• Journal of the Mineralogical Society of Korea
• /
• v.24 no.1
• /
• pp.1-17
• /
• 2011

Mineralogical study was carried out for heavy minerals in the sea sand near Ongjingun bay, Kyonggi-do separated using the gravity and magnetic separators. Ilmenite, zircon and minor monazite and garnet were valuable minerals with gangue minerals of quartz, K-feldspar, plagioclase, muscovite, hornblende, epidote and chlorite. Quantitative analysis with SIROQUANT program showed that the contents of ilmenite separated with the gravity separation (the shaking table separation), the 1st step magnetic separation (rare earth magnetic separation) and the 2nd step magnetic separation (the Eddy current magnetic separation) were increased into 0.8, 18.3, and 48.7%, respectively. The content of ilmenite, monazite and zircon were recalculated based on the chemical composition of the representative and heavy fraction products of raw sand, the 1 step and 2 step gravity separations, and the 1 step and 2 step magnetic separations. The content increased to 0.23, 0.55, 5.22, 16.17, and 44.99% in ilmenite, 0.11, 0.02, 0.16, 0.51, and 1.19% in monazite. Although the zircon content did not differ over the processes (0.13, 0.12, 0.11, 0.15, and 0.10%), the improved recovery of zircon is expected by applying sieving process because of its high content (27%) in the fine grain size fraction (< 140#) of the 2 step gravity separation.

• Applied Biological Chemistry
• /
• v.37 no.2
• /
• pp.85-93
• /
• 1994

The fish skin gelatin hydrolysates were produced using a continuous two-stage membrane (MWCO 10,000, MWCO 5,000) reactor, and molecular weights, amino acids and functional properties of the hydrolysates were investigated. The major molecular weights distribution of the major fractions were $8{\sim}10\;KDa$ and $4.5{\sim}6.5\;KDa$ in the 1st-step hydrolysates, $2{\sim}6\;KDa$ and $0.5{\sim}2\;KDa$ in the 2nd-step hydrolysates. Among the amino acids in the hydrolysates, glycine, proline, serine, alanine, hydroxyproline, glutamic acid and aspartic acid having sweet taste were responsible for $68{\sim}72%$ of the total amino acids. But valine, methionine, isoleucine, leucine, phenylalanine and histidine having a bitter taste were only $23{\sim}25%$ Taste evaluations show that the gelatin hydrolysates have a brothy and sweet taste, 2nd-step hydrolysate have more a favorable taste than 1st-step hydrolysate. The hydrolysates were completely soluble and clear over the entire pH range. Moisture sorption at intermediate water activities of the 2nd-step hydrolysate was much higher than the unmodified fish skin gelatin, but foaming and emulsification properties were poor. Buffer capacity of the 2nd-step hydrolysate was higher than the fish skin gelatin and 1st-step hydrolysate, while viscosities of the hydrolysates were lower than the fish skin gelatin.

• The Journal of the Korea institute of electronic communication sciences
• /
• v.5 no.5
• /
• pp.528-533
• /
• 2010

Currently the telephone service using Internet grows and the recent introduction of a smart phone is expected to accelerate the trend. In particular, considering the domestic situation that the wireless broadband (WiBro) system deployed over the nation, the telephone service over WiBro can be a solution toward its fast expansion. Unlike telephone service over a conventional telephone network or mobile network, however, internet telephone cannot guarantee it service quality, which can be severer in a wireless environment such as a WiBro network. Therefore, a more strict and systematic management for controlling the quality of internet telephone service over WiBro in a more efficient way. As the first step to establish the management system, this paper proposes a scheme to manage the quality of internet telephone service over WiBro and introduces a software developed for the purpose. The developed software is installed on a user terminal and facilitates efficient service quality management by measuring the quality of internet telephone service over WiBro in terms of VoIP metric, network metric, and wireless metric.

• Transactions of the Korean Society of Mechanical Engineers B
• /
• v.27 no.8
• /
• pp.1023-1032
• /
• 2003

The effect of local forcing on the separated flow over a backward-facing step is investigated through hot-wire measurements and flow visualization with multi-smoke wires. The boundary layer upstream of the separation point is laminar and the Reynolds number based on the free stream velocity and the step height is 13800. The local forcing is given from a slit located at the step edge and the forcing signal is always defined when the wind tunnel is in operation. In case of single frequency forcing, the streamwise velocity and the reattachment length are measured under forcing with various forcing frequencies. For the range of 0.010〈S $t_{\theta}$〈0.013, the forcing frequency component of the streamwise velocity fluctuation grows exponentially and is saturated at x/h = 0.75 , while its subharmonic component grows following the fundamental and is saturated at x/h = 2.0. However, the saturated value of the subharmonic is much lower than that of the fundamental. It is observed that the vortex formation is inhibited by the forcing at S $t_{\theta}$ = 0.019 . For double frequency forcing, natural instability frequency is adopted as a fundamental frequency and its subharmonic is superposed on it. The fundamental frequency component of the streamwise velocity grows exponentially and is saturated at 0.5 < x/ｈ < 0.75, while its subharmonic component grows following the fundamental and is saturated at x/ｈ= 1.5 . Furthermore, the saturated value of the subharmonic component is much higher than that for the single frequency forcing and is nearly the same or higher than that of the fundamental. It is observed that the subharmonic component does not grow for the narrow range of the initial phase difference. This means that there is a range of the initial phase difference where the vortex parring cannot be enhanced or amplified by double frequency forcing. In addition, this effect of the initial phase difference on the development of the shear layer and the distribution of the reattachment length shows a similar trend. From these observations, it can be inferred that the development of the shear layer and the reattachment length are closely related to the vortex paring.

• Journal of the Korean Geotechnical Society
• /
• v.34 no.12
• /
• pp.93-103
• /
• 2018

Behaviors of splices between bolts and welding spliced PHC piles using the tensile strength test were analyzed. The bolts spliced PHC piles, which were tightened over $200N{\cdot}m$ tightening torque, showed straight V shaped line at splices at the lowest 20 N load. Both sides of PHC piles stayed straight, so the full section of bolts spliced piles did not show the unifying behavior, which was the most important performance requirement as pile. Other bolts spliced PHC piles, tightened with $20N{\cdot}m$ loosening torque, also showed the same straight V shaped line at splices for each step of loading. The full section of bolts spliced piles did not return to the initial position after each step of unloading and did not show the elastic material behavior. The splices quality of bolts spliced piles is much lower than that of welding spliced piles with respect to displacement of splices during each step of loadings, residual displacements during each step of unloadings, and failure loads. Results showed that bolts spliced PHC piles, tightened with both over $200N{\cdot}m$ and as low as $20N{\cdot}m$ torque, fell short of performance requirements of spliced PHC pile.

• 대한공업교육학회지
• /
• v.39 no.2
• /
• pp.101-121
• /
• 2014

The study aims to develop the NCS based vocational curriculum model for the practical and creative human resources. For effectiveness of the study, the study consists of literature studies of both domestic and international, contents analysis, case study, expert(9samples) consultation and review, and in-depth-interview of the three advisory members. The validity of the developed model is analyzed through mean, standard deviation and contents validity ratio(CVR). The main results of the model development in our study are as follow. First, our NCS based vocational curriculum model for the practical and creative human resources is developed with the analyses of NCS development manuals, training standard utilization and training curriculum organization manuals, NCS learning module development manual and case studies, NCS research report, NCS based curriculum pilot development resources directed toward the high schools and vocational school as well as the domestic and international literature study on career training model like NCS. Second, based on the findings of our analysis in combination with the findings from the consultations with the expert and advisory committee, total 19 sub-factors of each step and domain are extracted. The sub-factors of domain in step 1 are the competency unit, definition of competency unit, competency unit element, performance criteria, range of variable, guide of assessment, key competency; in step 2, they are subject title, subject objectives, chapter title, chapter objectives, pedagogical methods, assessment methods and basic job competence; and in step 2, they are NCS based subject matrix table, NCS based subject profile, NCS based job training curriculum table, NCS based subjects organization flowchart, NCS based job training operation plan. Third, the final model including step 3 NCS based subject profile are developed in association with the linked organizational sub-factors of step 1 and step 2. Forth, the validity tests for the final model by the step and domain yield the mean 4.67, CVR value 1.00, indicating the superior validity. Also, the means of each sub-factors are all over 4.33 with the CVR value 1.00, indicating the high validity as well. The means of the associated organizations within the model are also over 4.33 with the CVR value of 1.00. Standard deviations are all .50 or lower which are small. Fifth, based on the validity test results and the in-depth-interview of the expert and advisory committee, the model is adjusted complemented to establish final model of the NCS based vocational curriculum for the practical and creative human resources.

• 한국정보디스플레이학회:학술대회논문집
• /
• 2004.08a
• /
• pp.98-100
• /
• 2004

We report a novel manner for preparing single layer anti-reflective coatings with excellent optical properties (<1% reflection) over a broad wavelength regime. The technology is based upon the self-assembly and UV curing of reactive nano-particles, leading to nano-structured coatings with a gradient in refractive index. The single processing step leading to such coatings is fast, robust and cost effective. Furthermore in this paper we will address the mechanical durability of such nano-structured coatings.

• Proceedings of the Korea Water Resources Association Conference
• /
• 2006.05a
• /
• pp.1931-1934
• /
• 2006

The accuracy impact of using high-order Boussinesq-type model as compared to the typical order model is examined in this paper. The multi-layer model developed by Lynett and Liu(2004a) is used for simulating of wave breaking over a step region. The overall comparisons between the two-layer model and the hydraulic experiments are quite good. The one-layer model overshoals the wave near the breakpoint, while the two-layer model shoals at a rate more consistent with the experimental data.

• Proceedings of the Korean Institute of Communication Sciences Conference
• /
• 1987.04a
• /
• pp.52-55
• /
• 1987

In tihis paper an improved matching method using subtemplate of moving region and 3-step search algorithm is proposed It reduces heavy computational load of the conventional method. The proposed method is applied to an automatic target tracker using high speed 16 bit microprocessor in order to track one moving target in real time. Expericmental results show that the proposed method has better performance over the conventional methodin spite of greately reducing the computational load, even in came complex background.

• 전기의세계
• /
• v.29 no.11
• /
• pp.733-741
• /
• 1980

A novel six-step current source inverter (CSI) with DC-side commutation and energy rebound capability is presented with detailed explanation of the circuit operation. The prposed inverter can operate in a very wide range of frequency and load variation by employing DC-side commutation. Also, the energy rebound makes the use of low voltage SCR's possible and increases the inverter efficiency. Motor operation is also possible in four quadrants in this proposed current source inverter. The advantages of the proposed CSI over conventional ones are described and experimental results are given in oscillograms.