• 대한전기학회:학술대회논문집
• /
• 대한전기학회 1993년도 정기총회 및 추계학술대회 논문집 학회본부
• /
• pp.160-162
• /
• 1993

This paper proposes a new converter for switched reluctance motors using a Boost converter in conjunction with a Buck converter. The proposed converter has a unity power factor(hereafter referred to an UPF) in the ac input regardless of the load variations. Moreover, compared to the conventional converter topologies, the total system efficiency is improved by introducing choppingless voltage control methods in the machine side converter and an energy recovery snubber in the pre-voltage regulation stage, respectively.

• 대한전자공학회:학술대회논문집
• /
• 대한전자공학회 2002년도 ITC-CSCC -2
• /
• pp.1030-1033
• /
• 2002

This paper, a new simple controller operates in continuous conduction mode (CCM) for Boost power factor collection converter is introduced. The duty ratios are obtained by comparisons of a sensed signal from inductor current and a negative ramp carrier waveform in each switching period. By using the proposed controller, input voltage sensing, error amplifier in the current feedback loop, and analog multiplier／divider are not required, then, the control circuit implementation is very simple. To verify the proposed controller, the circuit simulation for Boost power factor correction converter was applied. For the results, the input current waveform was shaped to be closely sinusoidal, implying low THD.

• 대한기계학회논문집
• /
• 제19권8호
• /
• pp.1901-1906
• /
• 1995

The frequency response functions of systems incorporating a non-linear cubic stiffness subject to sinusoidal excitation are derived using the Volterra series and the convergence characteristics investigated. It is shown that the series representation of the frequency response functions converges only when the sinewave input amplitude is within a certain range. Within the range of convergence the frequency response function based on the Volterra series approaches the analytical one as more higher order frequency response function terms are included. Proposed is a criterion for the studies systems to predict approximately the range of sinewave input amplitude for which the series representation of the frequency response functions converges.

• Earthquakes and Structures
• /
• 제18권3호
• /
• pp.313-320
• /
• 2020

The usage of conventional tuned mass damper (TMD) was proved as an effective method for passive mitigating vortex-induced vibration (VIV) of a bridge deck. Although a variety of linear TMD systems have been so far utilized for vibration control of suspension bridges, a sensitive TMD mechanism to wind spectrum frequency is lacking. Here, we introduce a bistable tuned mass damper (BTMD) mechanism which has an exceptional sensitivity to a broadband input of vortex shedding velocity for suppressing VIV in suspension bridge deck. By use of the Monte Carlo simulation, performance of the nonlinear BTMD is shown to be more efficient than the conventional linear TMD under two different wind load excitations of harmonic (sinusoidal) and broadband input of vortex shedding. Consequently, an appropriate algorithm is proposed to optimize the design parameters of the nonlinear BTMD for Kap Shui Mun Bridge, and then the BTMD system is localized for the interior deck of the suspension bridge.

• 전자공학회논문지B
• /
• 제32B권7호
• /
• pp.1003-1009
• /
• 1995

In This Paper, Linearization problem is discussed to reduce distortion of a nonlinear system based on Schetzen's pth-orfer inverse theorem. We propose a nonlinear adaptive prefiltering algorithm which can reduse nonlinear distortion up to pth order by tandemly connecting a pth-order Volterra filter before the nonlinear system under the consideration and by adjusting the filter coefficients adaptively. The feasibility of applying the proposed algorithm to a nonlinear system is conformed via computer simulation by observing significant reduction of total nonlinear distortion for the case of random input and sinusoidal input excitation.

• 전력전자학회:학술대회논문집
• /
• 전력전자학회 2002년도 전력전자학술대회 논문집
• /
• pp.241-244
• /
• 2002

This paper presents the electronic ballast for the metal halide lamp with free voltage input and implemented for CDM-T[150W] lamp. HID lamps have a good color rendition, long life and good focusing capability but they have fickers by acoustic resonance when driven at high frequency. To reduce the acoustic resonance phenomena, the electronic ballast was designed for high frequency operation with the constant frequency sinusoidal wave of 75[kHz]. Finally, the experimental results on the ballast of CDM-T [150W]metal halide lamp with the propose methods are discussed.

• Journal of Power Electronics
• /
• 제9권2호
• /
• pp.173-179
• /
• 2009

This paper proposes a new three-phase diode rectifier system with a sinusoidal input current at unity power factor and a regulated and isolated output voltage at low level. The inherent natural wave-shaping capability of the reduced kVA polyphase transformer together with an active current wave-shaping technique results in a significant reduction of input and output filter requirements associated with switching ripple and EMI. The operation principles are described along with a design example and a comparative evaluation. Experimental results on a 1.5kW prototype are provided to validate the proposed concept.

• 대한전기학회논문지:전기기기및에너지변환시스템부문B
• /
• 제48권6호
• /
• pp.322-329
• /
• 1999

In this paper a practical series-parallel compensated UPS is suggested, which has high input power factor and sinusoidal output voltage regulation capability. Compared to conventional cascaded UPS, the size can be reduced significantly with high quality input and output waveforms. The front converter and the main inverter can be considered decoupled, hence the front converter and the main inverter can be designed independent of each other. In this paper, analysis and experimental results for an l KVA prototype are presented.

• 한국정밀공학회지
• /
• 제15권10호
• /
• pp.165-171
• /
• 1998

An axial electromagnetic levitation system using attractive force is a highly nonlinear system due to the nonlinearity of materials, variable air gap and flux density. To control the levitating system with large air gap, a conventional PID control based on the linear model is not satisfactory to obtain the desired performance and the position tracking control of the sinusoidal motion by simulation results. Thus, sliding mode control(SMC) based on the input-output linearization is suggested and evaluated by simulation and experimental approaches. Usefulness of the SMC to this system is conformed experimentally. If the expected variation of added mass can be included in the gain conditions and the model, the position control performance of the electromagnetic levitation system with large air gap will be improved with robustness.

• 한국철도학회:학술대회논문집
• /
• 한국철도학회 2008년도 춘계학술대회 논문집
• /
• pp.1131-1136
• /
• 2008

The single-phase PWM converter employing power semiconductors is currently applied to the power unit of high-speed rail vehicle and increasingly used as the front-end converter with properties of near unity power factor. Power factor and harmonics are increasingly important needs for drive system of high-speed rail vehicle. The proposed approach has many advantages which include fewer semiconductor components, simplified control, high performance features and satisfies IEC 555 harmonic current standards. Simulation results show that the dc-link voltage control obey the reference value during constant load and input current is near sinusoidal.