• Proceedings of the IEEK Conference
• /
• 2005.11a
• /
• pp.869-872
• /
• 2005

In this paper we present a switch wrapper for an AMBA AXI, which is an efficient on-chip-network interface compared to bus-based interfaces in a multiprocessor SoC. The AXI uses an idea of NoC to provide the increasing demands on communication bandwidth within a single chip. A switch wrapper for AXI is located between a interconnection network and two IPs connecting them together. It carries out a mode of routing to interconnection network and executes protocol conversions to provide compatibility in IP reuse. A switch wrapper consists of a direct router, AHB-AXI converters, interface modules and a controller modules. We propose the design of a all-in-one type switch wrapper.

• Proceedings of the KIEE Conference
• /
• 2001.07d
• /
• pp.2519-2521
• /
• 2001

This paper presents an auxilary beam-assisted adaptive compensation technique applied to alleviate the problem of LDV's body vibration. The LMS algorithm is applied to adaptively compensate the body vibration utilizing the reference signal provided by the auxiliary beam. The usefulness of the proposed technique is verified computer simulations performed for diverse types of target signals and body vibration.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2011.02a
• /
• pp.477-477
• /
• 2011

In this paper, we synthesize ZnO wire on Si substrate by catalyst-free thermal chemical vapor deposition (CVD). Each ZnO wire is grew up at different condition such as temperature and O2 flow rate. The Young's modulus of individual ZnO wires were estimated using quasi-static and dynamic measurements, as well as resonance frequency measurements. Using this system, current-voltage characteristics of each ZnO wire structure fabricated on a trench were measured. A new concept of electromechanical device structure combined with the piezoelectric effect of ZnO will be suggested in the end of this paper.

• Proceedings of the KIEE Conference
• /
• 2007.07a
• /
• pp.545-546
• /
• 2007

A hybrid system that uses a parallel combination of wind turbine and fuel cell is modeled. Wind energy source is characterized by its intermittent and variable nature. The output power generated by the fuel cell is stable and can be properly controlled. Therefore, fuel cell system can be added to the wind turbine system for the purpose of ensuring continuous power flow. Fuel cell helps to compensate power and regulate the frequency in power system. Simulation results show the effect of the hybrid system on power regulation. The excess power generated by the wind turbine was directed to an electrolyzer to generate hydrogen and the power deficit was compensated by the fuel cell.

• Journal of The Korean Association For Science Education
• /
• v.17 no.4
• /
• pp.435-450
• /
• 1997

The status of facilities, management for the experiment, practices, teaching methods in middle schools have been investigated. The present status and reasonable management of the middle school science education have been grasped from the questionaires. To do this 125 secondary science teachers, 1,745 students and 70 principals of schools in Korea are administered questionaires of Science Education Reserch Institute of Kyungpook National University(1996). The results of this study are as follows : The reasonable management for experiments and practices of science education were scanty in the middle school around the urban and rural school owing to the shortage of facilities and equipments, crowded class, excessive class works for teacher, excessive contents of present textbooks and insufficiency of the administrative supports etc. The current teaching method of middle school science has emphasized knowledge. This fact does not satisfy the objective of learning due to lack of the teaching method. Desirable directions for the improvement of present status of middle school science education were proposed in this paper

• Proceedings of the Korean Information Science Society Conference
• /
• 2008.06a
• /
• pp.311-312
• /
• 2008

• Proceedings of the Korean Society of Dyers and Finishers Conference
• /
• 2009.03a
• /
• pp.231-232
• /
• 2009

• 대한치주과학회:학술대회논문집
• /
• 2006.11a
• /
• pp.56-57
• /
• 2006

• Journal of the Korean Institute of Educational Facilities
• /
• v.8 no.4
• /
• pp.68-77
• /
• 2001

• Journal of the Korean Institute of Educational Facilities
• /
• v.3 no.3
• /
• pp.27-40
• /
• 1996