• Progress in Medical Physics
• /
• v.9 no.4
• /
• pp.259-266
• /
• 1998

To achieve the 2D dose distribution around the designed high dose rate Ir-192 source substitution for Co-60 brachytherapy source, we determined the exposure rate constant and tissue attenuation factors as a large depth as a 20 cm from source center. The exposure rate constant is used for apparent activity in designed source with self-absorption and encapsulation steel wall. The tissue dose delivered from the 4401 segments of 2.5 mm in a diameter and 2.5 mm height of disk-type source layer. In the experiments, the tissue attenuation factors include the tissue attenuation and multiple scattering in a medium surrounding the source. The fitted the polynomial regression with 4th order for the tissue attenuation factors are very closed to the experimental measurement data within ${\pm}$1% discrepancy. The Meisberger's constant showed the large uncertainty in large distance from source. The exposure rate constant 4.69 Rcm$^2$/mCi-hr was currently used for determination of apparent activity of source and air kerma strength was obtained 0.973 for tissue absorbed dose from the energy spectrum of Ir-192 source. In our experiments with designed high dose rate brachytherapy source, the apparent activity of Ir-192 source was delivered from the 54.6 % of actual physical source activity through the self-absorption and encapsulation wall attenuations. This paper provides the 2-dimensional dose tabulation from unit apparent activity in a water medium for dose planning includes the multiple scattering, source anisotropy effect and geometric factors.

• Journal of Radiation Protection and Research
• /
• v.38 no.4
• /
• pp.228-233
• /
• 2013

It has been continuously generated the requirement for the replacement of the main components such as a steam generator due to the deterioration of the nuclear power plant all around the world. Also, a large amount of radioactive metal was generated during the decommissioning in a short period. It is required to make an accurate measurement of the residual radioactivity for recycling the metal waste for releasing from regulatory control. In planning the measurement procedures, the influence of geometry, self-absorption, density and other relevant factors on the representativeness of the measurements should be considered for the decommissioning metal waste. In this study, the method for measurement procedures, the source term evaluation, the ways to secure representative samples, the measurement device for wide area and the self-absorption correction factors for different density were evaluated. The metal samples for measurement were prepared for securing the simple geometry and representative by melting process. The developed correction method for measuring the radioactivity a variety density of metal waste could improve the reliability of the evaluation results for clearance.

• Progress in Medical Physics
• /
• v.14 no.2
• /
• pp.81-89
• /
• 2003

The dose distributions of designed Ir-192 micro-source were investigated by dose computations which were accomplished by employing shape of encapsule material and thickness of the source for self-absorption. The computation dose derived from air-kerma rate (S$_{k}$ ) and dose rate constant (Λ) includes the anisotropy of dose distribution around the source. We got the dose rate constants in a water medium is 1.154 cGy h$^{-1}$ U$^{-1}$ . The size of the source was 0.5 mm in diameter and 3.5 mm in length and it was encapsuled in 1.1 mm$\Phi$${\times}$5.5 mm of stainless steel sealed with 0.3 mm of filter thickness. The tissue dose of reference point at 1.0 cm radial distance of the source axis was delivered 1.154 Uh$^{-1}$ (1.3167${\times}$10$^{-3}$ cGy/mCi-sec) from the S$_{k}$ 4.108U/mCi of Ir-192 source. The filtration effect contributed to air-kerma strength as exponential filtering effect of 86.2% in total attenuation, but self-absorption was 88.4% from radial dose distributions. In particular, the dose attenuations showed a rapid anisotropic distributions as 56% of reference dose along to $\pm$10 degrees from the tip of source axis and 50% for of that to source-cable direction. We persist in use the large diameter of applicator will avoid the dose anisotropy by the filtered attenuation effects along the axis of Ir-192 micro-source.

• Journal of radiological science and technology
• /
• v.40 no.4
• /
• pp.605-611
• /
• 2017

The structure of the actual detector was computed using the code of the PENELOPE. Using the standard mixed sources (450, 1,000 ml), compare the effectiveness of each energy according to various densities and height of the PENELOPE computer simulation, and calculate the effectiveness of the various environmental specimens and apply them to various environmental specimens to determine the lower limit. The values obtained by the obtained value were obtained by applying the obtained efficiency to the actual environmental specimens and obtaining the lower limit values. The density correction factor is 1.155 g of the density correction factor of $0.4g/cm^3$ (59.54keV), 1.153 (661 keV), $1.06g/cm^3$ 1.064 (1,836.04keV), 1.03, and 1.033. It was confirmed that the radioactivity concentration of environmental samples decreased as the amount of specimen was measured increases, and the MDA value decreased as time measured increases.

• Journal of The Korean Astronomical Society
• /
• v.56 no.2
• /
• pp.231-252
• /
• 2023

We present the analysis results of the simultaneous multifrequency observations of the blazar 4C +28.07. The observations were conducted by the Interferometric Monitoring of Gamma-ray Bright Active Galactic Nuclei (iMOGABA) program, which is a key science program of the Korean Very Long Baseline Interferometry (VLBI) Network (KVN). Observations of the iMOGABA program for 4C +28.07 were conducted from 16 January 2013 (MJD 56308) to 13 March 2020 (MJD 58921). We also used γ-ray data from the Fermi Large Array Telescope (Fermi-LAT) Light Curve Repository, covering the energy range from 100 MeV to 100 GeV. We divided the iMOGABA data and the Fermi-LAT data into five periods from 0 to 4, according to the prosody of the 22 GHz data and the presence or absence of the data. In order to investigate the characteristics of each period, the light curves were plotted and compared. However, a peak that formed a hill was observed earlier than the period of a strong γ-ray flare at 43-86 GHz in period 3 (MJD 57400-58100). Therefore, we assumed that the minimum total CLEANed flux density for each frequency was quiescent flux (S_q) in which the core of 4C +28.07 emitted the minimum, with the variable flux (S_var) obtained by subtracting S_q from the values of the total CLEANed flux density. We then compared the variability of the spectral indices (α) between adjacent frequencies through a spectral analysis. Most notably, α_22-43 showed optically thick spectra in the absence of a strong γ-ray flare, and when the flare appeared, α_22-43 became optically thinner. In order to find out the characteristics of the magnetic field in the variable region, the magnetic field strength in the synchrotron self-absorption (B_SSA) and the equipartition magnetic field strength (B_eq) were obtained. We found that B_SSA is largely consistent with B_eq within the uncertainty, implying that the SSA region in the source is not significantly deviated from the equipartition condition in the γ-ray quiescent periods.

• Korean Journal of Microbiology
• /
• v.1 no.1
• /
• pp.38-44
• /
• 1963

According to the experiment on pure-isolation and the related contaminants of Chlorella, the phenomena of the ecological distributions of Chlorella in Korea have been manifested in several areas and also the aim that in going to do culture, biological and physiological study of Chlorella is carried out. Contaminants very oftenly occupied on the colony of the strains taken in order to fulfil pure-isolation of Chlorella, but in accordance with being piled up the minute research on this subject, I can obtain the desirable results as follows: 1. For the pure-isolation, the duration chose the time from May to September 1957 so that may easily isolate from contaminant water with utilizing the antibiotic substances. 2. To take long time, 36-48 hours until growth of nascent through the non-sporulated, it originates from the difference of the cultured media. In addition to the above mention, the mechanism of growth until nascent through the sporulated must not always require the ligh. However the supply of metabolic energy depend upon its nutritional conditions per phase. 3. The culture of Chlorella should be based on the lower culturing except adding especial conditions such as reagent concentration of media, artifical shake of media and other facts due to the natural conditions. And also these strains grew not only in distilled water but 2% NaCl solution without any abnormality in cell it self. I, therefore, guess it is possible to culture in sea-water under phasic environment. 4. In the experiment of ammonia detection, it is caused by the sampling surroundings to contain the minute quantity of ammonia in strain No. M 918; that is the place to be plenty of Carbohydrate on behalf of protein. 5. To compare the absorption curve of chlorophyll of higher plant with that of Chlorella, the absorption zone made mostly the Same ones each other but a little absorption grade dose not clearly appear. The colony which formed giant type grows with intensive colour and green band on surrounding of the colony and after that it was changed into all the green colour and developed up to end. 6. At first phase for a week, the development of Chlorella suspends the normal condition as in vivo but after a few days, the colour of chlorophyll gradually changed into blue-yellow which secrete the mucous substances on the agar media. The cell was flew out the contained substances itself on leaving the cell wall only, or the various micro-organism diffused on the outer-region of the cell.

• Journal of the Korean Chemical Society
• /
• v.50 no.1
• /
• pp.32-36
• /
• 2006

films of gold nanoparticles were formed on indium tin oxide (ITO) by an electrodeposition method from an aminosilicate stabilized gold colloid solution. The thin films were examined by cyclic voltammetry (CV), scanning electron microscopy (SEM), UV-visible, and energy dispersive X-ray spectroscopy (EDXS). The surface coverage of gold nanoparticles on the thin film was estimated to 1.2 nanomole/cm2. An anthraquinone-2, 6-disulfonic acid, disodium salt (AQDS) self-assembled layer was generated by immersing gold thin film into 1mM of AQDS in 0.1M HClO4 solution for over 20 hours. As a result, a new absorbance peak from the multi-layers (AQDS/thin film of gold /ITO) was obtained about at 690 nm. Also, the surface plasmon absorption of multi-layers was measured by UV-Visible spectrometer along with chronoamperometry by applying the various potentials from +0.5V to -0.5V. The maximum surface plasmon absorption band at 550 nm was decreased by applying negative potentials. The change of absorbance was correlated with the surface coverage of the AQDS indicating the pseudo-capacity surface state of the AQDS layer was coupled to the energy level of the plasmonband by applied negative potentials.

• Journal of the Korean Electrochemical Society
• /
• v.11 no.4
• /
• pp.256-261
• /
• 2008

In this study, Nafion membrane was modified to prevent methanol crossover by layer-by-layer self assembly using polyaniline (PANi) as a polycation and sulfonated poly(ether sulfone) (SPES) as a polyanion onto the Nafion surface. Since PANi and SPES possess thermal and chemical stability and rigid backbone, their layer-by-layer self-assembled films on the Nafion are expected to reduce methanol permeability and to increase mechanical stability. UV-Vis absorption spectroscopy verified a linear build-up of the multilayers of PANi and SPES. We found that the thickness per bilayer was about 10 nm by TEM measurement. Although modified Nafion membrane exhibited 15% decrease of proton conductivity, it reduceded 67% of methanol permeability compared to that of the pristine Nafion membrane, resulting in 2.5 times larger selectivity. At the performance test of the fuel cell using 5M methanol as a fuel, the modified Nafion membrane showed 2.4 times higher maximum power density at $30^{\circ}C$ and 1.4 times larger at $60^{\circ}C$ than the pristine Nafion.

• Journal of the Korea Academia-Industrial cooperation Society
• /
• v.18 no.12
• /
• pp.390-399
• /
• 2017

The purpose of this study is to investigate the effects of happiness of early childhood teachers on ego resilience and job engagement. The study subjects were 243 teachers who were working in early childhood education institutes located in K and D area. The collected data were analyzed through descriptive statistics, correlation analysis, and regression analysis using SPSS 18.0 Program. The study results are as follows. First, it was identified that the level of happiness, ego resilience, and job engagement of early childhood teachers were high. Secondly, happiness, ego resilience, and job engagement of early childhood teachers had a statistically significant correlation. Thirdly, the explanation power of happiness for ego resilience was 18% and self-acceptance, a subfactor of ego resilience, had an effect. Also, the explanation power of happiness for job engagement of early childhood teacher was vitality of 23%, and it was found to affect the subfactors of vitality of job engagement in the order of self-acceptance, positive personal relationship, and control over the environment. Also, the explanation power of happiness factors for undivided attention of early childhood teacher was 17%, and self-acceptance and positive personal relationship had a significantly positive effect on the undivided attention of teachers. Lastly, the explanation power of happiness factors for absorption of early childhood teacher was 14%, and self-acceptance among happiness factors of teachers had a significantly positive effect on the undivided attention of teachers. These study results suggest that the quality of early childhood education and happiness should be improved for the early childhood teachers and this may be a positive factor for the improvement of ego resilience and job engagement.

• Journal of the Korean Ceramic Society
• /
• v.43 no.2 s.285
• /
• pp.114-120
• /
• 2006

Nano-size Au particle doped $TiO_2$ films were prepared with $Ti(OC_3H_7^i)_4$, polyvinylpyrrolidone(PVP), $HAuCl_4$ and $C_3H_7OH$ etc. by sol-gel method. $TiO_2$ gel films were obtained by the dip-coating method on the $SiO_2$ glass substrates, and then heat-treated at $700^{\circ}C$ for 10 min. The thickness of $TiO_2$ films were $0.7\~1.8\;{\mu}m$. It was found that the thickness of films prepared from PVP containing solution was about $2\~8$ times higher values than that of thin films without PVP. The size of Au particles doped in the films were about $350\~750\;nm$. Nano-size Au particle dispersed $TiO_2$ films showed high absorption peak at visible region 450nm, which made them good candidates for non-linear optical materials and photo-catalytic materials. The contact angle of $TiO_2$ film for water was $12.5^{\circ}$, and therefore it is clear that $TiO_2$ films have very high hydrophilic properties and the self-cleaning effects.