• Proceedings of the KIEE Conference
• /
• 2003.07c
• /
• pp.1598-1600
• /
• 2003

Microcrystalline silicon(c-Si:H) thin-film solar cells are prepared with intrinsic Si-layer by hot wire CVD. The operating parameters of solar cells are strongly affected by the filament temperature ($T_f$) during intrinsic layer. Jsc and efficiency abruptly decreases with elevated $T_f$ to $1400^{\circ}C$. This deterioration of solar cell parameters are resulted from increase of crystalline volume fraction and corresponding defect density at high $T_f$ The heater temperature ($T_h$) are also critical parameter that controls device operations. Solar cells prepared at low $T_h$ (<$200^{\circ}C$) shows a similar operating properties with devices prepared at high $T_f$, i.e. low Jsc, Voc and efficiency. The origins for this result, however, are different with that of inferior device performances at high $T_f$. In addition the phase transition of the silicon films occurs at different silane concentration (SC) by varying filament temperature, by which highest efficiency with SC vanes with $T_f$.

• Biomolecules & Therapeutics
• /
• v.20 no.3
• /
• pp.352-356
• /
• 2012

The present study was undertaken to determine whether ethanol influences on the agonist-induced vascular smooth muscle contraction and, if so, to investigate the related mechanism. The measurement of isometric contractions using a computerized data acquisition system was combined with molecular experiments. Ethanol significantly inhibited thromboxane $A_2$ mimetic-induced contraction with intact endothelial function, but there was no relaxation on thromboxane $A_2$ mimetic U-46619-induced contraction irrespective of endothelium suggesting that the pathway such as Rho-kinase activation, $Ca^{2+}$ entry or thin filament regulation was not affected. In addition, ethanol didn't decrease thromboxane $A_2$ mimetic-induced increase of phospho-myosin phosphatase targeting subunit protein 1 (pMYPT1) or pERK1/2. Interestingly, ethanol didn't inhibit significantly phorbol ester-induced contraction in denuded muscles suggesting that thin filament regulation is less important on the ethanol-induced regulation in the muscle than endothelial NO synthesis. In conclusion, this study provides the evidence and possible related mechanism concerning the effect of ethanol on the agonist-dependent contraction in rat aortic rings with regard to endothelial function.

• Journal of the Semiconductor & Display Technology
• /
• v.5 no.1 s.14
• /
• pp.51-55
• /
• 2006

MgO thin films were prepared through electron-beam deposition onto ITO-coated glass substrates in order to measure electrical, dielectric, and microstructural properties. Design of experiments was performed in this study with the aim to understanding of the effects of processing variables, e.g., substrate temperature and filament current of an e-beam evaporator statistically. Leakage currents, relative dielectric constants, and diffraction intensities of MgO thin films were analyzed statistically, following the analysis procedure provided in the design of experiments. The leakage current level of MgO thin films has been found to be statistically significant at the level of $\alpha=0.1$.

• Applied Microscopy
• /
• v.51
• /
• pp.3.1-3.6
• /
• 2021

We examined the morphology of fertilized egg and ultrastructures of fertilized egg envelopes of dwarf rainbowfish (Melanotaenia praecox) belong to Melanotaeniidae using light and electron microscopes. The fertilized eggs were spherical with adhesive filament, transparent, demersal, and had a narrow perivitelline space and small oil droplets. The size of fertilized egg was 1.02 ± 0.18 mm (n = 30), and there were two kinds of adhesive filament on the fertilized eggs. The long and thick (diameter 12.22 ± 0.52 ㎛, n = 20) adhesive filaments were only at the area of animal pole, and short and thin (diameter 1.99 ± 0.23 ㎛, n = 20) adhesive filaments were around the long filaments. A micropyle was conical shaped with adhesive filament and located near the animal pole of egg. The outer surface of fertilized egg was rough side. Also, the total thickness of the fertilized egg envelope was about 7.46 ± 0.41 ㎛ (n = 20), the fertilized egg envelope consisted of two layers, an inner lamellae layer and an outer layer with high electron-density. And the inner layer was 8 layers. Collectively, these morphological characteristics and adhesive property of fertilized egg with adhesive filaments, and ultrastructures of micropyle, outer surface, and section of fertilized egg envelope are showed species specificity.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.22 no.5
• /
• pp.563-572
• /
• 1998

An experimental study of hot filament chemical vapor deposition(HFCVD) has been carried out for the fabrication of diamond thin film. Of particular interest is the measurement of deposition uniformity on large substrates. Experimental apparatus including a vacuum chamber, heating elements, etc. has been designed and manufactured. Deposition profiles for different pretreatment powders and different flow rates have been measured in conjunction with the measurement of substrate temperature distribution on a large substrate surface. As the flow rate increases, deposition rate increases, however, the crystallinity becomes worse. Higher growth rate has been found on the region closer to the center location where substrate temperature is higher. The crystallinity has been improved as gas flow rate decreases. The growth rate and morphology of deposition were identified by SEM and the existence of diamond phase was proved by Raman spectroscopy.

• Magazine of the Korean Society of Agricultural Engineers
• /
• v.31 no.2
• /
• pp.135-143
• /
• 1989

The in-plane permeabilities for domestic geotextile products are calculated by some theoretical formulas and compared with them obtained by experiments to examine the suitability of those formulas. The results obtained are as follows: 1. It appears that the diameter of the filament yarn is larger and more uniform than that of the staple fiber according to the microscopic analysis on the geotextile 2. The in-plane permeability of the geotextile shows that the theoretical values by drag and channel theory is close to the experimental ones. 3. The porosity of the geotextile is hardly influenced by normal pressure. 4. In the case of the same thickness of the geotextile the side surface area of the filament yarn is larger than that of the staple fiber. 5. The capillary height of the geotextile shows that the theoretical values is close to the experimental ones and thick geotextile is higher than thin geotextile.

• Biomedical Science Letters
• /
• v.6 no.3
• /
• pp.171-179
• /
• 2000

The lengths of thick and thin filaments in the sarcomeres of most vertebrate skeletal muscles are precisely regulated and are important structural parameters in understanding muscle contraction. Nebulin is a usually large protein that spans the whole length of thin filaments in the sarcomeres of skeletal muscles. In this paper we used SDS-PAGE and immunoblot to identify nebulin isoform proteins in muscle and non-muscle tissues. We prepared embryonic chicken tissues including skeletal muscle, cardiac muscle, smooth muscle, brain, liver to compare nebulin isoform proteins. The proteins were divided into soluble and insoluble fraction. As a result, we identified tissue specific expression of various nebulin isoform proteins in muscle and non-muscle tissues of chicken. Nebulin was detected in skeletal muscle of adult chicken about 500 kDa. Nebulett was expressed in cardiac muscle of embryonic and adult chicken about 107 kDa. A giant protein with molecular mass of about 380 kDa was identified in brain of non-muscle of chicken. This giant protein was detected in the soluble fraction of chicken embryo. The unequal distribution of the nebulin isoform proteins suggests tissue specific regulation of the isoform expression and indicates a functional specialization of the encoded isoform subtypes.

• Biomedical Science Letters
• /
• v.7 no.4
• /
• pp.167-172
• /
• 2001

Nebulin is an approximately 700 kDa filamentous protein in vertebrate skeletal muscle. It binds to the Z line and also binds side-by-side to the entire thin actin filament in a sarcomere. The correlation of nebulin size with thin filament length have led to the suggestion that nebulin acts as a molecular ruler for the length of thin filaments. The C-terminal part of human nebulin is anchored in the sarcomeric Z-disk and contains an SH3 domain. SH3 domains have been identified in an ever-increasing number of proteins important for a wide range of cellular processes, from signal transduction to cytoskeleton assembly and membrane localization. However, the exact physiological role of SH3 domains remains, in many cases, unclear. To explore the role of nebulin SH3 in the cytoskeletal rearrangement that accompanies myoblast differentiation, we transfected sense and antisense nebulin SH3 domain fused to enhanced green fluorescent protein in myoblast. Cells expressing nebulin SH3 fragment showed decrease of cell-cell adhesion, and cells transfected with antisense nebulin SH3 gene showed a rounded cell morphology and loss of cell-matrix adhesion. No alteration in cell shape and differentiation were observed in control cells expressing enhanced green fluorescent protein. Perturbation of nebulin altered the cell shape and disrupted cell adhesion in myoblast, demonstrating that nebulin can affect cytoskeleton rearrangement.

• Journal of The Korean Astronomical Society
• /
• v.40 no.3
• /
• pp.67-82
• /
• 2007

The basic building block of solar filaments/prominences is thin threads of cool plasma. We have studied the spectral properties of velocity threads, clusters of thinner density threads moving together, by analyzing a sequence of $H{\alpha}$ images of a quiescent filament. The images were taken at Big Bear Solar Observatory with the Lyot filter being successively tuned to wavelengths of -0.6, -0.3, 0.0, +0.3, and +0.6 ${\AA}$ from the centerline. The spectra of contrast constructed from the image data at each spatial point were analyzed using cloud models with a single velocity component, or three velocity components. As a result, we have identified a couple of velocity threads that are characterized by a narrow Doppler width($\Delta\lambda_D=0.27{\AA}$), a moderate value of optical thickness at the $H{\alpha}$ absorption peak($\tau_0=0.3$), and a spatial width(FWHM) of about 1". It has also been inferred that there exist 4-6 velocity threads along the line of sight at each spatial resolution element inside the filament. In about half of the threads, matter moves fast with a line-of-sight speed of $15{\pm}3km\;s^{-1}$, but in the other half it is either at rest or slowly moving with a line-of-sight velocity of $0{\pm}3km\;s^{-1}$. It is found that a statistical balance approximately holds between the numbers of blue-shifted threads and red-shifted threads, and any imbalance between the two numbers is responsible for the non-zero line-of-sight velocity determined using a single-component model fit. Our results support the existence not only of high speed counter-streaming flows, but also of a significant amount of cool matter either being at rest or moving slowly inside the filament.

• Proceedings of the Korea Association of Crystal Growth Conference
• /
• 2000.06a
• /
• pp.127-142
• /
• 2000

The charged cluster model states that chemical vapor deposition (CVD) begins with gas phase nucleation of charged clusters followed by cluster deposition on a substrate surface to form a thin film. A two-chambered CVD system, separated by a 1-mm orifice, was used to study gold deposition by thermal evaporation in order to determine if the CCM applies in this case. At a filament temperature of 1523 and 1773 K, the presence of nano-meter sized gold clusters was found to be positive and the cluster size and size distribution increased with increasing temperature. Small clusters were found to be amorphous and they combined with clusters already deposited on a substrate surface to form larger amorphous clusters on the surface. This work revealed that gold thin films deposited on a mica surface are the result of the sticking of 4-10 nm clusters. The topography of these films was similar to those reported previously under similar conditions.