• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.1 no.1
• /
• pp.32-45
• /
• 1996

Analyses of surface sediment textures and recent benthic foraminifera were carried out to understand the change of sedimentary depositional processes in the eastern part of Kwangyang Bay. Echo-sounding images revealed that topographic change of the delta front sheet sand was caused by POSCO (Pohang Steel Company)'s dredging and reclaiming. The sand body prograded toward southeast. Fine sediments are distributed in the northeastern part of the study area. Identification of benthic foraminifera was conducted for the two selected cores from the sand body for the first time. Dominant species are Ammonia beccarii, Elphidium excavatum and Quinqueloculina lamarckiana. No abrupt change of benthic foraminiferal assemblage was observed from the sedimentary sequences.

• Journal of Korean Society of Water and Wastewater
• /
• v.27 no.2
• /
• pp.185-196
• /
• 2013

In Yongwon channel, its natural flow of seawater is blocked by the construction of Busan Newport including the container berth. The channel was transformed into a narrow and long one, where it is possible that ships are only allowed to pass through the north-side channel of Gyeonmado located at the point of river mouth to Songjeongcheon. In addition, Yongwon channel is approximately 100 m wide on average and 3,600 m long, which has the highest slenderness ratio (length/width=36). So it is considered that the changes in the terrain characteristics of Yongwon channel is likely to alter the circulation of sea water, thereby changing its water quality. In this study, the seasonal change and the spatial variation of the water quality in Yongwon channel was analyzed for the effect of land pollution using the measurement data. The mass balance calculation method is used to analyze the water pollution resulting from sediment pollutants. This result shows that the improvement of the water quality in Yongwon channel can be obtained from the sewer pipe modification and the environmental dredging.

• Korean Journal of Microbiology
• /
• v.28 no.4
• /
• pp.331-336
• /
• 1990

Annual distribution of hiterotrophic marine bacteria and seasonal characteristics were investigated in the intertidal waters and sediments in the vicinity of Kunsan of Yellow Sea, Korea. Annual distribution of heterotrophic marine bacteria ranged from $ 7.5*10^{2}$ to $1.1*10^{5}$ c.f.u./ml in water and from $1.6*10 ^{4}$ to $4.8*10^{6}$ c.f.u.per g dry sediments. As for the morphological distribution measured by epifluorescence microscopy, rod-form bacteria were distributed more than 74% of total observed bacteria during surveying periods. Average biovolume of sampled bacteria ranged from $3.19\;+-\;0.59*10^{-2}$ to $6.19\;+-\;0.76*10^{-2}$ $\mu$$m^{3}$ for coccus-form bacteria. Isolated bacteria showed various utilization of carbon sources such as glucose, maltose, lactose, xylose and arabinose, and showed tolerance at various range of salinity. It was isolated 82 genus in seawater and 114 genus in sediments. Dominant genera were Pseudomonas, Vibrio, Flavobacterium and Acinetobacter in seawater, and Pseudomonas, Acinetobacter, Vibrio, and Mycobacterium in sediments.

• ALGAE
• /
• v.23 no.4
• /
• pp.251-255
• /
• 2008

In Gamak Bay, Paralytic Shellfish Poisoning (PSP) was first detected from seafoods in 2003, however the toxin source is unknown yet. In this study, we report potential PSP producers of toxic dinoflagellates, describing morphology and abundance of cysts isolated from surface sediment of Gamak Bay. The most abundant type in these cysts was characterized with ellipsoidal and transparent wall identical to Alexandrium catenella and/or A. tamarense. Germination experiment of the cysts revealed that all motile cells germinated were morphologically identified as A. tamarense. This result suggests that A. tamarense may relate to PSP contaminations in Gamak Bay. Moreover, bottom water temperature in Gamak Bay is favorable for germination of A. tamarense cysts. Further studies are required to carry out the PSP monitoring for preventing the risk of PSP events that may outbreak in future at Gamak Bay.

• 한국지구물리탐사학회:학술대회논문집
• /
• 2007.12a
• /
• pp.87-100
• /
• 2007

Marine controlled source electromagnetics (CSEM) or sea bed logging (SBL) is an emerging technology which can provide quantitative information on hydrocarbon reservoir embedded in marine sediment. Electromagnetic responses to the resistive formation saturated with a certain amount of hydrocarbon can be characterized by less attenuated profile otherwise exponentially attenuated fields in conductive sea water or through sediments, and thus can be regarded as a direct indicator of hydrocarbon. In this paper, we introduce the technology of marine CSEM in terms of its physical characteristics and in comparison of typical three-dimensional (3-D) seismic method. History and evolution of commercial marine CSEM are also briefly summarized. We then introduce a representative case history showing how marine CSEM works in reality. Outlook of future applications and technical advances to be made are discussed. Finally, we demonstrate a test example of 2.5-D inversion of synthetic data as the groundwork of 3-D inversion of field data that is to be the ultimate goal of technical development.

• Journal of Fisheries and Marine Sciences Education
• /
• v.28 no.4
• /
• pp.947-956
• /
• 2016

This study analysed the documents of Sea Area Utilization Consultation of JongChun and ApHae located in West Coast of Korea and NaJeong located in East Coast of Korea in order to find out problems of site surveys and numerical simulations for coastal erosion projects of ocean physics, and suggested the improvement way to go. Current especially like wave-induced current is the one of the important external forces to handle coastal erosion but underestimated in the west coast. In case of east coast the various tests including wave-induced current were conducted but less efficient to find out the reasons of coastal erosion. The stiffness structure to protect coastal line like beach made the secondary erosion by using them without sufficient analysis for the erosion. In order to consult a Sea Area Utilization Consultation those are needed to review the scenarios for external forces such as wave and tidal currents, the site surveys for external forces, the net sediment analysis for years, the long periods of monitoring, and the guide line and revision of the rule for coastal erosion.

• 한국신재생에너지학회:학술대회논문집
• /
• 2006.06a
• /
• pp.419-423
• /
• 2006

Basic studies on natural gas hydrates in the East Sea were been carried out by the Korea Institute of Geoscience and Mineral Resources (KIGAM) from 2000 to 2004 involving 2D multichannel seismic lines and piston coring. 27 piston cores recovered from the deed-water Ulleung Basin of the East Sea were analyzed in this study. In piston cores cracks generally developed parallel to bedding suggest significant gas content. The core analyses showed high total organic carbon (TOC) content, sedimentation rate and heat flow of sediments. The cores recovered from the southern study area show also high residual hydrocarbon gas concentrations for the formation of natural gas hydrates. This study indicates that there is the potential for the generation of biogenic gas and the formation of natural gas hydrates in the near seafloor sediments of the study area.

• Journal of the Mineralogical Society of Korea
• /
• v.24 no.1
• /
• pp.19-29
• /
• 2011

Clay mineral assemblages of core PC25A collected from the northern part of the Aleutian Basin in the Bering Sea were examined in order to investigate changes in sediment provenances and transport pathways. Ages of core PC25A were determined by both Last Appearance Datum of radiolaria (L. nipponica sakaii; $48.6{\pm}2\; ka$) and age control points obtained by the correlations of $a^{\ast},\; b^{\ast}$, and laminated sediment layers with the adjacent core PC23A, whose ages are well constrained. The corebottom age of core PC25A was calculated to be about 57,600 yr ago and core-top might be missing during coring execution. Average contents of smectite, illite, kaolinite, and chlorite during the last glacial period are 11% (5~24%), 47% (36~58%), 13% (9~19%), and 29% (21~40%), respectively. Clay mineral assemblages of the last glacial period are characterized by higher illite and lower smectite contents than those of core MC24 representing the modern values. Illite-rich clay sediments during the warm Early Holocene were transported from the northern part of Alaska continent (Province 1) through the ice-melt waters. During the deglacial period (B${\phi}$lling-All${\phi}$rod) of MIS 2, clay-sized particles seemed to be also transported by ice-melt waters mainly from Province 2 and Province 3 located farther south than Province 1. Higher smectite content during the Last Glacial Maximum is attributed to increased amounts of clay particles from the adjacent Alaska Peninsula (Province 4). From the early to the middle MIS 3, illite and smectite contents decreased, whereas chlorite content increased. With the low sea level standing during MIS 3 the supply of clay sediments from Province 2 and Province 3 was most likely intensified. Changes in clay mineral assemblages of core PC25A located in the northern part of the Aleutian Basin in the Bering Sea are closely related to the change of surface current system caused by sea level variation during the last glacial period.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.13 no.3
• /
• pp.168-177
• /
• 2008

Trafficablility of a miner and potential environmental impacts due to mining activities should be considered in the selection of a commercial manganese nodule mining site. These two factors can be evaluated comparatively with physical properties and shear strength of sea-bed sediments. For the qualitative comparison of potential minig sites in terms of these two factors, physical properties such as water contents, void ratios, porosities, and grain densities, and shear strengths of surface sediments were determined for the three potential manganese nodule mining sites(KR1, KR2, and KR5) in the Korean manganese nodule contract area, northeast Pacific. For the study, sediment samples were collected from 107 stations from 2004 to 2006. The physical properties of surface sediments showed more significant differences between northern(KR1, KR2) and southern(KR5) blocks than between northern blocks(KR1 vs. KR2). Water content, void ratio, and porosity of sediments from KR5 were relatively higher than those from KR1 and KR2. Grain density of sediments from KR5 was relatively lower than those from KR1 and KR2. Shear strengths of the top 10cm sediments were higher in KR1 and KR2, whereas those of the deeper part were highest in KR5 block. Generally, sediments of high water contents are less suspendible than those of the low water contents by benthic disturbances, thus less disturbance is expected in the sediments of high water content by mining activities. In terms of trafficability, the shear strength of sediment below 10 cm deep is more important than shallower part because miner will disturb at least top 10 cm interval of the surface sediments. Base on these results, we conclude that KR5 area will be the best site for commercial mining among three investigated sites in this study.

• The Sea:JOURNAL OF THE KOREAN SOCIETY OF OCEANOGRAPHY
• /
• v.4 no.4
• /
• pp.390-399
• /
• 1999

Siliceous and calcareous deep-sea core sediments were collected by a multiple corer from the KODOS (Korea Deep Ocean Study) area, northeast equatorial Pacific, to compare vane shear strengths measured by two different apparatuses and in different places of on-board and on-land laboratories. The apparatuses were 1) a hand-held vane with four blades of $2.0{\times}2.0$ cm, and 2) a motorized shear vane system with four blades of $1.0{\times}0.88$ attached on a rotational viscometer. Depth profiles of shear strengths of core samples determined by the apparatuses do not show any consistent difference. Also, there is no consistent difference between shear strength values measured on-board and on-land laboratories after storing the core samples for three months in a cold room by a motorized shear vane system. However, there are considerable differences between depth profiles of shear strengths measured at four different points (holes) of a core sample. Moreover, significant differences among the profiles of different tube samples from a multiple corer within a sampling station were observed. Heterogeneity in physical properties of each depth and sediment column, possibly due to bioturbation and bottom current flows, is likely responsible for the differences in the geotechnical properties.