• Journal of Sensor Science and Technology
• /
• v.5 no.1
• /
• pp.37-42
• /
• 1996

ZnO films have been deposited on oxide grown Si wafers by the conventional thermal evaporation method. Anhydrous zinc acetate was directly heated and sublimed in the laboratory-made brass boat. The substrates temperature varied from $200^{\circ}C$ to $600^{\circ}C$. Oxygen has been flowed into the deposition chamber to change the partial pressure of oxygen. The films deposited at high oxygen pressure exhibited higher resistivity than films at low pressure. X-Ray Diffraction(XRD), Energy Dispersive Spectroscopy(EDS) and Rutherford Backscattering Spectrometry (RBS) were conducted on the films to reveal the crystallinity and composition of the ZnO films. The ZnO films deposited at high oxygen pressure were extremly sensitive to the humidity of higher than 70 % RH.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07b
• /
• pp.1092-1095
• /
• 2004

The $ZnGa_2O_4$ phosphor target is synthesized through solid-state reactions as calcine and sintering temperature in order to deposit $ZnGa_2O_4$ phosphor thin film by rf magnetron sputtering system. The $ZnGa_2O_4$ phosphor thin film is deposited on $Pt/Ti/SiO_2/Si$ substrate and prepared $ZnGa_2O_4$ Phosphor thin film is annealed by rapid thermal processor(RTP) at $750^{\circ}C$, 10 sec. The x-ray diffraction patterns of $ZnGa_2O_4$ phosphor target and thin film show the position of (311) main peak. The cathodolumincsccnce(CL) succtrums of $ZnGa_2O_4$ phosphor target show main peak of 360nm and broad bandwidth of about 180nm.

• Journal of the Korean Ceramic Society
• /
• v.47 no.5
• /
• pp.467-473
• /
• 2010

The objective of this study is to prepare lead-free thick film resistor (TFR) paste compatible with AlN substrate for hybrid microelectronics. For this purpose, CaO-ZnO-$B_2O_3-Al_2O_3-SiO_2$ glass system was chosen as a sintering aid of $RuO_2$. The effects of the weight ratio of CaO to ZnO in glass composition, the glass content and the sintering temperature on the electrical properties of TFR were investigated. $RuO_2$ as a conductive and glass powder were dispersed in an organic binder to obtain printable paste and then thick-film was formed by screen printing, followed by sintering at the range between $750^{\circ}C$ and $900^{\circ}C$ for 10 min with a heating rate of $50^{\circ}C$/min in an ambient atmosphere. The addition of ZnO to glass composition and sintering at higher temperature resulted in increasing sheet resistance and decreasing temperature coefficient of resistance. Using $RuO_2$-based resistor paste containing 40 wt%glass of CaO-20.5%ZnO-25%$B_2O_3$-7%$Al_2O_3$-15%$SiO_2$ composition, it is possible to produce thick film resistor on AlN substrate with sheet resistance of $10.6\Omega/\spuare$ and the temperature coefficient of resistance of 702ppm/$^{\circ}C$ after sintering at $850^{\circ}C$.

• Journal of the Semiconductor & Display Technology
• /
• v.21 no.4
• /
• pp.106-109
• /
• 2022

The green-emitting Zn₂SiO₄:Mn²⁺ phosphor film was evaluated in a xenon excimer lamp. The phosphor film with 2 ㎛ thick was formed of monolithic structure on the inner side of quartz through a long-time annealing process of coated ZnO solution doped with Mn²⁺ ion and SiO₂ of quartz tube. The coated quartz was filled with 100 torr of xenon gas, and simultaneously both sides was melt and sealed. The xenon-field quartz tube was discharge by applying the voltage of 15 kV with a frequency of 26 kHz, and emitted the glow with dominant peak at 172 nm. The vacuum ultraviolet excited the inner-side coated Zn₂SiO₄:Mn²⁺ phosphor film, which emitted the pure and strong green light.

• KIEE International Transactions on Electrophysics and Applications
• /
• v.3C no.6
• /
• pp.241-245
• /
• 2003

ZnO thin films on (l00) p-type Si and sapphire substrates have been deposited by a pulsed laser deposition technique using an Nd:YAG laser with a wavelength of 266 nm. The influence of the deposition parameters such as oxygen pressure, substrate temperature and laser energy density on the properties of the grown films was studied. The experiments were performed for substrate temperatures in the range of 200∼50$0^{\circ}C$ and oxygen pressure in the range of 100∼700 sccm. All of the films grown in this experiment show strong c-axis orientation with (002) textured ZnO peak. With increasing substrate temperature, the FWHM (full width at half maximum) and surface roughness were decreased. In the case of using sapphire substrate, the intensity of PL spectra increased with increasing ambient oxygen flow rate. We investigated the structural and morphological properties of ZnO thin films using X-ray diffraction (XRD), scanning electron microscopy (SEM) and atomic force microscopy (AFM).

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.25 no.1
• /
• pp.24-28
• /
• 2012

In this study, we fabricated an amorphous InGaZnO pseudo-MOS transistor (a-IGZO ${\Psi}$-MOSFET) with a stacked $Si_3N_4/SiO_2$ (NO) gate dielectric and evaluated reliability of the devices with various thicknesses of a $SiO_2$ buffer layer. The roles of a $SiO_2$ buffer layer are improving the interface states and preventing degradation caused by the injection of photo-created holes because of a small valance band offset of amorphous IGZO and $Si_3N_4$. Meanwhile, excellent electrical properties were obtained for a device with 10-nm-thick $SiO_2$ buffer layer of a NO stacked dielectric. The threshold voltage shift of a device, however, was drastically increased because of its thin $SiO_2$ buffer layer which highlighted bias and light-induced hole trapping into the $Si_3N_4$ layer. As a results, the pseudo-MOS transistor with a 20-nm-thick $SiO_2$ buffer layer exhibited improved electrical characteristics and device reliability; field effective mobility(${\mu}_{FE}$) of 12.3 $cm^2/V{\cdot}s$, subthreshold slope (SS) of 148 mV/dec, trap density ($N_t$) of $4.52{\times}1011\;cm^{-2}$, negative bias illumination stress (NBIS) ${\Delta}V_{th}$ of 1.23 V, and negative bias temperature illumination stress (NBTIS) ${\Delta}V_{th}$ of 2.06 V.

• Journal of Information Display
• /
• v.2 no.3
• /
• pp.39-43
• /
• 2001

The glass compositions of $PbO-SiO_2-B_2O_3$ system and $P_2O_5-PbO-ZnO$ system for the transparent dielectric materials for front panel and $P_2O_5$-ZnO-BaO and $SiO_2-ZnO-B_2O_3$ for the reflective dielectric materials for back panel of PDP (Plasma Display Panel) were investigated. As a result, transparent dielectric materials for front panel showed good dielectric properties, high transparency, and proper thermal expansion matching to soda lime glass substrate. And the reflective dielectric layers for back panel were prepared from two series of parent glass and oxide filler. It was found that these glassceramics are useful materials for dielectric layers in PDP device, as they have similar thermal expansion to soda-lime glass plate, high reflectance, and low sintering temperature. In particular, the addition of $BPO_4$ and $TiO_2$ as fillers to $SiO_2-ZnO-B_2O_3$ system is considered to be the most effective for acquiring good properties of lower dielectric layer for PDP device.

• The Transactions of The Korean Institute of Electrical Engineers
• /
• v.65 no.11
• /
• pp.1835-1839
• /
• 2016

In this study, ZnO nanorods were grown by a hydrothermal method. $SiO_2/Si$ wafers and glass were used as substrates. ~20 nm-thick ZnO thin films were rf magnetron sputtered for seed layers. The precursor was prepared by mixing zinc nitrate hexahydrate and hexamethylenetetramine (hexamine) in DI water. The concentration of zinc nitrate hexahydrate was fixed at 0.05 mol, and that of hexamine was varied between 0 mol to 0.1 mol. The reactor containing substrates and precursor was put in an oven maintained at $90^{\circ}C$ for 1 h. X-ray diffraction was carried out to analyze the crystallinity of ZnO nanorods, and a field emission scanning electron microscope was employed to observe the morphology of nanorods. Transmittance and absorbance were measured by a UV-Vis spectrophotometer. Photoluminescence measurements were conducted using 266 nm light.

• Proceedings of the KIEE Conference
• /
• 2001.11a
• /
• pp.3-5
• /
• 2001

ZnO thin films are deposited on $SiO_2$/Si (111) substrate by RF magnetron sputtering. The two-step deposition method is proposed to enhance both the c-axis orientation and the resistivity of ZnO films. This method consists of the following two procedures: the 1 st-deposition for 30 min without oxygen at l00W and the 2nd-deposition with oxygen added in the range of $O_2/(Ar+O_2)=10{\sim}50%$. Effects of thermal treatment on the properties of ZnO films are systematically investigated.

• Korean Journal of Materials Research
• /
• v.8 no.9
• /
• pp.860-864
• /
• 1998

We investigated the photoluminescence and the crystalline properties with Ga doping concentrations (0-12 mol%) in $\textrm{Zn}_{1.98}\textrm{Mn}_{0.02}\textrm{SiO}_{4}$ green phosphors prepared by the solid state reaction. The photoluminescence was improved by a doping of Ga element in $\textrm{Zn}_{1.98}\textrm{Mn}_{0.02}(\textrm{Si_{1-x}\textrm{Ga}_{x})\textrm{O}_{4}$ phosphors which showed the highest emission intensity and good color purity in the doping concentration of x=0.08. The emission intensity of $\textrm{Zn}_{1.98}\textrm{Mn}_{0.02}(\textrm{Si_{1-x}\textrm{Ga}_{x})\textrm{O}_{4}$(x= 0.08) phosphors was increased to 7 times with increasing the sintering temperatures from $1100^{\circ}C$ to $1400^{\circ}C$, showing the improved crystalline quality. The decay time was not affected by Ga doping concentrations with constant values around 24ms. It was found from SEM and PSA analyses that the phosphors were composed of a large number of small grains around 1-3$10\mu\textrm{m}$ with a small amounts of agglomerated particles above $10\mu\textrm{m}$.