• 한국지반공학회논문집
• /
• 제26권4호
• /
• pp.47-58
• /
• 2010

불포화 흐름을 고려하지 않는 도해법 (Casagrande, 1961; Cedergren, 1997)과 근사식(Sakamoto, 1998)에 의한 중심코어형 사력댐 코어죤의 침투량은 실제 침투거동과는 차이가 있고, 저수위 변화에 대한 침투량 변화경향의 파악도 곤란하다. 본 연구에서는 소양강댐에 대한 2차원 정상상태 및 비정상상태 침투류해석으로 저수위, 포화투수계수, 불포화수리특성 변화에 대한 정상상태 침투량과 정상상태 도달시간에 미치는 영향요인을 분석하였다. 분석결과 침투량은 정규화된 선형 관계식으로 예측이 가능하고, 불포화 예측변수 n이 정상상태 침투량과 정상상태 도달시간에 가장 큰 영향을 주었다. 본 연구에서 제시한 예측기법은 복잡한 3차원 해석 및 여러 단면에 대한 2차원 해석을 수행하지 않고도 댐 설계자 및 안전관리 실무자가 중심코어형 사력댐의 침투량을 산정하여 실측치와의 정량적 분석에 손쉽게 이용할 수 있을 것으로 생각된다.

• Food Science and Biotechnology
• /
• 제18권2호
• /
• pp.526-532
• /
• 2009

Quenching mechanisms and kinetics of $\alpha$-, $\beta$-, $\gamma$-, and $\delta$-tocopherol in photosensitized oxidation of lard were studied. Lard at 0.03, 0.07, 0.11, and 0.3 M in methylene chloride containing $4.4{\times}10^{-6}\;M$ chlorophyll and 0, 0.1, 0.3, and 0.6 mM $\alpha$-, $\beta$-, $\gamma$-, and $\delta$-tocopherol were stored under light for 4 hr, respectively. Oxidation was determined by headspace oxygen and peroxide value. Tocopherols prevented the photosensitized oxidation of lard (p<0.05). Steady state kinetic study showed that $\alpha$-, $\beta$-, $\gamma$-, and $\delta$-tocopherol prevented the photosensitized oxidation of lard by quenching singlet oxygen. Singlet oxygen quenching rates of $\alpha$-, $\beta$-, $\gamma$-, and $\delta$-tocopherol by headspace oxygen depletion were 1.86, 2.39, 2.47, and $2.11{\times}10^7/M/sec$, respectively. The quenching rates of $\alpha$-, $\beta$-, $\gamma$-, and $\delta$-tocopherol by peroxide value were 1.42, 1.11, 0.97, and $0.42{\times}10^7/M/sec$, respectively. The quenching rates of tocopherols were slightly different depending on the measurements of oxidation.

• 대한화학회지
• /
• 제5권1호
• /
• pp.80-83
• /
• 1961

Solution of the diffusion problem applicable to steady state reduction at the ideal streaming mercury electrode are presented, with special attention being given to the influence of stream contraction caused by the gravity. To eliminate the convection occurring in the layer between the streaming mercury and the electrolytic solution, a new method have been invented, in this case the solution being tested was streamed with same velocity of the streaming mercury. Experiment have been made in order to compare the experimental value with the theoretical value and the experimental diffusion current was approached more to the theoretical value than the value obtained by earlier form of the streaming mercury electrode used by Heyrovsky.

• Journal of Electrical Engineering and Technology
• /
• 제3권1호
• /
• pp.79-87
• /
• 2008

This paper proposes the design and implementation of a direct torque controlled induction motor drive system. The method is based on control of decoupling between amplitude and angle of reference stator flux for determining reference stator voltage vector in generating PWM output voltage for induction motors. The objective is to reduce electromagnetic torque ripple and stator flux droop which result in a decrease in current distortion in steady state condition. In addition, the proposed technique provides simplicity of a control system. The direct torque control is based on the relationship between instantaneous slip angular frequency and rotor angular frequency in adjustment of the reference stator flux angle. The amplitude of the reference stator flux is always kept constant at rated value. Experimental results are illustrated in this paper confirming the capability of the proposed system in regards to such issues as torque and stator flux response, stator phase current distortion both in dynamic and steady state with load variation, and low speed operation.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2004년도 전력전자학술대회 논문집(2)
• /
• pp.799-802
• /
• 2004

There are many methods in controlling inverter's voltage and currents. most of all, PI control method is a general method. PI control has some merits. But, PI control has zero effect. So, steady-state response errors always exist by the zero effect. For removing the steady-state error, This paper presents the modeling, design and analysis of the double loop feedback control scheme. and computing the value of parameters and applying In the single-phase full bridge inverter for comparison and analysis between the PI control and PDFF control. The system model is employed to examine the dynamics of power circuit and select appropriate feedback variables for stable operation of the closed-loop UPS inverter system. It analyzes and proves the output characteristic of inverter system with the PDFF control.

• 대한기계학회:학술대회논문집
• /
• 대한기계학회 2000년도 춘계학술대회논문집B
• /
• pp.252-257
• /
• 2000

An efficient method is developed for mold thermal cycle analysis in repeated forming process, which is well suited to the analysis in TV glass production. plunger, which is a mold to press-form the glass, undergoes temperature fluctuation during a cycle due to the repeated contact and separation from the glass, which attains a cyclic steady state in the end. If analyzed straightforwardly of this problem, it leads to more than 80 cycles to get reasonable solution, and it is yet hard to setup stopping creteria due to extremely slow convergence. An exponential fitting method is proposed to solve the problem, where an exponential function is found to best approximate temperature values of 3 consecutive cycles, and new cycle is restarted with the function value at infinite time. From numerical implementation, it is found that the method reduces the number of cycles dramatically to only $6{\sim}15$ cycles to reach accurate solution within $1^{\circ}$ error. A system for the analysis is contructed, in which the thermal analysis is performed by commercial software ANSYS, and the fitting of the result is done by IMSL library.

• 대한수의학회지
• /
• 제13권1호
• /
• pp.79-83
• /
• 1973

Every month of pregnancy, vaginal smears were obtained from 42 dairy cows, and an attempt was made to correlate the cell picture with the stage of pregnancy. The results obtained in this work were summerized as follows: 1. At early pregnancy, most of the cells in the smears were the cells with normal nucleus and cytoplasm, and leucocytes. After the first month of pregnancy there was a progressive decrease in the rate of appearance of the cells with normal nucleus and cytoplasm, which dropped to the lowest value at the third month of pregnancy, thereafter, showing steady state. 2. After the first month of prgnancy the rate of appearance of the cells with karyolysis began to increase gradually, and reached a maximum at the fifth month of pregnancy, returning towards initial levels. 3. The rate of appearance of the cells with karyopyknosis was much lower at early pregnancy, but at the third month of pregnancy there was a rapid increase, thereafter, showing steady state (ranging from 20 to 50 percent). 4. The non-nucleated cornified cells, the cells with vacuolized cytoplasm, and the cells with swollen nucleus and cytoplasm were appeared much fewer or not, and significant changes were not recognized during pregnancy. 5. At early pregnancy there appeared many of leucocytes but dropped intensively at the third month of pregnancy, and, thereafter, appeared much fewer or not.

• 상하수도학회지
• /
• 제10권4호
• /
• pp.119-126
• /
• 1996

Influence factors and efficiency characteristics for treatment of wastewater containing phenol were studied with using Pseudomonas sp. B3. It took 130 hours to remove phenol, when only activated sludge of terminal disposal palnt of sewage was innoculated in batch culture, but it was required just 36 hours, when bacteria degrading phenol and activated sludge were simultaneously innoculated. If only phenol an carbon source was used, it necessary 36 hours for biodegradation of phenol, while glucose was added to medium, it took 73 hours. It was revealed as excellent effluent and SVI, when the F/M ratio, COD and phenol concentration were 53mg/l and 1.2mg/l, respectively, and optimum F/M ratio was revealed 0.31. The reactor were seriously shocked as reducing hydraulic retention time at constant phenol concentration more than increasing phenol concentration at constant hydraulic retention time, when volumetric loading rate was increased to $0.8kg\;phenol/m^3{\codt}d$ from $1.6kg\;phenol/m^3{\codt}d$. And also the effluent phenol concentration was 34mg/l after starting 12 hours of shocking and reactor was recovered as steady state after 65 hours of changing in the former test. Although the effluent phenol concentration was maximum value with 12mg/l after starting 20 hours of shocking and reactor was recovered as steady state after 54 hours of changing in the later test.

• E2M - 전기 전자와 첨단 소재
• /
• 제10권4호
• /
• pp.342-348
• /
• 1997

In this paper, the behavior of electron swarm parameters and energy distribution function of the discharge under high E/N condition in e$^{-10}$ -CF$_{4}$ gas have been analysed over the E/N range from 1-300(Td) by the MCS and BEq methods using set of electron collision cross section determined by the authors. The swarm parameters and energy distribution function have been calculated for the pulsed Townsend, steady-state Townsend and Time of Flight methods. The results gained that the value of electron swarm parameters such as the electron drift velocity, the electron ionization and attachment coefficients and longitudinal diffusion coefficients in agreement with the experimental and theoretical data for a range of E/N. The electron energy distribution function has been explained and analysed in e$^{-10}$ -CF$_{4}$ at E/N : 5, 10, 100, 200, 300(Td) for a case of the equilibrium region in the mean electron energy and respective set of electron collision cross sections. The validity of the results has been confirmed by TOF and SST methods.

• Journal of Advanced Marine Engineering and Technology
• /
• 제23권2호
• /
• pp.140-149
• /
• 1999

This study is on the development of the computer program that calculates a 3-D hull temperadistribution and analyzes BOR(Boil off rate) to be important to the heat design of a membrane type LNG carrier. The quarter of a tank is taken as an calculation model. And the thermal conductivity of insulation is assumed to be the function of a temperature. In the present steady state calculation, the temperature of LNG in a cargo tank is assumed to be -$162^{\circ}C$ and the air temperature of a cofferdam, to be +$5^{\circ}C$. The lowest air temperature in compartments is calculated as $21.39^{\circ}C$ under the USCG condition ($T_{air}=-18^{\circ}C,\;T_{sw}=O^{\circ}C)$ and B.O.R value is O.0977%/day under the maximum boil-off condition, IMO IGC ($T_{air}=45^{\circ}C,\;T_{sw}=32^{\circ}C$), which satisfies the requirement by KOGAS. The calculated temperature distribution over tank panels at each condition is maximum 3% less than GTT's results. From the results of this study, it can be concluded that the present design of LNG cargo tank satisfies the requirement by KOGAS.