• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.403.1-403.1
• /
• 2014

In conventional far-field microscopy, two objects separated closer than approximately half of an emission wavelength cannot be resolved, because of the fundamental limitation known as Abbe's diffraction limit. During the last decade, several super-resolution methods have been developed to overcome the diffraction limit in optical imaging. Among them, super-resolution optical fluctuation imaging (SOFI) developed by Dertinger et al [1], employs the statistical analysis of temporal fluorescence fluctuations induced by blinking phenomena in fluorophores. SOFI is a simple and versatile method for super-resolution imaging. However, due to the uncontrollable blinking of fluorophores, there are some limitations to using SOFI for several applications, including the limitations of available blinking fluorophores for SOFI, a requirement of using a high-speed camera, and a low signal-to-noise ratio. To solve these limitations, we present a new approach combining SOFI with speckle pattern illumination to create illumination-induced optical fluctuation instead of blinking fluctuation of fluorophore.. This technique effectively overcome the limitations of the conventional SOFI since illumination-induced optical fluctuation is possible to control unlike blinking phenomena of fluorophore. And we present the sub-diffraction resolution image using SOFI with speckle illumination.

• Bulletin of the Korean Chemical Society
• /
• v.35 no.2
• /
• pp.575-580
• /
• 2014

We uniformly coated Eu(III)- and Tb(III)-doped yttrium oxide onto the surface of $SiO_2$ spheres and then characterized them by scanning electron microscopy (SEM), transmission electron microscopy (TEM), X-ray diffraction crystallography and UV-Visible absorption. 2D and 3D photoluminescence image map profiles were reported for the core-shell type structure. Red emission peaks of Eu(III) were observed between 580 to 730 nm and assigned to $^5D_0{\rightarrow}^7F_J$ (J = 0 - 4) transitions. The green emission peaks of Tb(III) between 450 and 650 nm were attributed to the $^5D_4{\rightarrow}^7F_J$ (J = 6, 5, 4, 3) transitions. For annealed samples, Eu(III) ions were embedded at a $C_2$ symmetry site in $Y_2O_3$, which was accompanied by an increase in luminescence intensity and redness, while Tb(III) was changed to Tb(IV), which resulted in no green emission.

• Journal of the Optical Society of Korea
• /
• v.20 no.6
• /
• pp.653-662
• /
• 2016

An optimized multilayer superlens is designed, using a rigorous and efficient approach based on the method of moments (MoM) in conjunction with a simulated annealing (SA) algorithm. For the MoM solution, fast evaluation of closed-form Green's functions (GFs) in the spatial domain is performed by applying the complex-image (CI) technique, which obviates the time-consuming numerical evaluation of Sommerfeld integrals. The imaging capability of the superlens is examined with the correlation coefficient; results show that using circular polarization for the incident wave can improve this coefficient. To validate the proposed method, finite-element-based simulations are exploited, which reveal the method's accuracy and computational efficiency. Simulation results indicate that the designed structure is capable of producing two-dimensional sub-diffraction-limited images in the visible range, which may make it more versatile for practical applications. Finally, as a considerable finding, it is demonstrated for the proposed design that using circularly polarized illumination provides improved super-resolving performance, compared to linearly polarized illumination.

• Nuclear Engineering and Technology
• /
• v.55 no.12
• /
• pp.4642-4646
• /
• 2023

The Tb³⁺ or Eu³⁺-doped Lu₂Gd₁Ga₂Al₃O₁₂ phosphor were fabricated by funace at 1500 ℃ for 12 h using a solid state reaction. The XRD (X-ray diffraction_Panalytical X'Pert Pro) and FE-SEM (field emission scanning electron microscope) are measured to confirm the crystalline structure and surface morphology of the phosphor. The Tb³⁺-doped Lu₂Gd₁Ga₂Al₃O₁₂ phosphor emits the lights in 470~650 nm wavelength range due to transitions from ⁵D₄ to ⁷F_j. Therefore, it shows the green region in the CIE chromaticity diagram under both UV and X-rays excitations. The Eu³⁺-doped Lu₂Gd₁Ga₂Al₃O₁₂ phosphor emits the lights in 550~750 nm wavelength range because of ⁵D_i to ⁷F_j. The emission is confirmed to be in the red region using the CIE chromaticity diagram. The Tb³⁺ or Eu³⁺-doped Lu₂Gd₁Ga₂Al₃O₁₂ phosphor shows the characteristic f-f transition with a long decay time, which is about several milliseconds. They have the high efficiency of light emission for X-ray because of their high effective Z number (Z_eff = 58.5) and density. Therefore, they are very much promising phosphors for X-ray imaging application in medical fields.

• Journal of the Semiconductor & Display Technology
• /
• v.14 no.3
• /
• pp.1-5
• /
• 2015

In photolithography process, resolution enhancement techniques such as optical proximity correction (OPC) and phase shift mask (PSM) have been applied to improve resolution. Especially, sub-resolution assist feature (SRAF) is one of the most important OPC to enhance image quality including depth of focus (DOF). However, imaging performance of the mask could be varied with the diffraction order amplitude changed by inserting SRAF. Therefore, in this study, we investigated the imaging properties and process margin of attenuated PSM with SRAF. Reflectivities of attenuated PSMs at 13.5 nm were 3, 6, 9% and simulation was performed by $PROLITH^{TM}$. As a result, aerial image properties and DOF as well as diffraction efficiency were improved by increasing the reflectivity of attenuated PSM. Additionally, printed critical dimension variations depending on SRAF width and space error were also reduced for attenuated PSM with high reflectivity. However, SRAF could be printed when reflectivity of attenuated PSM is high enough. In conclusion, optimization of reflectivity of attenuated PSM and SRAF to prevent side-lobe from being printed is needed to be considered.

• Journal of the Semiconductor & Display Technology
• /
• v.15 no.3
• /
• pp.1-5
• /
• 2016

In order to apply sub-resolution assist feature (SRAF) in extreme ultraviolet lithography, the maximum non-printing SRAF width and lithography process margin needs to be improved. Through simulation, we confirmed that the maximum SRAF width of 6% attenuated phase shift mask (PSM) is large compared to conventional binary intensity mask. The increase in SRAF width is due to dark region's reflectivity of PSM which consequently improves the process window. Furthermore, the critical dimension error caused by variation of SRAF width and center position is reduced by lower change in diffraction amplitude. Therefore, we speculate that the margin of SRAF application will be improved by using PSM.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2015.08a
• /
• pp.78-78
• /
• 2015

Metamaterials, artificially structured nanomaterials, have enabled unprecedented phenomena such as invisibility cloaking and negative refraction. Especially, hyperbolic metamaterials also known as indefinite metamaterials have unique dispersion relation where the principal components of its permittivity tensors are not all with the same signs and magnitudes. Such extraordinary dispersion relation results in hyperbolic dispersion relations which lead to a number of interesting phenomena, such as super-resolution effect which transfers evanescent waves to propagating waves at its interface with normal materials and, the propagation of electromagnetic waves with very large wavevectors comparing they are evanescent waves and thus decay quickly in natural materials. In this abstract, I will focus discussing our efforts in achieving the unique optical property overcoming diffraction limit to achieve several extraordinary metamaterials and metadevices demonstration. First, I will present super-resolution imaging device called "hyperlens", which is the first experimental demonstration of near- to far-field imaging at visible light with resolution beyond the diffraction limit in two lateral dimensions. Second, I will show another unique application of metamaterials for miniaturizing optical cavity, a key component to make lasers, into the nanoscale for the first time. It shows the cavity array which successfully captured light in 20nm dimension and show very high figure of merit experimentally. Last, I will discuss the future direction of the hyperbolic metamaterial and outlook for the practical applications. I believe our efforts in sub-wavelength metamaterials having such extraordinary optical properties will lead to further advanced nanophotonics and nanooptics research.

• Metals and materials international
• /
• v.24 no.6
• /
• pp.1327-1332
• /
• 2018

In this study, a novel approach to the explosive synthesis of titanium carbide (TiC) is discussed. Nonstoichiometric $TiC_x$ powder was produced via the underwater explosion of a Ti powder encapsulated within a spherical explosive charge. The explosion process, bubble formation, and synthesis process were visualized using high-speed camera imaging. It was concluded that synthesis occurred within the detonation gas during the first expansion/contraction cycle of the bubble, which was accompanied by a strong emission of light. The recovered powders were studied using scanning electron microscopy and X-ray diffraction. Submicron particles were generated during the explosion. An increase in the carbon content of the starting powder resulted in an increase in the carbon content of the final product. No oxide byproducts were observed within the recovered powders.

• Nuclear Engineering and Technology
• /
• v.52 no.9
• /
• pp.2078-2084
• /
• 2020

Magnesium oxide (MgO) and Zinc oxide (ZnO) nanoparticles (NPs) have been successfully synthesized by solid-solid reaction method. The structural properties of ZnO and MgO NPs were studied using X-ray diffraction (XRD) and scanning electron microscopy (SEM). XRD results indicated a formation of pure MgO and ZnO NPs. The mean diameter values of the agglomerated particles were around to be 70 and 50 nm for MgO and ZnO NPs, respectively using SEM analysis. Further, a wide-range of nuclear radiation shielding investigation for gamma-ray and fast neutrons have been studied for Magnesium oxide (MgO) and Zinc oxide (ZnO) samples. FLUKA and Microshield codes have been employed for the determination of mass attenuation coefficients (μ_m) and transmission factors (TF) of Magnesium oxide (MgO) and Zinc oxide (ZnO) samples. The calculated values for mass attenuation coefficients (μ_m) were utilized to determine other vital shielding properties against gamma-ray radiation. Moreover, the results showed that Zinc oxide (ZnO) nanoparticles with the lowest diameter value as 50 nm had a satisfactory capacity in nuclear radiation shielding.

• Korean Journal of Optics and Photonics
• /
• v.12 no.2
• /
• pp.83-90
• /
• 2001

The Talbot effect for periodic objects with the spatial period p illuminated by expanded coherent light is analyzed by Fresnel diffraction theory, and the Talbot distance (Zr) at which we can observe 1: 1 imaging without any lenses can be defined. We confmned experimentally the Talbot imaging of line, circular, X -type and '||'&'||'copy;-type 2 dimensional alTay gratings at ZT. At the same time, we observed phase reversed Talbot imaging at Zr/2 and Talbot subimage with p/2 at Zr/4 and 3Zr/4. The visibility of Talbot images as a function of the number of slits of the input grating was measured by the FFf (Fast Fourier Transform) results of these images. As a result stationary maximum visibility of V = 0.25 was obtained from grating numbers with more than 15 slit pairs.