• International Journal of Industrial Entomology and Biomaterials
• /
• v.35 no.2
• /
• pp.106-110
• /
• 2017

The developmental responses of insects to temperature are important considerations in gaining a better understanding of their ecology and life histories. Temperature dependent models permit examination of the effect of temperature on the geographical distributions, population dynamics, and management of insects. The measurements of insect developmental and survival responses to temperature pose practical challenges that depend. The developmental characteristics of A. diaperinus were investigated at four temperature regimes (20, 25, 30 and $35^{\circ}C$), a relative humidity of 60%, and a light:dark photoperiod of 16:8h. The developmental time from larva to adult was 129.0, 49.8, 40.5 and 31.9 days at temperatures of 20, 25, 30 and $35^{\circ}C$, respectively. Pupal rate was 80.0%, 100%, 83.3% and 91.7% at temperatures of 20, 25, 30 and 35 respectively. There is an increasing need for a standardized manual for rearing this. Pupa had significantly lower weights at $35^{\circ}C$ than at the other temperatures. Female pupae (20mg) were significantly heavier than male (17mg).

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.2
• /
• pp.214-221
• /
• 2019

In this paper, a temperature dependent acoustic receiving characteristics of underwater acoustic sensor is studied by theoretical and experimental investigations. Two different types (low mid frequency sensor and high frequency sensor) of underwater acoustic sensors are designed with different configuration of baffle and conditioning plate. The temperature dependent characteristics of the acoustic sensors are investigated within the temperature range from $-2^{\circ}C$ to $35^{\circ}C$. The material properties of the piezoelectric ceramics, molding and baffle, which are the primary materials of the acoustic sensors, are measured with temperature change. The temperature dependent RVS (Receiving Voltage Sensitivity) characteristics of the acoustic sensors are simulated by using the measured material properties. The RVS changes of the acoustic sensors are measured by changing temperature in the watertank where the acoustic sensors are installed. The measured and the simulated data show that the temperature dependent characteristics of the acoustic sensors are mainly dependent for the sound speed changes of the molding material.

• Korean journal of applied entomology
• /
• v.62 no.4
• /
• pp.385-388
• /
• 2023

Gypsy moth (Lymantria dispar), a polyphagous insect pest belonging to the family Lymantriidae, is widely distributed in Korea, Japan, Siberia, Europe, and North America. They pose a threat to various host plants including pear trees, apple trees, and blueberries. Traditionally considered a forest pest, the increasing incursion of gypsy moths into agricultural land near forested areas has intensified damage to crops lacking effective control methods. This study aimed to investigate the temperature-dependent development of gypsy moths to enhance outbreak prediction and advance technology development. The effects of temperature on development of each life stage were investigated under constant temperature conditions of 18, 21, 24, 27, 30, and 33℃ (14L:10D, RH 60±5%) utilizing egg masses collected in Jeollanam-do Jangheung-gun in 2021. The results revealed that higher temperatures accelerated the development rate of the gypsy moth larvae with optimal development occurring at 30℃. However, the survival rate was lowest at 33℃. At the favorable temperature of 30℃, the total development period was 43.8 days for females and 42.5 days for males. The developmental threshold temperature were 13.1℃ for females and 12.5℃ for males, with effective accumulated temperature of 641.1 DD and 657.8 DD, respectively.

• Journal of the Korea Concrete Institute
• /
• v.17 no.5 s.89
• /
• pp.857-868
• /
• 2005

This paper deals with the accumulated damage in concrete structures due to the cyclic freeze-thaw as an environmental load. The cyclic ice body nucleation and growth processes in porous systems are affected by the thermo-physical and mass transport properties, and gradients of temperature and chemical potentials. Furthermore, the diffusivity of deicing chemicals shows significantly higher value under cyclic freeze-thaw conditions. Consequently, the disintegration of concrete structures is aggravated at marine environments, higher altitudes, and northern areas. However, the properties of cyclic freeze-thaw with crack growth and diffusion of chloride ion effects are hard to be identified in tests, and there has been no analytic model for the combined degradations. The main objective is to determine the driving force and evaluate the reduced strength and stiffness by freeze-thaw. For the development of computational model of those coupled deterioration, micro-pore structure characterization, pore pressure based on the thermodynamic equilibrium, time and temperature dependent super-cooling with or without deicing salts, nonlinear-fracture constitutive relation for the evaluation of internal damage, and the effect of entrained air pores (EA) has been modeled numerically. As a result, the amount of ice volume with temperature dependent surface tensions, freezing pressure and resulting deformations, and cycle and temperature dependent pore volume has been calculated and compared with available test results. The developed computational program can be combined with DuCOM, which can calculate the early aged strength, heat of hydration, micro-pore volume, shrinkage, transportation of free water in concrete. Therefore, the developed model can be applied to evaluate those various practical degradation cases as well.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1997.10a
• /
• pp.97-102
• /
• 1997

In this study, a predictive method which was modified from KIshi's model for the temperature development of concrete was developed by using mineral compounds of clinker and pozzolans. Temperature dependent heat generation of reaction was also considered. Specific heat considering the effect of mix proportion and temperature was calculated with experimental data in the literatures. Thermal conductivity considering the effect of mix proportion and temperature was experimentally investigated. Through this research it was found that the developed method considering thermal properties accurately predicted adiabatic temperature rise of concrete without the experiment. It was also found that the thermal conductivity of concrete could be predicted by the volume ratio of each component of mix proportion and was independent of temperature within the normal climatic range.

• Proceedings of the Korean Society of Propulsion Engineers Conference
• /
• 2008.03a
• /
• pp.476-479
• /
• 2008

The combustion efficiency of the solid fuel ramjet is affected by the inlet air temperature. And this inlet air temperature is dependent on the flight Mach number and the environment air temperature. If the flight altitude is changeable, the inlet air temperature and the air density also vary. The performance efficiency is investigated with this variables related to the combustion efficiency.

• Development and Reproduction
• /
• v.16 no.4
• /
• pp.321-327
• /
• 2012

Korean bullhead (Pseudobagrus fulvidraco) was collected from the Kum River areas of Kangkyung-eup, Nonsan city, Chungcheongnam-do, Korea, from April to June, 2012 and was fertilized in order to observe egg development and temperature-related cleavage rates and mitotic intervals (${\tau}_0$). The fertilized eggs were separative, demersal and light yellowish with $1.5{\pm}0.06mm$ in diameter, and did not contain oil globules. The first cleavage stages were 90 min, 80 min, 60 min and 50 min at $21^{\circ}C$, $24^{\circ}C$, $27^{\circ}C$ and $30^{\circ}C$, respectively. At higher temperatures, eggs developed faster and underwent further identical development. For Korean bullhead, ${\tau}_0$ were $33.4{\pm}2.08$ min at $21^{\circ}C$, $31.5{\pm}3.06$ min at $24^{\circ}C$, $28.1{\pm}2.11$ min at $27^{\circ}C$ and $26.4{\pm}3.35$ min at $30^{\circ}C$. There were strong negative correlations between the $\tau_0$ and water temperatures at all points studied (Y=-1.13X+58.15, $R^2$=0.98, n=30, where Y is ${\tau}_0$ and X is temperature). The results obtained in this work will be helpful for chromosome manipulation by use of cleavage frequency data and ${\tau}_0$ data in Korean bullhead.

• KOREAN JOURNAL OF CROP SCIENCE
• /
• v.64 no.3
• /
• pp.213-224
• /
• 2019

There is an increasing frequency in the occurrence of abnormal weather phenomena such as sharp increases and decreases in temperature. Under these weather conditions, the heading time of rice changes unexpectedly, which poses problems in agriculture. Therefore, we investigated the effect of temperature on the heading response at different growth stages in rice. During the period from transplanting to heading, the plants were subjected to different temperature treatments, each for a 9-day period, to observe the heading response. For the heading date analysis, "heading date" was defined as the number of days from transplanting to the appearance of the first spikelet. We found that the influence of temperature increased in the order of rooting stage, followed by meiosis, early tillering, spikelet differentiation, and panicle initiation stage in all ecological types and cultivars. In particular, unlike the results reported previously, the effect of temperature on heading during the photo-sensitive period was very small. Meanwhile, the influence of temperature on vegetative growth response at different growth stages was not consistent with heading response. These results can be used as basic data for predicting the variation in heading date owing to temperature variation at each growth stage. In addition, we propose that the concept of day length should be included in determining the influence of temperature on the photo-sensitive period.

• Korean journal of applied entomology
• /
• v.39 no.2
• /
• pp.73-82
• /
• 2000

Two Psyllidae species of Cacopsylla pyricola (Foerster) and C. pyrisuga (Foerster)damaging pear trees have been reported in Korea. However, their ecological characteristics and damagepatterns have not been evaluated yet. To establish basic control measures of C. pyricola, field phenology,overwintering ecology, seasonal fluctuation and temperature-dependent development of C. pyricola wereexamined. C. pyricola overwintered under the bark scale of pear trees as winter form adults and theymoved to fruiting twigs from mid-February. Honeydew produced by C. pyricola nymphs and adults asthey feed caused serious black sooty mold on leaves and fruits. The seasonal occurrence of C. pyricolawas different every year. In 1993, characterized by cold temperature and heavy precipitation, C. pyricolapopulation was maintained highly during growing season. However, the population was decreased rapidlyfrom early July in 1994, year of hot and dry weather condition. In 1995, year of average temperature, thedensity of C. pyricola population was decreased during hot months of July and August, and rebuilt up inSeptember and October. The development periods of C. pyricola eggs were 13.33 days at 15"C, 9.32 daysat 20$^{\circ}$C, 7.82 days at 25"C, 6.60 days at 30$^{\circ}$C, and 7.75 days at 35$^{\circ}$C. The development periods ofnymphs were 33.75 days at 15OC, 23.77 days at 20$^{\circ}$C, 15.21 days at 25"C, and 17.40 days at 30$^{\circ}$C. Theirdevelopment periods and mortalities were increased in higher temperatures. The parameters of nonlineardevelopment model, Weibull and linear development models of Cacopsylla pyricola were estimated.models of Cacopsylla pyricola were estimated.

• Korean journal of applied entomology
• /
• v.56 no.1
• /
• pp.1-18
• /
• 2017

Temperature-dependent development model is an essential component for forecasting models of insect pests as well as for insect population models. This study reviewed the nonlinear models which explain the relationship between temperature and development rate of insects. In the present study, the types of models were classified largely into empirical and biophysical model, and the groups were subdivided into subgroups according to the similarity of mathematical equations or the connection with original idea. Empirical models that apply analytical functions describing the suitable shape of development curve were subdivided into multiple subgroups as Stinner-based types, Logan-based types, performance models and Beta distribution types. Biophysical models based on enzyme kinetic reaction were grouped as monophyletic group leading to Eyring-model, SM-model, SS-mode, and SSI-model. Finally, we described the historical development and characteristics of non-linear development models and discussed the availability of models.