• 한국초전도ㆍ저온공학회논문지
• /
• 제1권2호
• /
• pp.37-42
• /
• 1999

The stability of high-temperature superconducting current leads for cryogenic devices are investigated. By assuming full transition from superconducting state to normal state at a transition temperature, the HTS current at a transition temperature, the HTS current lead shows bifurcation phenomenon. There is a bifurcation shape-factor, HTS leads have three steady state. Below the bifurcation shape-factor, the superconducting current lead is unconditionally stable, because there exists only one steady-factor HTS current lead is conditionally stable depending on the shape and intensity of disturbance.

• 분석과학
• /
• 제5권2호
• /
• pp.223-228
• /
• 1992

초산염(acetate)을 출발원료로 하여 $Bi_2Sr_2Ca_2Cu_3Oy$계 단일상 고온초전도체를 합성하려 하였으며 그 초전도상의 형성과정을 초전도전이온도 $T_c$ 및 전하나르게 농도와의 상관관계로부터 설명하고자 하였다. 초전도전이온도 $T_c$는 전기저항밀도 및 자화율을 측정하여 결정하였다. 시료로는 상기의 초전도체 출발조성물의 하소분말에 대해 $850^{\circ}C$, $860^{\circ}C$, 그리고 $870^{\circ}C$에서 40시간 동안 공기 중 열처리한 것을 이용하였다. 전하나르게농도는 홀계수를 측정하여 구하였다. 열처리과정 중의 초전도체 형성과정을 세라믹벌크내에 형성된 초전도체의 양 및 전하나르게농도 분포의 상관관계로부터 설명하였다.

• 한국초전도ㆍ저온공학회논문지
• /
• 제20권2호
• /
• pp.24-28
• /
• 2018

To understand the effects of Cd substitution for Cu, $(Pb_{0.5}Cu_{0.5-x}Cd_x)Sr_2(Ca_{0.7}Y_{0.3})Cu_2O_z$ (x = 0 ~ 0.5) compounds were synthesized and the structural and superconducting properties of the compounds were characterized. Resistivity data revealed that superconducting transition temperature rises initially up to x = 0.25 and then decreases as the Cd doping content increases. Room-temperature thermoelectric power decreases at first up to x = 0.25 and then increases with higher Cd doping content, indicating that the change in $T_c$ is mainly caused by the change in the hole concentration on the superconducting planes by the Cd doping. The non-monotonic dependence of the lattice parameters and the transition temperature with Cd doping content is discussed in connection with the possible formation of $Pb^{+2}$ ions and the removal of excess oxygen caused by Cd substitution in the charge reservoir layer. A correlation between transition temperature and c/a lattice parameter ratio was observed for the $(Pb_{0.5}Cu_{0.5-x}Cd_x)Sr_2(Ca_{0.7}Y_{0.3})Cu_2O_z$ system.

• 한국초전도ㆍ저온공학회논문지
• /
• 제16권1호
• /
• pp.23-26
• /
• 2014

This paper represents the detection method of voltage disturbance for high temperature superconducting (HTS) tape using electromagnetically coupled coils. In order to detect the voltage as the superconductor transits from the superconducting state to the normal conduction state, voltage taps are widely used to get the voltage signal. And voltage taps are connected to data acquisition device via signal wires. However this new suggested method can detect the superconducting transition voltage without signal wires between voltage taps and data acquisition device by using electromagnetically coupled coils. This system consists of two electromagnetically coupled coils, the first coil to detect and transmit the voltage of HTS tape and the second coil to pick up the transmitted voltage from the first coil. By using this new suggested method, we can build the 'separated voltage-detection system'. HTS tape and first coil are located under liquid nitrogen vessel and the second coil is located under room temperature condition. In this paper, experiments are performed to verify the feasibility of the proposed method. As the result of the experiment, the separated voltage-detection system using electromagnetically coupled coils can successfully observe superconducting-normal transition of HTS tapes.

• 한국전기전자재료학회논문지
• /
• 제21권10호
• /
• pp.943-949
• /
• 2008

We report on the development of transition edge sensors for x-ray detection. The sensor technology was based on the fabrication of a superconducting film on a thin membrane. A bilayer of a superconductor, Ti, and a noble metal, Au, was e-beam evaporated on a micromachined SiNx. Another Au layer was evaporated on the two side edges of the bilayer in order not to be affected by structural imperfections at the boundaries. With the method described in the present report, the superconducting transition temperature of the device was consistently achieved to near 80 mK with a sharp transition. The energy spectrum ueasured with the device provided 37 eV FWHM for 5.9 x-rays. We also discuss the design and fabrication considerations as well as the performance of the device in detail.

• 한국재료학회지
• /
• 제21권2호
• /
• pp.73-77
• /
• 2011

Specific heat of a crystal is the sum of electronic specific heat, which is the specific heat of conduction electrons, and lattice specific heat, which is the specific heat of the lattice. Since properties such as crystal structure and Debye temperature do not change even in the superconducting state, the lattice specific heat may remain unchanged between the normal and the superconducting state. The difference of specific heat between the normal and superconducting state may be caused only by the electronic specific heat difference between the normal and superconducting states. Critical temperature, at which transition occurs, becomes lower than $T_{c0}$ under the influence of a magnetic field. It is well known that specific heat also changes abruptly at this critical temperature, but magnetic field dependence of jump of specific heat has not yet been developed theoretically. In this paper, specific heat jump of superconducting crystals at low temperature is derived as an explicit function of applied magnetic field H by using the thermodynamic relations of A. C. Rose-Innes and E. H. Rhoderick. The derived specific heat jump is compared with experimental data for superconducting crystals of $MgCNi_3$, $LiTi_2O_4$ and $Nd_{0.5}Ca_{0.5}MnO_3$. Our specific heat jump function well explains the jump up or down phenomena of superconducting crystals.

• 한국초전도학회:학술대회논문집
• /
• 한국초전도학회 1999년도 High Temperature Superconductivity Vol.IX
• /
• pp.210-213
• /
• 1999

Magnetoresistance and magnetization of Sr$_{l-x}K_xBiO_3$ were both measured as functions of temperature and magnetic field. Resistivity goes to zero at T=10.1K and the overall superconducting transition behavior under applied magnetic fields is similar to that of other BiO based superconductors. Also, below T<5K we have observed the reappearance of finite resistivity with a power law temperature dependence( ${\rho}$ ${\sim}$T$^1$); the reentrant superconducting transition of resistivity. Contrary to the Josephson weak link effect in polycrystalline samples, which gives the depression of the superconducting state with increasing electrical current or magnetic field, the superconducting state for T<5K is resumed by applying a higher current or magnetic field. Magnetic susceptibility( ${\chi}$ ) of Sr$_{l-x}K_xBiO_3$ for T<5K also shows similar trends to that observed in transport measurements: increase of ${\chi}$ (paramagnetic-like behavior) at a low magnetic fields(B=50 Oe) and, the resumption of perfect diamagnetism at high fields.

• Progress in Superconductivity
• /
• 제9권2호
• /
• pp.162-166
• /
• 2008

We are developing a sensitive gamma ray spectrometer based on superconducting transition edge sensors. The detector consists of a small piece of high purity Sn as an absorber and a Ti/Au bilayer as a temperature sensor. It is designed to measure the thermal signal caused by absorption of gamma rays. The mechanical support and the thermal contact between the absorber and the thermometer were made with Stycast epoxy. The bilayer was formed by e-beam evaporation and patterned by wet etching on top of a $SiN_X$ membrane. A sharp superconducting transition of the film was measured near 100 mK. When the film was biased to the edge of the transition, signals were observed due to single photon absorption emitted from an $^{241}Am$ source. The measured spectrum showed several characteristic peaks of the source including 59.5 keV gamma line. The full with at half maximum was about 900 eV for the 59.5 keV gamma line. The background was low enough to resolve low energy lines. Considerations to improve the energy resolution of the gamma ray spectrometer are also discussed.

• Progress in Superconductivity
• /
• 제14권1호
• /
• pp.34-38
• /
• 2012

The effect of graphene inclusion in the ex-situ $MgB_2$ was analyzed with the help of resistivity behavior and critical current density studies. Amount of graphene was systematically varied from 0% for pristine sample to 3% by the weight of $MgB_2$. Graphene that is considered as a good source of carbon was found to be intact without any significant carbon doping in $MgB_2$ structure as reveled by XRD measurements. There was no signature of graphene inclusion as far as the superconducting transition is concerned which remained same at 39 K for all the samples. The transition width being sensitive to defect doping remained more or less about 2 K for all the samples showing no variation due to doping. Although there was no change in the superconducting transition or transition width, the graphene doped sample showed noticeable decrease in the overall resistivity behavior with respect to decrease in temperature. The graphene inclusion acted as effective pinning centers which have enhanced the upper critical field of these samples.

• Bulletin of the Korean Chemical Society
• /
• 제32권2호
• /
• pp.451-454
• /
• 2011

The traditional BCS superconductors $AOs_2O_6$ (A=K, Rb, and Cs) were investigated to find the relationship between their structures and superconducting transition temperatures. The $T_c$ decreases with increasing the unit cell parameter of $AOs_2O_6$. This is in contrast to the case of conventional BCS superconductivity in a single bond model, where $T_c$ may increase with increasing the the unit cell parameter since the DOS at Fermi level increases as the unit cell parameter increases. Instead, the $T_c$ of a $\beta$-pyrochlore oxide is proportional to the lattice softness of the compound.