• Journal of the Korea Society of Computer and Information
• /
• v.23 no.11
• /
• pp.1-7
• /
• 2018

In this paper, we propose soft dead pixels detection method by analysing different response at hot and cold images. Abnormal pixels are able to effect detecting a small target. It also makes confusing real target or not cause of changing target size. Almost exist abnormal pixels after image signal processing even if dead pixels are removed by dead pixel compensation are called soft dead pixels. They are showed defect in final image. So removing or compensating dead pixels are very important for detecting object. The key idea of this proposed method, detecting dead pixels, is that most of soft deads have different response characteristics between hot image and cold image. General infrared cameras do NUC to remove FPN. Working 2-reference NUC must be needed getting data, hot & cold images. The way which is proposed dead pixel detection is that we compare response, NUC gain, at each pixel about two different temperature images and find out dead pixels if the pixels exceed threshold about average gain of around pixels.

• Journal of the Korea Society of Computer and Information
• /
• v.21 no.12
• /
• pp.35-41
• /
• 2016

In this paper, we propose a new real-time dead pixel detection method based on spatial compare filtering, which are usually used in the small target detection. Actually, the soft dead and the small target are cast in the same mold. Our proposed method detect and remove the dead pixels as applying the spatial compare filtering, into the pixel outputs of a detector after the non-uniformity correction. Therefore, we proposed method can effectively detect and replace the dead pixels regardless of the non-uniformity correction performance. In infrared camera, there are usually many dead detector pixels which produce abnormal output caused by manufactural process or operational environment. There are two kind of dead pixel. one is hard dead pixel which electronically generate abnormal outputs and other is soft dead pixel which changed and generated abnormal outputs by the planning process. Infrared camera have to perform non-uniformity correction because of structural and material properties of infrared detector. The hard dead pixels whose offset values obtained by non-uniformity correction are much larger or smaller than the average can be detected easily as dead pixels. However, some dead pixels(soft dead pixel) can remain, because of the difficulty of uncleared decision whether normal pixel or abnormal pixel.

• Annual Conference on Human and Language Technology
• /
• 2018.10a
• /
• pp.382-385
• /
• 2018

Dead Link의 노출 최소화는 웹 검색 서비스의 품질 유지에 있어 매우 중요하다. 따라서 색인 내 Soft 404 오류의 정확한 판별은 필수적이지만, 리다이렉션 정보에 의존하거나 텍스트 혹은 HTML 자질 만을 고려하는 기존 방법의 활용만으로는 판별 가능한 Soft 404 오류의 유형이 한정될 수 있다는 문제가 있다. 이에 본 연구에서는 보다 범용성이 높은 Soft 404 오류 판별 기술의 개발을 위해, 404 오류 안내 페이지 고유의 형태적 특성을 오류 판별에 사용할 것을 제안한다. 제안 방법은 오류 안내 문서의 형태적 특성을 이미지 인식 모형에 기반해 학습한 후 이를 Soft 404 오류 판별에 사용하며, 리다이렉션 등 특정 정보에 의존하는 기존 방법에 비해 보다 폭넓게 적용 가능하다는 장점이 있다. 실험에서 제안 방법은 87.6%의 정확률과 92.7%의 재현율을 기록하는 등 높은 인식 성능을 보였다.

• Journal of the Institute of Electronics Engineers of Korea SC
• /
• v.39 no.6
• /
• pp.71-78
• /
• 2002

A method of soft switching in the half bridge converter using a small saturable core is presented. For the soft switching, a small dead time of both switch off is made in a pair of MOSFET switch. The saturable core is of rectangular magnetization characteristics and the core flux swings from the minus to the plus saturation during ON time of the switch. The soft switching is realized in dead time by a resonance between the saturating inductance of the core and the stray capacitance of MOSFET. As an extension of this concept, instead of the saturable core, we propose a new soft switching circuit using a linear inductance and two switches, which is especially suitable for regulating the output and also for high frequency switching. A theoretical principle of soft switching presented here was confirmed by experiments on a half bridge converter of 1.25 KW.

• Journal of Korean Foot and Ankle Society
• /
• v.6 no.2
• /
• pp.172-177
• /
• 2002

Objectives: To validate usefulness of the three phase bone scan for the diagnosis of osteomyelitis in the diabetic foot with soft tissue inflammation. Materials and Methods: Fourteen diabetic feet with soft tissue inflammation were included in this study. We took the bone biopsy from the site of hot uptake on the three phase bone scan but no abnormal findings on the plain radiographs. We observed whether the bone has evidence of osteomyelitis on the patholgic findings such as inflammatory cell infiltration within bone, dead bone, new bone formation and fibrosis. Results: Thirteen of fourteen cases (92.8%) were compatible with osteomyelitis on the pathologic criteria. Inflammatory cell infiltration within bone was observed in thirteen cases, dead bone in twelve cases. new bone formation in four cases. fibrosis in eight cases. All of the four findings were observed in three cases. Conclusion: In the diabetic foot with soft tissue inflammation, the osteomyelitis should be included in differential diagnosis if the lesion reveals increased uptake on three phase bone scan, even though the lesion does not show any abnormal findings on the plain radiographs.

• The Transactions of the Korean Institute of Power Electronics
• /
• v.13 no.4
• /
• pp.311-318
• /
• 2008

This paper proposes synchronous bidirectional DC-DC converter applying soft-switching technique. The proposed converter integrates two advantages which are conduction loss minimization and switching loss elimination by applying interleaved synchronous buck and ZVT-cell with a single resonant inductor. ZVS is guaranteed for wide load range in CCM(Continuous Conduction Mode) as well as wide output voltage range by current injection method. Also, reverse recovery effects of body diode can be minimized. In addition, it is possible to significantly reduce diode drop voltage occurred during dead time of conventional synchronous buck converter. The validity of the proposed converter is verified through experimental results.

• The korean journal of orthodontics
• /
• v.42 no.1
• /
• pp.39-46
• /
• 2012

Objective: We evaluated the detachment force, amount of deformation, fracture mode, and pull-out force of 3 different wires used for bonded lingual retainer fabrication. Methods: We tested 0.0215-inch five-stranded wire (PentaOne, Masel; group I), $0.016{\times}0.022$-inch dead-soft eight-braided wire (Bond-A-Braid, Reliance; group II), and 0.0195-inch dead-soft coaxial wire (Respond, Ormco; group III). To test detachment force, deformation, and fracture mode, we embedded 94 lower incisor teeth in acrylic blocks in pairs. Retainer wires were bonded to the teeth and vertically directed force was applied to the wire. To test pull-out force, wires were embedded in composite that was placed in a hole at the center of an acrylic block. Tensile force was applied along the long axis of the wire. Results: Detachment force and mode of fracture were not different between groups. Deformation was significantly higher in groups II and III than in group I (p < 0.001). Mean pull-out force was significantly higher for group I compared to groups II and III (p < 0.001). Conclusions: Detachment force and fracture mode were similar for all wires, but greater deformations were seen in dead-soft wires. Wire pull-out force was significantly higher for five-stranded coaxial wire than for the other wires tested. Five-stranded coaxial wires are suggested for use in bonded lingual retainers.

• Fisheries and Aquatic Sciences
• /
• v.26 no.4
• /
• pp.268-281
• /
• 2023

Coral reef fisheries are prominent for the archipelagic countries' food sufficiency and security. Studies showed that fish abundance and biomass are affected by biophysical variables. The present study determines which biophysical variables are important predictors of fish diversity, abundance, and biomass. The study used available monitoring data from the Indonesian Research Center for Oceanography, the National Board for Research and Innovation. Data were collected from 245 transects in 19 locations distributed across the Indonesian Archipelago, including the eastern Indian Ocean, Sunda Shelf (Karimata Sea), Wallacea (Flores and Banda Seas), and the western Pacific Ocean. Principal component analysis and multiple regression model were administered to 13 biophysical metrics against 11 variables of coral reef fishes, i.e., diversity, abundance, and biomass of coral reef fishes at three trophic levels. The results showed for the first time that the covers of other fauna, coral rubbles, and soft corals were the three most important predictor variables for nearly all coral reef fish variables. Other fauna cover was the important predictor for all 11 coral reef fish variables. Coral rubble cover was the predictor for ten variables, but carnivore fish abundance. Soft coral cover was a good predictor for corallivore, carnivore, and targeted fishes. Despite important predictors for corallivore and carnivore fish variables, hard coral cover was not the critical predictor for herbivore fish variables. The other important predictor variables with a consistent pattern were dead coral covered with algae and rocks. Dead coral covered with algae was an important predictor for herbivore fishes, while the rock was good for only carnivore fishes.

• Journal of Power Electronics
• /
• v.18 no.1
• /
• pp.45-55
• /
• 2018

It is usually difficult for dual-active-bridge (DAB) dc-dc converters to operate efficiently at light loads. This paper presents an in-depth analysis of a DAB with triple-phase-shift (TPS) control under the light load condition to overcome this problem. A kind of operating mode which is suitable for light load operation is analyzed in this paper. First, an analysis of the zero-voltage-switching (ZVS) constraints for the DAB converter has been carried out and a reasonable dead-band setting method has been proposed. Secondly, the basic operating characteristics of the converter are analyzed. Third, under the condition of satisfying the ZVS constraints, both the reactive power and the root mean square (RMS) value of the current are simultaneously minimized and a particle swarm optimization (PSO) algorithm is employed to analyze and solve this optimization problem. Lastly, both simulations and experiments are carried out to verify the effectiveness of the proposed method. The experimental results show that the converter can effectively achieve ZVS and improved efficiency.

• Archives of Reconstructive Microsurgery
• /
• v.10 no.2
• /
• pp.86-92
• /
• 2001

Failure of replantation is inevitable in finger replantation surgery, around 10% of failure rate are reported in many authors. Management of the failed finger replantation is one of big dilemma to microsurgeons. We report 5 cases of thumb reconstruction after failure of replantation. The reconstructive surgery composed with early debridement of soft tissue that are under gangrenous processing, extract the phalangeal bone without any soft tissues. Osteosynthesis of the extracted phalangeal bone with host phalangeal bone. The exposed bony portion covered with vascularized flaps such as revered radial forearm pedicled flap, free radial forearm flap and neurovascular island finger flap. This procedure underwent within a week after vascular insufficiency developed. All of the flaps are survived, bone union achieved within 3 months. The function and external appearance of the reconstructed thumb were encouraging; Pinch Power was average 1.2 Pounds. Early removal of necrotizing soft tissue followed by covering none vascular phalangeal bone which extracted from the dead phalanx with vascularized flap is one of the useful alterative solutions in failed replantation surgery in hand.