• Korean Membrane Journal
• /
• v.7 no.1
• /
• pp.28-33
• /
• 2005

The feasibility of producing sulfuric acid and ammonia water from ammonium sulfate was investigated by an integrated process including ammonia stripping (AS) and electrodialysis with bipolar membrane (EDBM). It was suggested that the production of sulfuric acid using ammonia stripping-electrodialysis with bipolar membrane (ASEDBM) was effective in obtaining high concentration of sulfuric acid compared with EDBM alone. AS was carried out over pH 11 and within the range of temperatures, $20^{\circ}C{\~}60^{\circ}C$. Sodium sulfate obtained using AS was used as the feed solution of EDBM. The recovery of ammonia increased from $40\%$ to $80\%$ at $60^{\circ}C$ due to the increased mobility of ammonium ion. A pilot-scale EDBM system, which is composed of two compartments and 10 cell pairs with an effective membrane area of $200 cm^2$ per cell, was used for the recovery of sulfuric acid. The performance was examined in the range of 0.1 M${\~}$1.0 M concentration of concentrate compartment and of $25 mA/cm^2{\~}62.5 mA/cm^2$ of current density. The maximum current efficiency of $64.9\%$ was obtained at 0.1 M sulfuric acid because the diffusion rate at the anion exchange membrane decreased as the sulfuric acid of the concentrate compartment decreased. It was possible to obtain the 2.5 M of sulfuric acid in the $62.5 mA/cm^2$ with a power consumption of 13.0 kWh/ton, while the concentration of sulfuric acid was proportional to the current density below the limiting current density (LCD). Thus, the integrating process of AS-EDBM enables to recover sulfuric acid from the wastewaters containing ammonium sulfate.

• Bulletin of the Korean Chemical Society
• /
• v.23 no.12
• /
• pp.1719-1723
• /
• 2002

1,5-diphenylcarbazone was immobilized on sodium dodecyl sulfate coated alumina. The alumina particle was effectively used for collection of mercury(II) and methylmercury cations at sub-ppb level. The adsorbed mercury was eluted with l mol $L^{-1}$ of hydrobromic acid solution. The mercury(II) was then directly measured by cold vapor atomic absorption spectrometry utilizing tin (II) chloride where as the total mercury was determined after the oxidation of methylmercury into the inorganic mercury. The methylmercury concentration was calculated by the difference between the value of total mercury and mercury (II). Mercury (II) and methylmercury cations were completely recovered from water with a preconcentration factor of 100 (for 1 L solution.) Relative standard deviation at Hg L ${\mu}gL^{-1}$ level 1.7%(n=8) and the limit of detection was 0.11 ${\mu}gL^{-1}$. The procedure was applied to spring water, well water and seawater and accuracy was assessed through recovery experiments.

• Proceedings of the PSK Conference
• /
• 2002.10a
• /
• pp.313.2-313.2
• /
• 2002

Environmentally benign protein staining method in sodium dodecyl sulfate-polyacrylamide gel electrophoresis (SDS-PAGE) using both an acidic dye, zincon (ZC) and a basic dye. ethyl violet (EV) is described. It is based on a counter ion-dye staining technique that employs oppositely charged two dyes to form an ion-pair complex. The selective binding of the free dye molecules to proteins in an acidic solution produces bluish violet colored bands. It is a rapid procedure, involving only fixin and staining steps that are completed in 45 min. (omitted)

• Membrane Journal
• /
• v.24 no.1
• /
• pp.69-77
• /
• 2014

To prepare the hollow fiber nanofiltration composite membranes, the poly(vinylidene fluoride) (PVDF) membrane was hydrophilized with $K_2Cr_2OH$ and $KMnO_4$ aqueous solutions. And then the composite membrane was synthesized on that membrane surfaces using interfacial polymerization with piperazine (PIP) and trimesoyl chloride (TMC). The resulting membranes were characterized in terms of the rejection and flux for NaCl, $CaSO_4$, $MgCl_2$ 100 ppm solution and 300 ppm of NaCl and $CaSO_4$ mixed solution by varying the coating time, drying time, and the concentration of the coating materials. As a result, the higher rejections were shown for $K_2Cr_2OH$ solutionas a hydrophilization material, and the flux was enhanced while the rejection reduced as the hydrophilization time is longer. Also, the rejection increased and the flux reduced as the concentrations of triethyl amine (TEA) and sodium lauryl sulfate (SLS) were higher. Typically, the rejection 50% and flux 40 LMH for NaCl 100 ppm solution, and the rejection 55% and flux 48 LMH for $CaSO_4$ 100 ppm solution were obtained for the PVDF hollow fiber composite membrane prepared with the conditions of PIP 2 wt% (Triethyl amine (TEA) 7 wt%, SLS 20 wt% mixed solution against PIP concentration) and TMC 0.1 wt%.

• Korean Journal of Food Science and Technology
• /
• v.8 no.4
• /
• pp.207-211
• /
• 1976

Treated with various methods, body muscle of squid was cross section, stained by Van Gieson staining method, and observed microscopically to study on the state of thin layer of skin separated from meat. Results obtained were summarized as follows : 1. By general hot spring treatment were 1st. 2nd. and 3rd. layers of skin removed from squid muscle but 4th. not. 2. By boiling treatment was tissue of muscle fibre fissured largely toward the muscle fibre. 3. Sodium acetate treatment was superior to sodium nitrate, sodium sulfate and sodium tartrate treatment in the effect that the skin was separated from meat. Especially, concentrate solution of sodium acetate had the most excellent effect in the chemical reagent treatment. 4. By proteolytic enzyme treatment were 1st. 2nd. 3rd. and 4th. layers of skin removed all from squid muscle and the boundary fibre between skin and meat swelled in particular. 5. Two kinds of skin removing method, proteolytic enzyme treatment and sodium acetate treatment, were desirable to the actual processing.

• Korean Journal of Food Science and Technology
• /
• v.11 no.2
• /
• pp.112-117
• /
• 1979

By using the existing caustic refining system with a minimum modification and by using a combination of various emulsifiers(0.2 % sodium hexametaphosphate. 0.05 % sodium lauryl sulfate and 0.001 % dioctyl sodium sulfosuccinate), a new economical dewaxing process for sunflower seed oil was developed in order to reduce the cost of the dewaxing process. The results indicate that the waxes can be removed satisfactorily from the sunflower seed oil by emulsifying. batchwise or continuously, the oil with the aqueous surfactant solution, followed by centrifugation at ambient temperatures $(16{\sim}27^{\circ}C)$. Dewaxing loss for the batch process was satisfactory for both low wax-and high wax-crude oil, whereas dewaxing loss for the continuous process needs to be improved. The results indicate that initial level of wax content (low wax vs. high wax) did not affect the loss for batch process (0.82 % vs. 0.62 %), but affected the loss for continuous processes, regardless of the type of mixing mode (2.28 % and 5.68 % for low wax-and high wax-oil, respectively). It was also noted that the type of mixing mode (centactor vs. static mixer) for the continuous process affected the loss, regardless of the wax content (5.2 % and 2.8 % for contactor and static mixer, respectively).

• Bulletin of the Korean Chemical Society
• /
• v.19 no.10
• /
• pp.1036-1042
• /
• 1998

The preconcentration and determination of trace elements in water samples were studied by a solvent sublation utilizing dithizonate complexation. After metal dithizonates were formed, trace amounts of cadmium, cobalt, copper and lead were floated and extracted into small volume of a water-immiscible organic solvent on the surface of sample solution and determined in the solvent directly by GF-AAS. Several experimental conditions as formation condition of metal-dithizonate complexes, pH of solution, amount of dithizone, stirring time, the type and amount of surfactants, N2 bubbling rate and so on were optimized for the complete formation and effective flotation of the complexes. And also four kinds of light solvents were compared each other to extract the floated complexes, effectively. After the pH was adjusted to 4.0 with 5 M HNO3, 8.0 mL of 0.05% acetone solution of dithizone was added to 1.00 L water sample. The dithizonate complexes were flotated and extracted into the upper methyl isobutylketone (MIBK) layer by the addition of 2.0 mL 0.2% ethanolic sodium lauryl sulfate solution and with the aid of small nitrogen gas bubbles. And this solvent sublation method was applied to the analysis of real water samples and good results of more than 85% recoveries were obtained in spiked samples.

• Journal of the Society of Cosmetic Scientists of Korea
• /
• v.31 no.1 s.49
• /
• pp.51-58
• /
• 2005

Alkyl ethoxy sulfate type surfactants, widely used in commercial cleansers, are easily adsorbed to skin to often cause skin irritation and inflammation if not thoroughly rinsed nut. In order to replace or complement existing surfactants, we screened the existing surfactants through protein denaturation method, cell cytotoxicity assay and human IL-1$\alpha$ assay, etc. Fourteen surfactants have been chosen from among too irritant anionic, cationic and/or zwitter-ionic ones and investigated for cell cytotoxicity in human fibroblast cell lines using monolayer culture with the thirteen commercially available cleansers for sensitive skin. From these results, we selected 5 surfactants and 2 commercial cleansers (names not shown), such as sodium laureth sulfate (anionic), sodium cocoyl isethionate (anionic), sodium lauroamphoacetate (zwitter-ionic), and cocamidopropyl betaine (zwitter-ionic), alkyl polyglycoside (non-ionic). 20 formulations were made out of 5 surfactants and five of them were chosen through a protein denaturation method (lower than 3 M sodium dodecyl sulfate solution ($13.2\%$)), cell cytotoxicity and human patch test. These five selected formulations containing preservatives were compared to two selected commercial cleansers by cell cytotoxicity and human IL-1$\alpha$ ELISA assay using dermal equivalent. Finally, we selected the best formulation. To this formulation, fructan ($3\%$ or $5\%$) or/and portulaca extract ($3\%$ or $5\%$) well known for its anti-inflammatory and moisturizing effects were added and investigated for cell cytotoxicity using dermal equivalent. In cytotoxicity assay using dermal equivalent, two formulations containing $5\%$ fructan and $3\%$ or $5\%$ portulaca extract were less toxic than the others. In cytotoxicity assay and human IL-1$\alpha$ ELISA using 3D culture, the selected formulation containing $5\%$ fructan and $5\%$ portulaca extract showed better efficiency than those of the others and 2 commercial cleansers. As a result, we could develop a low irritant and safe liquid cleanser.

• Microbiology and Biotechnology Letters
• /
• v.4 no.4
• /
• pp.152-158
• /
• 1976

Cultivation condition of yeast on the utilization of fermentable substrate from the cellulosic wastes such as rice hull, rice straw and corn starch cake was investigated. The results obtained were summarized as follows；1. Corn starch cake was respectively added to rice hull and rice straw in order to increase sugar concentration in the hydrolyzate, and then hydrolyzed. As the result, concentration of sugar in hydrolyzed solution of rice hull was 9.12％, in that of rice straw was 7.98％. 2. It was found that calcium carbonate as a neutralizer was the most effective to prepare the culture broth of yeast. 3. An optimal growth of Hansenula subpelliculosa GFY-2 was observed in the medium prepared by adding 0.3％ of ammonium sulfate, 0.4％ of potassium phosphate dibasic, 0.02％ of magnesium sulfate, sodium chloride and calcium chloride to hydrolyaed sugar solution, respectively. 4. Hansenula subpellicuiosa GFY-2 cultured in the substrate solution which of rice hull and rice straw added to corn starch cake was assimilated more than 90％ of sugar in the hydrolyzate within 48 hours. The yeast cells yielded in rice hull was 46.5％, and that of rice straw 45.4％ to utilized sugars.

• Applied Chemistry for Engineering
• /
• v.8 no.6
• /
• pp.1041-1047
• /
• 1997

The influence of $\omega$-phenylalkylammonium salt on the critical micelle concentration (CMC) of SDS has been examined using the electric conductivity method. CMC of SDS exhibited the tendency to decrease with the length of alkyl group of additives. The effect of temperature on CMC of SDS in additive solutions has been observed in the range of $18^{\circ}C-50^{\circ}C$. The free energy(${\Delta}G_m^{\circ}$) for the micellization of SDS is negative and the entropy(${\Delta}S_m^{\circ}$) is a large positive value. The enthalpy(ΔHm0is positive in low temperature($18^{\circ}C$) and negative in high temperature($>25^{\circ}C$). In the prensence of organic additives, the micellization of SDS was considered as a spontaneous process and to involve a phase transition. The values of ΔGm0has shown the tendency to increase but the values of ${\Delta}S_m^{\circ}$ and ${\Delta}H_m^{\circ}$ to decrease with the length of alklyl group of additive salts. The changes in ${\Delta}\kappa$(difference of specific conductivity) with increasing mole ratio of additives in the mixed solutions indicated the formation of mixed micelles between SDS and additives. The effect of the length of alkyl chain on the micellization of SDS demonstrated the penetration of organic additives into the palisade layer of the SDS micelle.