• Applied Chemistry for Engineering
• /
• v.20 no.5
• /
• pp.522-526
• /
• 2009

The catalytic oxidation of 1,2-dichloribenzene (1,2-DCB) and simultaneous catalytic reduction of nitrogen oxides over the single catalyst has been investigated over various metals (Ru, Mn, Co and Fe) supported on $Al_2O_3$ and $CeO_{2}$. The activity of the different catalysts for catalytic oxidation of 1,2-dichloribenzene depended on the used metal, Ru/Co/$Al_2O_3$, Mn-Fe/CeO2 and Cr/$Al_2O_3$ (commercial catalysts) being the most actives ones. In the catalytic oxidation of chlorobenzene (CB), Ru/Co/$Al_2O_3$ is better than Pt-Pd/$Al_2O_3$, which is the well-known catalyst good for VOC oxidation. Furthermore, it has a good durability on the deactivation by $Cl_2$ and sulfur. For nitrogen oxides (NOx) removal, NOx conversion was 70% at $260^{\circ}C$.

• Applied Chemistry for Engineering
• /
• v.5 no.2
• /
• pp.295-304
• /
• 1994

$Mo-V-O/SnO_2$(VM/Sn) and $SnO_2/Mo-V-O$(Sn/VM) catalysts have been prepared and characterized by XRD, BET, SEM and TPD of ammonia. The catalytic reaction of acrolein oxidation with these catalysts, in a continuous-flow fixed-bed reactor, showed that they had higher conversion of acrolein and higher yield of acrylic acid than those of Mo-V-O itself. The origin of the observed synergy studied by TPD, TPR and TPO is explained by the cooperation of $SnO_2$ and Mo-V-O at their interfaces where electrons flow from Mo-V-O phase to $SnO_2$ and $SnO_2$ produces spill-over oxygens, which, by being transported onto the surface of Mo-V-O, reoxidize the partially reduced active sites.

• Applied Chemistry for Engineering
• /
• v.18 no.6
• /
• pp.552-556
• /
• 2007

In this study, noble metals (Pd, Ru, Ir) were supported to $TiO_2$ catalyst. In order to distribute metals uniformly, $H_2O-H_2$ pretreatment technique was used. Xylene, toluene, and MEK were used as reactants. The monometallic or bimetallic catalysts were prepared by the excess wetness impregnation method and were characterized by XRD, and XPS analysis. Pd-Ru, Pd-Ir bimetallic catalysts had multipoint active sites which improved the range of Pd metal state. Bimetallic catalysts had a higher conversion of VOCs than that of monometallic one. The effect of $H_2O-H_2$ pretreatment technique was the enhancement of uniform distribution of Pd particles and promotion of catalytic efficiency. In this study, addition of Ru and Ir metals to Pd promoted oxidation conversion of VOCs. In addition, $H_2O-H_2$ pretreatment promoted removal efficiency of VOCs on the $TiO_2$ support.

• Applied Chemistry for Engineering
• /
• v.7 no.3
• /
• pp.410-415
• /
• 1996

It is well known that the heavy water separation process using hydrogen isotope exchange reaction over the platinum catalyst is the most efficient. In this study, the Pt/silicalite catalysts were prepared and characterized by hydrogen adsorption in order to develop the hydrophobic platinum catalyst for hydrogen isotope exchange reaction. Silicalite was synthesized as support material and it was verified that silicalite is more hydrophobic than activated carbon and ZSM-5. Also the platinum was loaded on silicalite by conventional impregnation and ion-exchange method respectively. The platinum dispersion of Pt/silicalite catalysts was measured through hydrogen adsorption experiment. The dispersion is very low in the catalyst prepared by the impregnation method while it is very high with limited platinum content in the catalyst prepared by the ion-exchange method.

• Mass Spectrometry Letters
• /
• v.11 no.2
• /
• pp.36-40
• /
• 2020

Untargeted metabolomics is a useful tool for drug development focusing on novel chemotherapeutic and chemopreventative agents against cancer cells. In recent years, quadrupole time of flight liquid chromatography-mass spectrometry (Q-TOF LC/MS)-based untargeted metabolomic approaches have gained importance to evaluate the effect of these agents at the molecular level. The researchers working on cell culture studies still do not apply standardized methodologies on sample preparation for untargeted metabolomics approaches. In this study, the rough and wet lysis techniques performed on MCF-7 breast cancer cells were compared with each other via the Q-TOF LC/MS-based metabolomic approach. The C18 and hydrophilic interaction liquid chromatography (HILIC) columns were used for the separation of the metabolites in MCF-7 cell lysates. 505 peaks were detected through the HILIC column and 551 peaks were found through the C18 column for the wet lysis technique. This situation supported by the base peak chromatograms showed that the wet lysis technique allowed us to extract higher number of non-polar metabolites. Almost equal number of metabolites was found for the C18 and HILIC columns (697 peaks for the HILIC column and 695 peaks for the C18 column) when the rough lysis technique was used. However, the intensities of polar metabolites were higher for the rough lysis technique on base peak chromatograms for both the HILIC and C18 columns. Although cell lysis technique, which is the first step in the sample preparation for cell culture studies, does not cause dramatic differences in the number of the detected metabolite peaks, it affects the polar and non-polar metabolite ratio significantly. Therefore, it must be considered carefully especially for in vitro drug development studies.

• Bulletin of the Korean Chemical Society
• /
• v.34 no.4
• /
• pp.1181-1187
• /
• 2013

Water-dispersible ZnS:Mn nanocrystals were synthesized by capping the surface of the nanocrystal with O-(2-Aminoethyl)polyethylene glycol (PEG-$NH_2$, Mw = 10,000 g/mol) and O-(2-Carboxyethyl)polyethylene glycol (PEG-COOH, Mw = 10,000 g/mol) molecules. The modified PEG capped ZnS:Mn nanocrystal powders were thoroughly characterized by XRD, HR-TEM, EDXS, ICP-AES and FT-IR spectroscopy. The optical properties were also measured by UV/Vis and photoluminescence (PL) spectroscopies. The PL spectra showed broad emission peaks at 600 nm with similar PL efficiencies of 7.68% (ZnS:Mn-PEG-NH2) and 9.18% (ZnS:Mn-PEG-COOH) respectively. The measured average particle sizes for the modified PEG capped ZnS:Mn nanocrystals by HR-TEM images were 5.6 nm (ZnS:Mn-PEG-NH2) and 6.4 nm (ZnS:Mn-PEG-COOH), which were also supported by Debye-Scherrer calculations. In addition, biological toxicity effects of the nanocrystals over the growth of wild type E. coli were investigated. They showed no biological toxicity to E. coli until very high concentration dosage of 1 mg/mL of the both nanocrystal samples.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.4
• /
• pp.1128-1132
• /
• 2014

A kinetic study on aminolysis of 4-chloro-2-nitrophenyl X-substituted-benzoates (6a-i) in MeCN is reported. The Hammett plot for the reactions of 6a-i with piperidine consists of two intersecting straight lines, while the Yukawa-Tsuno plot exhibits an excellent linear correlation with ${\rho}_X$ = 1.03 and r = 0.78. The nonlinear Hammett plot is not due to a change in rate-determining step (RDS) but is caused by the resonance stabilization of substrates possessing an electron-donating group in the benzoyl moiety. The Br${\phi}$nsted-type plot for the reactions of 4-chloro-2-nitrophenyl benzoate (6e) with a series of cyclic secondary amines is linear with ${\beta}_{nuc}$ = 0.69, an upper limit for reactions reported to proceed through a concerted mechanism. The aminolysis of 6e in aqueous medium has previously been reported to proceed through a stepwise mechanism with a change in RDS on the basis of a curved Br${\phi}$nsted-type plot. It has been concluded that instability of the zwitterionic tetrahedral intermediate ($T^{\pm}$) in MeCN forces the reaction to proceed through a concerted mechanism. This is further supported by the kinetic result that the amines used in this study are less reactive in MeCN than in $H_2O$, although they are more basic in MeCN over 7 $pK_a$ units.

• Journal of Microbiology and Biotechnology
• /
• v.17 no.5
• /
• pp.705-711
• /
• 2007

Two novel strains of the Cytophaga-Flexibacter-Bacteroides(CFB) group, designated Gsoil $219^T$ and Gsoil $238^T$, were isolated from soil of a ginseng field of Pocheon Province in Korea. Both strains were Gram-negative, aerobic, nonmotile, nonspore-forming, and rod-shaped. Phylogenetic analysis based on 16S rRNA gene sequences indicated that both isolates belong to the genus Chitinophaga but were clearly separated from established species of this genus. The sequence similarities between strain Gsoil $219^T$ and type strains of the established species and between strain Gsoil $238^T$ and type strains of the established species ranged from 91.4 to 94.7% and 91.6 to 94.2%, respectively. Phenotypic and chemotaxonomic data(major menaquinone, MK-7; major fatty acids, $iso-C_{15:0}\;and\;C_{16:1}\omega5c$; major hydroxy fatty acid, $iso-C_{17:0}3-OH$; major polyamine, homospermidine) supported the affiliation of both strains Gsoil $219^T$ and Gsoil $238^T$ to the genus Chitinophaga. Furthermore, the results of physiological and biochemical tests allowed genotypic and phenotypic differentiation of both strains from the other validated Chitinophaga species. Therefore, the two isolates represent two novel species, for which the name Chitinophaga soli sp. nov.(type strain, Gsoil $219^T=KCTC\;12650^T=DSM\;18093^T$) and Chitinophaga terrae sp. nov.(type strain, Gsoil $238^T=KCTC\;12651^T=DSM\;18078^T$) are proposed.

• Elastomers and Composites
• /
• v.41 no.1
• /
• pp.49-56
• /
• 2006

The waste tire powder is modified with allylamine in the presence of ultraviolet radiation and the influence of surface modification on the thermal and rheological properties of polypropylene/waste tire powder composites was investigated. X-ray diffraction studies of PP/waste tire powder composite without compatibilizer, such as maleic anhydride-g-polypropylene (MA-PP), shows the increase in peak intensity of ${\beta}$ crystalline peaks, whereas it completely disappears in the presence of the MA-PP. Differential scanning calorimetry results further supported the above fact. The melt viscosities and storage modulus of the composites with modified waste tire powder show higher value than that of composites with unmodified powder and it is attributed to the interaction between amine group on modified powder surface and maleic anhydride of MA-PP.

• Applied Chemistry for Engineering
• /
• v.22 no.3
• /
• pp.323-327
• /
• 2011

A zeolite sheet (ceramic paper containing zeolite) made in a cylindrical configuration can be applied to a honeycomb rotor for the effective VOC removal. In this study, the zeolite sheet containing ZSM-5 was used as a support for Pt-loading, and its catalytic activity for the toluene combustion reaction was compared with those of the other Pt catalysts loaded on ${\gamma}-Al_2O_3$ and cordierite honeycomb. Pt/zeolite sheet catalyst showed a higher activity for toluene combustion reaction than that of $Pt/{\gamma}-Al_2O_3$ or Pt/cordierite honeycomb. On the other hand, the dispersion of Pt particles loaded on the zeolite sheet was improved by the pretreatment with $NH_3-H_2O$ vapor at room temperature. Consequently, the pretreatment of Pt/zeolite sheet by $NH_3-H_2O$ vapor significantly enhanced the catalytic activation for toluene combustion reaction.