 솔라뱅크의 성능 검증을 위하여 색도실험과 열전이실험을 수행하였으며, 실험결과 삼파장 솔라뱅크가 산업용 적외선 램프뱅크보다 색차와 열전이현상의 견지에서 더 우수함을 알 수 있었다.

• Current Optics and Photonics
• /
• 제2권5호
• /
• pp.448-452
• /
• 2018

A three-wavelength $Pr^{3+}:YLF$ laser at 604 nm, 607 nm and 640 nm simultaneously output by Fabry-Perot (F-P) etalon has been obtained. A 444 nm blue laser diode is used for pumping the $Pr^{3+}:YLF$ crystal, and a 0.1 mm F-P etalon is inserted in the resonator to select wavelength. The theoretical model of three-wavelength $Pr^{3+}:YLF$ laser is established, by adjusting the tilt angle of the etalon, the transmittances of the different wavelengths can be controlled, and the threshold values can be made to equalize by controlling the loss among different wavelengths. In the experiment, when the tilt angle of etalon is $9^{\circ}$ and the optimized length of resonator is 48 mm, the total output power of 25 mW at the three-wavelength is achieved at incident pump power of 7.5 W.

• 한국통신학회논문지
• /
• 제34권4B호
• /
• pp.394-402
• /
• 2009

본 논문에서는 다수의 광섬유로 이루서진 광링크와 산재하여 있는 제한 영역 파장변환 능력을 가진 노드들로 구성된 광통신 망의 불통확률을 정확하게 계산할 수 있는 새로운 성능분석 모형을 제안한다. 제안하는 성능분석 모형은 다수의 광섬유로 이루어진 광링크 상에서 사용 가능한 파장들의 분포와 제한 영역 파장변환 이후의 사용 가능한 파장들의 분포, 그리고 다수의 광링크가 연결된 광경로에서의 불통 확률을 계산하기 위한 재귀적 공식을 도출함을 특징으로 한다. NSFNET 망에서 수행한 시뮬레이션 결과를 통해 제안하는 성능분석 모형이 광통신 망의 불통확률을 정확히 예측함을 보인다. 또한, 파장 연속성 제약이 없는 경우의 이상적인 블통화률에 근접하는 성능을 얻기 위해서 소수의 제한영역 파장변환 노드와 소수의 광섬유만으로 구성된 광링크를 포설하는 것으로 충분함을 보인다.

• 조명전기설비학회논문지
• /
• 제26권1호
• /
• pp.15-21
• /
• 2012

In this study, the characteristics of the 2-wavelength white organic light-emitting diod (WOLED) with two colors of yellow and blue were compared and analyzed with 3-wavelength WOLED with three colors of red, green, and blue. The results indicated that the power efficiency of the 2-wavelength WOLED was 1.6 times higher than 3-wavelength WOLED. In addition, the colot coordinate of the 2-wavelenth WOLED which was (0.34, 0.39) was found closer to the optimal color coordinate for the white-lighting application when compared with that of the 3-wavelength WOLED.

• Journal of the Optical Society of Korea
• /
• 제13권2호
• /
• pp.173-177
• /
• 2009

Digital holographic microscopy allows optical path difference measurement. Optical path difference depends on the both refractive index and morphology of sample. We developed a dual-wavelength in-line digital holographic microscope that can measure simultaneously the refractive index and morphology of a sample, providing highly precise three-dimensional information. Here we propose theoretical and experimental methods for dual-wavelength in-line digital holographic microscopy. The measured data were reasonable, although there was data error. By improving the experimental method, we could measure the refractive index more precisely and obtain more accurate three-dimensional information on samples.

• 분석과학
• /
• 제8권4호
• /
• pp.461-464
• /
• 1995

Three wavelength spectrophotometry was used to determine the content of eugenol in Eugenia Caryophyllata Thunb. Using this method could effectively eliminate the deviation of background absorption caused by the change of concentration and the error of quantitative analysis caused by asymmetric peaks, and at the same time the leaning degree of base line was corrected. This method was simple the recovery ratio was 90.05%-116.94% and the coefficient of variation was 3.5%.

• Journal of Biosystems Engineering
• /
• 제23권6호
• /
• pp.591-598
• /
• 1998

Light intensity and spectral characteristics of different types of fluorescent lamps were tested to investigate their possibility as the artificial lighting sources for the close illumination applied in the transplant production factory. Photosynthetic photon flux densitiy(PPF), illuminance and irradiance for all lamps decreased logarithmically with an increase of the vertical distance from the lighting source. The fluorescent lamp specially designed plant growth (PG lamp) showed a maximum spectral irradiance at the wavelength of 660nm. However, it showed lower irradiance than that of a standard fluorescent lamp at the range of wavelength between 500 and 600nm. On the other hand, PG lamp showed higher PPF and lower illuminance than those of the standard fluorescent lamp. The maximum peak of spectral characteristics for both of the single and twin three-bind fluorescent lamps was shorn at the wavelength of 545m and the next peaks were shown at the wavelength of 610nm and 435nm, respectively. Since the red fluorescent lamp has a narrower peak at the wavelength of 660nm, it may be useful for the supplementary red lighting. For three of standard, single three-band and twin three-band fluorescent lamps, the values of conversion factor for converting illuminance to PPF fell within the narrow range from 76 to 791x/$\mu$molㆍm$^{-2}$ ㆍs$^{-l}$ . However, for PG lamp, it was 29.71x/$\mu$molㆍm$^{-2}$ ㆍs$^{-1}$. Also, the values of conversion factor for converting PPF to irradiance of fluorescent lamp used in this study ranged between 4.85 and 5.34$\mu$molㆍm$^{-2}$ ㆍs$^{-1}$/Wㆍm$^{-2}$ .

• Geomechanics and Engineering
• /
• 제21권3호
• /
• pp.227-236
• /
• 2020

Non-destructive exploration using elastic waves has been widely used to characterize rock mass properties. Wave propagation in jointed rock masses is significantly governed by the characteristics and orientation of discontinuities. The relationship between spatial heterogeneity (i.e., joint spacing) and wavelength for elastic waves propagating through jointed rock masses have been investigated previously. Discontinuous rock masses can be considered as an equivalent continuum material when the wavelength of the propagating elastic wave exceeds the spatial heterogeneity. However, it is unclear how stress-dependent long-wavelength elastic waves propagate through a repetitive rock-joint system with multiple joints. A preliminary numerical simulation was performed in in this study to investigate long-wavelength elastic wave propagation in regularly jointed rock masses using the three-dimensional distinct element code program. First, experimental studies using the quasi-static resonant column (QSRC) testing device are performed on regularly jointed disc column specimens for three different materials (acetal, aluminum, and gneiss). The P- and S-wave velocities of the specimens are obtained under various normal stress levels. The normal and shear joint stiffness are calculated from the experimental results using an equivalent continuum model and used as input parameters for numerical analysis. The spatial and temporal sizes are carefully selected to guarantee a stable numerical simulation. Based on the calibrated jointed rock model, the numerical and experimental results are compared.

• 한국광학회:학술대회논문집
• /
• 한국광학회 2006년도 하계학술발표회 논문집
• /
• pp.515-516
• /
• 2006

We have demonstrated three-wavelength Raman fiber lasers using Ge-codoped fiber with 7-pairs of fiber bragg gratings. A slope efficiency of 18.4 % and an total output power of 1.65 W were achieved.