• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.27 no.4
• /
• pp.154-161
• /
• 2017

$Zn_2TiO_4$, which is a progenitor of zinc crystallization, plays a significant role in controlling the crystallization of willemite ($Zn_2SiO_4$) in forming glaze at low temperatures. Thus, $Zn_2TiO_4$ was used to formulate stable willemite and to gain structural control. When synthesized 15 wt% of $Zn_2TiO_4$ is added to engobe and then applied, it can manipulate its crystallization and location. Additionally, when colorant is added to $Zn_2TiO_4$ and then applied to engobe, the mixture's colorant effect can be shown at crystallization. Certain characteristics of synthesized $Zn_2TiO_4$ enable various engobes to be applied to clay bodies. With a single glazing, the crystallization, location, and color of the crystals can be discretionarily regulated.

• Journal of Sensor Science and Technology
• /
• v.19 no.3
• /
• pp.197-201
• /
• 2010

This paper describes the fabrication and characteristics of a NO sensor using ZnO thin film integrated 3C-SiC micro heater based on polycrystalline 3C-SiC thin film of operation in harsh environments. The sensitivity, response time, and operating properties in high temperature and voltages of NO sensors based SiC MEMS are measured and analyzed. The sensitivity of device with pure ZnO thin film at the heater operating power of 13.5 mW ($300^{\circ}C$) is 0.875 in NO gas concentration of 0.046 ppm. In the case of Pt doping, the sensitivity of at power consumption of 5.9 mW ($250^{\circ}C$) was 1.92 at same gas flow rate. The ZnO with doped Pt was showed higher sensitivity, lower working temperature and faster adsorption characteristics to NO gas than pure ZnO thin film. The NO gas sensor integrated SiC micro heater is more strength than others in high voltage and temperature environments.

• Korean Journal of Materials Research
• /
• v.27 no.8
• /
• pp.403-408
• /
• 2017

We investigated the effect of ZnO buffer layer on the formation of ZnO thin film by ultrasonic assisted spray pyrolysis deposition. ZnO buffer layer was formed by wet solution method, which was repeated several times. Structural and optical properties of the ZnO thin films deposited on the ZnO buffer layers with various cycles and at various temperatures were investigated by field-emission scanning electron microscopy, X-ray diffraction, and photoluminescence spectrum analysis. The structural investigations showed that three-dimensional island shaped ZnO was formed on the bare Si substrate without buffer layers, while two-dimensional ZnO thin film was deposited on the ZnO buffer layers. In addition, structural and optical investigations showed that the crystalline quality of ZnO thin film was improved by introducing the buffer layers. This improvement was attributed to the modulation of the surface energy of the Si surface by the ZnO buffer layer, which finally resulted in a modification of the growth mode from three to two-dimensional.

• Bulletin of the Korean Chemical Society
• /
• v.23 no.8
• /
• pp.1135-1138
• /
• 2002

CuO/ZnO, CuO/SiO,sub>2, and CuO/ZrO2 catalysts were prepared for investigating the support effects on methanol dehydrogenation. It was found that the conversion of methanol was proportional to the copper surface area on Cu/ZnO cat alysts and was independent on that on Cu/ZrO2 and Cu/SiO2. The highest copper surface area was obtained with the Cu/ZrO2 (9/1). The unusual deactivation of the Cu/ZnO, which showed the highest selectivity among the catalysts tested, was observed. Pulse reaction with methanol indicated that the lattice oxygen in ZnO could be removed by forming CO2 in the catalytic reaction, supporting that the ZnO reduction was responsible for the severe deactivation of the Cu/ZnO.

• Korean Journal of Materials Research
• /
• v.20 no.9
• /
• pp.463-466
• /
• 2010

We studied the initial reaction mechanism of Zn precursors, namely, di-methylzinc ($Zn(CH_3)_2$, DMZ) and diethylzinc ($Zn(C_2H_5)_2$, DEZ), for zinc oxide thin-film growth on a Si (001) surface using density functional theory. We calculated the migration and reaction energy barriers for DMZ and DEZ on a fully hydroxylized Si (001) surface. The Zn atom of DMZ or DEZ was adsorbed on an O atom of a hydroxyl (-OH) due to the lone pair electrons of the O atom on the Si (001) surface. The adsorbed DMZ or DEZ migrated to all available surface sites, and rotated on the O atom with low energy barriers in the range of 0.00-0.13 eV. We considered the DMZ or DEZ reaction at all available surface sites. The rotated and migrated DMZs reacted with the nearest -OH to produce a uni-methylzinc ($-ZnCH_3$, UMZ) group and methane ($CH_4$) with energy barriers in the range of 0.53-0.78 eV. In the case of the DEZs, smaller energy barriers in the range of 0.21-0.35 eV were needed for its reaction to produce a uni-ethylzinc ($-ZnC_2H_5$, UEZ) group and ethane ($C_2H_6$). Therefore, DEZ is preferred to DMZ due to its lower energy barrier for the surface reaction.

• Journal of the Korean Ceramic Society
• /
• v.40 no.7
• /
• pp.637-643
• /
• 2003

In order to improve the photoluminescent properties and crystallinity, Zn$_2$SiO$_4$:Mn, M(M=Cr, Ti) phosphors were synthesized by the sol-gel method. The willemite single phase was obtained at 110$0^{\circ}C$, which is lower temperature than that of the conventional solid-state reaction (130$0^{\circ}C$). The characteristics of fired samples were obtained by a 147 nm excitation source under VUV (Vacuum Ultraviolet). To investigation the effect of co-dopant, the content of Mn and the ratio of $H_2O$ to TEOS was fixed as 2 ㏖% and 36. 1, respectively. The highest emission intensity was obtained when the concentration of Cr and Ti was 0.1 ㏖% relative to Zn$_2$SiO$_4$:Mn. While the emission intensity decrease continuously the decay time improved as increased the Cr concentration. In the case of Ti added samples, however, the emission intensity increase up to 2 ㏖％ concentration.

• 한국신재생에너지학회:학술대회논문집
• /
• 2009.06a
• /
• pp.88-88
• /
• 2009

실리콘 이종접합 태양전지 제작을 위한 주요 요소기술 중 TCO/a-Si:H 간의 계면 특성은 태양전지 효율을 결정하는 주요 인자이다. 일반적으로 투명전도 산화막으로는 ZnO:Al 또는 ITO 가 사용되고 있으며 Zn, In, Sn, O 등의 확산과 Si원소의 확산으로 TCO/a-Si:H 계면에서 $SiO_x$가 생성되어 태양전지 충진률을 감소시키는 영향을 미친다. 따라서 본 연구에서는 TCO/a-Si 계면에서 확산을 방지 하면서 패시베이션 역할을 하는 완충층을 삽입하여 실리콘 이종접합 태양전지의 효율을 높이는 연구를 수행하였다. 완충층으로 사용된 ZnO:Al의 수소화와 Zn 박막, $TiO_2$ 박막의 전기 광학적 특성을 분석하였고 AES 분석을 통해 $SiO_x$의 생성과 각 원소의 확산정도를 분석하고, CTLM을 이용하여 TCO/완충층/a-Si 간의 접촉저항을 측정하였다. 결과적으로 완충층으로 사용된 $TiO_2$(5nm)는 광특성에 큰 감소요인 없이 전기적 특성과 접촉저항 특성이 우수하였으며, 원소들간의 확산방지층으로도 우수한 특성을 보였다. ZnO:Al의 수소화는 SIMS 분석 결과 수소원소들이 계면쪽에 위치하지 않고 표면쪽에 다수 존재함으로써 패시베이션 특성을 크게 보이지 않았으나 AZO 박막의 전기적 특성은 크게 향상 시켰다. 그밖에 완충층으로 사용된 Zn 박막은 두께가 두꺼원 질수록 접촉저항의 감소를 가져왔으나 광학적 특성이 크게 감소하면서 효율적인 광포획 특성을 가지지 못하였다. 본 연구를 통하여 TCO/a-Si:H 간의 완충층 삽입을 통해 접촉저항을 낮추고 원소간의 확산을 억제하여 계면 패시베이션 특성을 향상 시킬수 있었다.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.26 no.6
• /
• pp.441-445
• /
• 2013

ZnO nanowires on the a-, c- and m-plane oriented 4H-SiC substrates were grown by using a high temperature tube furnace. Ti/Au electrodes were deposited on ZnO nanowires and a-, c- and m-plane 4H-SiC substrates, respectively. The shape and density of the ZnO nanowires were investigated by field emission scanning electron microscope. It was found that the growth direction of nanowires depends strongly on growth parameters such as growth temperature and pressure. In this work, The sensitivity of nanowires formed a-, c- and m-plane oriented 4H-SiC gas sensor was measured at $300^{\circ}C$ with CO gas concentration of 80%. The nanowires grown on a-plane oriented 4H-SiC show improved sensing performance than those on c- and m-plane oriented 4H-SiC due to the increased density of nanowire on a-plane 4H-SiC.

• Korean Journal of Materials Research
• /
• v.11 no.3
• /
• pp.227-235
• /
• 2001

In this work, Zn$_2$SiO$_4$:Mn phosphors were prepared by solid state reaction. The effect of sintering/reduction temperature, flow rate of H$_2$-5%/$N_2$-95% mix gas, and ball milling conditions have been investigated on the sake of PDP(Plasma Display Panel) application. The characteristics such as particle morphology and photoluminescence of prepared phosphors were compared to those of commercial Zn$_2$SiO$_4$:Mn Phosphors. It was found that the Phosphor synthesized at 130$0^{\circ}C$ with 0.08 Mn concentration had a maximum brightness, This brightness was increased more 20% by reduction treatment under 100me/min flow rate of 5%H$_2$-95%$N_2$ mixed gas. The size of particles decreased under 3$\mu\textrm{m}$ after ball milling. Especially, higher luminescence was obtained in our Zn$_2$SiO$_4$:Mn phosphors than commercial Zn$_2$SiO$_4$:Mn phosphors, so that they are able to be applied for PDP.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.22 no.3
• /
• pp.262-268
• /
• 2009

We investigated the properties of inorganic diatomic films like silicon oxide ($SiO_2$) and zinc oxide (ZnO) and their composite films are packed as a passivation layer around Ca cells on glass substrates by using an electron-beam evaporation technique and rf-magnetron sputtering method. When these Ca cells are exposed to an ambient atmosphere, the water vapor penetrating through the passivation layers is adsorbed in the Ca cells, resulting in a gradual progress of transparency in the Ca cells, which can be represented by changes of the optical transmittance in the visible range. Compared with the saturation times for the Ca cells to become completely transparent in the atmosphere, the protection effects against permeation of water vapor are estimated for various passivation films. The thin composite films consist of$SiO_2$ and ZnO are found to show a superior protection effect from water vapor permeation compared with diatomic inorganic films like $SiO_2$ and ZnO. Also, this inorganic thin composite films are also found that their protection effect against permeation of water vapor can be significantly enhanced by choosing their suitable composition ratio and deposition method, in addition, the main factors affecting the permeation of water vapor through the oxide films are found to be the polarizability and the packing density.