• Korean Journal of Food Science and Technology
• /
• v.49 no.5
• /
• pp.463-468
• /
• 2017

Waxy rice starch purified from Hwaseonchal white rice was modified by octenyl succinic anhydride (OSA) for use as an emulsifier. OSA-modified starches (1, 2, and 3% OSA, pH 8.5, 6 h) were investigated to understand their physicochemical and pasting properties, and emulsion stability. The degree of substitution (DS) of 1, 2, and 3% OSA starches was 0.0062, 0.0182, and 0.0214, respectively. FT-IR spectroscopy showed that OSA starches showed weak peaks at 1724 and $1572cm^{-1}$ and the peak at $3300cm^{-1}$ was reduced by an increase in the DS. Native and OSA starches showed A type crystallinity and a similar granular size. The OSA starch increased the peak viscosity, but decreased the onset and peak temperatures, and enthalpy with an increase in OSA concentration. The creaming index of emulsion of OSA starches decreased with an increase OSA concentration. It was suggested that the emulsion stabilizing capacity of OSA waxy rice starches increased with an increase in the OSA concentrations.

• Clean Technology
• /
• v.13 no.3
• /
• pp.201-207
• /
• 2007

Carboxymethylcellulose (CMC), which is water-soluble at room temperature, was synthesized from cellulose in this study. Experimental parameters included reaction temperature, time, concentration of NaOH, and monochloroacetic acid (MCA). In mercerization and etherification, solubility and degree of substitution (DS) increased when NaOH (or MCA) concentration increased and maximum solubility and DS were achieved when NaOH or MCA was 30%. The effect of MCA concentrations on the DS was larger than that of the NaOH concentration. Tensile strength of the CMC was decreased by the increases of reaction time, reagent concentration and reaction temperature. Tensile strength also decreased by NaOH and MCA. However, low decrease of tensile strength was observed in near neutral region.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.8 no.3
• /
• pp.317-324
• /
• 2020

Plastic wastes generated from domestic waste are separated by mixed discharge with foreign substances, and the cost of the separation and screening process increases, so recycling is relatively low. In this study, as a fundamental study for recycling mixed plastic wastes generated from domestic waste into concrete aggregates, changes in concrete properties according to the plastic waste types and the substitution rate were evaluated experimentally. The mixed plastic waste aggregate(MPWA) was found to have a lower density and a higher absorption rate compared to the coarse aggregate with good particle size distribution. On the other hand, the single plastic waste aggregate(SPWA) was composed of particles of uniform size, and both the density and the absorption rate were lower than that of the fin e aggregate. It was found that the MPWA substitution concrete did not cause a material separation phenomenon due to a relatively good particle size distribution even with the largest amount of plastic waste substitution, and the amount of air flow increased little. The compressive strength and flexural strength of the PWA substitution concrete decreased as the amount of substitution of the PWA increased due to the low strength of the PWA, the suppression of the cement hydration reaction due to hydrophobicity, and the low adhesion between the PWA and the cement paste. It was found that the degree of deterioration in compressive strength and flexural strength of concrete substituted with MPWA having good particle size distribution was relatively small.

• Korean Journal of Food Science and Technology
• /
• v.22 no.6
• /
• pp.659-667
• /
• 1990

Starch acetates were prepared by conventional method, preheat treatment, and extrusion process through acetylation of corn starch with acetic anhydride and their physicochemical properties were investigated. The optimal conditions of the acetylation of starch by conventional method(CSA) was found that starch concentration was 30%, reaction temperature $35^{\circ}C$ and pH 8.5. With increasing the molar ratio of acetic anhydride to anhydrous glucose unit from 0.03 to 0.20, DS(Degree of substitution) value of corn starch acetate prepared at the optimum condition was increased from 0.019 to 0.080, while the acetylation efficiency was decreased from 31.6% to 20.5%. In the case of the preheated (gelatinized), then acetylated starch(PSA), DS value was increased from 0.027 to 0.04 at the fixed molar ratio of the acetic anhydride with increasing preheating temperature from $60^{\circ}C\;to\;90^{\circ}C$. The DS was low as 0.02 in the case of starch acetate prepared by extrusion process(WESA). The CSA and PSA showed lowering gelatinization temperature and enthalpy than raw corn starch with increasing DS. All of starch acetates showed the increased degree of transparency, the decreased lightness and the increased yellowness as compared to the raw corn starch. WESA showed lower apparent viscosity and more close to the characteristic of the Newtonian fluid than CSA and PSA. Intrinsic viscosity was reduced in CSA and WESA, although PSA has a slightly higher one than raw corn starch. The rate of retrogradation of the gels was retarded in all starch acetates.

• Journal of the Korean Wood Science and Technology
• /
• v.24 no.2
• /
• pp.20-25
• /
• 1996

Wood chips of oak(Quercus mongolica) and larch(Larix leptolepis) were exploded with the optimum condition. Main components of exploded wood were separated with hot hot water and methanol. The hemicelluloses were purified from hot water extracts and alditol complexs were prepared from purified hemicellulose. And also, cellulose nitrate was prepared from extractive residue and characterized. The results can be summarized as follows. 1. Amounts of carbohydrate(72~79%) in the crude hemicellulose of larch wood was more than those of oak wood(55~66%). 2. The crude hemicelluloses were mainly composed of oligosaccharides in oak wood but those in larch wood contained about 50% monosaccharides. 3. Decolorization of hemicellulose was successful with activated charcoal and ion-exchange resin treatment. The alditol yields were 56.3~82.9%. 4. The degree of substitution(D.S.) of cellulose nitrate was 1.95~2.87 and it showed a good acetone solubility.

• Journal of the Korean Applied Science and Technology
• /
• v.10 no.2
• /
• pp.41-47
• /
• 1993

Chitin was isolated from crab shells by modified Hackman's method, which was treated again with aqueous sodium hydroxide solution to give alkali chitin(sodium alkoxide of chitin). And after, the alkali chitin is allowed to react with monochloroacetic acid to synthesize 6-O-(carboxymethyl) chitin [CM-Chitin] under diminished pressure. In order to synthesize high performance CM-Chitin as hygroscopic agent, it was measured that the yield and degree of subsititution of each CM-Chitin according to molar ratio(monochloroacetic acid equivalent mol/N-acetyl-D-glucosamine residue) and their moisture-absorption and moisture-release properties were measured and compared with those of hyaluronic acid. The moisture-absorption and moisture-release properties of CM-Chitin, especially 0.8 in degree of substitution, were found quite similar to those of hyaluronic acid. The preliminary results show that CM-Chitin might be used as hygroscopic agent instead of hyaluronic acid in field of cosmetics.

• KDI Journal of Economic Policy
• /
• v.30 no.2
• /
• pp.129-155
• /
• 2008

The rate of antibiotics prescription for an acute airway infection significantly varies depending upon the diagnosis type, specialty, and the location of the hospital along with many other related factors. The objective of this study is to empirically investigate the possible relationship between the antibiotics prescription rates for an acute airway infection and the degree of competition in the hospital market regions of mainly the providers of primary medical care services such as clinics, internal medicines, pediatrics and otorhinolaryngology department. Using the data from Health Insurance Review and Assessment Service (HIRA) regarding the hospitals' antibiotics prescription rates for the acute airway infection and controlling for selected variables of demand and supply sectors, this study tries to figure out that the degree of competition in the hospital market, regardless of what type of competition indexes we employed, has a statistically significant effect on the variations of antibiotics prescription rate of the clinics in local areas. This result implies that as an economic consideration itself, the change in the degree of competition in the hospital market can play a crucial role influencing the treatment behaviors of the medical doctors. More specifically, this study reveals that as the degree of competition increases the antibiotics prescription rate goes up. This result means that if the market becomes more competitive in a specific region so that it might cause a reduction in doctor's income, doctors with rational decision-making process, recognize that the benefit created from inducing patients' seemingly unnecessary demand for medical care (income effect) would be higher than the costs associated with sustaining their targeted income (substitution effect). It is because that the doctors are more likely to prescribe antibiotics which create relatively higher margins than other medical care services in order to sustain their targeted income when the hospital market competition becomes tighter. Even though this study empirically confirms that antibiotics prescription can be affected by the economic incentives, it still raises following issues as limitations of the study: first issue is about the representativeness of the hospital regions segregated for this study, which might be weak in explaining whether these regions are mutually exclusive in reality. Patients actually consider the quality of services, transportation cost, time costs, and any other related factors choosing the doctors or hospitals, and in that sense, this study rules out 'border-crossing' in using the medical care services. Second issue arises in capturing the data of antibiotics prescription rate. Since we use the average rate for each medical institution, we cannot figure out the average rate for each patient so that we are not able to control for the variation of patients' medical conditions. It is because of the unavailability of data regarding each patient's medical condition from HIRA. Thirdly, since this study mainly analyzes the medical institutions providing primary care such as clinics, internal medicines, pediatrics, and otorhinolaryngology department, it is skeptical of whether those institutions can represent the hospital market in respective regions and truly reflect the degree of competition. It needs to extend the study areas and disease types as well as any micro data for future studies.

• Food Science and Biotechnology
• /
• v.17 no.3
• /
• pp.683-686
• /
• 2008

$\beta$-Glucans, which were isolated from sangwhang (Phellinus linteus), were subjected to reductive amination and the biological properties of the derivative were investigated. The degree of substitution of the aminated sangwhang $\beta$-glucan was calculated by elemental analysis to be 1.13. Bronchoalveolar lavage (BAL) experiments showed that the aminated derivative increased nitric oxide production. In addition, the amination enhanced in vitro cytotoxic activities against HT1080 and SNU-C2A cell lines. Thus, the aminated derivative is shown to enhance immune systems by the incorporation of amino groups into the polymer structure.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2001.11a
• /
• pp.1219-1224
• /
• 2001

In this study, concrete what plenty of fly ash used as binder is left in three condition humid condition($35^{\circ}C$), normal condition($20^{\circ}C$) and cold condition($5^{\circ}C$). Fly ash concrete is tested in fresh properties and early strength. The result of tests could give the decisive factor of form side's stripping time. The purpose of this study is presenting the stripping time data to help the construction work. The result of this study is below. 1. The plain concrete specimen in humid condition developed high strength before 5 days, then strength development is declined. 10 day strength of plain specimen is smaller than the normal condition specimen's. 2. The strength of the concrete which plenty of fly ash used is more developed than the concrete in normal condition. It says that fly ash concrete is useful in the humid condition. 3. As fly ash substitution rate is downsizing and outdoor temperature degree is low, form stripping times is getting shorter.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2004.05a
• /
• pp.588-591
• /
• 2004

Generally, $TiO_2$ powders absorb ultraviolet rays and make oxidation/reduction reactions on its surface. Hydroxide radical(OH), a product of photocatalyst reactions, has so strong oxidation/reduction electric potential that it can oxidize noxious gas like VOCs(Volatile Organic Compounds) and NOx. In this study, $TiO_2$ was substituted for exposed concrete to investigate the purifying degree of VOCs(Benzene, Toluene) and NOx. Anatase types of $TiO_2$ were used as photocatalyst. The sun rays and the ultraviolet were used as a light source. Anatase type $TiO_2$ was better than rutile type in purifying performance. The sunray showed the best purifying performance among the light sources. $3\%$ substitution of $TiO_2$ with the sunray was enough to purify VOCs(Benzene, Toluene) and NOx efficiently.