• Journal of the Korean Chemical Society
• /
• v.9 no.1
• /
• pp.49-54
• /
• 1965

One of the difficult and time consuming problems in the production of magnesia from sea water is a settling rate of magnesium hydroxide. In this experiments, authors attempted to accelerate its settling rate by addition of various sedimenting agents as C.M.C., Separan and Starch, and sought for optimum calcination temperature for domestic dolomite, as alkali source, mole ratio of dolomite milk to bittern. It is observed through experiments that the small amounts of sedimenting agents, C.M.C., Separan, starch, 20 mg/l, 40 mg/l, 400mg/l, respectively increase the settling rate of magnesium hydroxide by 8 times or more. The following conditions resulted in good yield of magnesium hydroxide from sea water with relatively tolerable calcium oxide contaminated for the magnesium clinker. Calcinating temperature, $1,100{\sim}1,200^{\circ}C$, mole ratio of 10% dolomite milk to magnesium salts in sea water or bittern, 1. 2 : 1.

• Proceedings of the Korean Society of Soil and Groundwater Environment Conference
• /
• 2002.09a
• /
• pp.355-358
• /
• 2002

A sediments are Integral called as gravel, sand, clay, mineral materials which are settling in bottom layer of reservoir, stream, and oceans from land. In practical problems relations of sediments are flood by decreed of flow capacity and down of water quality. Dredged sediments are composed with constructed material and variety of pollutant compounds. Therefore, it is very much of cost effects in nationally, if development for use of constructed material separated only constructed material within sediments. And it will be continue to the dredge operation of stream sediment for retrofit of water environment and sustainable's after the years. The following results could be obtained : In case of high concentration sediments, sample for design of CDF was shown property of flocculent settling. Assuming that average inflow rate is 1, 000㎥/hr, mean residence time( $T_{d}$), average ponding depth( $H_{pd}$ ), and design surface area for flocculent settling( $A_{df}$ ) were 5 hr, 0.6m, and 15, 750 $m^2$ respectivelyrespectivelyy

• Transactions of the Society of Information Storage Systems
• /
• v.3 no.1
• /
• pp.28-33
• /
• 2007

최근 Hard Disk Drive(HDD)는 컴퓨터 산업의 발달과 함께 멀티미디어 어플리케이션의 요구에 따라 대용량화 추세에 있다. 이러한 대용량 HDD 는 고밀도, 고정밀의 track 정보가 필요하게 되고, 이는 HDD 생산에 고속, 고정밀의 Servo Track Writer(STW)를 필요로 하게 되었다. 그러나, 기존의 STW 는 PID 제어기에 공진 모드 제거를 위한 notch filter 를 사용하기 때문에 고속화에는 한계가 있어 track 정보를 기록하는 생산시간의 단축이 어렵다. 본 논문에서는 이를 위하여 기존의 STW 에 공진 모드의 여기를 최소화하기 위해 제어 입력의 profile 을 설계하는데 convex optimization 을 이용한 최적화 기법을 사용하였다. 이렇게 설계된 제어 입력은 플랜트의 공진 모드가 존재하는 주파수 대역에 에너지를 최소화시켜 공진 모드의 영향을 적게 받는다. 그 결과로 빠른 settling time 과 위치 정밀도가 향상된다. 그 효과는 모의 실험을 통해 검증하였다.

• 제어로봇시스템학회:학술대회논문집
• /
• 2000.10a
• /
• pp.172-172
• /
• 2000

In this paper, we propose a new discrete-time sliding mode controller for reference tracking. Stability of tracking error is analyzed. Design method of sliding surface for tracking control is proposed. Simulation and experimental results are included to show the effectiveness of the proposed method.

• Korean Journal of Materials Research
• /
• v.7 no.2
• /
• pp.145-151
• /
• 1997

Remelting of $A-Si/SiC_{p}$ composites followed by isothermal holding and solidification, leads ro the settling of Sic particles to the bottom of the mold. With the isothermal holding time for molten $A-Si/SiC_{p}$ composites. the particle free zone increases rapidly up to approximately first 30 minutes of the holding time. Experimental resulls of the particle settling confirm that the larger SIC particles sink faster tlun the sniiller particles. An increase in volume fraction of Sic particles decreases the setrling velocity of the particles.

• Journal of the Korean Society of Manufacturing Technology Engineers
• /
• v.25 no.1
• /
• pp.75-82
• /
• 2016

In this study, a cross-damped low vibration controller was developed to reduce vibration in ultra-precision dual stage driven by master/slave principle. In master-slave structure, the master stage leads the driving motion and the slave stage follows it so as to maintain a constant gap between two stages. In this structure, a small perturbation of master stage makes big oscillations in slave servoing stage, so a low damped master stage composed of voice coil motor makes a long vibration in settling area after driving motion profile. In this research, an effective feedback damping algorithm for increase the damping characteristics of the dual stage was developed. The designed velocity damping algorithm improves the system stability and reduces the settling time of the whole system. Simulation and experimental results show that the developed algorithm reduces settling time and improves the regulating performance.

• Journal of the Korean Society of Environmental Restoration Technology
• /
• v.7 no.1
• /
• pp.97-109
• /
• 2004

The disposal of stormwater is one of the major problems in urban water management. One method of reducing peak runoff rates and other detrimental impacts of stormwater is detention storage. Detention ponds as a water quality control alternatives have been investigated by a number of researchers. Recognizing multiple roles such as flood peak attenuation, pollution removal and aesthetic enhancement, the design and management of detentions ponds deserve more research. The purpose of this research is to establish design criteria wet detention ponds to improve water quality. Water quality in detention pond discharge might be improve with physical, chemical and biological alterations. Physical alteration was focused in this study. There are several methods for estimating the suspended solid control capability of wet detention ponds. Existing models of suspended solids removal are based on sedimentation and gravity settling theory. The pollutant trap efficiency of pond is a function of several interrelating factors. Detention time is the most important factor, because it determine gravity settling quantities of pollutants. Desirable modification of physical factors for improvement of water quality in wet detention ponds are volume ratio, area ratio, length to width ratio, depth, out let location, bottom soil type. In order to apply design procedure in actual site, Namak new town development area was selected.

• Economic and Environmental Geology
• /
• v.32 no.1
• /
• pp.53-62
• /
• 1999

The possibility of heavy metal pollution by contaminated roadside soils was studied under controlled conditions. The soil samples from roadside and those from a retention pond consisting of settling particles were characterized by the XRD analyses and the sequential extraction experiments. Characterization by sequential extraction, for roadside soil indicates elevate total concentrations of heavy metals. The leaching behavior of the samples under different pH and time conditions were also studied. Differences between both types of samples result mainly from the buffering effect of carbonates, present in roadside soils and lacking from settling particles. Acid leaching of the settling particles is equivalent to the sum of FI+FII+FIII, while the amounts leached from roadside soil are lower probably from kinetic reasons. The buffering effects of carbonates were found to greatly delay the onset of the leaching reactions and the extent of dissolution in most metals except for Ca and Mn. The study of leaching kinetics at pH of 6.5 and 5 showed that Cd and Zn reached the maximum possible concentration within 3 days, while Pb did not show any sign of dissolution at both ph values. The absolute amounts of dissolved Cd and Zn increased by 7 to 9 times by decreasing the pH from 6.5 to 5, indicating slightly acidified rain may result in significant metal dissolution. As deduced from both sequential extraction and leaching experiments, the relative mobility of heavy metals is found to be : Mn=Cd>Zn>>Pb>Fe, in spite of large differences in heavy metal contents and localizations.

• Journal of Soil and Groundwater Environment
• /
• v.18 no.7
• /
• pp.54-62
• /
• 2013

Fine suspended solids and soluble heavy metals generated from mine drainage could destroy environment as the aesthetic landscapes, and depreciate water quality. Therefore, this research is focused on process development applied the actual field for controlling fine suspended solids and heavy metals, and so that bench-scale tests were performed for field application based on advanced researches. The field of mine drainage in this research was in H mine located Taebaek-si, Gangwon-do. The inclination plates were mounted 2 kinds of arrangement (octagon and radial types) in circle type settling basin. The inclination plates could be helped to settle of suspended solids; decreased 34% of suspended solids and 50% of turbidity in effluent. Radial type of inclination plates showed the results that is more efficient to settle of suspended solids (average to 3.45 mg/L) compared to octagon type. In the experiments to decrease retention time of mine drainage in settling basin from 6 hrs to 1.5 hrs, suspended solid concentration was exceeded to 30 mg/L as the standard for suspended solid at 10 days after the operation under tha retention time of 3hrs and 1.5hrs. In the tests for filtration, granular activated carbons were indicated the better effective to filtering and absorption of fine suspended solid and soluble heavy metals than anthracite.

• The Transactions of the Korea Information Processing Society
• /
• v.6 no.4
• /
• pp.952-958
• /
• 1999

This paper presented the application of GAs as a means of finding optimal solutions over a parameter space in the controller design for a fuzzy control system. The performance can involve a weighted combination of various performance characteristics such as rise-time, settling-time, settling-time, overshoot. The results obtained here are compared with those for a traditional design obtained using the root-locus method. In contrast to traditional methods, the GA-based method does not require the usual mathematical processess or mathematical model of the system. In this paper, the Ga-based Fuzzy control system combining Fuzzy control theory with the GA, that is known to be very effective in the optimization problem, will be proposed The effectiveness of the proposed control system will be demonstrated by computer simulations using task tracking position system in stable and unstable linear systems. It is shown that the GA-based controller is better than the traditional controller used It stable and unstable linear systems.