• Journal of the Korean Geosynthetics Society
• /
• v.11 no.1
• /
• pp.35-45
• /
• 2012

Dynamic characteristics of decomposed granite soil mixed with stone sludge and bentonite were investigated to figure out adequate applications of stone sludge, A total of 16 specimens with different stone sludge contents of 0%, 5%, 10%, 15% and bentonite with 0%, 5%, 10%, 15% were prepared. Resonant column tests were carried out on each specimen at different confining pressure. The results showed that the optimum mixing ratio which can satisfy the maximum shear modulus and the minimum damping ratio of the decomposed granite soils ranges from 5% to 10% respectively.

• Geomechanics and Engineering
• /
• v.15 no.1
• /
• pp.659-668
• /
• 2018

A series of direct shear tests were implemented on three different types of specimens (i.e., clean Perth sand, sand containing 10, 20 and 30% bentonite, sand containing 1, 3 and 5% slag, and sand containing 10, 20 and 30% bentonite with increasing percentages of added slag (1%, 3% and 5%). This paper focuses on the shear stress characteristics of clean sand and sand mixtures. The samples were tested under different three normal stresses (100, 150 and 200 kPa) and three curing periods of no curing time, 7 and 14 days. It was observed that the shear stresses of clean sand and mixtures were increased with increasing normal stresses. In addition, the use of slag has improved the shear strength of the sand-slag mixtures; the shear stresses rose from 128.642 kPa in the clean sand at normal stress of 200 kPa to 146.89 kPa, 154 kPa and 161.14 kPa when sand was mixed with 1%, 3% and 5% slag respectively and tested at the same normal stress. Internal friction angle increased from $32.74^{\circ}$ in the clean sand to $34.87^{\circ}$, $37.12^{\circ}$ and $39.4^{\circ}$ when sand was mixed with 1%, 3% and 5% slag respectively and tested at 100, 150, and 200 kPa normal stresses. The cohesion of sand-bentonite mixtures increased from 3.34 kPa in 10% bentonite to 22.9 kPa, 70.6 kPa when sand was mixed with 20% and 30% bentonite respectively. All the mixtures of clean sand, different bentonite and slag contents showed different behaviour; some mixtures exhibited shear stress more than clean sand whereas others showed less than clean sand. The internal friction angle increased, and cohesion decreased with increasing curing time.

• Korean Journal of Soil Science and Fertilizer
• /
• v.10 no.1
• /
• pp.69-74
• /
• 1977

This study has been conducted to identify physico-chemical and clay mineralogical characteristics of bentonites produced in Korea for the purpose of finding good quality bentonite for agricultural ure. The results are summarized as follows: 1. Bentonites are mainly composed of montmorillonite developed from tuffs in a lava flow. 2. Chemical properties of bentonites are: pH in $H_2O$(1:1), 7:cation exchange capacity, 60-96me/100g; content of $SiO_2$, 54-72%; ratio of $SiO_2$ to $Al_2O_3$, 4.1-10.0;oven dry loss of $H_2O$ is higher than the ingnition loss of $H_2O$. 3. The x-ray diffrection patterns of powder bentonites show peaks at $14-15{\AA}$, $4.4{\AA}$, and $2.5{\AA}$, and that of swellen one show $17{\AA}$ when treated with ethylene glycol. 4. Distribution areas of the good quality bentonites were (1) Dogu-Dong, Donghae-Myeon, Yeonil-Gun, Gyeongsangbug-Do (2) Hamyeon-Ri, Yangnam-Myeon, Weolseong-Gun, Gyeongsanbug-Do. (3) Joam-Ri, Gangdong-Myeon, Weolseong-Gun, Gyeongsangbug-Do. (4) Sanha-Ri, Gangdong-Myeon, Ulju-Gun, Gyeongsangnam-Do. (5) Sinhyeon-Ri, Gangdong-Myeon, Ulju-Gun, Gyeongsangnam-Do. (6) Yonghang-Ri, Pyeongchang-Myeon, Pyeongchang-Gun, Gangweon-Do.

• Geomechanics and Engineering
• /
• v.14 no.6
• /
• pp.553-562
• /
• 2018

Road construction is becoming increasingly important in marine and desert areas due to population growth and economic development. However, the load carrying capacity of pavement is of gear concern to design and geotechnical engineers because of the poor engineering properties of the soils in these areas. Therefore, stabilization of the soils is regarded as an important issue. Besides, due to the fuels combustion and carbonate decomposition, cement industry generates around 5% of global $CO_2$ emission. Thus, using bentonite as a natural pozzolan in soil stabilization is more eco-friendly than using cement. The aim of this research is to experimentally study of the stabilized marine and desert sands using deep mixing method by ordinary Portland cement and sodium bentonite. Different partial percentages of cement along with different weight percentages of sodium bentonite were added to the sands. Unconfined compression test (UCS), Energy Dispersive X-ray (EDX), and Scanning Electron Microscope (SEM) were conducted on the specimens. Moreover, a mathematical model was developed for predicting the strength of the treated soils.

• Proceedings of the Korean Geotechical Society Conference
• /
• 2010.09b
• /
• pp.192-199
• /
• 2010

This research produced internal model tester ($2.0m{\times}2.0m{\times}1.0m$) to evaluate the field application of Paju Unjeong District water recycling system for small streams eco-friendly river bed disparity method for the first time in Korea and conducted comparative analysis of the Paju Unjeong District water recycling system field test results and infiltration rate result of internal tests by each rainfall intensity following surface material. Infiltration rate result of internal tests concrete pavement by rainfall intensity following surface material, asphalt pavement, bentonite mate, stabilized soil construction and mixed soil construction manifested low infiltration rate. On the contrary, compaction soil, grassland and water permeable packaging materials resulted in significant amount of infiltration rate. As for the field permeability test results, they were manifested similar tendency as indoor permeability test results and they satisfied the standard for standard of water permeability of domestic disparity facility (less than $1.0{\times}10-7cm$/sec). As compaction rate increased, unconfined compression strength increased as well while coefficient of water permeability decreased.

• Journal of Soil and Groundwater Environment
• /
• v.16 no.4
• /
• pp.53-61
• /
• 2011

This study examined evaluation on stabilization of major and trace elements in tailings by various surface water-preventing materials. Six columns were filled with tailings of the Sinlim mine, then covered with tailings only, compacted soils, clay, soil-bentonite mixture, pozzolan and bentonite mat. After injection of artificial rain water, the leachate was sampled with times (3, 6, 9 and 12 pore volume) and analysed for major (Ca, Na, Mg, K) and trace elements (As, Cd, Cu, Pb, Zn) by ICP-AES. With exception to pozzolan type, the pH values of leachate from the other types became stabilized from 5.5 to 7.5, and EC (electric conductivity) of leachate from them decreased with times. For the pozzolan type, however, the pH and EC of leachate increased with time due to its alkalinity producing system. Concentrations of most major and trace elements in leachate decreased and stabilized with time. Consequently, soil-bentonite mixed cover shows the best ability of water-preventing and reducing mobility of elements in tailings site.

• Journal of Korea Soil Environment Society
• /
• v.3 no.1
• /
• pp.75-81
• /
• 1998

In most of studies on solidification/stabilization with waste, small columns have been used to examinate adsorption or leachate. However, these experiments using small apparatus have been limited to apply with the field. In this study, considering an application to the field, a large Lysimeter(100cm$\times$100cm$\times$100cm) used for the simulation. Then, the open dumping waste was mixed directly with bentonite to simulate the stabilization of waste, environmental aspects and several basic tests. As a result, the concentration of heavy metals and contaminated substances changed with bentonite rate. Most of contaminated substances were decreased in leaching with increased mixing rate of bentonite. Especially, the concentration of CODcr removed 25~30%. Also, the residual soil in dumping waste produced approximately 80% of total volume by 40$\times$40mm screen.

• Journal of the Korean GEO-environmental Society
• /
• v.9 no.6
• /
• pp.21-29
• /
• 2008

As household and industrial wastes continue to rapidly increase every year, the demands for landfill sites are also increasing. However, the construction of landfill sites causes many problems due to the high costs of liners, while the leachate from the landfills generates secondary contamination of surrounding lands and groundwater. The purpose of this study is to determine the proper mixing ratio to meet the liner conditions (must be less than $1{\times}10^{-7}cm/sec$), using the local soil as the main material and using fly ash, bentonite, and cement as the mixing materials. The possibility of using this mixture as the liner for landfill sites was examined. To determine the proper mixing ratio, this study conducted basic physical properties tests, compaction tests, consolidation tests, and uniaxial compression tests. It was found that the higher the ratio of bentonite, the lower the coefficient of permeability, and the higher the ratio of fly ash, the higher the coefficient of permeability. The reason for this is that, while bentonite expands and fills pores, fly ash cannot fill the pores because the particles have a round shape and do not have adhesion. In conclusion, the optimum coefficient of permeability that meets the landfill liner condition was obtained when the ratio of bentonite was 15% or higher. If fly ash was mixed, the landfill liner condition was met when the ratio of bentonite was 15% or higher and the ratio of fly ash was 20% or lower.

• Geomechanics and Engineering
• /
• v.12 no.2
• /
• pp.211-221
• /
• 2017

A laboratory investigation into crude oil contaminated sand-concrete interface behavior is performed. The interface tests were carried out through a direct shear apparatus. Pure sand and sand-bentonite mixture with different crude oil contents and three concrete surfaces of different textures (smooth, semi-rough, and rough) were examined. The experimental results showed that the concrete surface texture is an effective factor in soil-concrete interface shear strength. The interface shear strength of the rough concrete surface was found higher than smooth and semi-rough concrete surfaces. In addition to the texture, the normal stress and the crude oil content also play important roles in interface shear strength. Moreover, the friction angle decreases with increasing crude oil content due to increase of oil concentration in soil and it increases with increasing interface roughness.

• Geotechnical Engineering
• /
• v.13 no.2
• /
• pp.17-28
• /
• 1997

In this study sodium chloride solution is employed for chemicals, and several cylindrical triaxial tests are performed on the sand-bentonite mixtures saturated with sodium chloride solution. Deformation(elastic modulus, E) and strength(cohesion, c', and angle of friction, f') parameters are obtained from the triaxial tests as functions of confining pressure and sodium chloride solution concentrations. The results here indicate an increase in the value of effective cohesion with increase in the concentration of NaCl solution, which can be explained by using the Gouy-Chapman model. The value of the effective angle of shearing resistance does not show significant change with the increase in concentration of NaCl solution. The Young's modulus also increases with the increase in concentration of NaCl solution.