• International Journal of Naval Architecture and Ocean Engineering
• /
• v.13 no.1
• /
• pp.75-85
• /
• 2021

The broadband noise can be dominant or important for total characteristics for marine propeller noise representing the minimum base of self-noise. Accurate prediction of such noise is crucial for survivability of underwater military vessels. While the FW-H Formulation 1B can be used to predict broadband trailing edge noise, the method required experiment measurements of surface pressure correlations, showing its limitations in generality. Therefore, in this study, the methods are developed to utilize wall pressure spectrum models to overcome those limitations. Chase model is adopted to represent surface pressure along with the developed formulations to reproduce pressure statistics. Newly developed method is validated with the experiments of airfoils at different velocities. Thereafter, with its feasibility and generality, the procedure incorporating computational fluid dynamics is established and performed for a propeller behind submarine hull. The results are compared with the experiments conducted at Large Cavitation Tunnel, thus showing its usability and robustness.

• Journal of KSNVE
• /
• v.10 no.2
• /
• pp.345-352
• /
• 2000

Recently, it becomes to be very important to reduce the cabin noise of passenger ship, according to the trend of speedy and luxury ship. The noise reduction and control techniques should be considered as important factors from the viewpoint of the sound problem of cabin. Therefore, ship designer has to improve the sound quality as well as to redece the sound pressure level in cabins. In this paper, for the new approach of these problems, we tried to find the trends of noise and sound quality of high-speed coastal passenger ships. Loudness, roughness, fluctuation strength, and sharpness are selected as the parameters for the evaluation of sound quality. The parameters are calculated by using the sound measured in cabin while the ship is running. Furthermore we tried to find the trend of each parameter in cabins and compare with that of sound pressure level. As results, we find that the loudness is linearly proportional to sound pressure level. But, the other parameters show different trends which may be caused by ship motion on the wave and fluctuation of propelling power.

• The Journal of the Acoustical Society of Korea
• /
• v.38 no.1
• /
• pp.73-81
• /
• 2019

This paper proposes an acoustical inversion method using cepstrum analysis of underwater ship noise. Through the cepstrum analysis, multipath structure can be extracted from the recorded ship noise. The multipath structure comes from interferences between a direct arrival and multiple reflections from the sea surface and the bottom. The acoustic inversion is the optimization process to find the best parameters which show good correlation between cepstrums of the measured signal and the replica. The inversion method was applied to the underwater ship radiated noise data measured at Straits of Korea in order to estimate the acoustic center of the ship and the hydrophone position. The inversion results showed good agreement with the measured information.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2004.11a
• /
• pp.550-553
• /
• 2004

Recently, the demand for the Floating, Production, Storage, and Offloading facility (FPSO) which has some economic and technical advantages, has increased in offshore oil production areas. The 36,8000 DWT class FPSO was built in Hyundai Heavy Industries and will be installed in Offshore Angola. She dose not have self-propulsion system, but has additional facilities for oil production and positioning system. Main noise sources are contributing to the cabin noise of the accommodation are classified into three classes such as the machinery in the engine room and the deckhouse, HVAC system, and the topside equipments. In general, the noise regulation for the offshore structure is severer than that of the cargo ship and acceptable noise limit of cabin is specified as 45 dB(A). This paper describes the procedure of noise analysis, the countermeasures of noise control, and the measurement results of the quay trial. In order to minimize the noise levels, careful attention have to be paid by the special committee of experts from the initial design stage to the delivery. Proper countermeasures, considering the characteristics of sources and receiver spaces, were applied from the noise prediction and various experiment results. Finally, this ship was successfully delivered with excellent noise properties. The technology to minimize the noise levels for FPSO has been established throughout the construction of this ship.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.15 no.6 s.99
• /
• pp.738-748
• /
• 2005

The ship radiated noise level fluctuates by the difference of interference and reverberation according to measurement methods and environmental conditions. These phenomena cause error of the source level estimation even in the same environment conditions. This paper describes a quantitative analysis and a reduction method for an error value to the source level estimation in spatial and temporal interference environment. The design criteria of the radiated noise measurement array composed of omni-directional hydrophones and the source level accuracy in the deep water range are given. The source level accuracy in the shallow water range is also derived based on the statistical model of the multiple reflection paths. The results are verified using the water tank experiment and the sea trial.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.26 no.4
• /
• pp.365-374
• /
• 2016

The underwater radiated noise can be reduced by decreasing the structure borne noise of the on-board equipment. Therefore, the structure borne noise of the onborad installed equipment is strongly restricted by ROK navy with MIL-Std 740-2. Usually, the vibration transmissibility from the equipment to the hull of the ship is dependent on its mount characteristics. Even though the double mount structure is proper to apply for ship board application rather than single mount, it is not widely applied due to the weight and volume resriction of the ship. Therefore, in this research, the base using sandwitch panel which can act as double mount structure is suggested and its noise reduction capacity is verified with analytic calculation as well as experiment.

• Proceedings of the KIEE Conference
• /
• 2006.07b
• /
• pp.1012-1013
• /
• 2006

Marine technology must advance to meet the needs of a wealthier and more demanding public while at the same time provide greater environmental protection. Pollution noise and vibration is the specific issue being discussed in this paper Noise is of course due to vibration from high speed engines driving generators, entilators, winch and other gear, while underwater noise pollution results from the propellers and the resistance produced by the hull of the ship moving through the water. Vibration is also a factor in potential damage to sensitive electronic gear and metal fatigue. The issue of noise pollution does not cease when a vessel enters her berth and the main engines shut down. There is still the matter of ventilation and other mechanical factors at work to maintain a comfortable, efficient environment. We measured the noise level and vibration displacement in the training ship A-Ra at underway and Berth. The authors analyzed the frequency of noise and maximum vibration displacement in the position.

• Journal of Advanced Marine Engineering and Technology
• /
• v.38 no.4
• /
• pp.396-402
• /
• 2014

The measurement of air-borne noise in a naval ship is a crucial element. Because the noise in a naval ship interferes with a communication between crews and finally it causes to reduce the combat power. Thus, most of newly built ships have to satisfy the criteria of air-borne noise in the stage of delivery of a naval ship. In order to evaluate success or failure of criteria, uncertainty of the measurement should be considered. This study introduces the test method for the measurement of the air-borne noise in a naval ship and is concerned with the evaluation of uncertainty. The uncertainty results which was from the measurement of air-borne noise in 7 naval ships newly built satisfy the error tolerance(2dB). Therefore, it is need to reduce the error tolerance for the reliable measurement result.

• Journal of Ocean Engineering and Technology
• /
• v.33 no.2
• /
• pp.196-202
• /
• 2019

In this study, the excessive noise and vibration phenomena of a high-speed Ro/Ro passenger ship were analyzed, and a countermeasure was taken based on them. This ship was granted a comfort class notation by the classification society, which was COMFORT-VIBRATION-II and COMFORT-NOISE-CREW-II. However, unfortunately, excessive noise and vibration in the aft part of the ship were delivered from the twin shaft propellers, and therefore the Class Requirement was not satisfied before delivery. In order to obtain the class notation, all of the concerned parties came to an agreement to reduce the noise and vibration level during operation after delivery because a seasonal ferry service was already scheduled and the cabin was fully booked. The root cause of the massive amount of noise and vibration was mainly the propeller-induced excitation pulse and beating that occurred from the mismatch of the rotating speeds of the two shaft lines. A 1st order vibrating force and beating phenomena existed in the propeller. Thus, a reduction of the excitation force, elimination of the beating phenomena, and decrease of the noise level at the aft area cabins and public spaces were required. In addition, structural reinforcements were conducted using pillars and additional girders at the aft part of the decks.

• Ocean Systems Engineering
• /
• v.1 no.3
• /
• pp.249-261
• /
• 2011

The stochastic nonlinear dynamic behavior and probability density function of ship rolling are studied using the nonlinear dynamical systems approach and probability theory. The probability density function of the rolling response is evaluated through solving the Fokker Planck Equation using the path integral method based on a Gauss-Legendre interpolation scheme. The time-dependent probability of ship rolling restricted to within the safe domain is provided and capsizing is investigated from the probability point of view. The random differential equation of ships' rolling motion is established considering the nonlinear damping, nonlinear restoring moment, white noise and colored noise wave excitation.