• Journal of Korean Academy of Oral and Maxillofacial Radiology
• /
• v.17 no.1
• /
• pp.163-171
• /
• 1987

The author has clinically and radiologically investigated 57 cases of odontogenic keratocyst in 47 patients consisted of 26 males and 21 females aged from.2 to 63 years, who were pathologically diagnosed as odontogenic keratocyst at infirmaries of dental colleges, Yonsei University and Seoul national university during 1965-1986. The results were as follows: 1. The peak incidence of the disease was on their teenagers (29.8%). The ratio of Male/Female was 1.23:1 and incidence rate of males showed higher than their counterpart. 2. The most frequent complaints were swelling in (65.9%) followed by pus discharge, unknown mass, pain, residual root. 3. The most common site was mandibular third molar and mandibular ramus region (15.8%) followed by mandibular body and ramus, mandibular third molar, mandibular anterior teeth. Incidence of this disease in mandible was higher than in maxilla. 4. The lesions not associated with adjacent teeth were (14.0%) and in the lesions associated with adjacent teeth (35.1%) showed root resorption, (50.9%) were without root resorption, (35.1%) showed tooth migration and (50.9%) were without tooth migration. 5. The border types of the lesions were scalloped type in (52.6%), smooth type in (47.4%) and morphological type were unilocular in (50.9%), multilocular in (49.1%). 6. The radiologic cyst type of the lesions were follicular type (42.1%) followed by primordial, unclassified odontogenic, residual, lateral periodontal, median mandibular, globulomaxillary type.

• Textile Coloration and Finishing
• /
• v.20 no.2
• /
• pp.29-37
• /
• 2008

Polar amino groups of the waste SS(silk-sericin) were modified by two isocyanate compounds of MOI[2-(methacryloyloxy)ethyl isocyanate] and AOI [2-(acryloyloxy)ethyl isocyanate]. When the MOISS (MOI-modified silk sericin) or AOISS(AOI-modified silk sericin) was pressed hot, vinyl groups in the MOI or AOI were polymerized and then the flexible and transparent films were obtained. Tensile moduli and strengths of the MOISS films were significantly improved as the MOI contents increased. By the addition of the isocyanate compounds, silk sericin films exhibited lower solubility to the distilled water($80^{\circ}C$) and also lower swell ratio to the distilled water(room temperature). In the effect of tensile properties and restraining the water swelling, MOI was better than AOI. BOD(biochemical oxygen demand)/TOD(theoretical oxygen demand) of the pure sericin film was almost 100% perfect level after 10 days immersion into the activated sludge. With increasing isocyanate content reacted with polar amino groups, BOD/TOD decreased. When more than 50 mol% of polar amino groups remained unreacted, sericin films could retain more biodegradability. Comparing with MOI from the viewpoint of biodegradability, AOI was more effective.

• Food Science and Biotechnology
• /
• v.16 no.3
• /
• pp.381-385
• /
• 2007

The objective of this experiment was to study the influence of feed moisture content on the degree of enzymatic hydrolysis of com starch in a twin screw extruder and the saccharification yield of the dried extrudate. The feed moisture content was set at 25, 30, and 35% and ${\alpha}$-amylase solution was directly injected into the feed section at a barrel temperature of $95^{\circ}C$ and screw speed of 250 rpm. Amyloglucosidase was used for the saccharification of the dried extrudate at a concentration of 0.055%(w/w). Expansion ratio and swelling factor of extrudates decreased with increasing the feed moisture content. Addition of ${\alpha}$-amylase during extrusion process raised reducing sugar content of extrudates which also increased with the feed moisture content. The saccharification yield of dried extrudate was higher for the extrudate with lower feed moisture content.

• Polymer(Korea)
• /
• v.30 no.4
• /
• pp.286-292
• /
• 2006

Super water-absorbent resins were prepared by inverse suspension copolymerization of sodium acrylate, acrylamide and 2-hydroxyethyl acrylate using N, N'-methylene-bis-acrylamide as cross-linker. For the suspension copolymerization, monohexadecyl phosphate was employed as the dispersing agent, cyclohexane as the dispersing medium and potassium persulfate as the initiator. The dependence of water-absorption capacity on the amount of crosslinking agent, oil/water ratio, degree of neutralization and the composition of the copolymer were systematically investigated. Furthermore, the swelling kinetics of the super water-absorbent copolymer was carried out. The absorption of the resins is more than 1800 g/g for deionized water and 100 g/g for 0.9% NaCl solution, respectively. The copolymers showed an increased salt resistance and enhanced water retention of soil.

• Polymer(Korea)
• /
• v.25 no.5
• /
• pp.728-735
• /
• 2001

In this study, hydrogels from mixtures of chitosan/poly(vinyl alcohol) (PVA) and chitosan/poly(N-vinylpyrrolidone) (PVP) were prepared by ${\gamma}$-ray irradiation, and the mechanical properties such as gelation, water absorptivity and gel strength were examined to evaluate the applicability of these for wound dressing. The PVA : chitosan and PVP : chitosan ratio were in the range of 97:3 ~ 90:10, and the solid concentration of PVA/chitosan and PVP/chitosan solution were 15 wt%. Gamma irradiation with doses of 25, 35, 50, 60 and 70 kGy, was exposed to mixtures of PVA/chitosan and PVP/chitosan to evaluate the effect of irradiation dose. Gel content and gel strength increased as chitosan concentrations in PVA/chitosan and PVP/chitosan decreased, and as irradiation dose increased. Swelling degree increased as chitosan concentrations in PVP/chitosan and PVA/chitosan increased, and as irradiation dose decreased.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.09a
• /
• pp.1156-1167
• /
• 2010

The constant rate of strain (CRS) consolidation test has been widely used to evaluate consolidation characteristics of soils instead of the standard Incremental Loading Test. In practical problems, after the ground improvement, the condition of the soil is over-consolidated. Therefore, it is important to determine the recompression indices and the coefficient of consolidation(or the coefficient of swelling) of unloading-reloading cycle to predict the settlement behavior. However, since standard testing procedures or studies related with strain rate are insufficient especially in unloading-reloading cycle, it is difficult to predict the settlement field behavior accurately from the CRS consolidation test results in spite of its lots of strengths. The several CRS consolidation tests were performed changing the unloading strain rate from 0.2%/hr to 20%/hr with vertical drainage condition using the reconstituted kaolinite sample. For the reconstituted kaolinite sample in CRS consolidation test, the recompression indices are insensitive to the strain rate. It is revealed that the coefficient of consolidation of reloading is affected by the developed pore pressure during unloading. Additionally, the test should be conducted in the positive pore pressure ratio range (3~15%) to obtain the reasonable coefficient of consolidation in the whole range(loading, unloading and reloading).

• Journal of Chest Surgery
• /
• v.18 no.1
• /
• pp.69-74
• /
• 1985

Most clinicians have taken a lot of interest in tumors arising from the bony thorax because not only of their rarity and predictable diagnosis which could be reflected as a unique radiologic shadow but also variable surgical modes for maintenance of chest wall stability encountered after en-bloc resection. By the retrospective review, we have analyzed 24 cases of primary bony thorax tumors which were experienced and surgically treated at the St. Mary`s hospital of Catholic Medical College from Jan. 1969 to Sept. 1984. The results are as follows: 1. Age incidence was evenly distributed through all decades and the male-female ratio is 15:9. 2. 16 cases out of 24 were benign tumors and the commonest one of which was fibrous dysplasia. 3. Remaining 8 cases were malignant tumors and among which osteogenic sarcoma was the commonest one. 4. The majority of tumors [22/24] were developed from the rib and the remains were from the sternum. 5. Common manifestation were palpable mass or swelling and localized tenderness. 6. Various kinds of operative procedure were underwent: single resection of rib including tumor,14 cases; multiple resection of ribs with chemotherapy or myoplasty, 2 cases; en-bloc resection of the chest wall and reconstructive procedure, 5 cases; partial resection of sternum, 1 case; bone biopsy and chemotherapy, 2 cases.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2004.05a
• /
• pp.132-135
• /
• 2004

High-performance concrete (HPC) may be expected to differ from usual concrete with respect to shrinkage behavior, and it shows high autogenous shrinkage due to the use of very low water-binder ratio (w/b) and various admixtures. Therefore, in order to minimize the shrinkage stress and to ensure the service life of concrete structure, volumetric change of HPC should be understood. In this study, small prisms made of HPC with w/b of 0.32 and blast-furnace slag content of $0\%,\;30\%,\;and\;50\%$ were prepared to measure the volumetric changes such as autogenous shrinkage, drying shrinkage, and swelling under three different curing conditions. It was observed that the concrete cured. sealed condition showed only autogenous shrinkage while the concrete let to dry condition at temperature of $20^{\circ}C$ and relative humidity of $60\%$ during the test period showed both autogenous and drying shrinkage. Moreover, the concrete exposed to dry condition after 2-day water curing swelled and then started to shrink with age. The total shrinkage (autogenous+drying) of this concrete was smaller than that of the concrete cured dry condition, especially at early-age. Therefore, the early-age moisture curing is very effective to control or minimize the volumetric change and its induced stress of HPC.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.25 no.8
• /
• pp.657-663
• /
• 2012

The spherical mesoporous silica is synthesized and incorporated with CdSe/ZnS quantum dots(QDs) for preparing micro beads to detect toxic and bio-materials with high sensitivity. The spherical silica beads with the brunauer-emmett-telle(BET) average pore size of 15 nm were prepared with a ratio 1, 3, 5-trimethylbenzen, as a swelling agent, to the block-copolymer template surfactant of over 1 and under vigorous mixing condition. The surface of spherical mesoporous silica is modified using octadecylsilane for incorporating QDs. Based on photoluminescence(PL) spectra, the relative brightness of mesoporous silica beads incorporated with 10 nM of QDs is 79,000 times brighter than that of Rodamine 6 G.

• International Journal of Industrial Entomology and Biomaterials
• /
• v.6 no.2
• /
• pp.151-155
• /
• 2003

Using gel filtration chromatography, high molecular silk fibroin with high purity was obtained and silk flbroin microsphere particles (SFMP) could be simply made by spray dryer method. Also, some of the physicochemical properties of SFMP and morphology were investigated. The average molecular weight of pure silk fibroin protein dissolved in calcium chloride is about 61,500g/㏖ as measured by gel permeation chromatography. SFMP was spherical in shape, and particles, sized average of 2 ${\pm}$ 10 ${\mu}$, were observed by SEM and particle analyzer, respectively. Obtaining microspheres particles by spray dryer method accelerated the transition from the random coil to the $\beta$-sheet structure during spray dryer treatment. It was identified by the basic fourier transform infrared spectroscopy of SFMP. The swelling ratio of SFMP is majorly dependent on the pH of the solution, not on the occurred gelation. The characteristic structure, which might be applicable to immobilization of drugs is superior to other matrix materials for the use of biomaterials with skin affinity.