• Journal of Welding and Joining
• /
• v.20 no.2
• /
• pp.102-108
• /
• 2002

Resistance spot welding of aluminum alloys is based upon Joule heating of the components by passing a large current in a short duration. Since aluminum alloys have the potential to replace steels fur automobile body assemblies, it is important to study the process robustness of aluminum spot welding process. In order to evaluate the effects of process parameters on the weld quality, major process variables and abnormal process conditions were selected and analyzed. A newly developed two-stage, sliding-level experiment was adopted fur effective parameter design and analysis. Suitable ranges of welding current and button diameters were obtained through the experiment. The effects of the factors and their levels on the variation of acceptable welding current were considered in terms of main effects. From the results, it is concluded that any abnormal process condition decreases the suitable current range in the weld lobe curve. Pareto analysis of variance was also introduced to estimate the significant factors on the signal-to-noise (S/N) ratio. Among the six factors studied, fit-up condition is found to be the most significant factor influencing the SM ratio. Using a Pareto diagram, the optimal condition is determined and the SM ratio is significantly improved using the optimal condition.

• Journal of the Korea Institute of Information and Communication Engineering
• /
• v.10 no.4
• /
• pp.724-730
• /
• 2006

The earth resistance is a essential basic factor of the performance of the earth. The earth enables system to be operated in a stable way not only against thunderbolts, unexpected transitional currents, the inflow of voltages and electric noises but also protect human life from electric shocks. In a domestic case, there is a technique criterion about earth technique but it falls short of reality since the content is very limitted, which causes a lot of problems to establish communications facilities. This paper gives the results through actual measurement or the earth resistance as reffered date in a way to improve these problems.

• Clinical and Experimental Pediatrics
• /
• v.46 no.10
• /
• pp.1032-1035
• /
• 2003

In pseudohypoparathyroidism as reported by Albright in 1942, the parathyroid gland can normally synthesize and secrete parathyroid hormone(PTH). Pseudohypoparathyroidism has a similar biochemical finding with hypoparathyroidisms like hypocalcemia and hyperphosphatemia due to target tissue resistance to PTH. Administered PTH does not raise the serum levels of calcium and urinary phosphate. PTH activates G-protein in peripheral tissue and adenylate cyclase through a second messenger, cAMP. Pseudohypoparathyroidism produces hyperphosphatemia and hypocalcemia because of the resistance to PTH in peripheral tissue due to a defect of G-protein, although it releases PTH normally. According to the mechanism of resistance, pseudohypoparathyroidism is classified into types : Ia, Ib, Ic and psedopseudohypoparathyroism. Type Ia is accompanied by congenital growth retardation and abnormal bony development that shows mental retardation, obesity, low height, round face, short metacarpal bone and metatarsal bone, ectopic calcification, etc. We report a case of pseudohypoparathyroidism in a premature who shows hypocalcemia, hyperphosphatemia, elevation of serum PTH and 24 hr urinary basal c-AMP in biochemical tests without Albright's hereditary osteodystrophy at physical examination, accompanied by a spontaneous fracture in the femur.

• Geotechnical Engineering
• /
• v.3 no.3
• /
• pp.21-30
• /
• 1987

Some methods are presented to estimate the ultimate lateral resistance of single active piles subjected to lateral loads above the ground surface, considering the lateral soil reaction, the pile length and the fixity condition of a pile head. The lateral soil reaction acting on a single active pile embedded in soil due to pile movement can be estimated by use of a theoretical equation which is derived by considering especially the plastic state of ground surrounding the pile and the pile- section shape. The piles are named short or long depending upon the relative magnitude of the induced bending moment to the yielding moment. As for the fixity condition of a pile head, the free head and the unrotated head are considered. Comparison with other experimental results gives that the calculated ultimate lateral resistance obtained by the author's theory is closer to experimental results than the one obtained by Brom's theory.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.5 no.4
• /
• pp.191-197
• /
• 2012

In this paper, method using electric braking from stop area to high-speed area was presented in order to improve air-brake. And electric braking method can be improved environmental problems, efficiency, economy, etc.. Method for electrical complete braking are two ways that method of inserting series resistance between the motor and the inverter, and method of inverter output voltage increase. In this paper, use series resistance insert method because economical and easy to apply. In addition, Series resistor is used short circuit method for reduce the power loss. In improved efficiency and the laboratory environment for secure braking, resistance insert method and inverter output voltage increase method showed same characteristics in all areas.

• The Journal of Korea Institute of Information, Electronics, and Communication Technology
• /
• v.5 no.3
• /
• pp.127-137
• /
• 2012

In this paper, method using electric braking from stop area to high-speed area was presented in order to improve air-brake. And electric braking method can be improved environmental problems, efficiency, economy, etc. Method for electrical complete braking are two ways that method of inserting series resistance between the motor and the inverter, and method of inverter output voltage increase. In this paper, use series resistance insert method because economical and easy to apply. In addition, Series resistor is used short circuit method for reduce the power loss. In improved efficiency and the laboratory environment for secure braking, resistance insert method and inverter output voltage increase method showed same characteristics in all areas.

• Proceedings of the Korean Institute of IIIuminating and Electrical Installation Engineers Conference
• /
• 2003.11a
• /
• pp.279-281
• /
• 2003

We analysed the operating properties of resistive type superconducting fault current limiters (SFCLs) based on YBCO thin films with a single line-to-ground fault. When a single line-to-ground fault occurred, the short circuit current of a fault phase increased up to about 6 times of transport currents immediately after the fault instant and was effectively limited to the designed current level within 2 ms by the resistance development of the SFCL. The fault currents of the sound phases almost did not change because of their direct grounding system. The unsymmetrical rates of a fault phase were distributed from 6.4 to 1.4. It was found that the unsymmetrical rates of currents were noticeably improved within one cycle after the fault instant. We calculated the zero phase currents for a single line-to-ground fault using the symmetrical component analysis. The positive sequence resistance was reduced remarkably right after the fault but eventually approached the balanced positive resistance component prior to the system fault. This means that the system reaches almost the three-phase symmetrical state in about 60 ㎳ after the fault. The ground currents were almost 3 times of the zero phase mts since most of the fault currents flowed through the grounding line.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2007.11a
• /
• pp.68-69
• /
• 2007

To make cost-effective solar cells, We have to use low cost material or make short process time or high temperature process. In solar cells, formation of emitter is basic and important technique according to build-up P-N junction. Diffusion process using spin-on dopants has all of this advantage. In this paper, We investigated n+ emitter formation spin-on dopants to apply crystalline silicon solar cells. We known variation of sheet resistance according to variation of temperature and single-crystalline and multi-crystalline silicon wafer using Honeywell P-8545 phosphorus spin-on dopants. We obtain uniformity of sheet resistance within 3~5% changing RPM of spin coater.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2004.07a
• /
• pp.547-550
• /
• 2004

Superconducting fault current limiter(SFCL) is expected to be introduced into electric power system in future as an effective countermeasure for the increase of the short-circuit current due to the growth of the electric power system. SFCL has a merit that the fault current can be limited by the resistance generated when a superconductor transits from a superconducting state to a normal state without additional detecting device. In this paper, we investigated the resistance variance of resistive type SFCL and the fault current limiting characteristics due to the amplitude of source voltage. We could obtain the more effective fault current limiting characteristics of SFCL as the source voltage increased.

• Journal of Life Science
• /
• v.7 no.4
• /
• pp.347-354
• /
• 1997

Some attempts were made to investigate the gentic characteristics of the brown planthopper(BPH), Nilaparvata lugens Sta${\aa}$l, biotypes. In terms of egg and nymphal periods, egg hatcgability, emergence ratio, and population change of BPH and plant damage of rice cultivars by the infestation of BPH biotypes and their hybrid progenies in field conditions. The egg and nymphal periods of the three of BPH biotypes and their hybrid progenies on Dongjinbyeo with no resistance gene were shorter than on rice cultivars with resistance gene. But the periods of biotype-2(♀) X 2(♂) (E) on Samgangbyeo with Bph-1 gene and biotype-3(♀) X 3(♂)(I) on Mirying 63 with bph-2 gene were as short as on Dongjinbyeo. The egg hatchability and emergence ratio of the three Bph biotypes and their hybrid progenies on Dongjinbyeo were higher than on the other rice cultivars, and those of E on Samgangbyeo and I on Miryang 63 were as high as on Dongjinbyeo. In rice paddy field, biotype-1(♀) X 1(♂)(A)$\sim$I infested on Dongjinbyeo, E onSamgangbyeo, and I on Miryang 63 were increased their population densities remarkably in next generation. Dongjinbyeo infested by A$\sim$I, and Myryang 63 infested by I were hopperburned at 60 days after infestation and had a damage rating of 0.9. But Samgangbyeo infested by E was no hopperburn(damage rating: 7.3) though it showed high BPH population at 60 days after infestation.