• Journal of Korea Society of Industrial Information Systems
• /
• v.12 no.2
• /
• pp.79-84
• /
• 2007

This papar reports design and fabrication of CMOS temperature control circuit using MOSIS 0.25um-3.3V CMOS technology. The proposed circuit has a temperature coefficient of $13mV/^{\circ}C$ for a wide operating temperature range with a good linearity. Furthermore, the temperature coefficient of output voltage can be controlled by adjusting external bias voltage. This circuit my be applicable to the design of one-chip IC where quartz crystal resonator is mounted on CMOS oscillator chips.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2001.11a
• /
• pp.391-396
• /
• 2001

In order to estimate thermal cracking in mass concrete and to decide the removal time of the forms outside the concrete structures in wintertime, temperature measurement is indispensible. Until now, the measurement system employs thermocouple type. In this paper, we introduce economical and accurate NTC(Negative Temperature Coefficient) ceramic type measurement system. In principle, NTC ceramic type sensor is very sensitive in the range -20~15$0^{\circ}C$. In this range, the signal change is so large that the sensor needs less amplification than thermocouple. Therefore, not only the sensor itself is inexpensive but also the system is too. In this experiments the temperature of the NTC system are identical to those of thermocouple. In conclusion, inexpensive NTC thermistor system is very adequate to the temperature measurement during concrete curing.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 1999.03b
• /
• pp.136-142
• /
• 1999

The injection molded part shrinks in the process of solidification by the amount of the coefficient of linear thermal expansion multiplied by the temperature difference between the coefficient of linear thermal expansion multiplied by the temperature difference between the room temperature and the temperature at which the solid structure is formed in the mold And it is called warpage for this type of deformation that shrinkage are not uniform throughout the injection molded part. To predict warpage phenomena in the articles the results obtained theoretically from the change of mold temperature fiber content of composites have been compared with exsperimental results.

• Proceedings of the KIEE Conference
• /
• 1995.11a
• /
• pp.342-344
• /
• 1995

Using piezoresistive effects of single-crystal and poly-crystalline silicon, pressure sensors of the same pattern were fabricated for comparison of temperature characteristics. Optimum size and aspect ratio of rectangular sensor diaphragm were calculated by FEM. For polsilicon pressure sensor, polysilicon resistors of Wheatstone bridge were deposited by LPCVD to be used in a wide' temperature range. Polysilicon pressure sensors showed more stable temperature characteristics than single-crysta1 silicon in the range of $-20\sim125[^{\circ}C]$. To get low TCO (Temperature Coefficient of Offset), below $\pm$3 [${\mu}V/V/^{\circ}C$], it is needed for each TCR of piezoresistors to have a deviation within $\pm25[ppm/^{\circ}C]$ less than $\pm500[ppm/^{\circ}C]$ of resistors for polysilicon pressure sensor can result in low TCS(Temperature Coefficient of Sensitivity) of -0.1[%FS/$^{\circ}C$].

• Proceedings of the KSRS Conference
• /
• 2007.10a
• /
• pp.518-521
• /
• 2007

To retrieve Sea Surface Temperature(SST) from NOAA-AVHRR imagery the spilt window atmospheric correction algorithm is generally used. Recently, there have been various new algorithms developed to process these data, namely the variable-coefficient split-window, the R54 transmittance-ratio method, fixed-coefficient nonlinear algorithm, dynamic water vapour (DWV) correction method, Dynamic Water Vapour and Temperature algorithm (DWVT). We used MCSST (Multi-Channel Sea surface temperature) and NLSST(Non linear sea surface temperature) algorithms in this study. The study area is around the Korea sea area (Yellow Sea). We compared and analyzed with various methods by applying each Ocean in-situ data and satellite data. The primary aim of study is to verify and optimize algorithms. Finally, this study proposes an optimized algorithm for SST retrieval.

• The Korean Journal of Ceramics
• /
• v.6 no.3
• /
• pp.206-208
• /
• 2000

0.65 mol% MgO-doped LiNbO$_3$single crystals were grown by CZ method. The obtained single crystals were colorless and transparent. Noncritically phase-matched second harmonic generation (SHG) of 532-nm radiation from 1064-nm in MgO-doped LiNbO$_3$has been investigated by using pulsed Nd:YAG laser. The phase-matching temperature was room temperature. SHG conversion efficiencies were typically achieved higher than 50% at the phase-matching temperature with no photorefractive damage in the region of fundamental power density which was used in this experiment. The thermo-birefringence coefficient and the electro-birefringence coefficient of SHG were calculated from the temperature phase-matching profile with the electric field.

• Journal of Ginseng Research
• /
• v.9 no.2
• /
• pp.248-255
• /
• 1985

In order to investigate the optimal drying condition of white ginseng by using bulk air drier(130 x 62 x 65cm), drying curves, diffusion coefficient at various drying temperature, the energy of activation, variation of color intensity and chemical components during drying of white ginseng were studied. Fick's second low of diffusion for diffusion out of spheres was successfully applied to describe the drying of white ginseng. It was found that the diffusion coefficient of water was 2.2x107, 9.0x107 cm2/sec at drying temperature 4$0^{\circ}C$, 55$^{\circ}C$, respectively. An Arrhenius type temperature dependency of moisture diffusivity was found, the energy of activation being 18.8 Kcal/g mol. Color intensity of white ginseng dried at various drying temperature was increased with an increase in drying temperature. The contents of crude protein, reducing sugar and crude saponin during drying of white ginseng were gradually decreased as increasing of drying time. And with the sensory evaluation by multiple comparison difference analysis, the optimal drying temperature of white ginseng was between 45$^{\circ}C$ and 5$0^{\circ}C$.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.14 no.9
• /
• pp.726-730
• /
• 2001

Temperature stabilities of dielectric constraints and resonant frequencies of the substrates are very important in piezoelectric ceramics oscillators and filters. In this study, it was investigated temperature stability of the length-extensional vibration mode of Pb(Zr$\_$y/Ti$\_$1-y/)O$_3$+x[wt%]Cr$_2$O$_3$ ceramics. The mode can be utilized in fabricating ultra-small 455 kHz IF devices. Addition of Cr$_2$O$_3$ in morphotrophic phase PZT decreased the variations of dielectric constant, electro-mechanical coupling factor k$\_$31/ and resonant frequency by thermal shock. As additive weight of Cr$_2$O$_3$increased, the temperature coefficient of resonant frequency changed from positive number to negative one. And the composition tith temperature coefficient of resonant frequency was shifted to the one with increased Cr$_2$O$_3$ additive weigh by thermal aging.

• Journal of the Optical Society of Korea
• /
• v.7 no.2
• /
• pp.84-88
• /
• 2003

A new method for temperature compensation of fiber Bragg grating (FBG) using hi-metal is proposed and experimentally demonstrated. Bi-metal bends toward the metal of low temperature expansion coefficient as the temperature increases, and this property is utilized to cancel the thermo-optic effect of the fiber. The optimum thickness of the high coefficient metal was empirically found by the trial-and-error method. The temperature sensitivities were 8.1 pm/$^{\circ}C$ and -0.018 pm/$^{\circ}C$ for the uncompensated and compensated FBGs, respectively, which indicates a reduction to a mere 0.22 % of the original sensitivity. No appreciable change in the spectral shape was observed. The packaging technique described in this paper is simple and compact, and it can be used for FBGs in WDM and DWDM communication systems that have stringent requirements on the temperature stability of the components.

• Journal of Environmental Science International
• /
• v.29 no.7
• /
• pp.703-713
• /
• 2020

In this study, carbon dioxide concentration and air temperature at different elevations were observed and analyzed in the upper atmosphere of mud flat and reed beds at low tide in Suncheon Bay. The carbon dioxide concentration and air temperature sensors were mounted on the drone, and the carbon dioxide concentration and air temperature by altitude (5 m, 10 m, 20 m, 40 m) at five points in the tidal flat and reed beds were observed in the morning and afternoon. The carbon dioxide concentrations in the upper atmosphere of the tidal flat ranged from 453.0 to 460.2 ppm in the morning and 441.6 to 449.7 ppm in the afternoon. The carbon dioxide concentrations in the upper atmosphere of the reed beds ranged from 448.9 to 452.4 ppm in the morning and 446.0 to 454.4 ppm in the afternoon. The carbon dioxide concentrations in the upper atmosphere of the tidal flat was higher in the morning than in the afternoon, and the carbon dioxide concentration decreased as the altitude increased. The carbon dioxide concentration in the upper atmosphere of the reed beds was similar in the morning and afternoon at all altitudes, and the carbon dioxide concentration decreased as the altitude increased. The correlation coefficient between carbon dioxide concentration and air temperature observed in the tidal flat in the morning was -0.54 ~ -0.77, and the correlation coefficient between carbon dioxide concentration and air temperature observed in the afternoon was 0.56 ~ 0.80. The correlation coefficient between carbon dioxide concentration and temperature observed in the morning in the reed field was low, below 0.3, and the correlation coefficient between carbon dioxide concentration and air temperature observed in the afternoon was 0.35 ~ 0.77. In the upper atmosphere of the tidal flats and reed beds, the linear function was suitable for the change of carbon dioxide concentration as a air temperature, and the coefficient of determination of the estimated linear function was higher in the afternoon than in the morning. Through this study, it was confirmed that the carbon dioxide concentration in the upper atmosphere of the tidal flat and the reed beds was different, and the increase rate of carbon dioxide concentration in the upper atmosphere of the tidal flat and the reed beds was higher in the afternoon than in the morning.