• Resources Recycling
• /
• v.23 no.1
• /
• pp.25-32
• /
• 2014

The purpose of this research is to develop a process and a system to collect, purify and reuse the residual quantity of trimethylgallium, used as a raw material, upon GaN epitaxial growth for LED from a metal organic chemical vapor deposition(MOCVD) equipment. This research reviews whether TMGa collected from the process can be used through a chemical and structural characteristics evaluation. As a result of analyzing the purity using ICP-MS and ICP-AES, 7N high purity (99.99999%) of TMGa was obtained. According to checking the structural change of TMGa through NMR analysis, TMGa having pure $(CH_3)_3Ga$ structure was obtained without structural change. For reliability review of the collected TMGa, u-GaN was deposited using the MOCVD process and an structural, optical and electrical characteristics evaluation was conducted. As a result, it was found out that the reuse was possible.

• Proceedings of the KIEE Conference
• /
• 1989.11a
• /
• pp.79-82
• /
• 1989

We studied the epitaxial growth of GaAs/GaAs and GaAs/Si by Laser CVD with 193nm ArF pulsed excimer laser. The source gases of TMGa and AsC13 or TMGa-TMAs adducts are mixed with H2, and photolyzed above the substrate which is heated up to around 300$^{\circ}C$. Then the photolyzed atoms are deposited on the silicon or GaAs substrate. The deposited films are analyzed with ESKA depth profiling and X-ray differaction method, which shows that the films on Si and GaAs are stoichiometric and crystalized at such a low temperature. We show a clear evidence for the epitaxial growth of GaAs on Si or GaAs on GaAs at low temperature by excimer laser CVD.

• Journal of the Korean Vacuum Society
• /
• v.5 no.3
• /
• pp.206-212
• /
• 1996

$In_{1-x}Ga_xAs$ epitaxial layers were grown at 76 Torr by low pressure metalorganic chemical vapor deposition (LP-MOCVD). Growth rate did not change much with growth temperature. Surface morphology of $In_{1-x}Ga_xAs$ epitaxial layer was affected by lattice mismatch, growth temperature and $AsH_3/(TMIn+TMGa)$ ratio. A high quality epilayer showed a full width at half maximum of 2.8 meV by photoluminescence measurement at 5K. The composition of the $In_{1-x}Ga_xAs$ was determined by the relative gas phase diffusion of TMIn and TMGa. Lattice mismatch and growth temperature were the most important variables that determine the electrical properties of $In_{1-x}Ga_xAs$ epitaxial layers. At optimized growth condition, it was possible to obtain a high quality $In_{1-x}Ga_xAs$ epilayers with a electron concentration as low as $8{\times}10^{14}/cm^3$ and an electron mobility as high as 11,000$\textrm{cm}^2$/Vsec at room temperature.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.10 no.2
• /
• pp.116-121
• /
• 2000

The temperature profiles of gas phase and the concentration profiles of GaN precursors in an inverted OMVPE reactor have been carried out by in-situ Raman spectroscopy. Pure rotational Raman scattering from the carrier gas (rd) was used to determine the temperature profiles in the reactor, and a large temperature gradient perpendicular the susceptor surface was observed. The homogeneous gas phase decompositions of the OMVPE precursors were investigated by the vibrational Raman spectra, and it was found that the pyrolyses of $NH_3$ and TMGa begin above 800 K and 650 K, respectively, but a noticeable amount of precursors remain undecomposed even in the region very close to the susceptor.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.7
• /
• pp.564-569
• /
• 2002

Heteroepitaxial GaN films were grown on sapphire substrates in order to study the effects of the buffer layer's surface roughness and thermal treatment on the epitaxial layer's quality. For this, GaN buffer layers were grown at $550^{\circ}C$ with various TMGa flow rates and durations of growth, and annealed at $1010^{\circ}C$ for 3 min after the temperature was raised by 23 ~ $92^{\circ}C/min$, and then GaN epitaxial layers were grown at $1000^{\circ}C$. It has been found that the buffer layer's surface roughness and the thermal treatment condition are critical factors on the quality of the epitaxial layer. When a buffer layer was frown with a TMGa flow rate of $24\mu mole/min$ for 30 sec, the surface roughness of the buffer lather was minimum and when the thermal ramping rate was $30.6^{\circ}C/min$ on this layer, the successively grown epitaxial layer's crystalline and optical qualities were optimized with a specular morphology. The minimum full width at half maximum(FWHM) of GaN(0002) x-ray diffraction peak and that of near-band-edge(NBE) peak from a room temperature photoluminescence (PL) were 5 arcmin and 9 nm, respectively.

• Proceedings of the Korea Association of Crystal Growth Conference
• /
• 1997.10a
• /
• pp.141-144
• /
• 1997

High quality 3C-SiC epilayer was grown on Si(111) at 125$0^{\circ}C$ using chemical vapor deposition(CVD) technique by pyrolyzing tetramethylsilane(TMS). 3C-SiC epilayer was doped by tetramethylgallium(TMGa) during the CVD growth. The crystallinity of 3C-SiC was significantly enhanced by doping the gallium impurity.

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.13 no.5
• /
• pp.247-253
• /
• 2003

In this study, a numerical analysis of the deposition of gallium arsenide from TMGa and arsine in a horizontal MOCVD reactor is performed to investigate the effect of inlet diffuser shape of reactor on the flow and deposition characteristics. The effects of two geometric parameters (diffuser angle, diffuser shape) on the growth rate, growth rate uniformity, flow uniformity and pressure loss are presented. As a results, it is found that the optimum linear diffuser angle is in the range of $50^{\circ}$∼$55^{\circ}$ and parabolic diffuser in the range of $40^{\circ}$∼$45^{\circ}$ from the viewpoint of growth rate uniformity, flow uniformity and average growth rate. It is also found that variation of diffuser angle has greater impact on growth rate uniformity than average growth rate particularly in parabolic diffuser.

• Proceedings of the Korean Vacuum Society Conference
• /
• 1998.02a
• /
• pp.109-109
• /
• 1998

최근 들어 MOCVD 법으로 성장시킨 GaN, InGaN, AIGaN를 이용한 광소자 ( (LED, LD)와 전자소자(FET, MODFET)에 대한 관심이 고조되면서, MOCVD 법 을 이용한 GaN 중심의 질화물 반도체 성장에 관심이 집중되고 있다. 금번 실험에 사용된 MOCVD 장비는 수직형 MOCVD 장비이다. 특히, wafer c carner를 1$\alpha$)() rpm이상의 고속으로 회전시킬 수 있는 장치로서 원료 가스의 반웅 기 내에서의 흐름을 균일하게 하여 uniformity가 높은 질화물 반도체를 성장시킬 수 있다 .. GaN 에피충은 c-plane 사파이어를 기판으로 하여 11 00 "C 이상의 고온 에서 수소를 이용하여 기판을 cleaning하고, 500 "C 부근에서 핵생성충올 성장시 킨 후 1050 "C에서 trimethylgallium(TMGa)과 NI-h를 이용하여 성장시켰다. n n -GaN를 성장시키기 위해서는 SiH4을 사용하였으며, InGaN의 경우는 t trimethylindium(TMIn)을 In원 료 가스로 하여 635 - 725 "C 범 위 에 서 성 장시 켰 다. 성 장된 undoped GaN, n-GaN, InGaN는 X -ray di잔raction(XRD), H떠l m measurement, Photoluminescence(PU동올 이용하여 결정성과 전기적 및 광학적 특성올 고찰하였다 .. 2ttm 두께로 성장된 undoped G값V박막의 경우 Hall 측정결과 6 6 X lOI6/e며 정도의 낮은 도핑 농도를 보였으며, V!lII ratio(2500 - 5000)증가에 따라 결정성이 향상됨을 GaN (102)면의 X -ray e -rocking분석올 통하여 확인하 였다 .. n-GaN의 경우 SiH4양올 3 - 13 sccm으로 증가시킴에 따라 n -type 도명농 도가 선형적으로 증가하였고, 1017/c며 범위 내로 도평이 된 경우 상온에서 300 e마 N Ns 이상의 high mobility를 얻올 수 있었다 .. PL 관측 결과로부터 Si 도핑으로 인 하여 GaN bandedge emission이 강화됨을 알 수 있었다 .. InGaN 박막의 경우 성 장온도를 낮춤에 따라서 m의 양을 증가시킬 수 있었다. 또한 유량비(TMIn I T TMGa)가 1에 가까운 경 우에서도 온도를 635 "C 정도로 낮훈 경우 410 nm정도에 서 PL bandedge peak올 얻을 수 있었으며, 이 때의 반치폭은 50 meV정도의 낮 은 값을 보였다. 반치폭은 50 meV정도의 낮 은 값을 보였다.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2010.08a
• /
• pp.232-232
• /
• 2010

Recently light emitting diodes (LEDs) have been expected as the new generation light sources because of their advantages such as small size, long lifetime and energy-saving. GaN, as a wide band gap material, is widely used as a material of LEDs and GaN nanorods are the one of the most widely investigated nanostructure which has advantages for the light extraction of LEDs and increasing the active area by making the cylindrical core-shell structure. Lately GaN nanorods are fabricated by various techniques, such as selective area growth, vapor-liquid-solid (VLS) technique. But these techniques have some disadvantages. Selective area growth technique is too complicated and expensive to grow the rods. And in the case of VLS technique, GaN nanorods are not vertically aligned well and the metal catalyst may act as the impurity. So we just tried to grow the GaN nanorods on Si substrate without catalyst to get the vertically well aligned nanorods without impurity. First we deposited the AlN buffer layer on Si substrate which shows more vertical growth mode than sapphire substrate. After the buffer growth, we flew trimethylgallium (TMGa) as the III group source and ammonia as the V group source. And during the GaN growth, we kept the ammonia flow stable and periodically changed the flow rate of TMGa to change the growth mode of the nanorods. Finally, as the optimization, we changed the various growth conditions such as the growth temperature, the working pressure, V/III ratio and the doping level. And we are still in the process to reduce the diameter of the nanorods and to extend the length of the nanorods simultaneously. In this study, we focused on the shape changing of GaN nanorods with different growth conditions. So we confirmed the shape of the nanorods by scanning electron microscope (SEM) and carried out the Photoluminescence (PL) measurement and x-ray diffraction (XRD) to examine the crystal quality difference between samples. Detailed results will be discussed.

• Journal of the Korean Vacuum Society
• /
• v.2 no.1
• /
• pp.34-40
• /
• 1993

새로운 단결정 박막 성장방법으로 최근에 많은 관심을 끌고 있는 초고진공 화학기상증착법(Ultra-High Vacuum Chemical Vapor Deposition)을 이용하여 AlGaAs에 에피탁시 박막을 성장시켰다. AlGaAs 에피탁시층의 성장은 2。 경사진 GaAs(100) 기판을 사용하였다. 반응 기체로는 Trimethylgallium(TMGa), Trimethylaluminum(TMAl)과 arsine을 사용하였고, 성장온도는 $580~700^{\circ}C$, 기체 압력은 10-5~10-4Torr를 유지하였다. 특히 본 연구에서는 arsine을 사전에 열분해 하는 통상의 Chemical Beam Epitaxy(CBE) 성장법과는 달리, arsine이 표면에서 분해되는 화학 반응만을 사용하여도 AlGaAs 에피탁시를 성장할 수 있음은 물론 박막내의 탄소 불순물의 농도가 크게 낮아짐을 관찰하였다. 또한 성장 온도의 변화에 따른 AlGaAs 에피탁시층의 Al 함유 과정에 대하여도 고찰하였다.