• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.34 no.11C
• /
• pp.1106-1112
• /
• 2009

The SC-FDMA(single carrier-frequency division multiple access) was recently adopted as the uplink multiple access scheme from 3GPP LTE(3rd Generation Partnership Project Long Tenn Evolution) due to its low PAPR (Peak-to-averaged power ratio). The bandwidth of IFDMA(interleaved FDMA), one of the sub-carrier mapping methods of SC-FDMA, gets narrower as the roll-off factor of RRC(root raised cosine) filter decreases from 1 to 0, whereas its PAPR can increase significantly. In practice, to increase the power efficiency of an amplifier, signals with high PAPR undergo the process of clipping. Clipping of signals may cause regeneration of high-frequency components as well as distortion of signals. The current paper deals with the effect of clipping on the spectrum and BER of IFDMA signals with RRC filters.

• Journal of the Institute of Electronics Engineers of Korea SP
• /
• v.41 no.2
• /
• pp.99-108
• /
• 2004

This thesis deals a method to deliver more realistic sound by cancelling the cross-talk which is inherent to the 5.1 channel speaker system. The acoustical model for cross-talk cancellation is the free field model. This model minimizes distortion of sound. I used the bark scale sound quality compensation which based on psycho-acoustic. For the surround channels, band-limited sound quality compensation is performed in the frequency domain. I also performed the sound quality assessment test on the traditional 2 channel stereo and 5.1 channel system. This test is performed in the test chamber which satisfies the ITU-R specifications. I uses the IACC(Inter-Aural Cross-Correlation) to determine the preferences of the amateur and the golden ear experts to asses the trans-aural filter. According to the result from the proposed method, I got more the 38㏈ separation rates with the Dolby standard speaker array. The results on the diffusion by the subjective test with the experts shows 0.4 point increased then before.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.19 no.10
• /
• pp.1175-1184
• /
• 2008

Delay-sum back projection(DSBP) algorithm and the time reversal algorithm based on the finite-difference time-domain method are compared. The two algorithms, which operate in the time domain, can process the ultra-wideband (UWB) radar data to generate images that are close to the original location and shape of the target. For the experiment, the UWB radar consists of a network analyzer, a resistive V dipole antenna, a scanner, and a control computer. The radar aperture is synthesized by linearly scanning the antenna. A calibration procedure is applied to the measured data to remove signal distortion and clutter. The two algorithms are applied to the same data on the same platform. It is shown that the DSBP algorithm produces better images but takes longer time to produce the images than the FDTD-TR algorithm.

• Proceedings of the Korean Institute of Information and Commucation Sciences Conference
• /
• 2015.10a
• /
• pp.861-862
• /
• 2015

In this paper we present a low area 12-bit SAR ADC (Successive Approximation Register Analog-to-Digital Converter). The proposed circuit is fabricated using Magnachip/SK Hynix 1-Poly 6-Metal $0.18-{\mu}m$ CMOS process, and it is powered by a 1.8-V supply. Total chip area is reduced by replacing the MIM capacitors with MOS capacitors instead of the capacitors consisting of overall part in chip area. The proposed circuit showed improved power dissipation of 1.9mW, and chip area of $0.45mm^2$ as compared to conventional research results at the power supply of 1.8V. The designed circuit also showed high SNDR (Signal-to-Noise Distortion Ratio) of 70.51dB, and excellent effective number of bits of 11.4bits.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.11 no.2
• /
• pp.95-103
• /
• 2011

This paper proposes a 6b 1.2 GS/s 47.8 mW 0.17 $mm^2$ 65 nm CMOS ADC for high-rate wireless personal area network systems. The proposed ADC employs a source follower-free flash architecture with a wide input range of 1.0 $V_{p-p}$ at a 1.2 V supply voltage to minimize power consumption and high comparator offset effects in a nanometer CMOS technology. The track-and-hold circuits without source followers, the differential difference amplifiers with active loads in pre-amps, and the output averaging layout scheme properly handle a wide-range input signal with low distortion. The interpolation scheme halves the required number of pre-amps while three-stage cascaded latches implement a skew-free GS/s operation. The two-step bubble correction logic removes a maximum of three consecutive bubble code errors. The prototype ADC in a 65 nm CMOS demonstrates a measured DNL and INL within 0.77 LSB and 0.98 LSB, respectively. The ADC shows a maximum SNDR of 33.2 dB and a maximum SFDR of 44.7 dB at 1.2 GS/s. The ADC with an active die area of 0.17 $mm^2$ consumes 47.8 mW at 1.2 V and 1.2 GS/s.

• JSTS:Journal of Semiconductor Technology and Science
• /
• v.13 no.2
• /
• pp.98-107
• /
• 2013

This work describes a 13b 100 MS/s 0.13 um CMOS four-stage pipeline ADC for 3G communication systems. The proposed SHA-free ADC employs a range-scaling technique based on switched-capacitor circuits to properly handle a wide input range of $2V_{P-P}$ using a single on-chip reference of $1V_{P-P}$. The proposed range scaling makes the reference buffers keep a sufficient voltage headroom and doubles the offset tolerance of a latched comparator in the flash ADC1 with a doubled input range. A two-step reference selection technique in the back-end 5b flash ADC reduces both power dissipation and chip area by 50%. The prototype ADC in a 0.13 um CMOS demonstrates the measured differential and integral nonlinearities within 0.57 LSB and 0.99 LSB, respectively. The ADC shows a maximum signal-to-noise-and-distortion ratio of 64.6 dB and a maximum spurious-free dynamic range of 74.0 dB at 100 MS/s, respectively. The ADC with an active die area of 1.2 $mm^2$ consumes 145.6 mW including high-speed reference buffers and 91 mW excluding buffers at 100 MS/s and a 1.3 V supply voltage.

• The Journal of the Acoustical Society of Korea
• /
• v.32 no.3
• /
• pp.269-278
• /
• 2013

The speech recording of the National Archives of Korea contains very important traces which represent modern times of Korea. But the way to be recorded by analogue is easily contaminated as time goes by. So it has to be digitalized for management and services. Consequently, restoration method of distorted speech is needed. We propose the four classes for each distortion kind and apply restoration algorithms for the cases of speech level, stationary noise and abrupt noise. As a result, speech volume adjusts to -26 dBov for only on the speech region and SNR improves above 10dB. Especially, conventional way to remove the noise is almost impossible because we need to listen to all of them but it can be more effective by adaptation of auto restoration algorithm.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.41 no.6
• /
• pp.698-706
• /
• 2016

Orthogonal frequency division multiplexing (OFDM) has high peak to power ratio (PAPR). High PAPR makes problems such as signal distortion and circuit cost increasing. To solve the problemsm several PAPR reduction methods have been proposed. However, synchronization and orthogonality in OFDM systems may be a limitation to reduce latency for 5G networks. Generalized frequency division multiplexing (GFDM) is one of the possible solutions for asynchronous and non-orthogonal systems, which are more preferable to reduce the latency. However, multiple subsymbols in GFDM result in more superposition in time domain, GFDM has higher PAPR. Selective mapping (SLM) is one of PAPR reduction techniques in OFDM, which uses phase shift. The PAPR of GFDM SLM is compared to conventional GFDM and OFDM SLM in terms of PAPR reduction enhancement via numerical simulations. In addition, the out-of-band performance is analyzed in the aspect of asynchronous condition interference.

• The Journal of Korean Institute of Communications and Information Sciences
• /
• v.33 no.1A
• /
• pp.7-15
• /
• 2008

In this paper, it is investigated that the limitation due to the asymmetry of optical power with respect to optical phase conjugator(OPC) in mid-span spectral inversion(MSSI) for compensating optical signal distortion due to group velocity dispersion(GVD) and nonlinearities generated in fiber by combining with lumped dispersion management(DM) technique into MSSI. Two kinds of lumped DM configuration(configuration A and configuration B) are considered and compared each other in this research. Configuration A consists of two dispersion compensating fiber(DCF) span positioned after transmitter and before receiver, respectively. Configuration B consists of two dispersion compensating fiber(DCF) span positioned before and after OPC placed at middle of total transmission link, respectively. It is confirmed that the transmission performances are more improved by the configuration A combined with MSSI than configuration B. Also, it is confirmed that the best performance of overall channels are obtained by making net residual dispersion(NRD) to have positive value in self phase modulation(SPM)-limited WDM transmission systems, irrelevant to the configuration of DM.

• The Journal of Korean Institute of Electromagnetic Engineering and Science
• /
• v.12 no.7
• /
• pp.1157-1166
• /
• 2001

In this paper, we investigated the degree of compensation for optical pulse shape distortion due to both chromatic dispersion and SPM(self phase modulation) in high speed optical transmission system with dispersion shift fiber. We adopted the power symmetric MSSI(mid-span spectral inversion) as compensation method. We used EOP(eye-opening penalty) parameter in order to evaluate the compensation efficiency of distorted optical pulse. We evaluated input signal power range being able to maintain stable reception performance in the case of various chirp parameter of modulated optical pulse. And, in order to verify the applicable to wideband WDM system, we evaluated the wavelength range being able to maintain stable reception performance through the EOP calculation of various dispersion coefficient of first fiber D$\_$11/. We showed that proposed MSSI is effective compensation method to down chirped optical pulse transmission rather than up chirped optical pulse transmission in anomalous dispersion range. And we showed that this method have possibility of relative high power transmission and wideband transmission in WDM system.