• The Journal of the Petrological Society of Korea
• /
• v.10 no.3
• /
• pp.222-232
• /
• 2001

Secondary ion mass spectrometry (SIMS) uses focused high-speed primary ions to produce secondary ions from sample surface that are analyzed through a mass filter. SIMS is often called as ion microprobe, since it offers a micrometer-scale spatial resolution. Although the precision and accuracy of SIMS are not as good as many conventional mass spectrometers, it has several advantages such as small sample-size requirement, high spatial resolution and capability of in-situ analysis. In the field of geochemistry/cosmochemistry, SIMS is widely used for (1) stable isotope geochemistry of H, C, O, S, etc., (2) geochronology of U/Th-bearing minerals, (3) lateral distribution of trace elements in a mineral, and (4) discovery of presolar grains and investigation of their isotopic compositions.

• Transactions on Electrical and Electronic Materials
• /
• v.14 no.2
• /
• pp.94-100
• /
• 2013

The elements B, P and As can each be implanted in silicon; for the fabrication of integrated semiconductor devices and the wells in CMOS (complementary metal oxide semiconductor). The implanted range due to different implanted species calculated using TRIM (Transport of Ions in Matter) simulation results was considered. The profiles of implanted samples could be measured using SIMS (secondary ion mass spectrometry). In the comparison between the measured and simulated data, some deviations were shown in the profiles of MeV implanted silicon. The Moliere, C-Kr, and ZBL potentials were used for the range calculations, and the results showed almost no change in the MeV energy region. However, the calculations showed remarkably improved results through the modification of the electronic stopping power. The results also matched very well with SIMS data. The calculated tolerances of $R_p$ and ${\Delta}R_p$ between the modified $S_e$ of TRIM and SIMS data were remarkably better than the tolerances between the TRIM and SIMS data.

• Proceedings of the Korean Vacuum Society Conference
• /
• 2016.02a
• /
• pp.384.1-384.1
• /
• 2016

We reported that amorphous silicon (a-Si) thin film provide sample plate exhibiting a multimodality to measure biomolecules by secondary ion mass spectrometry (SIMS) and laser desorption/ionization mass spectrometry (LDI-MS). Kim et al.1 reported that a-Si thin film were suitable to detect small molecules such as drugs and peptides by SIMS and LDI-MS. Recently, bacterial identification has been required in many fields such as food analysis, veterinary science, ecology, agriculture, and so on.2 Mass spectrometry is emerging for identifying and profiling microbiology samples from its advantageous characters of label-free and shot-time analysis. Five species of bacteria - S. aureus, G. glutamicum, B. kurstaki, B. sphaericus, and B. licheniformis - were sampled for MS analysis without lipid extraction in sample preparation steps. The samples were loaded onto the a-Si thin film with a thickness of 100 nm which did not only considered laser-beam penetration but also surface homogeneity. Mass spectra were recorded in both positive and negative ionization modes for more analytical information. High reproducibility and sensitivity of mass spectra were demonstrated in a mass range up to mass-to-charge ratio(m/z) 1200 by applying the a-Si thin film in mentioned above MS. Principle component analysis (PCA) - a popular statistical analysis widely used in data processing was employed to differentiate between five bacterial species. The PCA results verified that each bacterial species were readily distinguished and differentiated effectively from our MS approach. It shows a new opportunity to rapid bacterial profiling and identification in clinical microbiology. More details will be discussed in the presentation.

• Bulletin of the Korean Chemical Society
• /
• v.34 no.3
• /
• pp.815-819
• /
• 2013

Micropatterns of streptavidin and human epidermal carcinoma A431 cells were successfully imaged, as received and without any labeling, using cluster $Au_3{^+}$ ion beam-based time-of-flight secondary ion mass spectrometry (TOF-SIMS) together with a principal component analysis (PCA). Three different analysis ion beams ($Ga^+$, $Au^+$ and $Au_3{^+}$) were compared to obtain label-free TOF-SIMS chemical images of micropatterns of streptavidin, which were subsequently used for generating cell patterns. The image of the total positive ions obtained by the $Au_3{^+}$ primary ion beam corresponded to the actual image of micropatterns of streptavidin, whereas the total positive-ion images by $Ga^+$ or $Au^+$ primary ion beams did not. A PCA of the TOF-SIMS spectra was initially performed to identify characteristic secondary ions of streptavidin. Chemical images of each characteristic ion were reconstructed from the raw data and used in the second PCA run, which resulted in a contrasted - and corrected - image of the micropatterns of streptavidin by the $Ga^+$ and $Au^+$ ion beams. The findings herein suggest that using cluster-ion analysis beams and multivariate data analysis for TOF-SIMS chemical imaging would be an effectual method for producing label-free chemical images of micropatterns of biomolecules, including proteins and cells.

• Mass Spectrometry Letters
• /
• v.12 no.2
• /
• pp.47-52
• /
• 2021

Evaluating the impurity concentrations in semiconductor thin films using time of flight secondary ion mass spectrometry (ToF-SIMS) is an effective technique. The mass interference between isotopes and matrix element in data interpretation makes the process complex. In this study, we have investigated the doping concentration of phosphorus in, phosphorus doped silicon thin film on glass using ToF-SIMS in the dynamic mode of operation. To overcome the mass interference between phosphorus and silicon isotopes, the quantitative analysis of counts to concentration conversion was done following two routes, standard relative sensitivity factor (RSF) and SIMetric software estimation. Phosphorus doped silicon thin film of 180 nm was grown on glass substrate using hot wire chemical vapor deposition technique for possible applications in optoelectronic devices. Using ToF-SIMS, the phosphorus-31 isotopes were detected in the range of 10¹~10⁴ counts. The silicon isotopes matrix element was measured from p-type silicon wafer from a separate measurement to avoid mass interference. For the both procedures, the phosphorus concentration versus depth profiles were plotted which agree with a percent difference of about 3% at 100 nm depth. The concentration of phosphorus in silicon was determined in the range of 10¹⁹~10²¹ atoms/cm³. The technique will be useful for estimating distributions of various dopants in the silicon thin film grown on glass using ToF-SIMS overcoming the mass interference between isotopes.

• Bulletin of the Korean Chemical Society
• /
• v.22 no.2
• /
• pp.205-209
• /
• 2001

Uniformly-doped silicon thin films were fabricated by ion beam sputter deposition. The thin films had four levels of copper dopant concentration ranging between 1 ${\times}$1019 and 1 ${\times}$ 1021 atoms/cm3 . Concentrations of Copper dopants were determined by the isotope dilution inductively coupled plasma mass spectrometry (ICP-MS) to provide certified reference data for the quantitative surface analysis by secondary ion mass spectrometry (SIMS). The copper-doped thin films were dissolved in a mixture of 1 M HF and 3 M HNO3 spiked with appropriate amounts of 65 Cu. For an accurate isotope ratio determination, both the detector dead time and the mass discrimination were appropriately corrected and isobaric interference from SiAr molecular ions was avoided by a careful sample pretreatment. An analyte recovery efficiency was obtained for the Cu spiked samples to evaluate accuracy of the method. Uncertainty of the determined copper concentrations, estimated following the EURACHEM Guide, was less than 4%, and detection limit of this method was 5.58 ${\times}$ 1016 atoms/cm3.

• Journal of the Korean Institute of Electrical and Electronic Material Engineers
• /
• v.15 no.7
• /
• pp.576-582
• /
• 2002

Nonvolatile semiconductor memory devices with reoxidized nitrided oxide(RONO) gate dielectrics were fabricated, and nitrogen distribution and bonding species which contribute to memory characteristics were analyzed. Also, memory characteristics of devices depending on the anneal temperatures were investigated. The devices were fabricated by retrograde twin well CMOS processes with $0.35\mu m$ design rule. The processes could be simple by in-situ process in growing dielectric. The nitrogen distribution and bonding states of gate dielectrics were investigated by Dynamic Secondary Ion Mass Spectrometry(D-SIMS), Time-of-Flight Secondary Ion Mass Spectrometry(ToF-SIMS), and X-ray Photoelectron Spectroscopy(XPS). As the nitridation temperature increased, nitrogen concentration increased linearly, and more time was required to form the same reoxidized layer thickness. ToF-SIMS results showed that SiON species were detected at the initial oxide interface which had formed after NO annealing and $Si_2NO$ species within the reoxidized layer formed after reoxidation. As the anneal temperatures increased, the device showed worse retention and degradation properties. It could be said that nitrogen concentration near initial interface is limited to a certain quantity, so the excess nitrogen is redistributed within reoxidized layer and contribute to electron trap generation.

• ETRI Journal
• /
• v.10 no.2
• /
• pp.63-69
• /
• 1988

SIMS(Secondary Ion Mass Spectrometry) 분석 데이터의 정량화 방법으로 이온주입에 의한 실험적 접근법과 LTE(Local Thermal Equilibrium) 모델을 사용한 준이론적 접근법 2가지가 주로 논의되고 있다. 본 고에서는 LTE 모델을 사용, SIMS data를 정량화하는 방법에 대하여 기술하였으며 아울러 BASIC language로 된 간단한 LTE 프로그램을 제시하였다.

• Polymer Science and Technology
• /
• v.24 no.5
• /
• pp.528-534
• /
• 2013

• Journal of the Korean Crystal Growth and Crystal Technology
• /
• v.11 no.5
• /
• pp.224-230
• /
• 2001

The characteristics of $NO/N_2O$ annealed reoxidized nitrided oxide being studied as super thin gate oxide and gate dielectric layers of Non-Volatile Semiconductor Memory (NVSM) were investigated by Dynamic Secondary Ion Mass Spectrometry (D-SIMS), Time-of-Flight Secondary Ion Mass Spectrometry (ToF-SIMS), and Auger Electron Spectroscopy (AES). The specimen was annealed by $NO/N_2O$ after initial oxide process and then rcoxidized for nitrogen redistribution in nitrided oxide. Out-diffusion of incorporated nitrogen during the wet oxidation in reoxidation process took place more strongly than that of the dry oxidation. It seems to indicate that hydrogen plays a role in breaking the Si N bonds. As reoxidation proceeds, incorporated nitrogen of $NO/N_2O$ annealed nitrided oxide is obsen-ed to diffuse toward the surface and substrate at the same time. ToF-SIMS results show that SiON species are detected at the initialoxide interface, and Si,NO species near the new $Si_2NO$ interface that formed after reoxidation. These SiON and $Si_2NO$ species most likely to relate to the origin of the state of memory charge traps in reoxidized nitrided oxide, because nitrogen dangling bonds of SiON and silicon dangling bonds of $Si_2NO$ are contained defects associated with memory effect.