• Journal of Food Hygiene and Safety
• /
• v.20 no.2
• /
• pp.73-76
• /
• 2005

Center for Food Standard Evaluation, Korea Food and Drug AdministrationThis study was performed to compare analytical methods of nine synthetic food colors and six food color lakes in Korea, Japan, Joint FAO/WHO Expert Committee of Food Additives (JECFA), and USA. The experimental protocol of this study consists of three parts: titration method with titanium chloride, gravimetric and spectrophotometric method. To measure the total contents of food colors, Korea and Japan used titration method with titanium chloride, USA used the average value of titration method with titanium chloride equipped with Kipp generator and spectrophotometric method. Also, JECFA used titration method with titanium chloride equipped with KiPP generator. However, All the low organizations used gravimetric method to measure the total content of coloring matter on Food Red No.3. Although all organizations use various methods for analysis of coloring matters, total contents of coloring matter on food colors tested fell into the standard showing $85.08-96.40\%$ in synthetic food colors and $10.00-36.86\%$ in food color lakes.

• Imaging Science in Dentistry
• /
• v.32 no.3
• /
• pp.147-151
• /
• 2002

Purpose: To compare the standard deviation of gray levels on digital subtracted images obtained by different dental subtraction programs. Materials and Methods: Paired periapical films were taken at the lower premolar and molar areas of the phantoms involving human mandible. The bite registration group used Rinn XCP equipment and bite registration material, based on polyvinyl siloxane, for standardization. The no bite registration group used only Rinn XCP equipment. The periapical film images were digitized at 1200 dpi resolution and 256 gray levels by a flat bed scanner with transparency unit. Dental digital subtraction programs used for this study were Subtractor (Biomedisys Co., Korea) and Emago (Oral Diagnostic Systems, The Netherlands). To measure the similarities between the subtracted images, the standard deviations of the gray levels were obtained using a histogram of subtracted images, which were then analyzed statistically. Results: Subtracted images obtained by using the Emago program without manual selection of corresponding points showed the lowest standard deviation of gray levels (p<0.01). And the standard deviation of gray levels was lower in subtracted images in the group of a bite registration than in the group of no use of bite registration (p < 0.01). Conclusion: Digital radiographic subtraction without manual selection of reference points was found to be a convenient and superior method.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.02a
• /
• pp.181-181
• /
• 2012

The microwave probe for measuring plasma density is widely used for its advantages: First, it is not affected by the reactive gas. Second, it can measure local plasma parameters such as plasma density, plasma potential and plasma temperature. Third, it is simple and robust. A cut-off probe is the one of the most promising microwave probe. Recently, Kim et al. reveals the physics of the cut-off probe but the effect of the sheath on the determination of the plasma density is not explained. In this presentation, for taking account of sheath effects on determination of plasma density from the cut-off peak, a simplified circuit modeling and an E/M simulation are conducted. The results show that occupation ratio of sheath volume between two tips of the cut-off probe and subsequence pressure condition mainly change position of the cut-off peak with respect to plasma frequency. Magnitude of relative voltage taken on the impedance of sheath and the impedance of bulk plasma can explain this effect. Furthermore, effects of gap size, tip radius, and tip length ware revealed based on above analysis.

• Journal of Korean Clinical Nursing Research
• /
• v.23 no.1
• /
• pp.54-63
• /
• 2017

Purpose: The purpose of this study was to compare the working status and Standard Shiftwork Index (SSI) between night shift-fixed nurses and rotating shift nurses. Methods: Participants were 367 nurses working as registered nurses at 7 different medical institutions. The data were collected from August 8, 2016 to September 30, 2016. Results: Night shift fixed nurses were more satisfied with work schedule than rotating shift nurses. Rotating shift nurses reported higher SSI scores, such as chronic fatigue, musculoskeletal problems, than night shift fixed nurses. In SSI's sub-items, rotating shift nurses reported higher scores, such as the amount of sleep, feeling well after sleep, heartburn or stomach-ache and heartbeat irregularities, than night shift fixed nurses. Conclusion: The results indicated that night shift fixed system might be an effective method to improve nurses' work satisfaction. It is necessary to figure out any suitable night shift fixed system based on the characteristics of each nursing organization. The SSI might be an useful tool to measure the nurses' satisfaction in reference to their work shift.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.44 no.1
• /
• pp.18-23
• /
• 2007

In this paper, LPDA standard antenna for measuring DTV signal strength is developed. Duralumin material is used to fabricate antenna having mechanical strength and flexibility. Operating frequency of designed antenna is range from $450{\sim}850$MHz and its gain is greater than 10 dBd to satisfy FCC requirements. Experimental results show that the developed antenna has minimum 10 dBd gain (average 11.7 dBd) over the entire frequency region and has ${\pm}1.5$ dB pass band ripple characteristic, From the results, the developed antenna is well adequate for standard antenna to measure DTV signal strength.

• KIEAE Journal
• /
• v.10 no.5
• /
• pp.181-186
• /
• 2010

Research on construction waste unit was in progress in the 1995 when 'Proper Disposal and Recycling Measures for Construction Waste' was made by the Seoul Development Institute. Such an effort has been made in order to cope with the lack of natural resources in Korea and to utilize the reusable resources. Furthermore, these efforts have also increased due to the improved standing of Korea in the international community. A large number of residential buildings were built in the response to the government's policy by increasing the supply of houses between the 1970's and 1980's. In 2000, more reconstruction and redevelopment was done because of the aged buildings and change of use for those buildings. And the project has been actively promoted until now, which caused a sharp increase in the generation volume of construction waste. In Korea, 8 kinds of construction waste unit, including the standard construction manpower and materials estimation, are introduced. Currently, they provide standards to different building categories and waste properties while for construction sites different standards are applied. This study aims to measure the actual amount of construction waste after sample buildings are dismantled and analyzes the estimation of the waste quantity by using various standard units. Through comparison, this study will figure out the differences among the standard units in order to find out how to apply the standard units properly. Moreover, this research will provide practical measures to apply such units to construction sites.

• Nuclear Engineering and Technology
• /
• v.56 no.7
• /
• pp.2698-2703
• /
• 2024

A bilateral comparison was conducted between the International Atomic Energy Agency (IAEA) and the Korea Research Institute of Standards and Science (KRISS) to measure the absorbed dose to water in accelerator photon beams. KRISS served as a linking laboratory to compare the IAEA standard with the key comparison reference value (KCRV) of the BIPM.RI(I)-K6 program, in which KRISS participated in 2017. Two ionization chambers from the IAEA were used as transfer instruments for the comparison. Both laboratories measured the calibration coefficients of these instruments and calculated the ratios. The ratio of the KRISS standard to the KCRV was applied to obtain the degree of equivalence of the IAEA, along with its uncertainty. The largest deviation of the IAEA measurement from the KCRV was 3.4 mGy/Gy, significantly smaller than the expanded uncertainty of 10.7 mGy/Gy (k = 2, 95% level of confidence). This study demonstrates the equivalence of IAEA's measurement standard for accelerator photon beams to other primary standard dosimetry laboratories. It provides evidence for the satisfactory operation of IAEA's quality management system and enhances the international credibility of the IAEA SSDL network, particularly in high-energy accelerator photon beams from linear accelerators.

• Journal of Korean Library and Information Science Society
• /
• v.45 no.4
• /
• pp.185-205
• /
• 2014

This study investigated IRA's 3 standards related to reading instruction and examined the value which can be meaningful to Korean situation. IRA divided reading educators into 7 types and proposed each detailed professional standard through the 'Standards for reading professionals'. The next standard called 'Standards for the English language art' described their direction and content for English language education including reading instruction. The 'Standards for the assessment of reading and writing' aims at the basis to evaluate students' reading ability. The value found through these standards is as follow: IRA's reading professionals standard can be a useful way to define the type of reading educator in Korea. A reading instruction standard like IRA's language art standard can guide reading instruction of Korean libraries in a more systemic and consistent way. A valid evaluation standard to measure students' reading ability can show the possibilities to define the students who struggle with reading and to provide more suitable instruction for them.

• Korea Trade Review
• /
• v.44 no.1
• /
• pp.177-191
• /
• 2019

Global trade protectionism has increased further and U.S. priorities and protectionism have strengthened since Trump took office in 2017. Trump administration is actively implementing tariff measures based on U.S. domestic trade laws rather than the WTO rules and regulations. In particular, the American government has recently been imposing high tariffs due to national security and imposing economic sanctions on other countries' imports. According to the U.S. Trade Expansion Act Section 232, the American government imposed additional tariffs on steel and aluminum imports to WTO member countries such as China, India, and EU etc. on march 15, 2018. Thus, this study aims to investigate whether the U.S. Trade Expansion Act Section 232 is consistent with GATT/WTO rules by comparing the legal basis of US / China / WTO regulations related to Section 232 of the U.S. Trade Expansion Act, and gives some suggestions for responding to the Section 232 measure. As the Section 232 measure exceeded the scope of GATT's Security Exceptions regulation and is very likely to be understood as a safeguard measure. If so, the American government is deemed to be in breach of WTO's regulations, such as the most-favored-nation treatment obligations and the duty reduction obligations. In addition, American government is deemed to be failed to meet the conditions of initiation of safeguard measure and violated the procedural requirements such as notification and consultation. In order to respond to these U.S. protection trade measures, all affected countries should actively use the WTO multilateral system to prevent unfair measures. Also, it is necessary to revise the standard jurisdiction of the dispute settlement body and to explore the balance of the WTO Exception clause so that it can be applied strictly. Finally, it would be necessary for Chinese exporters to take a counter-strategy under such trade pressure.

• Journal of architectural history
• /
• v.27 no.5
• /
• pp.7-16
• /
• 2018

This study investigated the dimensional plan of Kor Sork temple in Preah Pithu complex, Angkor by civil surveying, 3D scan, measured integer ratio and regularity. According to epitaph and preceding researches, Khmer temples were built based on structural planing with the constant ratio and regularity by using special construct measure scales "Hasta" and "Byama". The study assumed the same unit method was applied in Kor Sork temple and identified the regularity of actual measurement value about the temple. The assumed construct measure scale (Hasta) used for the design of this temple is 413mm. The overall apart arrangement of the temple is different in the East-West direction and the North-South direction. In the East-West direction, the whole scale is 180 hasta, and it is divided into 20 hastas. On the other hands, it was confirmed that the North-South direction is 96 hasta and it was divided four quadrants in 24 hastas. Regarding the detailed design, the regularity according to the constant ratio was confirmed. 7 hasta was used as the basic unit on the first floor and 6 hasta were used as the basic unit on the second floor of the terrace. the basement and the central sanctuary is of 6 hasta and 8 hasta were used as the basic standard.