• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.25 no.5
• /
• pp.212-217
• /
• 2015

Ships and marine structures have a lot of problems in their high maintenance and operating cost by biofouling. A biofouling occurrs by the adhesion of marine microorganism, algae and bacteria. In this study, the aim is to prevent or to reduce the biofouling phenomena through silver nano-particle coating on artificial light-weight aggregates and geopolymer. The antibacterial activity on them is tested according to ASTM E2149-2013a. The test results showed, it is estimated that silver nano-particles removed 99.99 % of bacteria. Specimens were set up in the sea side of field test area in Korea Institute of Ocean Science and Technology (KIOST) and have been observed for five months. The anti-biofouling effect and difference in weight change rate have been detected two months later after the installation. Because silver nanoparticles inhibit bacterial growth and kill the cells by destroying bacterial membranes, silver nano-particle coating on artificial lightweight aggregates is a well-suited and eco-friendly method for preventing biofouling in the sea up to 5 months.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2015.11a
• /
• pp.113-114
• /
• 2015

This paper is to investigate the effect of poor quality aggregate source used in Korea on the mixture proportion and strength development of the high strength concrete fixed at 450 kg/m3 of cement contents. For aggregate kinds, good quality crushed stone from KS certified manufacturer and low quality crushed stone from non certified construction field are used. For fine aggregates, river sand, land sand, sea sand and mixed sand are also used. It is found that the use of low quality aggregates resulted in an increase of water demand considerably due to poor gradation of aggregate and excessive fine particles. Test results indicate that the use of low quality aggregate also decreases the compressive strength compared with that of good quality aggregate.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2005.11a
• /
• pp.459-462
• /
• 2005

Recently, interest grew on the quality of aggregates following the diminution of primary resources from river and the growing construction demand which exhausted high-quality sand sources around large cities and incited the use of low grade aggregates like shore sand and sea sand that can be supplied in natural state. Moreover, the most sensitive aspect highlighted by the unstability of aggregate supply is the quality. The extreme insufficiency of quality criteria about the materials currently used as substitute aggregates and about concrete mixed with such materials is also critical. This study investigated influence of qualities of concrete which is using mixed crushed sand and natural sand

• Proceedings of the Korea Concrete Institute Conference
• /
• 2005.11a
• /
• pp.463-466
• /
• 2005

This study examined the effects of comparatively widely used fine aggregates in the domestic construction fields on the quality of concrete through the analysis of the effects of such fine aggregates on the physical properties of fresh concrete and strength of hardened concrete. Results revealed that crushed sand degrades the fluidity and air entraining of concrete compared to natural aggregates like sea sand and river sand. Especially, the use of crushed sand exhibiting low grain shape and grade was seen to have larger adverse effect on the physical properties of concrete.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2006.05b
• /
• pp.125-128
• /
• 2006

As the ministry of construction and transportation established quality standards for recycled aggregate in August, 2005, the consumption of recycled aggregates is expected to be increased in construction fields in the future. Thus the relations between compressive strength of general concretes and that of recycled aggregate concretes which are applied to actual structures are attempted to investigate through non-destruction testing method. Presently Schmitt-Hammer test method is that concrete compressive strength is predicted by measuring surface hardness of concretes, and is well known as the most convenient and simply operated method among many non-destruction testing methods. In this study, cylinder specimen and mock-up were constructed using recycled aggregate concretes made by the first class recycled coarse aggregates and recycled fine aggregates specified in KS F 2573 (recycled aggregate for concrete), and compressive strength of hardened concrete of middle ages was evaluated.

• Journal of the Korea Institute of Building Construction
• /
• v.3 no.4
• /
• pp.79-86
• /
• 2003

The purpose of study is to offer base data for high fluid concrete mix property, as grasp effect of aggregate to reach much more effect for producing high fluid concrete. For this study, there are three types of combined aggregates, river sand + river aggregate(type A), river sand + crusted aggregate(type B), washed sea sand + crushed aggregate(type C) and take a factor, water-contents, water-binder ratio and S/a. And so, we had following conclusion, resulting application-ability of high fluid mortar by K-slump tester to use a handy consistency measuring instrument. And so, we had following conclusion, resulting application-ability of high fluid concrete by K-slump tester to use a handy consistency measuring instrument. 1) In cafe of regular water binder ratio, high fluid concrete suffered much effect of combined aggregates and water binder ratio. Range of water binder ratio by combined aggregates is w/b 0.4 downward(type A and B), w/b 0.35 downward(type C). 2) Water contents to need for producing high fluid concrete is minimum 170kg/$\textrm{m}^3$ without regard to combined aggregates. 3) The effect of S/a on high fluid concrete by combined aggregates is approximately S/a 50% (type A and B), s/a 50-55% (type C). 4) Consistency measuring of high fluid concrete by K-slump tester is possible and first indication value, high fluid concrete can be produced, is 6~10.5cm.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.6 no.4
• /
• pp.229-235
• /
• 2018

In this study, recycled aggregate and natural aggregate were mixed in advance using an aggregate mixing facility that was developed to improve the quality of recycled aggregate concrete. Then the mixed aggregate was applied and concrete characteristics before and after a mix were considered. Based on the findings extracted, this study aimed to suggest a new direction for quality stabilization and application activation of recycled aggregate. The test results of change rates of mortars and coarse aggregates in fresh concrete mixed by a concrete mixer, before and after mixing aggregates showed that the variations of the mortars and coarse aggregates in the concrete mixed with the aggregates beforehand were decreased than those in the concrete before mixing them. The variation of compressive strength and the mean compressive strength at the ages of 3 and 7 days showed similar results before and after the aggregates were mixed, and the strength at the age of 28 days before and after mixing them showed larger deviation than that at the ages of 3 and 7 days. The use of the mixed aggregates after mixing aggregates beforehand reduced the variation in strength and is believed that it is advantageous for long-age strength development. The above results show that the variations of coarse aggregates and compressive strength in the concrete using the mixed aggregates produced by mixing recycled aggregates and natural aggregates beforehand are reduced so it will be possible to produce the homogeneous concrete by mixing aggregates beforehand.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.5 no.4
• /
• pp.359-365
• /
• 2017

This study examined concrete characteristics depending on the replacement ratio of recycled fine aggregates, which suits the KS F 2573 concrete recycled aggregate standard. As physical properties, slump, air content, changes in the elapse of time and compressive strength were studied in order to provide basic data for activation of recycled fine aggregate recycling. As a result of experimenting recycled fine aggregate concrete, the increase in the replacement ratio of recycled aggregates led to the increase in slump and air content. Also, when the replacement ratio of recycled fine aggregates was 30%, it was judged that there was no problem with constructability. When the replacement ratio was 30%, recycled fine aggregate concrete had a similar tendency to natural aggregate concrete at a compressive strength of 24MPa. When the replacement ratio was 30%, at a target strength of 24MPa, recycled fine aggregate concrete had the same physical characteristics as natural aggregate concrete. This means that a replacement ratio of 30% is appropriate for replacement of recycled fine aggregates. In future, there will be a need to improve the quality of recycled fine aggregates for activating the use of recycled fine aggregates and further research will have to evaluate physical properties of recycled fine aggregate concrete using improved recycled fine aggregates.

• Journal of the Korean Recycled Construction Resources Institute
• /
• v.5 no.3
• /
• pp.247-252
• /
• 2017

The aim of this research is the feasibility analysis of the reject ash premixed cement mortar with combined aggregate. Namely, for the combined aggregate with two different qualities of aggregates, a fundamental properties of cement mortar was evaluated depending on various replacing ratios of reject ash(Ri). According to the experimental results, the combined aggregate consisted with low-quality aggregate and sea sand did not change the flow value depending on the reject ash while the combined aggregates consisted with low quality aggregate and sea sand; and consisted exploded debris sand and sea sand the increasing reject ash increased the air content with increased replacing ratio of reject ash. In the case of compressive strength, as the replacing ratio of reject ash was increased, the compressive strength was increased. It is considered that when 5% of reject ash replacing ratio made similar quality of cement mortar with favorable quality aggregate, hence, it can be suggested that 5% replacement of reject ash for desirable fluidity and compressive strength of concrete.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1995.04a
• /
• pp.78-83
• /
• 1995

In lTI2ny countries, a considemble amount of demolition waste IS generated and concrete forms a signiftcallt proportion of the waste. The neceSSity for the lIse of recycled aggregate in concrete arises due to the following reasons : (1) diminishing supplies of natuml aggregates; (2) securing ample supply of concrete aggregates to the construction industry; (3) dirninisrl! ng dumping area within the utban limits; and (4) avoid,ing danger to marine life by limiting the indiscriminate dumping of highly alkaline nature of concrete in the sea. It is the purpose of thiS report to improve the quality of recycled aggregate concrete and to put to practical use of such concrete.