• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.59 no.4
• /
• pp.793-796
• /
• 2010

The equalizer compensates a signal distorted by transmission lines and amplifying stages, so the signal can have uniform characteristics over all frequency range. The equalizer in ODD(Optical Disc Drive) improves the stability of the extracted clock from a received signal and the readability of an inserted disc by suppressing noise and ISI(Inter-Symbol Inference). The length of marks-spaces and track pitch on discs becomes shorter as the recording density of an optical media is higher, which causes noise and ISI. And, the sensitivity about the fluctuation of physical systems is higher as the optical devices become more complicate. This paper proposes a method to select the coefficient of built-in equalizer of ODD in order to maintain the quality of signals against noise and ISI caused by system fluctuation.

• The Journal of The Korea Institute of Intelligent Transport Systems
• /
• v.10 no.4
• /
• pp.100-106
• /
• 2011

Radio Frequency (RF) signal fluctuates dynamically in wireless communication environments, where this fluctuation is severe especially in vehicular environments. Automatic Gain Control (AGC) is critical in wireless communications to establish reliable communication links and compensate the received signal fluctuation. In this paper, we introduce a simple and novel AGC scheme which uses both Received Signal Strength Indicator (RSSI) and analog-to digital converter (ADC) signals. Performance enhancement of the proposed AGC scheme is verified with practical measurements including simulations.

• Transactions of the Korean Society of Automotive Engineers
• /
• v.8 no.2
• /
• pp.41-49
• /
• 2000

To understand the signal fluctuation of a wide-range oxygen sensor installed at the exhaust confluence point, when a misfiring is triggered in a cylinder, the steady state and the transient response characteristics of the sensor to the flow of the misfired gas were investigated quantitatively. It was recognized that the steady state output voltage of the sensor increased higher when it contacted the misfired gas even though the fueling condition was the same as the normal combustion case and this characteristic enabled the application of the wide-range oxygen sensor for the misfire detection. The transient response was compared at different engine speeds and it was found that the response speed increased with the engine speed. The signal fluctuation was also estimated quantitatively, using these steady state and transient response of the sensor, and the estimated signal showed satisfactory correlation with the measurements.

• Korean Journal of Air-Conditioning and Refrigeration Engineering
• /
• v.24 no.5
• /
• pp.433-442
• /
• 2012

The influence of outdoor sky conditions on photosensor signals were examined to determine an appropriate index that is effectively used for optimum illuminance fluctuation when a daylight dimming system is used for a small office. Field measurements were conducted under various sky conditions. Results indicate that the outdoor global and vertical illuminance fluctuated within narrow ranges under clear and overcast sky conditions. The fluctuation of sky ratio under partly-cloudy sky caused wide ranges of illumnance fluctuation. A partially-shielded photosensor at backwall produced 56% of light output from fixtures controlled by a photosensor at ceiling. This implies that the photosensor at backwall does not always guarantee target illuminance due to the less output. The fluctuation of light output from fixtures were insignificant under clear and overcast sky. The fluctuation range of photosensor illuminance under partly-cloudy sky caused wide fluctuation ranges of light output. Regression result implies that the outdoor vertical illuminance was recommended for an effective index that is used for control of light output.

• Journal of Electrical Engineering and Technology
• /
• v.12 no.6
• /
• pp.2227-2236
• /
• 2017

In order to solve the neutral-point voltage fluctuation problem of three-phase three-level T-type inverters (TPTLTIs), the unbalance characteristics of capacitor voltages under different switching states and the mechanism of neutral-point voltage fluctuation are revealed. Based on the mathematical model of a TPTLTI, a feed-forward voltage balancing control strategy of DC-link capacitor voltages error is proposed. The strategy generates a DC bias voltage using a capacitor voltage loop with a proportional integral (PI) controller. The proposed strategy can suppress the neutral-point voltage fluctuation effectively and improve the quality of output currents. The correctness of the theoretical analysis is verified through simulations. An experimental prototype of a TPTLTI based on Digital Signal Processor (DSP) is built. The feasibility and effectiveness of the proposed strategy is verified through experiment. The results from simulations and experiment match very well.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2014.02a
• /
• pp.403.1-403.1
• /
• 2014

In conventional far-field microscopy, two objects separated closer than approximately half of an emission wavelength cannot be resolved, because of the fundamental limitation known as Abbe's diffraction limit. During the last decade, several super-resolution methods have been developed to overcome the diffraction limit in optical imaging. Among them, super-resolution optical fluctuation imaging (SOFI) developed by Dertinger et al [1], employs the statistical analysis of temporal fluorescence fluctuations induced by blinking phenomena in fluorophores. SOFI is a simple and versatile method for super-resolution imaging. However, due to the uncontrollable blinking of fluorophores, there are some limitations to using SOFI for several applications, including the limitations of available blinking fluorophores for SOFI, a requirement of using a high-speed camera, and a low signal-to-noise ratio. To solve these limitations, we present a new approach combining SOFI with speckle pattern illumination to create illumination-induced optical fluctuation instead of blinking fluctuation of fluorophore.. This technique effectively overcome the limitations of the conventional SOFI since illumination-induced optical fluctuation is possible to control unlike blinking phenomena of fluorophore. And we present the sub-diffraction resolution image using SOFI with speckle illumination.

• Laser Solutions
• /
• v.9 no.2
• /
• pp.17-22
• /
• 2006

In this study, PID control method was applied to decrease the power fluctuation of the pulse laser which is one of the major processing variables in laser machining process. To stabilize the power fluctuation of the pulse laser, we averaged 10 pulse outputs of Nd:YAG laser operating in 10Hz using boxcar averager, and with taking this averaged output as an input signal, we conducted PID control using optical attenuator which is consisted of half wave plate attached on the stepping motor and polarizer. When PID control was not enabled, the power fluctuation was 4.71% and with PID control, the power fluctuation was 1.86% for 2 hours and 1 hour respectively. As a result, we stabilized the power fluctuation of the pulse laser by 60.5%

• Proceedings of the Korean Society of Laser Processing Conference
• /
• 2006.06a
• /
• pp.89-96
• /
• 2006

In this study, PID control method was applied to decrease the power fluctuation of the pulse laser which is one of the major processing variables in laser machining process. To stabilize the power fluctuation of the pulse laser, we averaged 10 pulse outputs of Nd:YAG laser operating in 10Hz using boxcar averager, and with taking this averaged output as an input signal, we conducted PID control using optical attenuator which is consisted of half wave plate attached on the stepping motor and polarizer. When PID control was not enabled, the power fluctuation was 4.71% and with PID control, the power fluctuation was 1.86% for 2 hours and 1 hour respectively. As a result, we stabilized the power fluctuation of the pulse laser by 60.5%

• Economic and Environmental Geology
• /
• v.42 no.2
• /
• pp.143-152
• /
• 2009

Recent raw material prices fluctuation has been unexpectedly high and that made Korean economic activities to be depressed. Because most raw material supply in Korea depends upon oversea imports, unexpected raw material price fluctuation affects Korean industrial economies through macroeconomic variables. So Korean government enforces some political measures such as demand management and the supply-security assurance as long-range policies, and reservation and general early warning system as short-range policies. In short-range policies, it is necessary to be expected short term fluctuation. Up to recently, there have been many researches and most of those researches use parametric methods or time series analyses. Because those methods and analyses often generate inadequate relations among variables, it is possible that some consistent variables are left out or the results are misunderstood. This study, therefore, is aim to mitigate those methodological problems and find the relatively appropriate model for economic explanation. So that, in this paper, by using non-parametric signal approach method mitigating some shortages of previous researches and forecasting properly short-range prices fluctuation of non-ferrous materials are presented empirically.

• Transactions of the Korean Society of Mechanical Engineers A
• /
• v.21 no.3
• /
• pp.485-501
• /
• 1997

Pressure control is possible driving a simple ON/OFF 3-way valve of hydraulic servo system by pulse width modulation signal. But the pressure varies according to the duty ratio and carrier frequency and repeated on-off action induces pressure fluctuation. So equations for mean pressure and ripple amplitude are theoretically derived as a function of on/off time, the system parameters which decide the pressure characteristics are arranged and they are verified by experimental study. As the result selection criteria for the major design parameters are established and the basic strategy to suppress the unnecessary fluctuation can be provided for a hydraulic pressure control system using these type of valves.