• Korean Journal of Materials Research
• /
• v.20 no.12
• /
• pp.676-680
• /
• 2010

Most TCOs such as ITO, AZO(Al-doped ZnO), FTO(F-doped $SnO_2$) etc., which have been widely used in LCD, touch panel, solar cell, and organic LEDs etc. as transparent electrode material reveal n-type conductivity. But in order to realize transparent circuit, transparent p-n junction, and introduction of transparent p-type materials are prerequisite. Additional prerequisite condition is optical transparency in visible spectral region. Oxide based materials usually have a wide optical bandgap more than ~3.0 eV. In this study, single-phase transparent semiconductor of $SrCu_2O_2$, which shows p-type conductivity, have been synthesized by 2-step solid state reaction at $950^{\circ}C$ under $N_2$ atmosphere, and single-phase $SrCu_2O_2$ thin films of p-type TCOs have been deposited by RF magnetron sputtering on alkali-free glass substrate from single-phase target at $500^{\circ}C$, 1% $H_2$/(Ar + $H_2$) atmosphere. 3% $H_2$/(Ar + $H_2$) resulted in formation of second phases. Hall measurements confirmed the p-type nature of the fabricated $SrCu_2O_2$ thin films. The electrical conductivity, mobility of carrier and carrier density $5.27{\times}10^{-2}S/cm$, $2.2cm^2$/Vs, $1.53{\times}10^{17}/cm^3$ a room temperature, respectively. Transmittance and optical band-gap of the $SrCu_2O_2$ thin films revealed 62% at 550 nm and 3.28 eV. The electrical and optical properties of the obtained $SrCu_2O_2$ thin films deposited by RF magnetron sputtering were compared with those deposited by PLD and e-beam.

• Progress in Superconductivity
• /
• v.14 no.2
• /
• pp.110-115
• /
• 2012

Samples with nominal compositions of $RuSr_2(Eu_{1.34-x}Tb_xCe_{0.66})Cu_2O_z$ (x = 0, 0.67) were prepared and their superconductivity and magnetic properties were compared to shed light on the effect of Tb substitution for Eu. X-ray diffraction measurements indicate that the Tb substitution resulted in a decrease in both a and c lattice parameters in consistent with ionic size difference between Eu and Tb. Contrary to the Tb-free sample, no superconducting transition behavior is observed in the Tb-sustituted sample. It is also found that the Tb substitution for Eu significantly increases the weak-ferromagnetic component of the field-cooled magnetic susceptibility as well as an increase in the magnetic ordering temperature. These results suggest that the magnetic state of the Ru sublattice is significantly affected by the Tb substitution for Eu.

• Journal of Sensor Science and Technology
• /
• v.32 no.4
• /
• pp.238-245
• /
• 2023

0.75(Bi_1/2Na_1/2)TiO₃-0.25SrTiO₃ (BNT-25ST) ceramics with high densities were successfully prepared at a sintering temperature of 1,000℃ by adding a mixture of 1 mol% CuO and 0.5 mol% Na₂CO₃ or 0.5 mol% CuO and 0.25 mol% Na₂CO₃. Double polarization-electric field (P-E) hysteresis curves and sprout-shaped bipolar strain-electric field (S-E) hysteresis curves with small negative strains were observed in the pristine and CuO-added BNT-25ST ceramics whereas the Na₂CO₃-added sample showed similar P-E and S-E curves to a typical ferroelectric. The pristine BNT-25ST ceramics showed an extremely large strain and a large-signal piezoelectric strain constant (d₃₃^*): 0.287 % at 80 kV/cm and 850 pm/V at 20 kV/cm. Similar values, 0.248 % at 80 kV/cm and 655 pm/V at 20 kV/cm, were obtained in the CuO-added sample. However, the pristine and CuO-added samples showed large hysteresis in unipolar S-E curves at an electric field of less than 20 kV/cm. The Na₂CO₃-added sample showed smaller values of the strain and d₃₃^* but displayed a linear change and small hysteresis in the unipolar S-E curve. The co-added sample with CuO and Na₂CO₃ displayed intermediate P-E and S-E hysteresis curves.

• Economic and Environmental Geology
• /
• v.34 no.3
• /
• pp.283-299
• /
• 2001

The middle cover soils and clay liners collected from the Kumheung landfill in Gongiu City were analysed for As, Ba, Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb, Sr, Ti and Zn concentrations using 0.] N HCl digestion and total/sequential extraction experiments followed by ICP-AES determination. The uncontaminated soil and sediment samples were also analyzed for the comparison. The results of sequential extraction showed that Cu was dominant in the oxidizable fraction, and As, Ni, Sr, Ba, and Mn were in the exchangeable fraction. Zinc and Mn occurred mostly in association with reducible, residual and carbonate fractions. Most of Cd and Pb were bound to the reducible and oxidizable fractions. The main carrier of Co, Cr, Fe and 11 was the residual fraction and another important carrier was the reducible fraction. The percentage of the metals of organically-bound form in the middle cover soils and clay liner was in the order of Cu(48%) > Ti(42%) > Pb(27%) > As(25%) > Cd(20%). As deduced from sequential extraction analysis, potential order of metal mobility in the middle cover soils and clay liner from the landfill was proposed: Cd > Sr > As > Ni > Mn > Ba > Cu > Pb > Zn » Co > 11 > Fe > Cr. Based on the 'geoaccumulation index' and the 'enrichment factor' normalized to A], the level of contamination of Cu, Ni and C1' was significant in the samples from Kumheung landfill and surrounding farmland. Their enrichments were attributed partly to anthropogenic pollutions.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 1988.10a
• /
• pp.98-101
• /
• 1988

The material system (Bi$\sub$0.7/Pb$\sub$0.3/)Sr$_1$Ca$_1$Cu$\sub$1.8/Ox forms, at 845$^{\circ}C$, two major phases having a high Tc(100K) and a low Tc(∼70K) both of which consists of platelets and a non-superconducting minor phase which has rod-like shape and isolated by the major phases. As the sintering period increases, the amount of high Tc phase increases accompanying the decrease in low Tc phase while the amount of the non-superconducting phase is sintering period independent, resulting in a superconductor with Tc of 100K. Changes in compositions of each phase also occur during sintering due to evaporation of bismuth and lead.

• Journal of Environmental Science International
• /
• v.25 no.12
• /
• pp.1613-1622
• /
• 2016

Zeolite (FZ), prepared from fly ash, was immobilized with polyacrylonitrile (PAN) to fabricate PAN/FZ beads. The prepared PAN/FZ beads were characterized by scanning electron microscopy, thermogravimetric analysis, and Fourier transform infrared spectroscopy. The optimum ratio to prepare PAN/FZ beads was 0.3 g of PAN to 0.3 g of FZ. The diameter of the prepared PAN/FZ beads was about 3 mm. Sr and Cu ion adsorption experiments were conducted with PAN/FZ beads. A pseudo-second-order model fit the kinetic data for Sr and Cu ion adsorption by PAN/FZ beads well. The equilibrium data fitted well with the Langmuir isotherm model, and the maximum adsorption capacities were 96.5 mg/g and 74.6 mg/g for the Sr and Cu ions, respectively. Additionally, the values of thermodynamic parameters such as Gibbs free energy (${\Delta}G^o$), enthalpy (${\Delta}H^o$) and entropy (${\Delta}S^o$) were determined. The positive values of ${\Delta}H^o$ revealed the endothermic nature of the adsorption process and the negative values of ${\Delta}G^o$ were indicative of the spontaneity of the adsorption process.

• Journal of Environmental Science International
• /
• v.25 no.12
• /
• pp.1623-1632
• /
• 2016

Zeolite (FZ) prepared using coal fly ash from an Ulsan industrial complex was immobilized with polysulfone (PS) to fabricate PS-FZ beads. The prepared PS-FZ beads were characterized by scanning electron microscopy and Fourier transform infrared spectroscopy. The optimum ratio for preparing PS-FZ beads was 1 g of PS to 2 g of FZ. The removal efficiencies of Sr and Cu ions by the PS-FZ beads increased as the solution pH increased and nearly reached a plateau at pH 4. A pseudo-second-order model morel fit the adsorption kinetics of both ions by the PS-FZ beads better than a pseudo-first-order model. The Langmuir isotherm model fit the equilibrium data well. The maximum adsorption capacities calculated from the Langmuir isotherm model were 46.73 mg/g and 62.54 mg/g for the Sr and Cu ions, respectively. Additionally, the values of thermodynamic parameters such as free energy (${\Delta}G^{\circ}$), enthalpy (${\Delta}H^{\circ}$) and entropy (${\Delta}S^{\circ}$) were determined. The results implied that the prepared PS-FZ beads could be interesting an alternative material for Sr and Cu ion removal.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2012.08a
• /
• pp.169-169
• /
• 2012

The high-temperature superconductor YBa2Cu3O7-x (YBCO) have attached attentions because of a high superconducting transition temperature, low surface resistance, high superconducting critical current density (Jc), and superior superconducting capability under magnetic field. Moreover, the Jc of YBCO superconductors can be enhanced by adding impurities to the YBCO films for vortex-pinning. Understanding and controlling pinning centers are key factors to realize high Jc superconductors. We synthesized vertically-aligned ZnO nanorods on SrTiO3 (STO) substrates by catalyst-free metal-organic chemical vapor deposition (MOCVD), and subsequently, deposited YBCO films on the ZnO nanorods/STO templates using pulsed laser deposition (PLD). The various techniques were used to analyze the structural and interfacial properties of the YBCO/ZnO nanorods/STO hybrid structures. SEM, TEM, and XRD measurements demonstrated that YBCO films on ZnO nanorods/STO were well crystallized with the (001) orientation. EXAFS measurements from YBCO/ZnO nanorods/STO at Cu K edge demonstrated that the local structural properties around Cu atoms in YBCO were quite similar to those of YBCO/STO.

• Journal of Radiation Protection and Research
• /
• v.24 no.1
• /
• pp.39-43
• /
• 1999

Thermoluminescent (TL) response characteristics of a thin LiF:Mg,Cu,Na,Si Teflon detectors have been studied for use in beta radiation detection. The detectors were fabricated from a mixture of LiF:Mg,Cu,Na,Si phosphor and Teflon powder which was molded into a thin disk form of $50mg/cm^2$ thickness. These detectors were irradiated to beta fields of $^{147}Pm,\;^{204}Tl\;and\;^{90}Sr/^{90}Y$ sources with a covering of Kapton foil ($2mg/cm^2$) and photon irradiation was carried out with a $^{137}Cs$ source at the Korea Atomic Energy Research Institute (KAERI). Batch uniformity was estimated to be 4.7% and the beta dose response presented linear relationship from 0.1 mGy to 100 Gy. The beta energy responses of thin detectors normalized to $^{137}Cs$ were presented as 0.46, 1.09 and 1.06 for $^{147}Pm,\;^{204}Tl\;and\;^{90}Sr/^{90}Y$ beta rays, respectively. The evaluated values for angular responses were $0.93{\pm}0.03\;(^{147}Pm),\;0.94{\pm}0.04\;(^{204}Tl),\;and\;0.92{\pm}0.05\;(^{90}Sr/^{90}Y)$. The results satisfied well a proposed ISO Standard for beta ray dosimeters.

• Journal of the Korean Society for Heat Treatment
• /
• v.4 no.1
• /
• pp.13-18
• /
• 1991

The formation of high $T_c$ phase is very sluggish and c parameter of unit cell of high $T_c$ phase is about $37{\AA}$. High $T_c$ oxide superconductor with a $T_c$ above 100 K has been successfully prepared by solid state reaction method in BiSrCaCuO system by Pb adding. The microstructure related to the formation of the high $T_c$ phase has been investigated. As compared with YBCO compound, the formation reaction of the high $T_c$ requires long time heat treatment. It is due to the transformation from the low $T_c$ phase to high $T_c$ phase. The sintering just below the melting point of the calcined powder mixture is effective on the formation of the high $T_c$ phase in Pb-added BiSrCaCuO system. The growth of the high $T_c$ superconducting phase has a thin plate shape, which is characterized by the c parameter of $37{\AA}$. The formation of the high $T_c$ phases is delayed by the excessive addition of Pb. The lattice parameter(c) of the unit cell (both the low and high $T_c$ phases) is increased with increase of Pb.