• KSII Transactions on Internet and Information Systems (TIIS)
• /
• 제8권3호
• /
• pp.924-944
• /
• 2014

This paper investigates the power allocation and outage performance of MIMO full-duplex relaying (MFDR), based on orthogonal space-time block codes (OSTBC), in cognitive radio systems. OSTBC transmission is used as a simple means to achieve multi-antenna diversity gain. Cognitive MFDR systems not only have the advantage of increasing spectral efficiency through spectrum sharing, but they can also extend coverage through the use of relays. In cognitive MFDR systems, the primary user experiences interference from the secondary source and relay simultaneously, owing to full duplexing. It is therefore necessary to optimize the transmission powers at the secondary source and relay. In this paper, we propose an optimal power allocation (OPA) scheme based on minimizing the outage probability in cognitive MFDR systems. We also analyse the outage probability of the secondary user in noise-limited and interference-limited environments in Nakagami-m fading channels. Simulation results show that the proposed schemes achieve performance improvements in terms of reducing outage probability.

• Journal of Power Electronics
• /
• 제14권1호
• /
• pp.30-39
• /
• 2014

This paper studies a new three-level pulse-width modulation (PWM) resonant converter for high input voltage and high load current applications. In order to use high frequency power MOSFETs for high input voltage applications, a three-level DC converter with two clamped diodes and a flying capacitor is adopted in the proposed circuit. For high load current applications, the secondary sides of the proposed converter are connected in parallel to reduce the size of the magnetic core and copper windings and to decrease the current rating of the rectifier diodes. In order to share the load current and reduce the switch counts, three resonant converters with the same active switches are adopted in the proposed circuit. Two transformers with a series connection in the primary side and a parallel connection in the secondary side are adopted in each converter to balance the secondary side currents. To overcome the drawback of a wide range of switching frequencies in conventional series resonant converters, the duty cycle control is adopted in the proposed circuit to achieve zero current switching (ZCS) turn-off for the rectifier diodes and zero voltage switching (ZVS) turn-on for the active switches. Finally, experimental results are provided to verify the effectiveness of the proposed converter.

• IEIE Transactions on Smart Processing and Computing
• /
• 제6권3호
• /
• pp.200-209
• /
• 2017

In this paper, we investigate the tradeoff between security and reliability for a multi-hop protocol in cluster-based underlay cognitive radio networks. In the proposed protocol, a secondary source communicates with a secondary destination via the multi-hop relay method in the presence of a secondary eavesdropper. To enhance system performance under the joint impact of interference constraint required by multiple primary users and hardware impairments, the best relay node is selected at each hop to relay the source data to the destination. Moreover, the destination is equipped with multiple antennas and employs a selection combining (SC) technique to combine the received data. We derive closed-form expressions of the intercept probability (IP) for the eavesdropping links and the outage probability (OP) for the data links over a Rayleigh fading channel. Finally, the correction of our derivations is verified by Monte-Carlo simulations.

• Asian Pacific Journal of Cancer Prevention
• /
• 제13권9호
• /
• pp.4639-4643
• /
• 2012

The burden of lung cancer in terms of mortality is the highest among all types of cancers globally. The present study aimed to evaluate lifestyle related habits, clinico-pathological profile and treatment details of lung cancer patients who were registered at Malabar Cancer Centre (MCC), Kerala, during the calendar year 2010. A retrospective evaluation was made from medical records to gather data from 281 registered lung cancer cases in 241 males and 40 females, with a male to female ratio of 6.03: 1. Approximately 89% of the cases were above 50 years of age. Among males about 91% of the cases were smokers and 62% of them had a chronic smoking habit. Adenocarcinomas, squamous cell carcinomas, non-small cell carcinomas and small cell cancers accounted for 10.7, 13.9, 17.0 and 5.7% respectively. Out of 281 cases around 67% were diagnosed with distant metastasis and the remainder had regional lymph node involvement. However, no statistically significant difference was observed for secondary site of tumor according to gender. As majority of the cases reported at MCC were in an advanced stage of the disease, histology of the secondary site from supraclavicular lymph nodes or liver was taken for diagnosis. Initiation of population based screening for early detection of cancer, and primary and secondary prevention strategies for reducing the prevalence of tobacco consumption are high priorities to reduce the lung cancer burden in Kerala.

• Ecology and Resilient Infrastructure
• /
• 제4권1호
• /
• pp.54-62
• /
• 2017

본 연구는 OpenFOAM의 large eddy simulation (LES)를 이용하여 복단면 흐름을 분석하였다. LES는 여과된 연속방정식과 운동량 방정식을 수치적으로 해석하였다. 일방정식 LES와 비균일 격자를 적용하여 벽 부근의 난류 비등방성과 이차류를 재현하였다. 복단면 개수로 난류의 LES 결과는 홍수터의 수심이 깊은 경우와 얕은 경우에 대해서 제시하였다. 이들 결과는 실험 결과와 비교하였으며 실험결과와 계산 결과는 부합되는 양상을 보여준다. 또한 이차류를 생성하는 난류 비등방성의 역할에 대해서 제시하고 있다.

• Transactions on Electrical and Electronic Materials
• /
• 제18권2호
• /
• pp.97-102
• /
• 2017

A current transformer (CT) is a type of sensor that consists of a combination of electric and magnetic circuits, and it measures large ac currents. When a large amount of current flows into the primary winding, the alternating magnetic flux in the iron core induces an electromotive force in the secondary winding. The characteristics of a CT are determined by the iron core design because the iron core is saturated above a certain magnetic flux density. In particular, when a large current, such as a current surge, is input into a CT, the iron core becomes saturated and the induced electromotive force in the secondary winding fluctuates severely. Under these conditions, the CT no longer functions as a sensor. In this study, the characteristics of the secondary winding were investigated using the time-difference finite element method when a current surge was provided as an input. The CT was modeled as a two-dimensional analysis object using constraints, and the saturation characteristics of the iron core were evaluated using the Newton-Rhapson method. The results of the calculation were compared with the experimental data. The results of this study will prove useful in the designs of the iron core and the windings of CTs.

• 한국위성정보통신학회논문지
• /
• 제9권3호
• /
• pp.91-97
• /
• 2014

본 논문은 에너지 검출 기반 협력 스펙트럼 센싱을 이용하여 주사용자와 부사용자 사이의 거리에 따른 검출 확률에 가중치를 부여하는 기법을 제안하고, 이에 따른 분석 및 모의실험 결과를 나타낸다. 주사용자와 부사용자 사이의 거리는 모두 다르다고 가정하였고, 이들 사이의 무선 채널은 레일레이(Rayleigh) 채널로 모델링하였다. 제안하는 가중치 부여 기법을 적용한 협력 스펙트럼 센싱을 수행한 결과가 가중치를 적용하지 않은 스펙트럼 센싱을 수행한 결과에 비해 커버리지를 확대 할 수 있고, 이 검출 확률에 가중치를 적용한 것이 가중치를 적용하지 않은 이전의 방식에 비해 센싱 효율이 향상 되는 것을 알 수 있었다.

• Journal of Ecology and Environment
• /
• 제32권3호
• /
• pp.183-189
• /
• 2009

This research focused on the effects of fragmentation on moth diversity in an agricultural land-scape by comparing moth species richness and abundance between hillocks and young secondary forests. We examined five sites from the southwestern part of South Korea: three sites from hillock forest and two from secondary forest. We collected moths bi-weekly from April to October for a 2-year period (2006-2007) with a UV light trap that usually attracts moths within 30 meters. Tree species richness and abundance in $20m{\times}20m$ plots at each moth sampling site showed a substantial difference in tree diversity between the two types of forest habitats. The total abundance and richness of moth species were higher in secondary forests (541 species with 4,998 individuals) than in hillock forests (423 species with 3,913 individuals), irrespective of the distance among the sites. An ordination analysis with NMDS showed that habitat is the most important factor of grouping sites. The food preferences of the dominant moth species i,n each habitat were closely related to the habitat type.

• KSBB Journal
• /
• 제23권5호
• /
• pp.398-402
• /
• 2008

Cyanobacteria havebeen identified as one of the most promising group producing novel biochemically active natural products. Cyanobacteria are a very old group of prokaryotic organisms that produce very diverse secondary metabolites, especially non-ribosomal peptide and polyketide structures. Though many useful natural products have been identified in cyanobacterial biomass, cyanobacteria produce also extracellular proteins related with NRPS/PKS. Detection of unknown secondary metabolites in medium was carried in the present study by a screening of 98 cyanobacterial strains. A degenerated PCR technique as molecular approaches was used for general screening of NRPS/PKS gene in cyanobacteria. A putative PKS gene was detected by DKF/DKR primer in 38 strains (38.8%) and PCR amplicons resulted from a presence of NRPS gene were showed by MTF2/MTR2 primer in 30 strains (30.6%) and by A3/A7 primer in 26 strains (26.5%). HPLC analysis for a detection of natural products was performed in extracts from medium in which cyanobacteria containing putative PKS or NRPS were cultivated. CBT57, CBT62, CBT590 and CBT632 strains were screened for a production of extracellular natural products. 5 pure substances were detected from medium of these cyanobacteria.

• 한국레이저가공학회지
• /
• 제16권3호
• /
• pp.11-21
• /
• 2013

As parts are becoming more complex and smaller with the development of new materials, high-quality laser precision processing is getting the limelight. Laser enables quick processing and less deformation of materials. It also enables welding with diverse materials. In this study, the pole rod and tap for the secondary battery were laser-welded using cross and coaxial nozzles. The results of the comparative analysis of cross and coaxial nozzles according to the processing parameters showed that the coaxial nozzle had more sensitive welding characteristic to the nozzle position or pressure than the cross nozzle. This indicated that the processing parameters should be carefully determined for the welding with the coaxial nozzle. The pole rod and tap were welded together in a form of T joint to improve the output of the secondary battery, and the cross nozzle had a better welding characteristic than the coaxial nozzle.