• 한국신재생에너지학회:학술대회논문집
• /
• 한국신재생에너지학회 2006년도 춘계학술대회
• /
• pp.597-601
• /
• 2006

The advantages of solar energy are that it is renewable, infinite supplied and environmentally safe energy source. However, solar energy related products have the problems such as the limitation for installation, problems in maintenance and insufficient reliability which have been the barrier to consumers to satisfy the purchase need for solar heat related products. In this regard, in order to support the solar energy related companies the necessity for various technical information required for the commercialization of new products such as various performance test necessary for the certification of solar energy system, standardization for facilities and products, performance evaluation method and the measurement of performance is suggested. The purpose of this paper is to design the monitoring system for positive tests of system linked household hot water system using solar heat out of various solar energy systems, to establish an analysis and monitoring system for performance maintenance and operation technique, and to configure the centralized detection network by utilizing remote monitoring system. This research also aims at conducting monitoring for operation and performance evaluation in relation to database establishment and analytical evaluation and at describing the method of enhancing the reliability of solar energy system through the development of performance evaluation program.

• 대한설비공학회지:설비저널
• /
• 제13권4호
• /
• pp.230-236
• /
• 1984

This paper presents a method for estimating the useful output of solar D.H.W. system. Heating load calculations, climate data and various conditions are used in this procedure to assess the fraction of the monthly solar energy and the actual solar energy supplied by solar energy for particular system. The design procedure presented in this paper referred to the f-Chart Method. The results of analyzing of this study by Fortran programming are as follows ; 1 . The amount of actual solar energy required to the hot water system is slowly rised to the ascend of tilt angle within the range of $45^{\circ}$, with is decreased since $45^{\circ}$. 2. The fraction of solar energy is superior when collector area is $8.64m^2$. 3. At the tilt angle with the range of $37.6^{\circ}\~45^{\circ}$, the amount of actual solar energy established the best results. 4 Both the fraction of solar energy and the actual solar energy are the most suitable during the storage volume is $300{\iota}$.

• 동굴
• /
• 제89호
• /
• pp.27-33
• /
• 2008

Solar energy is most green and clean, unlimited and sustainable energy source on the earth. It is almost 97% of imported consumer energy in Korea. Because of resource poor nation, it is necessary to do their best to make alternative energy to allot their deficiency of the matter in hand of energy resources of petroleum. In a point of view of this problems, the natural solar energy should be improved by any methods as much, possible as we need. Photovoltaic generation with solar tracking system for obtaining optimal power is one of most benefit equipment to improve power of solar-cell panel producing clean electric power efficiently. Solar tracker is a device for orienting a solar photovoltaic panel toward the sun perpendicularly to sunlight, especially in widely separated place. For this reason, we are very interested in developing the equipment system of tracker, specially in solar cell applications, obtaining a high degree of accuracy to ensure that the optimal sunlight could be directed precisely against to the powered device. As a result, it was obtained of 12.46 volts at 90$^\circ$toward solar panel and 9.44 volts at 45$^\circ$, furthermore, improved efficiency more than 30% of average output voltage between tracker system (12.41V) and fixed system (8.55V), respectively. It is also very useful for optimum power system of widely separated cave.

• 한국태양에너지학회 논문집
• /
• 제32권3호
• /
• pp.68-76
• /
• 2012

Since the solar energy resource is the main input for sizing any solar energy utilization system, it is essential to utilize the solar radiation data as an application and development of solar energy system increase. It will be necessary to understand and evaluate the insolation data. The Korea Institute of Energy Research(KIER) has begun collecting horizontal global insolation data since May, 1982 at 16 different locations in Korea and for the more detailed analysis, images taken by geostationary satellite may be used to estimate solar irradiance fluxes at earth's surface. It is based on the empirical correlation between a satellite derived cloud index and the irradiance at the ground. From the results, the measured data has been collected at 16 different stations and estimated using satellite at 44 different stations over the Korean peninsula from 1982 to 2010. The Result of analysis shows that the annual-average daily global radiation on the horizontal surface is 3.66 $kWh/m^2/day$ and estimated solar radiation fluxes show reliable results for estimating the global radiation with average deviation of -7.2 to +3.7 % from the measured values.

• 한국태양에너지학회:학술대회논문집
• /
• 한국태양에너지학회 2011년도 춘계학술발표대회 논문집
• /
• pp.223-228
• /
• 2011

The volumetric solar receiver is a key element of solar power plants using air. The solar flux distribution inside the receiver should be a priori known for its heat transfer modeling. Previous works have not considered characteristics of the solar flux although they change with radiative properties of receiver materials and receiver geometries. A numerical method, which is based on the Monte Carlo ray-tracing method, was developed in the current work. The solar flux distributions inside multi-channeled volumetric solar receivers were calculated when light is concentrated at the KIER solar furnace. It turned out that 99 percentage of the concentrated solar energy is absorbed within 15 mm charmel length for the charmel radius smaller than 1.5 mm. If the concentrated light is assumed to be diffuse, the absorbed solar energy at the charmel entrance region is overpredicted while the light penetrates more deeply into the charmel. The developed method will help understand the solar flux when only a part of concentrated light is of interest. Furthermore, if the presented results are applied for heat transfer modeling of multi-channeled volumetric solar receivers, one could examine effects of receiver charmel properties and shape on air temperature profiles.

• 한국태양에너지학회 논문집
• /
• 제29권2호
• /
• pp.47-54
• /
• 2009

The amount of incident rays over inclination according to direction has been widely utilized as important data m installing solar thermal systems. To optimize the incident solar radiation, the slope, that is the angle between the plane surface in question and the horizontal, and the solar azimuth angles are needed for these solar thermal systems. This is because the performance of the solar thermal systems in much affected by angle and direction of incident rays. Recognizing that factors mentioned above are of importance, actual experiment on the moving route of the sun have been performed in this research to obtain the angle of inclination with which the maximum incident rays can be absorbed. After all, the standard for designing highly optimized solar thermal systems will be provided for designers and employees working in the solar collector related industries.

• 한국태양에너지학회 논문집
• /
• 제21권4호
• /
• pp.73-83
• /
• 2001

Since the solar radiation is the main input for sizing any solar system, it will be necessary to understand and evaluate the insolation data. The horizontal global insolation data have been measured since May, 1982 and direct normal solar insolation data since December 1990 at 16 different sites all over the country and considerable effort has been made for constructing a standard value from measured data at each station. In the results, the average global total solar radiation of the nation is $3,055kcal/m^2.day(12.79MJ/m^2.day)$ and the average clear day direct normal solar beam radiation was $4,600kcal/m^2.day(19.26MJ/m^2.day)$, which indicates possible solar energy application of medium and high temperature technologies with high concentration.

• 한국태양에너지학회 논문집
• /
• 제37권5호
• /
• pp.39-47
• /
• 2017

In a hot water system using solar energy, solar heat is not simply collected by the heat collecting plate, but by heat exchange between the solar collector (flat or vacuum type) and the hot water storage tank. Therefore, the amount of collected solar energy depends on the hot water usage patterns that determine the temperature of the thermal storage tank. Also, if the temperature of the hot water stored in the storage tank exceeds the dangerous temperature during the summer, the heat must be released for safety. If the temperature of the hot water in the storage tank is low, it is necessary to heat by the auxiliary heat source. In this study, three buildings are defined as hotel, swimming pool, and school facilities. And we calculated the released heat energy, auxiliary heat source, and pure storage heat energy based on different hot water usage patterns and installation angle of the solar collectors.

• 태양에너지
• /
• 제12권1호
• /
• pp.103-108
• /
• 1992

• 태양에너지
• /
• 제11권3호
• /
• pp.89-95
• /
• 1991