• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.1 no.2
• /
• pp.169-181
• /
• 1997

Some association rules can have very high confidence in a sub-interval or a subrange of the domain, though not quite high confidence in the whole domain. In this paper, we define a ranged association rule, an association with high confidence worthy of special attention in a sub-domain, and further propose an efficient algorithm which finds out ranged association rules. The proposed algorithm is data-driven method in a sense that hypothetical subranges are built based on data distribution itself. In addition, to avoid redundant database scanning, we devise an effective in-memory data structure, that is collected through single database scanning. The simulation shows that the suggested algorithm has reliable performance at the acceptable time cost in actual application areas.

• Ocean Systems Engineering
• /
• v.10 no.3
• /
• pp.317-332
• /
• 2020

This study examines the behaviors and properties of discharged liquid CO₂ from a long elastic pipe moving with a vessel for the oceanic CO₂ sequestration by considering pipe dynamics and vessel motions. The coupled vessel-pipe dynamic analysis for a typical configuration is done in the frequency and time domain using the ORCAFLEX program. The system's characteristics, such as vessel RAOs and pipe-axial-velocity transfer function, are identified by applying a broadband white noise wave spectrum to the vessel-pipe dynamic system. The frequency shift of the vessel's RAO due to the encounter-frequency effect is also investigated through the system identification method. Additionally, the time histories of the tip-of-pipe velocities, along with the corresponding discharged droplet size and Weber numbers, are generated for two different sea states. The comparison between the stiff non-oscillating pipe with the flexible oscillating pipe shows the effect of the vessel and pipe dynamics to the discharged CO₂ droplet size and Weber number. The pipe's axial-mode resonance is the leading cause of the fluctuation of the discharged CO₂ properties. The significant variation of the discharged CO₂ properties observed in this study shows the importance of considering the vessel-pipe motions when designing oceanic CO₂ sequestration strategy, including suitable sequestration locations, discharge rate, towing speed, and sea states.

• Proceedings of the KSME Conference
• /
• 2002.08a
• /
• pp.55-58
• /
• 2002

Parallel finite element code has been recently developed for the analysis of the incompressible Wavier-Stokes equations using domain decomposition method. Metis and MPI libraries are used for the domain partitioning of an unstructured mesh and the data communication between sub-domains, respectively. For unsteady computation of the incompressible Navier-Stokes equations, 4-step splitting method is combined with P1P1 finite element formulation. Smagorinsky and dynamic model are implemented for the simulation of turbulent flows. For the validation performance-estimation of the developed parallel code, three-dimensional Laplace equation has been solved. It has been found that the speed-up of 40 has been obtained from the present parallel code fir the bench mark problem. Lastly, the turbulent flows around the MIRA model and Tiburon model have been solved using 32 processors on IBM SMP cluster and unstructured mesh. The computed drag coefficient agrees better with the existing experiment as the mesh resolution of the region increases, where the variation of pressure is severe.

• Journal of Korean Elementary Science Education
• /
• v.19 no.2
• /
• pp.29-41
• /
• 2000

The purpose of this study is to examine the effects of the Portfolio applied science instruction on the students' scientific affective domain and perceptions of portfolio in elementary schools. Portfolio applied science instruction of the 6th grade science unit 'Environment pollution and Nature protection' was developed for this study. Traditional instruction was implemented to the control group and portfolio applied science instruction was implemented to the experimental group. Pretests of the scientific affective domain were administered to both groups. The treatment was given for about seven weeks for both groups. Instruments about scientific affective domain were administered to both groups. A questionnaire on perception of portfolio applied science instruction was given to the experimental group after the treatment. The results were analyzed using t-test on the students' scientific affective domain. The results of this study are as follows: 1. Portfolio applied science instruction program for elementary schools was developed. Students themselves determine the portfolio learning goal in a portfolio applied science instruction. Students construct the portfolio and they evaluate themselves and other colleagues. Also teachers go on portfolio applied science instruction considering portfolio purpose, concepts, evaluation. 2. There was not a statistically meaningful difference between an experimental group and a control group o]1 the students' scientific affective domain. In three sub categories of a scientific affective domain, the science perception, the interest on science and scientific attitude, there were not statistically meaningful difference among them. 3. As the results of the questionnaire on perceptions of portfolio, they didn't understand it very well but after learning portfolio, they showed positive attitude to perceptions of portfolio. Students in portfolio applied science instruction like more the portfolio applied science instruction than general instruction. 4. Portfolio applied science instruction has an useful value as a method of teaching and evaluation. Students and teachers can produce various portfolios products in portfolio applied science instruction. As a conclusion, portfolio applied science instruction was not statistically meaningful on the students' scientific affective domain, but it gives positive effects on perceptions of portfolio in elementary schools. Therefore, portfolio has an educational value as a method of teaching and evaluation for students' growth. In the future, teachers and students must have interaction and feedback in portfolio applied science instruction.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.32 no.5C
• /
• pp.556-564
• /
• 2007

This paper proposes an efficient scheme to track a time variant channel induced by multi-path Rayleigh fading in mobile MIMO-OFDM systems with null sub-carriers. The proposed adaptive channel tracking scheme removes in the frequency domain the interfering signals of the other transmit (Tx) antennas by using a predicted channel frequency response before starting the channel estimation. Time domain channel estimation is then performed to reduce the additive white Gaussian noise (AWGN). The simulation results show that the proposed method is better than the conventional channel tracking method [3] in time varying channel environments. At a Doppler frequency of 300 Hz and bit error rates (BER) of 10-3, signal-to-noise power ratio (Eb/N0) gains of about 2.5 dB are achieved relative to the conventional channel tracking method [3]. At a Doppler frequency of 600 Hz, the performance difference between the proposed method and conventional one becomes much larger.

• Korean Journal of Materials Research
• /
• v.16 no.12
• /
• pp.747-753
• /
• 2006

(BaSr)$TiO_3$ (BST) thick films were prepared by tape casting method, using $BaTiO_3$ and $SrTiO_3$ powder slurry and their dielectric properties were investigated. With an additive, $Li_2CO_3$, the sintering temperature was lowered by $200^{\circ}C$. Sintering density was 5.7 g/$cm^3$ and the BST thick films exhibited a maximum dielectric constant, tunability at temperatures near phase transition point. Whilst their characteristics were deteriorated above the phase transition temperature, they were unchanged below the phase transition temperature, which is presumedly due to the acceleration of $90^{\circ}$ domain formation, its contribution to the relaxation of internal stress and the increase in sintering according to the replacement of Li.

• Journal of the Korean Institute of Telematics and Electronics C
• /
• v.35C no.2
• /
• pp.56-64
• /
• 1998

Multi-layered perceptrons that are a nonlinear neural network model, have been widely used for various applications mainly thanks to good function approximation capability for nonlinear fuctions. However, for digital hardware implementation of the multi-layere perceptrons, the quantization scheme using "look-up tables (LUTs)" is commonly employed to handle nonlinear signmoid activation functions in the neworks, and thus requires large amount of storage to prevent unacceptable quantization errors. This paper is concerned with a new effective methodology for digital hardware implementation of multi-layered perceptrons, and proposes a "piecewise affine approximation" method in which input domain is divided into (small number of) sub-intervals and nonlinear sigmoid function is linearly approximated within each sub-interval. Using the proposed method, we develop an expression and an error backpropagation type learning algorithm for a multi-layered perceptron, and compare the performance with the quantization method through Monte Carlo simulations on XOR problems. Simulation results show that, in terms of learning convergece, the proposed method with a small number of sub-intervals significantly outperforms the quantization method with a very large storage requirement. We expect from these results that the proposed method can be utilized in digital system implementation to significantly reduce the storage requirement, quantization error, and learning time of the quantization method.quantization method.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.13 no.2
• /
• pp.217-224
• /
• 2002

One of the dominant aspects governing the accuracy of the FDTD method is the size of the spatial increment used in the model. The effect of having reduced cell size is to increase the computational time and memory requirements. To overcome these problems, sub-gridding technique can be used. This implies that the application of a sub-grid cell would provide improved accuracy without increasing the run time and computer resources considerably. In this paper, we describe the three dimensional sub-gridding technique that is applied to model only the fine structure region of interest. The detailed solution procedure is described and some test geometries were solved by both uniform grid and sub-grid models to validate the suggested approach. While keeping the accuracy, the computational time becomes 6 times faster and the memory requirement is reduced by a factor of 2.5 comparing to the conventional FDTD approach.

• Korean Journal of Computational Design and Engineering
• /
• v.12 no.4
• /
• pp.255-262
• /
• 2007

In the finite element analysis of forming process, objects are described with a finite number of elements and nodes and the approximated solutions can be obtained by the variational principle. One of the shortcomings of a finite element analysis is that the structure of mesh has become inefficient and unusable because discretization error increases as deformation proceeds due to severe distortion of elements. If the state of current mesh satisfies a certain remeshing criterion, analysis is stopped instantly and resumed with a reconstructed mesh. In the study, a new remeshing algorithm using tetrahedral elements has been developed, which is adapted to the desired mesh density. In order to reduce the discretization error, desired mesh sizes in each lesion of the workpiece are calculated using the Zinkiewicz and Zhu's a-posteriori error estimation scheme. The pre-constructed mesh is constructed based on the modified point insertion technique which is adapted to the density function. The object domain is divided into uniformly-sized sub-domains and the numbers of nodes in each sub-domain are redistributed, respectively. After finishing the redistribution process of nodes, a tetrahedral mesh is reconstructed with the redistributed nodes, which is adapted to the density map and resulting in good mesh quality. A goodness and adaptability of the constructed mesh is verified with a testing measure. The proposed remeshing technique is applied to the finite element analyses of forging processes.

• Journal of Institute of Control, Robotics and Systems
• /
• v.12 no.4
• /
• pp.364-370
• /
• 2006

Optical coherence tomography (OCT) is high resolution medical imaging system which is obtaining image inside biological objects with non-destructive method. OCT system is based on Michelson interferometer with a reciprocating mirror in the reference arm and a biological object in the sample arm. The obtained OCT image suffers from a granular or mottled image, called speckle. Speckle is caused by random interferences between reflected coherence waves. In this paper, we propose effective speckle reduction method that uses wavelet transform. With wavelet domain image, sub-windowing and thresholding are performed. Finally, speckle reduction experiments for Misgurnus mizolepis skin and rat eye images are shown.