• The Journal of the Acoustical Society of Korea
• /
• v.30 no.3
• /
• pp.115-122
• /
• 2011

In this paper, we present a method to estimate an accurate real-time sound source direction based on time delay of arrival by using generalized cross correlation with four cross-type microphones. In general, existing systems have two disadvantages such as system embedding limitation due to the necessity of data acquisition for signal processing from microphone input, and real-time processing difficulty because of the increased number of channels for sound direction estimation using DSP processors. To cope with these disadvantages, the system considered in this paper proposes hardware design for enhanced real-time processing using microphone array signal processing. An accurate direction estimation and its design time reduction is achieved by means of an efficient hardware design using spatial segmentation methods and verification techniques. Finally we develop a system which can be used for embedded systems using a sound codec and an FPGA chip. According to experimental results, the system gives much faster real-time processing time compared with either PC-based systems or the case with DSP processors.

• Journal of the Korean Institute of Gas
• /
• v.14 no.2
• /
• pp.15-21
• /
• 2010

The demand of gas as an eco-friendly energy source has being increased. With increasing the LPG demand, the number of LPG filling station. In this work, the influence on over-pressure caused by Vapor Cloud Explosion in gas station was calculated by using the Hopkinson's scaling law and injury effect by the accident to a human body was estimated by applying the probit model. As a result of the injury estimation conducted by using the probit model for leakage 10% of 20ton storage tank. The distances from LPG station for death and tympanum rupture are 36.5 and 290 meters, respectively.

• The KIPS Transactions:PartB
• /
• v.9B no.1
• /
• pp.35-46
• /
• 2002

The EEG is a time series of electrical potentials representing the sum of a very large number of neuronal dendrite potentials in the brain. The collective dynamic behavior of neural mass of different brain structures can be assessed from EEG with depth electrodes measurements at regular time intervals. In recent years, the theory of nonlinear dynamics has developed methods for quantitative analysis of brain function. In this paper, we considered it is reasonable or not for ICA apply to EEG analysis. Then we applied ICA to EEG for big toe movement and separated the independent components for 15 samples. The strength of each independent component can be represented on the topological map. We represented ICA can be applied for time and spatial analysis of EEG.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.38 no.2
• /
• pp.6-12
• /
• 2001

When CBR source traffics are loaded to ATM switch and broadband network termination, CTD values of ATM switch and broadband network termination are measured and then the values of CTD in the domestic region arc estimated. The estimation values of CTD satisfy the objective of CTD in the domestic region allocated by allocation rules of 1.356. The peak-to-peak CDV allocation method based On Chernoff accumulation method is proposed and applied to the nodes of national portion. From the result of numerical analysis, the proposed method is more accurate than the equal allocation method for peak -to-peak CDV in case that the CDVs at each node and the number of ATM nodes on the path increase.

• International Journal of Naval Architecture and Ocean Engineering
• /
• v.12 no.1
• /
• pp.819-831
• /
• 2020

Wind load is one of the major design loads for the hull and mooring of offshore floating structures, especially due to much larger windage area above water than under water. By virtue of extreme design philosophy, fully turbulent flow assumption can be justified and the hydrodynamic characteristics of the flow remain almost constant which implies the wind load is less sensitive to the Reynolds number around the design wind speed than wind profile. In the perspective of meteorology, wind profile used for wind load estimation is a part of Atmospheric Boundary Layer (ABL), especially maritime ABL (MBL) and have been studied how to implement the profile without losing turbulence properties numerically by several researchers. In this study, the MBL is implemented using an open source CFD toolkit, OpenFOAM and extended to unstable ABL as well as neutral ABL referred to as NPD profile. The homogeneity of the wind profile along wind direction is examined, especially with NPD profile. The NPD profile was applied to a semi-submersible rig and estimated wind load was compared with the results from wind tunnel test.

• Journal of Environmental Science International
• /
• v.17 no.10
• /
• pp.1069-1073
• /
• 2008

Indoor air quality can be affected by indoor sources, ventilation, decay and outdoor levels. Although technologies exist to measure these factors, direct measurements are often difficult. The purpose of this study was to develop an alternative method to characterize indoor environmental factors by multiple indoor and outdoor measurements. Using a mass balance model and regression analysis, penetration factor (ventilation rate divided by the sum of ventilation rate and deposition constant) and source strength factor (source strength divided by the sum of ventilation rate and deposition constant) were calculated using multiple indoor and outdoor measurements. Subsequently, the ventilation rate and $NO_2$ generation rate were estimated. Mean of ventilation rate was 1.41 ACH in houses, assuming a residential N02 deposition constant of 0.94 $hr^{-1}$. Mean generation rate of $NO_2$ was 16.5 ppbv/hr. According to house characterization, inside smoking and family number were higher $NO_2$ generation rates, and apartment was higher than single-family house. In conclusion, indoor environmental factors were effectively characterized by this method using multiple indoor and outdoor measurements.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.3 no.1
• /
• pp.36-45
• /
• 1998

A simple source voltage clamped resonant link (SVCRL) inverter is proposed to clamp the DC link voltage to the input source voltage and reduce the current rating of resonant inductor. The current control of a permanent magnet synchronous motor (PMSM) using a predictive current control technique (PCCT) employing the SVCRL inverter is also investigated to overcome the disadvantage of the current regulated delta modulation (CRDM) control technique. By using the PCCT based on the discrete model of a PMSM and estimation of back EMF, the minimized current ripple with small number of switchings can be obtained. Finally, the comparative computer simulation and experimental results are given to show the usefulness of the proposed technique.

• Journal of Korean Society for Atmospheric Environment
• /
• v.32 no.2
• /
• pp.158-166
• /
• 2016

To characterize the features of particle apparent density, continuous measurements of particle number size distributions from optical particle sizer (OPS) and 24 hr integrated particle mass concentrations from filter based sampler were conducted at the National institute of environmental research NamBu Supersite (NNBS, $35.22^{\circ}N$, $126.84^{\circ}E$) in Gwangju for 16 days from Nov. 4 in 2014. Source apportionment model was carried out by applying Positive Matrix Factorization (PMF) to particle size distribution data. Three different distributions related to primary and secondary sources were investigated by the diurnal patterns of identified factors. Density estimated by gaussian model has been calculated as $1.69g/cm^3$ with 95% confidence bounds ($1.57{\sim}1.81g/cm^3$).

• Journal of Families and Better Life
• /
• v.24 no.5 s.83
• /
• pp.251-270
• /
• 2006

This study examined how the households used and combined financing sources to pay for college education. It compared the probability of using each source (current incomes, saving, education loans and grants) by households' socio-economic characteristics and analyzed which factors influence the decision to use each source and the amounts from each source for financing college education. Data for this study were from a questionnaire completed by 4-year college students (n=623) and were analyzed by t-tests, ANOVA and Heckman's two-step estimation models. The findings of this study were as follows: First, the most frequent source for college education was parents' savings and the second one was parents' incomes. Also, the most frequent combination of sources was saving and current incomes and the second was combination of three sources, saving, incomes and education loans. Second, the probability of using incomes was higher for younger students than for older students. The number of siblings showed significant differences among income, savings and education loans. Those who had higher incomes were more likely to use current incomes, saving, but less likely to borrow for financing college education. Middle-class income groups were more likely to borrow for education. Third, household incomes and asset holdings had generally positive impacts on the probability of using incomes and savings for college education, while total debt burden decreased both the probability and amounts of income and saving sources. The college costs had significantly positive effects on both the probability and the amounts of all of financing sources. Total grants received significantly decreased the amounts from incomes, savings and borrowing sources.

• Journal of the Korean Society of Surveying, Geodesy, Photogrammetry and Cartography
• /
• v.29 no.4
• /
• pp.381-392
• /
• 2011

Pollutant loads calculated with unit factor method can not identity seasonal variations of pollutant inputs. Estimation of pollutant loads considering rainfall runoff can overcome these limits. SCS curve number method was applied to estimate runoff of each event of Koeup watershed of Koheung estuary lake. SCS curve numbers were calculated based upon land use, soil types of the catchment using GIS. Point and nonpoint source pollutant loads were summed up for total loads estimation. Those from nonpoint source were estimated by multiplying the calculated runoff and expected mean concentrations (EMC) presented by the Minister of Environment of Korea. DEM can present three dimensional views of a terrain, identity stream networks and flow accumulation. Furthermore, it can examine accumulated pollutant loads of specific point of a catchment. Therefore, cell based pollutant load estimation was attempted using DEM. ArcView was utilized to collect, store and manipulate spatial and attribute data of pollutant sources and features of the catchment. Cell-based DEM which was established by the GRID module of ARC/INFO was employed to estimate flows and pollutant loads.