• The Bulletin of The Korean Astronomical Society
• /
• v.36 no.1
• /
• pp.40.2-40.2
• /
• 2011

We investigated solar flare occurrence probability depending on sunspot group classification and its area change. For this study, we used the McIntosh sunspot group classification and then selected most flare-productive six sunspot groups : DKI, DKC, EKI, EKC, FKI and FKC. For each group, we classified it into three sub-groups according to the sunspot group area change : increase, steady and decrease. For sunspot data, we used the NOAA's active region information for 19 years (from 1992.01 to 2010.12). As a result, we found that the probabilities of the all "increase" sub-groups is noticeably higher than those of other sub-groups. In case of FKC McIntosh sunspot group, for example, the M-class flare occurrence probability of the "increase" sub-group is 65% while the "decrease" and "steady" sub-groups are 50% and 44%, respectively. In summary, when sunspot group area increases, the probability of solar flares noticeably increases. This is statistical evidence that magnetic flux emergence is an very important mechanism for triggering solar flares.

• Korean Journal of Materials Research
• /
• v.30 no.5
• /
• pp.262-266
• /
• 2020

In this paper, we investigated the effect of the passivation stack with Al₂O₃, hydrogenated silicon nitride (SiN_x:H) stack and Al₂O₃, silicon oxynitride (SiON_x) stack in the n type bifacial solar cell on monocrystalline silicon. SiNx:H and SiON_x films were deposited by plasma enhanced chemical vapor deposition on the Al₂O₃ thin film deposited by thermal atomic layer deposition. We focus on passivation properties of the two stack structure after laser ablation process in order to improve bifaciality of the cell. Our results showed SiN_x:H with Al₂O₃ stack is 10 mV higher in implied open circuit voltage and 60 ㎲ higher in minority carrier lifetime than SiON_x with Al₂O₃ stack at Ni silicide formation temperature for 1.8% open area ratio. This can be explained by hydrogen passivation at the Al₂O₃/Si interface and Al₂O₃ layer of laser damaged area during annealing.

• Journal of the Korean Association of Geographic Information Studies
• /
• v.25 no.2
• /
• pp.1-17
• /
• 2022

This study analyzed the PM_2.5 pattern by using data measured for one year from June 2020 to May 2021 by 21 low-cost sensors installed near the Changwon National Industrial Complex in Changwon, Gyeongsangnam-do. For the PM_2.5 pattern, the land use types around the measuring points and meteorological factors such as air temperature and wind speed were considered. The PM_2.5 concentration was high from November to March in winter, and from 1 to 9 in the morning and early in the morning by time zone. The concentration of PM_2.5 was higher as it got closer to the industrial area, but the concentration was lower in the residential area and public facility area. In terms of meteorological factors, the higher the air temperature and wind speed, the lower the concentration of PM_2.5. As a result of this study, it was possible to identify the PM_2.5 patter near Changwon National Industrial Complex. This result will be useful data that can be used in urban and environmental planning to improve air quality including PM_2.5 in urban area in the future.

• Korean Chemical Engineering Research
• /
• v.60 no.4
• /
• pp.620-629
• /
• 2022

By varying various experimental conditions such as heating rate, molar hourly space velocity (MHSV), and nitridation reaction temperature, vanadium oxynitride was prepared through temperature programmed reduction/nitridation reaction (TPRN) of vanadium pentoxide and ammonia, and characterization were performed. In order to investigate the physico-chemical properties of the prepared catalyst, N₂ adsorption-desorption analysis, X-ray diffraction analysis (XRD), hydrogen temperature programmed reduction (H₂-TPR), temperature programmed oxidation (TPO), ammonia temperature programmed desorption (NH₃-TPD), transmission electron microscopy (TEM) was performed. Transformation of V₂O₅ with 5 m² g^-1 low specific surface area by reduction at 340 ℃ to V₂O₃ showed a high specific surface area value of 115 m² g^-1 by micropore formation. As the nitridation temperature increased beyond that, the specific surface area continued to decrease due to sintering. The nitridation reaction variable that had the greatest influence on the specific surface area was the reaction temperature, and the x + y value of VN_xO_y of a single phase approached from 1.5 to 1.0 as the nitridation reaction temperature increased. At a high reaction temperature of 680 ℃, the cubic lattice constant a was VN. close to the value. At 680 ℃, the highest nitridation temperature among the experimental conditions, the ammonia conversion rate was 93%, and no deactivation was observed.

• Particle and aerosol research
• /
• v.17 no.3
• /
• pp.55-69
• /
• 2021

Chungnam region accounts for the largest SO_X (22.8%) emission with the second-largest NO_X (10.8%) emission in Korea due to the integration of many large industrial sources including a steel mill, coal-fired power plants, and petrochemical complex. Air pollutants emitted by large industrial sources can cause harmful problems to humans and the environment. Thus, it is necessary to understand dispersion patterns of air pollutants from large industrial sources in Chungnam to characterize atmospheric contamination in Chungnam and the surrounding area. In this study, seasonal atmospheric dispersion characteristics for SO_X, NO_X, and PM2.5 from ten major point sources in Chungnam were evaluated using HYSPLIT 4 model, and their contributions to SO₂, NO₂ concentrations in the regions near the source areas were estimated. The predictions of the HYSPLIT 4 model show a seasonal different dispersion pattern, in which air pollutants were dispersed toward the southeast in winter while, northeast in summer. In summer, due to weaker wind speed, air pollutants concentrations were higher than in winter, and they were dispersed to the metropolitan area. The local emissions of air pollutants in Taean area had a greater influence on the ambient SO₂ and NO₂ concentrations at Taean, whereas SO_X and NO_X emissions from large sources located at Seosan showed relatevely little effect on the ambient ambient SO₂ and NO₂ concentrations at Seosan.

• Journal of Environmental Science International
• /
• v.32 no.7
• /
• pp.503-520
• /
• 2023

In this study, numerical simulations using community multiscale air quality (CMAQ) were conducted to analyze the change in ozone (O₃) concentration due to the reduction in nitrogen oxides (NO_x)andvolatile organic compounds (VOCs) emissions in Busan. When the NO_x and, VOCs emissions were reduced by 40% and, 31%, respectively, the average O₃ concentration increased by 4.24 ppb, with the highest O₃ change observed in the central region (4.59 ppb). This was attributed to the decrease in O₃ titration by nitric oxide (NO) due to the reduction of NO_x emissions in Busan, which is classified as a VOCs-limited area. The distribution of O₃ concentration changes was closely related to NO_x emissions per area, and inland emissions were highly correlated with daily maximum concentrations and 8-h average O₃ concentrations. Contrastingly, the effect of emission reduction depended on the wind direction. This suggests that the emission reduction effects may vary depending on the environmental conditions. Further research is needed to comprehensively analyze the emission reduction effects in Busan.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 2020.11a
• /
• pp.126-126
• /
• 2020

• ETRI Journal
• /
• v.23 no.3
• /
• pp.129-137
• /
• 2001

A random sampling or systematic sampling method is commonly used to assess the accuracy of classification results. In remote sensing, with these sampling methods, much time and tedious work are required to acquire sufficient ground truth data. So, a more effective sampling method that can represent the characteristics of the population is required. In this study, fractal analysis is adopted as an index for reference sampling. The fractal dimensions of the whole study area and the sub-regions are calculated to select sub-regions that have the most similar dimensionality to that of the whole area. Then the whole area's classification accuracy is compared with those of sub-regions, and it is verified that the accuracies of selected sub-regions are similar to that of whole area. A new kind of reference sampling method using the above procedure is proposed. The results show that it is possible to reduce sampling area and sample size, while keeping the same level of accuracy as the existing methods.

• Journal of the Korean Ceramic Society
• /
• v.56 no.5
• /
• pp.497-505
• /
• 2019

Lanthanum-based transition metal cations containing perovskites have emerged as potential catalysts for the intermediate-temperature (600-800℃) oxygen reduction reaction (ORR). Here, we report a facile acetylacetone-assisted combustion route for the synthesis of nanostructured La_0.6Sr_0.4Co_0.2Fe_0.8O_3-δ (LSCF6428) cathodes for intermediate-temperature solid-oxide fuel cells (IT-SOFCs). The as-prepared powder was analyzed by thermogravimetry analysis-differential scanning calorimetry. The powder calcined at 800℃ was characterized by X-ray diffraction, scanning electrode microscopy, energy dispersive X-ray spectroscopy, and Brunauer-Emmett-Teller surface area measurements. It was found that the porosity of the air electrode significantly increased by utilizing the nanostructured LSCF6428 instead of commercial powder. The performance of a single cell fabricated with the nanostructured LSCF6428 cathode increased by 112%, from 0.4 to 0.85 W cm^-2, at 700℃. Electrochemical impedance spectroscopy showed a considerable reduction in the area-specific resistance and activation energy from 133.5 to 61.5 kJ/mol, resulting in enhanced electrocatalytic activity toward ORR and overall cell performance.

• Journal of Environmental Science International
• /
• v.31 no.12
• /
• pp.1079-1087
• /
• 2022

This study investigated the effect of volcanic materials that erupted from the Nishinoshima volcano, Japan, 1,300 km southeast of the Busan area at the end of July 2020, on the fine particle concentration in the Busan area. Backward trajectory analysis from the HYSPLIT model showed that the air parcel from the Nishinoshima volcano turned clockwise along the edge of the North Pacific high pressure and reached the Busan area. From August 4 to August 5, 2020, the concentration of PM₁₀ and PM_2.5 in Busan started to increase rapidly from 1000 LST on August 4, and showed a high concentration for approximately 13 hours until 2400 LST. The PM_2.5/PM₁₀ ratio showed a relatively high value of 0.7 or more, and the SO₂ concentration also showed a high value at the time when the PM₁₀ and PM_2.5 concentrations were relatively high. The SO₄^2- concentration in PM_2.5 in Busan showed a similar trend to the change in PM₁₀ and PM_2.5 concentrations. It rose sharply from 1300 LST on August 4, at the time where it was expected to have been affected by the Nishinoshima Volcano. This study has shown that the occurrence of high concentration fine particle in Busan in summer has the potential to affect Korea not only due to anthropogenic factors but also from natural causes such as volcanic eruptions in Japan.