• Journal of Aerospace System Engineering
• /
• v.10 no.2
• /
• pp.14-21
• /
• 2016

In this study, we proposed a water rocket CULV-1 (Chosun University Launch Vehicle-1). Unlike a conventional water rocket, CULV-1 can perform the booster rocket, fairing, and payload separation like an actual launch vehicle and also the imaging data acquisition. The conceptual and critical design of the proposed CULV-1 have been performed considering the operation characteristics. The verification tests have been performed from subsystem to system level in accordance with the established test specifications and verification procedures. Through the final launch test of the flight model, we have verified the design effectiveness of the proposed separation mechanisms for water rocket applications and the mission requirements of the CULV-1 also have been complied.

• Proceedings of the KSME Conference
• /
• 2001.06a
• /
• pp.401-406
• /
• 2001

When propagating the thickness direction of composite laminates ultrasound waves interacts strongly with the orientation and sequence of the plies in a layup. Also the layup orientation greatly influences its properties in a composite laminate. If one ply of the layup orientation is misaligned, it could result in the part being rejected and discarded. Now, most researchers cut a small coupon from the waste edge and use a microscope to optically verify the ply sequences on important parts. Those may add a substantial cost to the product since the test is both labor hard and performed after the part is cured. A nondestructive technique would be very beneficial, which could be used to test the part after curing and require less time than the optical test. Therefore we have developed, reduced, and implemented a novel ply-by-ply vector decomposition model for composite lam mates fabricated from unidirectional plies. This model decomposes the transmission of a linearly polarized ultrasound wave into orthogonal components through each ply of a laminate. It is found that a high probability shows between the model and tests developed in characterizing cured layups of the laminates.

• The Transactions of the Korean Institute of Electrical Engineers A
• /
• v.49 no.7
• /
• pp.359-364
• /
• 2000

This paper is introducing a newly developed spark-gap switch with dual trigger system, into which the current from the voltage source is injected along with the test sequence during the synthetic testing of high voltage circuit-breaker. The currently-used spark gap switch is narrow in operating range due to the use of the method of triggering energy being injected by single way. As a result, the frequent happening of misoperation has greatly reduced the test quality and test efficiency and has required the cost of maintenance excessively. In this study, accordingly, in order to basically remove these problems, another triggering system is installed to the opposite direction on the existing triggering system; attaching the same time and the same rising time of pulse wave as on the existing system, so that at a comparatively trigger gap distance from the main electrode(the gap can be operated at 60% of self-break voltage, while at 80% in the current system), the main electrode has been enabled to be closed by the development of spark gap switch with dual trigger system.

• The Korean Journal of Applied Statistics
• /
• v.22 no.3
• /
• pp.515-530
• /
• 2009

Evaporation from surface water bodies is influenced by a number of meteorological parameters. The rate of evaporation is primarily controlled by incoming solar radiation, air and water temperature and wind speed and relative humidity. In the present study, influence of weekly meteorological variables such as air temperature, relative humidity, bright sunshine hours, wind speed, wind velocity, rainfall on rate of evaporation has been examined using 35 years(1971-2005) of meteorological data. Statistical analysis was carried out employing linear regression models. The developed regression models were tested for goodness of fit, multicollinearity along with normality test and constant variance test. These regression models were subsequently validated using the observed and predicted parameter estimates with the meteorological data of the year 2005. Further these models were checked with time order sequence of residual plots to identify the trend of the scatter plot and then new standardized regression models were developed using standardized equations. The highest significant positive correlation was observed between pan evaporation and maximum air temperature. Mean air temperature and wind velocity have highly significant influence on pan evaporation whereas minimum air temperature, relative humidity and wind direction have no such significant influence.

• Korean Journal of Veterinary Pathology
• /
• v.1 no.2
• /
• pp.119-124
• /
• 1997

The objective of this study was to develop digoxigenin (DIG)-labeled in situ hybridization (ISH) test for diagnosis of Aujeszky's Disease(AD) in infected organs. Specific DNA with well conserved gene sequences encoding gp50 antigen in AD virus (ADV) was obtained by Polymerase Chain Reaction (PCR) method. A pair of oligonucleotide primers used in PCR allowed amplification of a 217 bp sequence from the gp50 ADV gene. The DNA was then labeled with DIG by primer labeling method for use as probe in ISH test to detect ADV nucleic acids in various tissue. Positive hybridization was demonstrated by dark pigmentation in nuclei and cytoplasm of ADV infected cells particularly in brain tonsillar crypt epithelium and pulmonary alveolar cells. This result suggests that ISH is a valuable sensitive and rapid diagnostic test for AD.

• Journal of the Korean Society for Aeronautical & Space Sciences
• /
• v.42 no.4
• /
• pp.291-297
• /
• 2014

A Design of Experiments(DOE) approach to an experimental study of fuselage drag and stability characteristics of a helicopter configuration was applied to achieve an accuracy improvement in the wind tunnel testing. The impact of blocking the test was assessed by comparing the ANOVA table for the blocked and unblocked cases. For a second-order response model, the role of blocking resulted in a substantial increase in the accuracy of test results. These accuracy improvement could be achieved through randomization, blocking, and replication of the data points i.e. a re-ordering of the test sequence where the data were acquired.

• Proceedings of the KIEE Conference
• /
• 1997.07e
• /
• pp.1715-1717
• /
• 1997

This paper deals with the dead operation characteristics of the earth leakage circuit breaker(ELB) caused by impulse voltages. The surge protective devices for electronic circuit and AC power lines are becoming more widely used. It is possible to give rise to the malfunction of ELB due to the operation of surge protective devices, and the interruption of AC power lines brings about several disadvantages such as low reliability of electronic and informational systems, economical loss, and etc. The dead operation characteristics of the ELB from impulse voltages were measured under the conditions of KS C 4613 and the test circuit with a varistor. As a result, the peak current value of the zero-phase sequence circuit of the ELB is increased as the surge voltage and stray capacitance increase. All of the ELBs used in this work were satisfied with the lightning impulse dead operation test condition defined in KS C 4613. However one specimen only did not cause dead operation in the condition of the test circuit with a varistor. There is high possibility that a large portion of the ELBs connected with the AC power lines having the surge protective devices bring about the dead operation.

• YAKHAK HOEJI
• /
• v.33 no.4
• /
• pp.229-236
• /
• 1989

Even though two different preparations are chemically equivalent, the variance of bioavailability differenciates the clinical effect of preparations, so that the preparations need to be evaluated by comparing bioavailability in vivo as well as chemical equivalence. In this study, bioequivalence tests of commercially available isoniazid tablets A, B, C and D (standard) were performed to give some guidelines to bioequivalence test. The bioavailability parameters obtained by drug administeration were statistically analyzed. Statistical evaluation of the data involved an analysis of variance for a cross over design. Cross over design was employed with 8 healthy volunteers. The results were within 20% difference of mean value in the AUC, Cmax, Tmax and amount of urinary excretion (Au) between standard and isoniazid tablets. The results of ANOVA showed no significant differences for 'group or sequence', but almost not for 'between subjects'. The tablet. A, B and D were within 20 min, but tablet C was within 50 min. Tablet A was biologically equivalent in the Au. tablet B biologically equivalent in the Au and AUC. Tablet C was biologically equivalent in the Au. The relationship between the dissolution rate and Au was significant.

• Korean Journal of Soil Science and Fertilizer
• /
• v.49 no.3
• /
• pp.251-258
• /
• 2016

A rhizobacterium LPN-2, which showed strong antifungal activity and auxin producing ability, was isolated from a farmland in North Gyeongsang Province, South Korea. Based on analysis of the 16S rDNA sequence, strain LPN-2 was identified as a novel strain of Burkholderia and was designated as Burkholderia sp. LPN-2. In vitro experiments showed that the isolated stain LPN-2 significantly produced auxin within 48 hr incubation. In order to check for PGPR function we performed in vivo growth promoting test in different crops, including mung bean, pea and cabbage. Application of Burkholderia sp. LPN-2 showed dramatic growth promoting effect on all the tested plants. We also confirmed siderophore and cellulase productions by Burkholderia sp. LPN-2 using CAS blue agar and CMC plate test. Further treatment with LPN-2 and the crude culture broth was effective in suppressing anthracnose in vitro test and also reduced incidence and severity of anthracnose in apple and pepper. Taken together, we conclude that Burkholderia sp. LPN-2 might be used as organic fertilizer for effective crop production in organic farming.

• Journal of Korean Institute of Industrial Engineers
• /
• v.35 no.4
• /
• pp.257-265
• /
• 2009

This paper considers the hybrid flow shop scheduling problem for the objective of minimizing the number of tardy jobs. In hybrid flow shops, each job is processed through multiple production stages in series, each of which has multiple identical parallel machines. The problem is to determine the allocation of jobs to the parallel machines at each stage as well as the sequence of the jobs assigned to each machine. Due to the complexity of the problem, we suggest search heuristics, tabu search and simulated annealing algorithms with a new method to generate neighborhood solutions. In particular, to evaluate and select neighborhood solutions, three surrogate objectives are additionally suggested because not much difference in the number of tardy jobs can be found among the neighborhoods. To test the performances of the surrogate objective based search heuristics, computational experiments were performed on a number of test instances and the results show that the surrogate objective based search heuristics were better than the original ones. Also, they gave the optimal solutions for most small-size test instances.