• 대한전자공학회논문지TC
• /
• 제49권5호
• /
• pp.44-50
• /
• 2012

개인 휴대용 장치를 위한 최초의 CR (cognitive radio) 표준인 ECMA-392에서는 채널 추정을 위해, 매 프레임마다 2 OFDM 심볼 길이의 long preamble과 13 OFDM 심볼 구간 단위로 반복되는 pilot sub-carrier를 전송해 주도록 하고 있다. 본 논문에서는 ECMA-392 시스템의 long preamble과 pilot sub-carrier를 모두 이용하는 채널 추정 방식들을 고려하며, pilot sub-carrier에서 얻은 채널 추정치에 1차 순환 필터(first order recursive filter)를 적용하고 long preamble에서 얻은 초기 추정치를 필터의 초기 값으로 사용하는 '1차 순환 필터 기반 채널 추정' 방식을 제안한다. 또한 채널 추정 지연을 줄일 수 있는 방안도 제시할 것이며, 컴퓨터 모의실험을 통해 제안된 방식들이 저속 이동 채널 환경에서 우수한 성능을 가짐을 보이고자 한다.

• 대한원격탐사학회:학술대회논문집
• /
• 대한원격탐사학회 2004년도 Proceedings of ISRS 2004
• /
• pp.577-580
• /
• 2004

To overcome with large size noise source distribution network design difficulty in interferometric radiometer system, especially for sub-Y-type array, a new on-board calibration technique using noise re-radiation is proposed in this paper. The suggested calibration technique is using noise re-radiation effect of center antenna after noise source injection from matched load. This approach is especially proper to sub-Y-type array interferometric synthetic aperture radiometer in mm-wave frequency band. Compared with noise injection network of a conventional synthetic aperture radiometer, the system mass, volume, and hardware complexity is reduced and cost-effective. Only one internal noise source, matched load, is used for injection using noise re-radiation technique a small set of sub-Y receiver channels is calibrated. Detailed calibration scenario is discussed and simulation results about noise re­radiation effect are presented.

• 한국정밀공학회지
• /
• 제23권5호
• /
• pp.51-58
• /
• 2006

The necessities for heightening fuel efficiency as well as lightweight design, lead to an increase of the use of aluminum alloys in the automobile industry. Extruded aluminum profile channels are used widely for the design of frame parts as lightweight assemblies, especially if a high stiffness is needed. While many applications can be realized with forming of hollow square-sectioned extruded profiles such as a stretch bending and a hydro-forming, some applications demand the use of a press bending which can be hardly found in the previous study. In this study, by introducing the use of a press bending into car sub-frames, the demands for higher accuracy as well as higher flexible method than the conventional methods will be satisfied. With respect to the design of sub-frames, the process planning was performed from the shape of a sub-frame product. The designed processes were analyzed by the commercial FEM code, DEFORM-3D. Forming dies for the each process were designed and prototypes of sub-frames were manufactured by the verified farming process. In addition, some of the important features of design parameters in the press bending were reviewed.

• 대한수의학회지
• /
• 제40권2호
• /
• pp.275-282
• /
• 2000

Substantia nigra is known to highly express glibenclamide binding site, a protein associated to ATP-sensitive $K^{+}$ ($K_{ATP}$) channel in the brain. However, the functional expression of $K_{ATP}$ channels in the area is not yet known. In this work, we attempted to estimate the functional expression of $K_{ATP}$ channels in neurons of the substantia nigra pars compacta (SNC) in young rats using slice patch clamp technique. Membrane properties and whole cell currents attributable to $K_{ATP}$ channel were examined by the current and voltage clamp method, respectively. In SNC, two sub-populations of neurons were identified. Type I (rhythmic) neurons had low frequency rebound action potentials ($4.5{\pm}0.25Hz$, n=75) with rhythmic pattern. Type II (phasic) neurons were characterized by faster firing ($22.7{\pm}3.16Hz$, n=12). Both time constants and membrane capacitance in rhythmic neurons ($34.0{\pm}1.27$ ms, $270.0{\pm}11.83$ pF) and phasic neurons ($23.7{\pm}4.16$ ms, $184{\pm}35.2$ pF) were also significantly different. The current density of $K_{ATP}$ channels was $6.1{\pm}1.47$ pA/pF (2.44~15.43 pA/pF, n=8) at rhythmic neurons of young rats. Our data show that in SNC there are two types of neurons with different electrical properties and the density of $K_{ATP}$, channel of rhythmic neuron is about 600 channels per neuron.

• Korean Chemical Engineering Research
• /
• 제60권4호
• /
• pp.574-581
• /
• 2022

리튬-황 전지의 기능성 중간층으로 그래핀과 Mo₂C/Mo₂N 나노입자로 구성된 나노섬유(Mo₂C/Mo₂N rGO NFs)를 사용하였다. Mo₂C/Mo₂N 나노입자는 섬유 구조 내 고르게 분산되어 리튬 폴리설파이드의 화학적 흡착을 위한 활성 사이트 역할을 함으로써 전해질로의 용출을 효과적으로 억제하였다. 또한 구조 내 매트릭스로 구성된 그래핀 나노시트는 충방전이 진행되는 동안 이온 및 전자의 빠른 이동을 보장할 뿐만 아니라 반응 시 산화/환원 반응을 원활하게 하여 높은 리튬 폴리설파이드의 재사용을 보장하였다. 그 결과 Mo₂C/Mo₂N rGO NFs로 코팅된 분리막을 기능성 중간층으로 사용, 순수 황 전극(황 함량 70 wt%, 황 로딩 2.1 mg cm^-2)으로 제작된 리튬-황 전지는 0.1 C에서 400회 충방전 후 476 mA h g^-1의 안정적인 방전 용량을 나타냈으며, 1.0 C의 높은 전류밀도에서도 574 mA h g^-1의 방전용량을 나타내었다. 본 연구에서 제안된 나노구조체 합성 전략은 고성능 리튬-황 전지 용 기능성 중간층 및 다양한 에너지 저장 소재분야로의 확장이 가능하다.

• Journal of electromagnetic engineering and science
• /
• 제6권2호
• /
• pp.83-91
• /
• 2006

In this paper, we develop space-time(ST) Rake receivers for Time Division Synchronous Code Division Multiple Access(TD-SCDMA) base stations(BS). The beamforming of BS transforms the uplink MIMO channel space into many sub-sectors' channels to be nearly orthogonal, thus, well established 1-D Rake technology can be used to TD-SCDMA base station to construct ST Rake, which simplified the system's implementation as well as enlarged users' capacity by the beamforming. The construction and capacity of MIMO sub-sectors by multi-beamforming have been presented. The proposed ST Rake algorithm include the multi-beamforming algorithm for MIMO sub-sectors and classical 1-D Rake algorithm. The calculating formulas for interference plus noise ratio(SINR) and bit error rate(BER) have been derived. Simulations verify that the proposed ST Rake receiver for BS is effective, and the BS systems can get higher system capacity and can be of better performance than presented TD-SCDMA systems.

• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제10권9호
• /
• pp.4326-4341
• /
• 2016

In this paper, an adjustable multiple relay selection (MRS) scheme for cooperative communication with amplify-and-forward (AF) relay under frequency selective channels is proposed. In the proposed scheme, the relays are ordered firstly by the steady-state mean square error (MSE), then the relays are sequentially selected out from N relays and the number of cooperating relays is adjusted dynamically according to the steady-state mean square joint error (MSJE). The aim of this work is to dynamically estimate the optimum number N_o of cooperating relays. Optimum means the minimum number of cooperating relays, N_o, achieving the minimum level of steady-state MSJE. Numerical results verify the analyses and show that the scheme can adaptively adjust the number of cooperating relays, and outperform conventional relay selection schemes. Hence, the proposed scheme provides better tradeoff between BER performance and spectral efficiency and to save more energy in cooperative wireless networks.

• Journal of Applied Biological Chemistry
• /
• 제62권4호
• /
• pp.425-431
• /
• 2019

Platelet activation is essential for hemostatic process on blood vessel damage. However, excessive platelet activation can cause some cardiovascular diseases including atherosclerosis, thrombosis, and myocardial infarction. Scoparone is commonly encountered in the roots of genus Artemisia or Scopolia, and has been studied for its potential pharmacological properties including immunosuppression and vasorelaxation, but antiplatelet effects of scoparone have not been reported yet. We investigated the effect of scoparone on human platelet activation prompted by an analogue of thromboxane A₂, U46619. As the results, scoparone dose-dependently increased cyclic adenosine monophosphate (cAMP) levels as well as cyclic guanosine monophosphate (cGMP) levels, both being aggregation-inhibiting molecules. In addition, scoparone strongly phosphorylated inositol 1, 4, 5-triphosphate receptor (IP3R) and vasodilator-stimulated phosphoprotein (VASP), substrates of cAMP dependent kinase and cGMP dependent kinase. Phosphorylation of IP₃R by scoparone resulted in inhibition of Ca²⁺ mobilization in calcium channels in a dense tubular system, and phosphorylation of VASP by scoparone led to an inability of fibrinogen being able to bind to αIIb/β3. Finally, scoparone inhibited thrombin-induced fibrin clotting, thereby reducing thrombus formation. Therefore, we suggest that scoparone has a strong antiplatelet effect and is highly probable to prevent platelet-derived vascular disease.

• Nuclear Engineering and Technology
• /
• 제52권11호
• /
• pp.2479-2490
• /
• 2020

We performed experiments to measure a single-phase upward flow in a 5 × 5 rod bundle with spacer grids using a particle image velocimetry, focusing on the crossflow. The Reynolds number based on the hydraulic diameter and the bulk velocity is 10,000. The ratio of pitch between rods and rod diameter is 1.4 and spacer grid is installed periodically. The turbulence in the rod bundle results from the combination of a forced mixing and natural mixing. The forced mixing by the spacer grid persists up to 10D_h from the spacer grid, while the natural mixing is attributed to the crossflow between adjacent subchannels. The combined effects contribute to a sinusoidal distribution of the time-averaged stream-wise velocity along the lateral direction, which is relatively weak right behind the spacer grid as well as in the gap. The streamwise and lateral turbulence intensities are stronger right behind the spacer grid and in the gap. Based on these findings, we newly defined a modified mixing coefficient as the ratio of the lateral turbulence intensity to the time-averaged streamwise velocity, which shows a spatial variation. Finally, we compared the developed model with the measured data, which shows a good agreement with each other.

• 한국전기전자재료학회논문지
• /
• 제30권8호
• /
• pp.474-478
• /
• 2017

We report on thin-film transistors based on $TiO_x$ pre-annealed by femtosecond laser pulses. A 30-nm thick $TiO_x$ active channel layer was initially deposited by an ALD system. The $TiO_x$ semiconducting films were annealed by irradiation with a femtosecond laser (power: $3W/cm^2$) for 5, 25, and 50s. Atomic force microscopy images revealed that the surface of a $TiO_x$ film without femtosecond laser pre-annealing was relatively rough, while after annealing with femtosecond laser pulses, the surface of the $TiO_x$ films became smooth. With increasing radiation time, the surrounding gas atmosphere could have a larger impact on the $TiO_x$ surface; meanwhile, the thin-film roughness decreased. Thin-film transistors with $TiO_x$ active channels pre-annealed at 50s exhibited good transfer characteristics and an on-to-off current ratio of ${\sim}10^3$.