• ETRI Journal
• /
• v.26 no.5
• /
• pp.493-496
• /
• 2004

An effective paging strategy is essential for improving the utility of radio channels. This paper proposes a two-step paging strategy which involves using base station paging agents to page a single cell at each paging. An analytical model is used to evaluate the performance of the proposed strategy. The proposed strategy is compared with the traditional simultaneous paging strategy and a recent proposal using the base station paging agents. The numerical results showed that the proposed strategy proficiently reduces paging cost on radio channels compared with other paging strategies.

• Proceedings of the KIEE Conference
• /
• 2005.07b
• /
• pp.1147-1149
• /
• 2005

Time switch is widely used to reduce the energy loss by selecting the duration of daily-based operating pattern for the electrical apparatus. Driving force of the time switch is the single-phase step motor which has the starting torque due to the asymmetrical airgap. Cogging and total torque of the tapered-airgap motor is analyzed by finite element method.

• Journal of Electrical Engineering and Technology
• /
• v.4 no.4
• /
• pp.476-484
• /
• 2009

This paper deals with improvements to the special protection schemes (SPS) which have been applied to the low probability and high impact contingencies in the Korea Electric Power Corporation (KEPCO) system since 2004. Among them, the SPS for voltage instability in the Seoul metropolitan area is considered in this paper, and is a form of event-based undervoltage load shedding with a single-step scheme. Simulation results based upon a recent event that occurred on 765kV lines show that the current setting values of the SPS have to be revised and enhanced. In addition, by applying response-based multi-step undervoltage load shedding (UVLS) schemes to severe contingencies in the system, more effective results than those of the existing single-step SPS can be obtained. Centralized and distributed UVLS schemes are considered in the simulation. ULTC-based load recovery models and over excitation limiters (OXL) for the KEPCO system are also included in the long-term voltage instability studies.

• Journal of the Korean GEO-environmental Society
• /
• v.4 no.3
• /
• pp.61-67
• /
• 2003

A new precess which consists of pre-dewatering device, post composting for solid phase and post sequencing batch reactor(SBR) for liquid phase was designed. Nitrogen in supernatants of dewatering device was removed by sequencing batch reactor. Experiments were carried out to investigate the SBR operation modes such as fill ratio, SRT, and operation cycle. The optimum fill ratio, SRT and aeration/non-aeration time were 1/12, 15days, and 2hr aeration / 1hr non aeraion, respectively. Methanol as an external carbon source increased denitrification when step feeding method was applied, not single feeding method.

• Journal of Mechanical Science and Technology
• /
• v.19 no.spc1
• /
• pp.371-376
• /
• 2005

Relative contributions of lower extremity joints on the support moment were investigated in this study. Three-dimensional gait analyses were performed in normal walking and in unexpected step-down walking. For both gait studies, inverse dynamics were performed to obtain each joint moment of the lower extremity, which was applied to the forward dynamics simulation to determine the contributions on the support moment at different phases of walking. The forward dynamic simulation results showed that, in normal walking, the ankle plantar flexors contributed significantly during single-limb-support. However, the ankle plantar flexors, knee extensors and hip extensors worked together during double-limb-support. In unexpected step-down walking, the important contributors on the support of the body during single-limb-support were not only ankle plantar flexors but also knee extensors. This study, analyzing the relative contributions of the lower limb joint moments for the body support, would be helpful to understand different unexpected walking conditions and compensatory mechanisms for various pathological gaits.

• Physical Therapy Korea
• /
• v.22 no.4
• /
• pp.27-33
• /
• 2015

The purpose of this study was to find which spatiotemporal gait parameters gained from stroke patients could be predictive factors for the gait part of Tinetti Performance-Oriented Mobility Assessment (POMA-G). Two hundred forty-six stroke patients were recruited for this study. They participated in two assessments, the POMA-G and computerized spatiotemporal gait analysis. To analyze the relationship between the POMA-G and spatiotemporal parameters, we used Pearson's correlation coefficients. In addition, multiple linear regression analyses (stepwise method) were used to predict the spatiotemporal gait parameters that correlated most with the POMA-G. The results show that the gait velocity (r=.67, p<.01), cadence (r=.66, p<.01), step length of the affected side (r=.49, p<.01), step length of the non-affected side (r=.53, p<.01), swing percentage of the non-affected side (r=.47, p<.01), and single support percentage of the affected side (r=.53, p<.01) as well as the double support percentage of the non-affected side (r=-.42, p<.01) and the step-length asymmetry (r=-.64, p<.01) correlated with POMA-G. The gait velocity, step-length asymmetry, cadence, and single support percentage of the affected side explained 67%, 2%, 2%, and 1% of the variance in the POMA-G, respectively. In conclusion, gait velocity would be the most predictive factor for the POMA-G.

• Journal of Power Electronics
• /
• v.15 no.4
• /
• pp.1085-1092
• /
• 2015

In this paper, the expressions of the estimated information of a single-phase enhanced phase-locked loop (EPLL), when input signal contains harmonics and a DC offset while the fundamental component takes step changes, are derived. The theoretical analysis results indicate that in the estimated information, the n^th-order harmonics cause n+1^th-order periodic ripples, and the DC offset causes a periodic ripple at the fundamental frequency. Step changes of the amplitude, phase angle and frequency of the fundamental component cause a transient periodic ripple at twice the frequency. These periodic ripples deteriorate the performance of the EPLL. A hybrid filter based EPLL (HF-EPLL) is proposed to eliminate these periodic ripples. A delay signal cancellation filter is set at the input of the EPLL to cancel the DC offset and even-order harmonics. A sliding Goertzel transform-based filter is introduced into the amplitude estimation loop and frequency estimation loop to eliminate the periodic ripples caused by the residual input odd-order harmonics and step change of the input fundamental component. The parameter design rules of the two filters are discussed in detail. Experimental waveforms of both the conventional EPLL and the proposed HF-EPLL are given and compared with each other to verify the theoretical analysis and advantages of the proposed HF-EPLL.

• The Journal of Korean Academy of Orthopedic Manual Physical Therapy
• /
• v.10 no.1
• /
• pp.83-101
• /
• 2004

The propose of the study was to evaluate the efficacy of the partial body weight support during treadmill training on the ambulation in elderly with chronic stroke. Fourteen hemiplegic volunteers participated and were divided into an experimental and control groups. In the experimental group, the body weight support during treadmill training was performed 3 times per week for 6 weeks. In the control group, usual treadmill training was applied. Before and after experiments, temporal-spatial gait parameters were measured. The date of 14 patients who carried out the whole experimental course were statistically analyzed. The results of the study were : 1. In the comparison of gait velocity before and after experiment, the gait velocity was significantly increased in the experimental group and the control group(p<.05). In the comparison of difference of the gait velocity between groups, there was not, significant difference between the experimental group and the control group(p>.05). 2. In comparison of gait cadence before and after experiment, the gait cadence was significantly increased in both groups(p<.05). In the comparison of difference of the gait cadence between groups, there was not significant difference between the experimental group and the control group(p>.05). 3. In the comparison of step length before and after experiment, the step length was significantly increased in the experimental group and the control group(p<.05). In the comparison of difference of the step length between groups, there was not significant difference between the experimental group and the control group(p>.05). 4. In the comparison of single support time asymmetry before and after experiment, the single support time asymmetry was no significant difference between groups(p>.05). In the comparison of difference of the single support time asymmetry between groups, there was not significant difference between the experimental group and the control group(p>.05). 5. In the comparison of step length asymmetry before and. after experiment, the step length asymmetry was not significant difference between the experimental group and the control group(p>.05). In the comparison of difference of the single step length asymmetry between groups, there was not significant difference between the experimental group and the control group(p>.05).

• Restorative Dentistry and Endodontics
• /
• v.28 no.5
• /
• pp.378-384
• /
• 2003

This study evaluated the influence of a desensitizer(MS coat) on microtensile bond strength of different adhesives:a three-step adhesive(All-Bond 2), a two-step adhesive(Single Bond), a one-step adhesive(One-up Bond F). Non-caries extracted human molars were used. Dentin surface was obtained by horizontal section on mid-portion of crown using a water-cooled low speed diamond saw. Teeth were randomly divided into 6 group. AMO(MS coat + All Bond), SMO(MS coat + Single Bond)- and OMO(MS coat + One-up Bond F)-dentin surface were treated with 17% EDTA before bonded adhesive. AMX-, SMX- and OMX-dentin surface were bonded with All-Bond 2, Single Bond and One-up Bond F, respectively. with no previous treatment with MS coat and 17% EDTA. About 1cm high resin composite($Z-250^{TM}$) were incrementally build-up on the treated surface. The specimens for the microtensile test were serially sectioned perpendicular to the adhesive layer to obtain $0.7{\times}0.7mm$ sticks. 30 sticks were prepared from each group. After that. tensile bond strength for each stick was measured with Microtensile Tester at a 1mm/min crosshead speed. Fractured dentin surfaces were observed under the SEM. The results were statistically analysed by using a One-way ANOVA and Tukey's test(p<0.05). Value in MPa were: $AMO-44.35{\pm}13.21;{\;}SMO-39.35{\pm}13.32;{\;}OMO-31.07{\pm}10.25;{\;}AMX-49.22{\pm}16.38;{\;}SMX-56.02{\pm}13.35;{\;}OMX-72.93{\pm}16.19$. Application of MS coat reduced microtensile bond strengths of both Single Bond and One-up Bond F, whereas microtensile bond strengths of All-Bond 2 were not affected significantly.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.13 no.2
• /
• pp.95-100
• /
• 2000

For the well-controlled growing in-situ heavily phosphorus doped polycrystalline Si films directly on Si wafer by reduced pressure chemical vapor deposition, a study is made of the two step growth. When in-situ heavily phosphorus doped Si films were deposited directly on Si (100) wafer, crystal structure in the film is not unique, that is, the single crystal to polycrystalline phase transition occurs at a certain thickness. However, the well-controlled polycrtstalline Si films deposited by two step growth grew directly on Si wafers. Moreover, the two step growth, which employs crystallization of grew directly on Si wafers. Moreover, the two step growth which employs crystallization of amorphous silicon layer grown at low temperature, reveals crucial advantages in manipulating polycrystal structures of in-situ phosphorous doped silicon.