• Journal of Environmental Science International
• /
• v.12 no.10
• /
• pp.1061-1069
• /
• 2003

The adsorption behaviors of strontium and cesium ions on fly ash, natural zeolites, and zeolites synthesized from fly ash were investigated. The zeolites synthesized from fly ash had greater adsorption capabilities for strontium and cesium ions than the original fly ash and natural zeolites. The maximum adsorption capacity of synthetic zeolite for strontium and cesium ions was 100 and 154 mg/g, respectively, It was found that the Freundlich isotherm model could fit the adsorption isotherm. The distribution coefficients (K$\_$d/) for strontium and cesium ions were also calculated from the adsorption isotherm data, The distribution coefficients decreased with increasing equilibrium concentration of strontium and cesium ions in solution. By studying the removal of cesium and strontium ions in the presence of calcium, magnesium, sodium, potassium, sulfate, nitrate, nitrite, and EDTA (in the range of 0.01 - 5 mM) it was found that these coexistence ions competed for the same adsorption sites with strontium and cesium ions.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.31 no.4
• /
• pp.483-489
• /
• 2007

We have investigated quantitative measurement techniques of the degree of dispersion of single-walled carbon nanotubes (SWNTs). SWNTs were suspended in aqueous media using a sodium dodecyl sulfate (SDS) surfactant. SWNTs with different dispersion states were prepared by controlling the intensity and time of sonication and centrifugation. The laser spectroscopic techniques were employed to characterize the dispersion state; i.e., raman fluorescence and absorption spectroscopic techniques. Raman spectroscopy has been used to probe the dispersion and aggregation state of SWNTs in solution. Individually suspended SWNTs show increased fluorescence peaks and decreased roping peaks at a raman shift 267 $cm^{-1}$ compared with the samples containing bundles of SWNTs. The ultraviolet-visible-near infrared (UV-vis-NIR) absorption spectrum of decanted supernatant samples show sharp van Hove singularity peaks

• Journal of Surface Science and Engineering
• /
• v.26 no.5
• /
• pp.263-270
• /
• 1993

The effects of surfactants on electorless copper plating bath for PCB was studied. Basic bath composition was cuplic sulfate 10g/l, EDTA.2Na 40 g/l, formalin$ 3m\ell$/l and sodium hydroxide solution for pH adjust. After addition of accelerators, stabilizers and surfactants, the polarization curves in plating bath were carried out for presumption of the plating rate. From the plating rate in bath with the various concentration of additives, the optimum condition for manufacturing the electroless copper plating bath was confirmed. It was found that the addition of $\alpha$.$\alpha$'-dipyridyl, pyridine and polyxyethylene octylphenylether was good as stabilizer, accelerator and surfactants, respectively. With this additives, the maximum plating rate of $12\mu\textrm{m}$/h at $65^{\circ}C$ and $2\mu\textrm{m}$/h at $25^{\circ}C$ was obtained.

• Bulletin of the Korean Chemical Society
• /
• v.19 no.1
• /
• pp.50-56
• /
• 1998

A solvent sublation was studied for the determination of trace Cd, Co, Cu and Ni in water samples. Ammonium pyrrolidine dithiocarbamate (APDC) was used as a complexing agent. Experimental conditions such as pH of solution, amounts of APDC, the type and amount of surfactant, the type of solvent, etc. were optimized for the effective sublation of analytes. After metal-PDC complexes were formed in sample solutions of pH 2.5, the precipitate-type complexes were floated in a flotation cell with an aid of sodium lauryl sulfate as a surfactant and by bubbling with nitrogen gas. The precipitates were dissolved and separated into the surface layer of methyl iso-butyl ketone (MIBK). The analytes preconcentrated were determined by a graphite furnace atomic absorption spectrophotometry (GF-AAS). Extractability of each element was 88% for Cd(Ⅱ), 86% for Co(Ⅱ), 95% for Cu(Ⅱ) and 76% for Ni(Ⅱ), respectively. And this procedure was applied to the analysis of real samples. From the recoveries of more than 92%, it was concluded that this method could be simple and applicable for the determination of trace elements in various water samples of a large volume.

• Bulletin of the Korean Chemical Society
• /
• v.14 no.6
• /
• pp.704-708
• /
• 1993

The intramolecular charge transfer (ICT) phenomena of the photoexcited 2-biphenylcarboxylic acid (2BPCA) and 4-biphenylcarboxylic acid (4BPCA) have been investigated in some surfactant micellar solutions. The ICT emission of 4BPCA and 2BPCA in aqueous solution at sufficiently low pH (1-3) has been observed to be markedly quenched and blue-shifted upon addition of a cationic surfactant, cetyltrimethylammonium chloride (CTAC) in contrast to little change in anionic sodium dodecyl sulfate (SDS) and neutral Brij 35. An anionic emission band has been observed to be enhanced at expense of the ICT emission as a function of the concentration of CTAC. These results with the micellar effects on the fluorescence decay kinetics of 4BPCA suggest that formation of the ICT state of the excited acids is inhibited by CTAC-induced proton transfer as well as the decrease in the polarity and/or hydrogen-bonding ability of the micellar microenvironment entrapping the acids.

• Korean Journal of Veterinary Research
• /
• v.36 no.2
• /
• pp.379-387
• /
• 1996

The objects of the present study were to establish the method of purification, subunit dissociation of verotoxin-2 (VT2) produced by Escherichia coli O157:H7, and to investigate the characteristics of purified verotoxin-2 such as molecular weight and composition of amino acid. The results were summerized as follows; Verotoxin-2 was extracted by addition of polymyxin B sulfate into bacterial cell lysate prepared from Escherichia coli O157:H7(KSC109). As an initial step, the bacterial cell lysate was precipitated with 30% saturated ammonium sulfate. The precipitated crude toxin was then subjected to anion-exchange, chromatofocusing and cation-exchange chromatography. Using this scheme, we obtained highly purified toxin with a specific activity of $1.1{\times}10^9$ $CD_{50}/mg$. Sodium dodecyl sulfate-polyacrylamide gel electrophoresis(SDS-PAGE) for purified VT2 showed two protein bands. The upper band, approximately 32 Kd, was supposed as A subunit and the lower band, approximately 7.7 Kd, was supposed as B subunit. When the toxin was separated in the subunit-dissociating solution, two peaks emerged with retention times of 15 and 28 min by HPLC. These peaks represented A subunit and B subunit, respectively. The amino acid composition of purified VT2 were made up in order of glutamic acid, histamine, asparaginic acid, histidine, lysine, alanine and leucine etc. The largest amount among the amino acid composing VT2 was methionine.

• Journal of the Mineralogical Society of Korea
• /
• v.25 no.3
• /
• pp.155-162
• /
• 2012

We observed characteristic oxidation and dissolution phenomena induced by dissolved oxygen for mackinawite that is produced via sulfate-reducing bacteria (SRB) living in anaerobic environments such as soils and groundwater. We tried to recognize the role of the sulfide minerals that usually coexist with some stabilized radionuclides (e.g., reduced uranium), which can be reoxidized and redissolved by an oxygen-rich groundwater invaded into a contaminated area. The mackinawite produced by 'Desulfovibrio desulfuricans', a sulfate-reducing bacterium, was conducted to be dissolved for 2 weeks by some oxidants such as 'hydrogen peroxide' and 'sodium nitrite'. Although mineralogical oxidation and dissolution characteristics were different from each other according to the oxidants, the initially oxidized solution was early stabilized through the oxygen consumption by ${\mu}m$-sized sulfide particles and the resultant increase of sulfate in solution. From these results, we can anticipate that the large amount of sulfide minerals generated by SRB can not only repress the anoxic environment to be disturbed by the consumption of oxygen in groundwater, but also contribute to stabilize the reduced/precipitated radionuclides as a buffer material for a long time.

• Journal of Korean Society of Environmental Engineers
• /
• v.30 no.3
• /
• pp.339-344
• /
• 2008

Titanium dioxide nanotubes were fabricated by self-organized electrochemical potentiostatic anodization of titanium thin film with an electrolyte solution of sodium sulfate 1M and sodium flouride 0.5wt% aqueous solution at 20$^{\circ}C$ for 20min. Field Emmision Scanning Electron Microscopy(FE-SEM) and X-ray Diffractometer(XRD) were used to evaluate the micromorphology and crystalline structure of the titanium dioxide nanotube thin film. Titanium dioxide nanotube were fabricated with diameters approx. 100nm and tube length from appox. 1 $\mu$m. Titanium dioxide films formed through anodization and annealing process at 450$^{\circ}C$ contained a phase of anatase. Also, this study was performed to evaluate the application of titanium dioxide thin film for treating humic acid dissolved in water. The reaction tended to follow the Langmuir-Hinshelwood kinetics with zero order. Comparative experiments with thin film and anatase powder showed the same zero order kinetics when 0.3g of powder had been used.

• Journal of the Korean Chemical Society
• /
• v.35 no.3
• /
• pp.275-279
• /
• 1991

Ultra-fine alumina, ${\alpha}-Al_2O_3$, with ${\phi}$ = 0.1∼0.5 ${\mu}$m was obtained from pure ammonium aluminum sulfate(alum) as the thermal decomposition product. Pure alum(> 99.7%) could be prepared by the precepitation and the successive recrystallization in an acidic aqueous solution at pH = 1.5∼2.5, which was theoretically predicted by only considering the concentrations of hydroxide and carbonate for aluminum and sodium in the solution, and also experimentally confirmed as the optimum precepitation condition for alum without forming any impurities like aluminum hydroxide or sodium one.

• Membrane and Water Treatment
• /
• v.2 no.3
• /
• pp.137-145
• /
• 2011

Membrane processes are major breakthrough for the removal of organic pollutants in water remediation. The separations of solutes depend on nature of the membranes and solutes. The separation performance depends on the nature of the solutes (i.e., molecular volume, polarity, and hydrophobicity) for the same membrane. As 4-chlorophenol is of more dipolemoment compared to 2-chlorophenol, the orientation of the molecule enables it pass through the pores of the membrane, which is of negatively charged and thus separation order follows: 2-chlorophenol > 4-chlorophenol. Hydrophobicity factor also supports the order. Addition of sodium dodecyl sulfate (SDS) to chlorophenol solution shows remarkable increase in separation performance of the membrane. The improvement in separation is 1.8 and 1.5 times for 4- and 2- chlorophenol consecutively in case of 0.0082 M SDS (1cmc = 0.0082 M) in the solution. 4-chlorophenol has better attachment tendency with SDS because of its relatively more hydrophobic nature and thus reflects in performance i.e. the separation performance of 4-chlorophenol with SDS through the membrane is better compared to 2-chlorophenol.