• 한국결정성장학회지
• /
• 제13권5호
• /
• pp.241-246
• /
• 2003

ATO(antimony-doped tin oxide) 투명전도막을 sol-gel dip coating 방법에 의해 $SiO_2$/glass 기판 위에 성공적으로 제조하였다 ATO막의 결정상은 $SnO_2$상임을 확인하였고, 막의 두께는 withdrawal speed를 50 mm/minute로 코팅시 약 100 nm/layer였다. $SiO_2$/glass 기판 위에 코팅한 400 nm두께의 ATO 박막을 질소분위기에서 annealing한 후, 측정한 광 투과율과 전기 저항치는 각각 84%와 $5.0\times 10^{-3}\Omega \textrm{cm}$였다. 이러한 특성은 $SiO_2$막이 Na 이온의 확산을 제어하여 $Na_2SnO_3$ 및 SnO와 같은 불순물의 형성을 억제하고, 막 내부의 Sb의 농도와 $Sb^{3+}$에 대한 $Sb^{5+}$의 비를 증가시키는데 기여했기 때문으로 확인되었다. 또한, $N_2$ annealing은 $Sb^{5+}$뿐만 아니라 $Sn^{4+}$를 환원시킴으로써 전기전도도를 향상시킴을 확인하였다.

• 대한화학회지
• /
• 제24권3호
• /
• pp.183-192
• /
• 1980

$SnO_2$, Sb-doped $SnO_2$>, 그리고 백금촉매하에서 일산화탄소의 산화반응을 연구하였다. $SnO_2$ 및 Sb-doped $SnO_2$ 촉매하에서 산화반응은 CO 및 $O_2$에 대해서 각각 1차, 백금 촉매하에서는 1/2차 반응에 따랐다. $SnO_2$에 소량의 Sb첨가(dopant composition : 0.05∼0.1mole%)는 반응속도를 증가시키고 그 이상의 첨가는 오히려 반응속도를 감소시켰다. 백금 촉매하의 산화반응에서는 일산화탄소의 농도가 증가함에 따라 반응속도가 오히려 감소하는 억제효과를 보여주었다. 각 촉매하에서 산화반응의 활성화에너지는 Sb-dopoped $SnO_2$ 촉매 (dopant compisito : 0.05 mole%)에서 5.7 kcal, 백금 촉매에서 6.4 kcal이었다. 실험적으로 얻은 반응차수와 doping 효과로부터 가능한 반응메카니즘을 제안하였다.

• 한국세라믹학회지
• /
• 제51권1호
• /
• pp.43-50
• /
• 2014

We fabricated undoped and Sb-doped $SnO_2$ thin films on glass substrates by a pulsed laser deposition (PLD) process. Undoped and 2 - 8 wt% $Sb_2O_3$-doped $SnO_2$ targets with a high density level of ~90% were prepared by the spark plasma sintering (SPS) process. Initially, the effects of the deposition temperature on undoped $SnO_2$ thin films were investigated in the region of $100-600^{\circ}C$. While the undoped $SnO_2$ film exhibited the lowest resistivity of $1.20{\times}10^{-2}{\Omega}{\cdot}cm$ at $200^{\circ}C$ due to the highest carrier concentration generated by the oxygen vacancies, 2 wt% Sb-doped $SnO_2$ film exhibited the lowest resistivity value of $5.43{\times}10^{-3}{\Omega}{\cdot}cm$, the highest average transmittance of 85.8%, and the highest figure of merit of 1202 ${\Omega}^{-1}{\cdot}cm^{-1}$ at $400^{\circ}C$ among all of the doped films. These results imply that 2 wt% $Sb_2O_3$ is an optimum doping content close to the solubility limit of $Sb^{5+}$ substitution for the $Sb^{4+}$ sites of $SnO_2$.

• 한국세라믹학회지
• /
• 제29권4호
• /
• pp.319-327
• /
• 1992

Sb-doped SnO2 films were formed on Corning glass 7059 substrate by chemical vapor deposition using simulataneous hydrolysis of SnCl4 and SbCl5. Fairly good transparent conducting film with a low resistivity of ~6$\times$10-4{{{{ OMEGA }}cm and high average optical transparency above ~85% in the range of visible light was obtained at the deposition condition of 50$0^{\circ}C$ and input-gas ratio, [Psbcl5/Psncl4] of 0.05. Film conductivity was improved without loosing optical transparency at light doping of Sb and found to be due to the increase of electron concentration. However, high doping of Sb into SnO2 film largely deteriorated conductivity, optical transparency and crystallinity of the film.

• 한국결정성장학회지
• /
• 제13권5호
• /
• pp.254-259
• /
• 2003

Sol-gel dip coating법으로 soda lime glass 기판 위에 ATO(antimony-doped tin oxide) 투명전도막을 제조할 때, 기판 위에 형성된 $SiO_2$ barrier 층 및 $N_2$ gas annealing 에 따른 광투과율 및 전기적 특성에 대한 효과를 정량적으로 측정하고, XPS(X-ray photoelectron spectroscopy) 분석을 통해 고찰하였다. $SiO_2$ barrier층을 갖는 glass 기판 위에 코팅된400 nm 두께의 ATO 박막을 질소분위기에서 annealing한 결과, 광 투과율은 84%그리고 전기저항은 약 $5.0\times 10^{-3}\Omega \textrm{cm}$로 측정되었다 XPS 분석결과 이러한 우수한 전기전도성은 $SiO_2$ buffer층이 glass 기판으로부터 Na 이온의 확산을 막아 ATO막 내에 $Na_2SnO_3$ 및 SnO와 같은 2차상 불순물의 형성을 억제하여 막 내부의 Sb의 농도 및 $Sb^{5+}/Sb^{3+}$ 비를 증가시키고, $N_2$ annealing은 $Sb^{5+}$ 도 환원시키지만 $Sn^{4+}$를 환원시키는 효과가 크게 작용하였기 때문으로 사료된다.

• 센서학회지
• /
• 제22권4호
• /
• pp.302-307
• /
• 2013

The Sb-doped $SnO_2$ nanowire network sensors were prepared by thermal evaporation of the mixtures between tin and antimony powders. Pure $SnO_2$ nanowire networks showed high sensor resistance in air ($99M{\Omega}$), similar gas responses to 4 diffferent gases (5 ppm $C_2H_5OH$, CO, $H_2$, and trimethylamine), and very sluggish recovery speed (90% recovery time > 800 s). In contrast, 2 wt% Sb-doped $SnO_2$ showed the selective detection toward $C_2H_5OH$ and trimethylamine, relatively low resistance ($176k{\Omega}$) for facile measurement, and ultrafast recovery speed (90% recovery times: 6 - 18 s). The change of gas sensing charactersitics by Sb doping was discussed in relation to gas sensing mechanism.

• 한국세라믹학회지
• /
• 제37권2호
• /
• pp.194-200
• /
• 2000

Sb-doped tin oxide films were deposited on Corning glass 1737 substrate by plasma enhanced chemical vapor deposition(PECVD) technique using a gas mixture of SnCl4/SbCl5/O2/Ar. The deposition behaviors of tin oxide films by PECVD were compared with those by thermal CVD, and effects of deposition temperature, r.f. power and Sb doping on the electrical properties of tin oxide films were investigated. PECVD technique largely increased the deposition rate and smoothed the surface of tin oxide films compared with thermal CVD. Electrical resistivity decreased with doping of Sb due to the increase of carrier concentration. However, large doping of Sb diminished carrier concentration and mobility due to the decrease of crystallinity, which resulted in the increase of electrical resistivity. As the deposition temperature and r.f. power increased, Cl content in the film decreased.

• 한국전기전자재료학회논문지
• /
• 제22권3호
• /
• pp.269-276
• /
• 2009

Antimony doped tin oxide ($SnO_2:Sb$) films, which are used as the front contact and back reflector of thin film solar cells, have been deposited by d,c, magnetron sputtering. The dependence of electrical and optical properties of the films on the preparation conditions, such as $O_2$ gas ratio, substrate temperature, annealing temperature was investigated. The sputter gas composition was found to affect the properties of the films. With incorporating $O_2$ gas, the electrical and optical properties of films significantly were improved. The minimum resistivity and optical transmittance over 80 % in visible region were obtained at the oxygen concentration of 30 %, When the substrate temperature was higher, the resistivity of $SnO_2:Sb$ films was decreased, while the absorption edge shifted to shorter wavelength, indicating higher optical band gap. Heat treatment over $600^{\circ}C$ resulted in poorer electrical and optical properties due to SnO phase (102) plane.

• 한국전기전자재료학회논문지
• /
• 제28권11호
• /
• pp.690-693
• /
• 2015

In this paper, in order to develop excellent Pb-free composition ceramics for ultrasonic sensor. The $SnO_2$-doped ($Na_{0.525}K_{0.443}Li_{0.037})(Nb_{0.883}Sb_{0.08}Ta_{0.037})O_3$)(abbreviated as NKL-NST) ceramics have been synthesized using the ordinary solid state reaction method. The effect of $SnO_2$-doping on their dielectric and piezoelectric properties was investigated. The ceramics doped with 0 wt% $SnO_2$ have the optimum values of piezoelectric constant($d_{33}$), piezoelectric figure of merit($d_{33}.g_{33}$), planar piezoelectric coupling coefficient($k_p$) and density : $d_{33}=195[pC/N]$, $d_{33}.g_{33}=5.62pm^2/N.kp=0.40$, $density=4.436[g/cm^3]$. suitable for duplex ultrasonic sensor application.

• 한국세라믹학회:학술대회논문집
• /
• 한국세라믹학회 2002년도 추계총회 및 연구발표회 초록집
• /
• pp.183.1-183
• /
• 2002