• 대한전자공학회논문지TC
• /
• 제41권11호
• /
• pp.25-32
• /
• 2004

본 논문에서는 전력선통신에서 발생하는 잡음에 대해서 DSSS을 적용할 수 있는 가능성을 분석했다. 이 잡음은 4가지가 있는데, 이들 잡음을 분석하기 위해서 특성에 따라서 실제로 전력선에서 발생하는 잡음원을 만들었다. 이들 잡음모델을 대상으로 DSSS을 적용한 BPSK의 BER 성능을 DSSS을 적용하지 않는 BPSK의 경우와 비교해서 모의실험하고 분석했다. 그 결과, DSSS을 적용한 BPSK의 경우가 DSSS을 적용하지 않는 BPSK의 경우에 비해서 8 dB 개선되었음을 알 수 있었다.

• Journal of Power Electronics
• /
• 제12권5호
• /
• pp.787-799
• /
• 2012

Real and reactive power flows on a transmission line interact inherently. This situation degrades power flow controller performance when independent real and reactive power flow regulation is required. In this study, a quasi multi-pulse interline power flow controller (IPFC), consisting of eight six-pulse voltage source converters (VSC) switched at the fundamental frequency is proposed to control real and reactive power flows dynamically on a transmission line in response to a sequence of set-point changes formed by unit-step reference values. It is shown that the proposed hybrid fuzzy-PI commanded IPFC shows better decoupling performance than the parameter optimized PI controllers with analytically calculated feed-forward gains for decoupling. Comparative simulation studies are carried out on a 4-machine 4-bus test power system through a number of case studies. While only the fuzzy inference of the proposed control scheme has been modeled in MATLAB, the power system, converter power circuit, control and calculation blocks have been simulated in PSCAD/EMTDC by interfacing these two packages on-line.

• Journal of Power Electronics
• /
• 제19권4호
• /
• pp.1020-1033
• /
• 2019

This paper presents a control strategy to enhance the accuracy of reactive power sharing between paralleled three-phase inverters in an islanded microgrid. In this study, the mismatch of power sharing when the line impedances have significant differences between inverters connected to a microgrid has been solved, the accuracy of the reactive power sharing in an islanded microgrid is increased, the voltage droop slope is tuned to compensate for the mismatch of voltage drops across the line impedances by using an enhanced droop controller. The proposed method ensures accurate power sharing even if the microgrid has local loads at the output of the inverters. The control model has been simulated by MATLAB/Simulink with two or three inverters connected in parallel. Simulation results demonstrate the accuracy of the implemented control method. Furthermore, in order to validate the theoretical analysis and simulation results, an experimental setup was built in the laboratory. Results obtained from the experimental setup verify the effectiveness of the proposed method.

• 한국전기전자재료학회:학술대회논문집
• /
• 한국전기전자재료학회 2000년도 춘계학술대회 논문집 유기절연재료 방전 플라즈마
• /
• pp.50-54
• /
• 2000

Recently, the HFPD measurement testing is widely used in partial discharge measurement of HV machines because HFPD measurement testing receives less influence of external noise and has a merit of good sensitivity. Also HFPD testing is able to offer the judgement standard of degradation level of HV machine and can detect discharge signals in live-line. Therefore it is very useful method compare to previous conventional PD testing method and effective diagnosis method in power transformer that requires live-line diagnosis. But partial discharges have very complex characteristics of discharge pattern so it is required continuous research to development of precise analysis method. In recent, the study of partial discharge is carrying out discover of initial defect of power equipment through condition diagnosis and system development of degradation diagnosis using HFPD(High Frequency Partial Discharge) detection. In this study, simulated transformer is manufactured and HFPD occurred from transformer is measured with broad band antenna in real time, the degradation grade of transformer is analyzed through produced patterns in simulated transformer according to applied voltages.

• Journal of Power Electronics
• /
• 제9권4호
• /
• pp.575-581
• /
• 2009

In this paper two modes of operating a wound rotor induction machine as a generator at sub-and super-synchronous speeds in wind energy conversion systems are investigated. In the first mode, known as double fed induction generator (DFIG), the rotor circuit is fed from the ac mains via a controlled rectifier and a forced commutated inverter. Adjusting the applied rotor voltage magnitude and phase leads to machine operation as a generator at sub-synchronous speeds. In the second mode, the machine is operated in a slip recovery scheme where the slip energy is fed back to the ac mains via a rectifier and line commutated inverter. This mode is described as double output induction generator (DOIG) leading to increase the efficiency of the wind-to electrical energy conversion system. Simulated results of both modes are presented. Experimental verification of the simulated results are presented for the DOIG mode of operation, showing larger amount of power captured and better power factor when compared to conventional induction generators.

• Journal of Power Electronics
• /
• 제18권1호
• /
• pp.234-250
• /
• 2018

This paper presents a new load sharing control for use between paralleled three-phase inverters in an islanded microgrid based on the online line impedance estimation by the use of a Kalman filter. In this study, the mismatch of power sharing when the line impedance changes due to temperature, frequency, significant differences in line parameters and the requirements of the Plug-and-Play mode for inverters connected to a microgrid has been solved. In addition, this paper also presents a new droop control method working with the line impedance that is different from the traditional droop algorithm when the line impedance is assumed to be pure resistance or pure inductance. In this paper, the line impedance estimation for parallel inverters uses the minimum square method combined with a Kalman filter. In addition, the secondary control loops are designed to restore the voltage amplitude and frequency of a microgrid by using a combined nominal value SOGI-PLL with a generalized integral block and phase lock loop to monitor the exact voltage magnitude and frequency phase at the PCC. A control model has been simulated in Matlab/Simulink with three voltage source inverters connected in parallel for different ratios of power sharing. The simulation results demonstrate the accuracy of the proposed control method.

• 한국원자력학회:학술대회논문집
• /
• 한국원자력학회 1995년도 추계학술발표회논문집(2)
• /
• pp.544-549
• /
• 1995

An analysis for Steam Line Break (SLB) events which result in a return-to-power conditions after reactor trip was performed for a postulated Yonggwang Nuclear Power Plant Unit 3 cycle 8. Analysis methodology for post-trip return-to-power SLB is quite different from that of a no return-to-power SLB and is more complicated. Therefore, it is necessary to develop an methodology to analyze the response of the NSSS parameter and the fuel performance for the post-trip return-to-power SLB events. In this analysis, the cases with and without offsite power were simulated by crediting 3-D reactivity feedback effect due to local heatup around stuck CEA and compared with the cases without 3-D reactivity feedback with respect to fuel performance, departure from nucleate boiling ratio (DNBR) and linear heat generation rate (LHGR).

• 대한전자공학회논문지SD
• /
• 제41권10호
• /
• pp.77-83
• /
• 2004

VLSI 시스템에서 전력 소모를 줄이기 위해서는 메가블록이 동작하지 않는 동안 전원을 차단하여 누설 전류를 억제하는 방법이 효과적이다. 최근 들어 다중 문턱 전압 CMOS를 사용하여 전원을 차단하는 방법이 널리 연구되고 있으나, 동작 주파수가 증가함에 파라 전원 복귀에 필요한 시간이 짧아지게 되고, 짧은 시간에 전원이 복귀되면서 전원선에 대량의 전류가 순간적으로 흐르게 된다. 이에 따라 매우 큰 전원 잡음이 생겨서 전원 전압이 안정적이지 못하고 흔들리게 되며 이는 많은 경우 시스템의 오동작을 초래하게 된다. 본 논문에서는 이러한 문제점을 해결하기 위하여 새로운 전원 복귀 기법을 제안한다. 제안하는 기법은 메가블록의 전원이 차단되었다가 다시 복귀할 때 한꺼번에 전원을 켜는 것이 아니라 파이프라인 방식으로 몇 단계로 나누어 전원을 켬으로서 전원선에 흐르는 최대 전류 및 이에 따른 전원 잡음을 크게 억제한다. 제안하는 파이프라인 전원 복귀 기법을 검증하기 위해서 컴팩트 플래시 메모리 제어기 칩에 본 기법을 적용하여 곱셈기 블록의 전원을 차단하고 복귀할 때의 전원 잡음을 모의실험하고 분석하였다. 모의실험 결과, 제안하는 기법은 기존의 전원 차단 기법에 비해 전원 잡음을 매우크게 줄일 수 있음을 확인하였다.

• 조명전기설비학회논문지
• /
• 제24권5호
• /
• pp.152-159
• /
• 2010

가공전력선이 통과하는 지역에서 발생된 연소화염은 계통 섬락사고의 원인이 되고 있다. 본 논문에서는 연소화염에 의한 전력선의 절연내력 저하특성과 화염의 형상변화를 알아보기 위해, 직류 및 교류 전압 인가시 전력선을 모의한 대기압 공기 갭에 대한 섬락특성과 화염의 소화특성을 조사하였다. 실험 결과, 화염에 의한 섬락현상은 비교적 작은 갭에서 발생되었으며, 수평배치형 침대침 갭에서 교류 섬락전압의 상대값은 평균 37.3[%]인 것으로 나타나 화염이 없는 경우에 비해 크게 저하하였다. 갭 길이가 증가함에 따라 전극간 섬락이 발생되기 전에 침전극로부터 발생된 코로나풍에 의해 화염은 소화되는 현상이 나타났다.

• 대한전기학회:학술대회논문집
• /
• 대한전기학회 2002년도 하계학술대회 논문집 C
• /
• pp.1782-1784
• /
• 2002

In this paper, the coefficient of friction betwee and sheath in 345kv XLPE cable was measured the simulated inclinated condition of You-Youngdeungpo transmission line. The phenomena of slipping down the simu inclination was investigated theoretically usin measured data and was analyzed from experim result. The measured and analyzed result were conside be as a reference data for real installation of XLPE Youngseo-Youngdeungpo transmission line.