• Electrical & Electronic Materials
• /
• v.9 no.4
• /
• pp.357-363
• /
• 1996

The superconducting properties of YBa$_{2}$Cu$_{3}$$O_{7-x}$(YBaCuO) thin films prepared by laser ablation have been investigated. The x-ray diffraction patterns of the films were substantially different from one another. The Y and Ba oxides are formed by the collisions with oxygen molecules. On the other hand, the Cu oxide is mainly formed at initial stage of the laser irradiation. The YBaCuO films manufactured on MgO(100) substrate were indicated T$_{c}$(zero)=90 K, T$_{c}$(onset)=92 K, and J$_{c}$=3.5*10$^{5}$ A/cm$^{2}$(at 77.3K). The optimum conditions were found to be a substrate temperature of 710.deg. C, an energy density of 2 J/cm$^{2}$, and a target-substrate distance of 60mm in an oxygen partial pressure of 200 mTorr.0 mTorr.

• Journal of the Semiconductor & Display Technology
• /
• v.10 no.2
• /
• pp.45-48
• /
• 2011

In this paper, vacancy clustering formation and diffusion of germanium substrate was studied. The analysis method was adopted Monte Carlo method. At temperatures higher than melting point, fewer clusters formed, but there was less variation in the number of clusters than at lower temperatures, as the time increased. Equilibrium diffusivities in the clustering region were $10^2$ lower than those of free vacancies in the initial stage of kinetic lattice Monte Carlo simulations. They were expressed according to three temperature regimes: at temperatures above 1,100 K, at temperatures of 1,100-900 K, and at temperatures below 900 K. The effective mean migration energy, 1.1 eV, closely coincided with that of the 1.0-1.2 eV in experiments.

• Journal of the Korean institute of surface engineering
• /
• v.32 no.3
• /
• pp.303-306
• /
• 1999

On the effect of substrate bias at first stage of diamond synthesis at lower substrate temperature(approximately 673K) using microwave plasma CVD and effect of reaction gas system for the bias enhanced nucleation were studied. The reaction gas was mixture of methane and hydrogen or carbon monoxide and hydrogen. The nucleation density of applied bias -150V using $CH_4-H_2$ reaction gas system, significantly higher than that of $C-H_2$ reaction gas system. When the $CH_4-H_2$ reaction was used, nucleation density was increased because of existence of SiC as a interface for diamond nucleation. By use of this negative bias effect for fabrication of CVD diamond film using two-step diamond growth without pre-treatment, fabrication of the diamond film consist of diamond grains $0.2\mu\textrm{m}$ in diameter was demonstrated

• Asian-Australasian Journal of Animal Sciences
• /
• v.28 no.6
• /
• pp.888-895
• /
• 2015

Polymerase chain reaction-restriction fragment length polymorphism (PCR-RFLP) and subsequent sub-cloning and sequencing were used in this study to analyze the molecular phylogenetic diversity and spatial distribution of bacterial communities in different spatial locations during the cooling stage of composted swine manure. Total microbial DNA was extracted, and bacterial near full-length 16S rRNA genes were subsequently amplified, cloned, RFLP-screened, and sequenced. A total of 420 positive clones were classified by RFLP and near-full-length 16S rDNA sequences. Approximately 48 operational taxonomic units (OTUs) were found among 139 positive clones from the superstratum sample; 26 among 149 were from the middle-level sample and 35 among 132 were from the substrate sample. Thermobifida fusca was common in the superstratum layer of the pile. Some Bacillus spp. were remarkable in the middle-level layer, and Clostridium sp. was dominant in the substrate layer. Among 109 OTUs, 99 displayed homology with those in the GenBank database. Ten OTUs were not closely related to any known species. The superstratum sample had the highest microbial diversity, and different and distinct bacterial communities were detected in the three different layers. This study demonstrated the spatial characteristics of the microbial community distribution in the cooling stage of swine manure compost.

• Transactions of Materials Processing
• /
• v.13 no.1
• /
• pp.39-44
• /
• 2004

Transcribability of pit or land groove structures in replicating an optical disk substrate greatly affects the performance of a high-density optical disk. However, a solidified layer, generated during the polymer filling, deteriorates transcribability because the solidified layer prevents the polymer melt from filling the sub-micro patterns. Therefore, the development of the solidified layer during filling stage of injection molding must be delayed. For this delay, passive heating by insulation layer has been used. In the present study, to examine the development of the solidified layer delayed by passive heating, the flow of polymer melt with passive heating was analyzed. Passive heating markedly delayed the development of the solidified layer, reduced the viscosity of the polymer melt, and increased the fluidity of the polymer melt in the vicinity of the stamper surface with the sub-micro patterns. As a result, we predict that passive heating can improve transcribability of an optical disk substrate. To verify our prediction, we fabricated an optical disk substrate by using passive heating of a mold and measured the transcribability of an optical disk substrate.

• Journal of Korean Society of Water and Wastewater
• /
• v.24 no.4
• /
• pp.369-376
• /
• 2010

The purpose of this study is to reprocess Waste-LCD(Liquid Crystal Display), to widely increase specific surface-area by foaming agent in the process of reprocessing and to use as a substrate of water treatment which is increased the ability of biological treatment, as well as to control non-point source pollutants produced by surface run off during rainfall with using this substrate, and to improve water quality of public watershed as developing substrate for water treatment to be able to purify second treated water which is exhausted at the wastewater treatment plant. The average removal efficiency of Waste-LCD that using the foaming technology was SS 71.2%, BOD 55.7%, COD 58.4%, T-N 29.5% and T-P was 50.3%. Almost Media, early stage showed low removal efficiency of SS and BOD. However, it became high when the microorganism adhered the Media. The variation of SS removal efficiency was high by inflow concentration of SS. The reason for the Media 4 showed high SS removal efficiency is that it has wide specific surface-area, and also it has a pore. All in all, it shows floating matter treatment ability not only inside but it also works outside of the substrate.

• Microbiology and Biotechnology Letters
• /
• v.24 no.5
• /
• pp.597-603
• /
• 1996

This study was carried out to examine degradation characteristics of microalgae Chlorella vulgaris in methane fermentation. We measured COD and VS reduction, gas and methane productivity, VFA (volatile fatty acid), respectively. Then we calculated material balance and hydrolysis rates in soluble and solid material. The substrate concentration was controlled from 14 gCOD$_{cr}$/l to 64 gCOD$_{cr}$/l in batch cultures, and HRT (hydraulic retention time) controlled from 2 days to 30 days in continuous experi- ments. The results were as follows. In batch culture, accumulated gas productivity increased with the increase of the substrate concentration. The SS and VSS was removed all about 30% increase of substrate concentration and the most of the degradable material removed during the first 10 days. The curve of gas and methane production rate straightly increased until substrate concentration is 26 gCOD$_{cr}$/l. In continuous culture experiments, the removal rates at HRT 10days were 20% for total COD and TOC, respectively. At longer HRT, there was no increase in the removal efficiency. At HRT 15 days, the removal rates were 30% for SS and VSS, respectively. Soluble organic materials were rapidly degraded, and so there was no accumulated. Soluble COD concentration was not increase regardless of HRT-increasing. That meaned the hydrolysis was one of the rate-limiting stage of methane fermentation. The first-order rate constants of hydrolysis were 0.23-0.28 day$^{-1}$ for VSS, and 0.07-0.08 day$^{-1}$ for COD.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• v.10 no.2
• /
• pp.522-541
• /
• 2016

Network virtualization provides an effective way to overcome the Internet ossification problem. As one of the main challenges in network virtualization, virtual network embedding refers to mapping multiple virtual networks onto a shared substrate network. However, existing heuristic embedding algorithms evaluate the embedding potential of the nodes simply by the product of different resource attributes, which would result in an unbalanced embedding. Furthermore, ignoring the hops of substrate paths that the virtual links would be mapped onto may restrict the ability of the substrate network to accept additional virtual network requests, and lead to low utilization rate of resource. In this paper, we introduce and extend five node attributes that quantify the embedding potential of the nodes from both the local and global views, and adopt the technique for order preference by similarity ideal solution (TOPSIS) to rank the nodes, aiming at balancing different node attributes to increase the utilization rate of resource. Moreover, we propose a novel two-stage virtual network embedding algorithm, which maps the virtual nodes onto the substrate nodes according to the node ranks, and adopts a shortest path-based algorithm to map the virtual links. Simulation results show that the new algorithm significantly increases the long-term average revenue, the long-term revenue to cost ratio and the acceptance ratio.

• Carbon letters
• /
• v.6 no.2
• /
• pp.101-105
• /
• 2005

Like bamboo-sprouts after rains, numerous sub${\mu}m$-sized pyrocarbon whiskers growth on the Mullite ($3Al_2O_3{\cdot}2H_2O$) substrate could be observed through a looking glass during methane pyrolysis at the temperature of $1050^{\circ}C$ in this study. If the surface of substrate would be scrubbed strongly with iron metals, then finely sticked iron particles were more effective catalytic for nm-sized whisker growth. Numerous fine flakes of pyrolytic carbon were hanging by invisible nm-whiskers as like as small spiders hanging by a spiderweb. This is the identification of nm-sized whisker growth. Therefore if the pyrolysis would be stopped at the initial stage of the whisker growth, the primary lengthening growth was nm-sized whisker. So could we vary arbitrarily sizes of whisker from nm- to ${\mu}m$-sizes. But ${\mu}m$- and nm-whiskers grown with the different growth mechanism; the former was straight and the latter has twigs, The lengthening growth of whisker was depended on the flow pattern pyrolysis species on the active sites of substrate and on the growth duration. We could obtained straight whisker length of 10~20 ${\mu}m$/min during the primary growth and laboratory spiral whisker of 30~40 ${\mu}m$-diameter/hr during the secondary growth.

• The Korean Journal of Zoology
• /
• v.39 no.2
• /
• pp.190-197
• /
• 1996

The optimal conditions and substrate specificity of whole body esterase (EST) activity, effects of inhibitors (Eserine, Paraoxon, p-HMB, DDVP, DFP) on the enzyme, and ontogenv of the isozymes were determined in Lucilio ilfustris Meisen. The optimal temperature was $45^{\circ}C$ regardless of kind of reacted substrate, $\alpha-naphthyl$ acetate $(\alpha-Nal,$ a.naphthvl butylate $(\alpha-N),$ and Pnaphthyl acetate $(\beta-Na),$ but the optimal pH showed some regioselectivitv to naphthvl group of the esters; PH 7.0 for Iform, pH 7.5 for a-form. The maximum reaction rate was recorded at about 2.5 $\times$ 10's M of PNa and etNa, but 1.0 $\times$ 10'S M of $\alpha-Nb.$ Among the five EST inhibitors tested, DDVP was the most powerful. However, distinction of the relative specificity of inhibitors between three body parts, head, thorax, and abdomen, was shouts, representing differences in the distribution and activity of isozvmes. Of 12 carboxyl-esterases (CE), 8 cholinesterases (ChE) and 2 arvlesterases (ArE) identified based on their inhibitor specificity throughout the development, two larval and prepupal stage specific ChEs, no pupal specific, and 2 CEs.2ChEs. and one ArE adult specific isozvmes were confirmed.