• Phonetics and Speech Sciences
• /
• v.5 no.4
• /
• pp.227-232
• /
• 2013

Since a reverberation filter is generally much shorter than the corresponding dereverberation filter, a single-channel speech dereverberation method based on reverberation filter estimation has been developed to improve its performance. Unfortunately, a typical reverberation filter still requires too many coefficients to be accurately estimated using limited speech observations. In order to exploit sparseness of reverberation filter coefficients, in this paper, we present an algorithm to impose a sparse prior to the process of reverberation filter estimation. Simulation results demonstrate that the sparse prior imposition further improves performance of the speech dereverberation method based on reverberation filter estimation.

• Journal of Mechanical Science and Technology
• /
• v.17 no.4
• /
• pp.511-520
• /
• 2003

In room acoustics, reverberation time is an important acoustic parameter. However it is often difficult to measure short reverberation times at low frequencies with a traditional band pass filter bank if the product of filter bandwidth (B) and reverberation time (T) is small. It it well known that the minimum permissible product of bandwidth and reverberation time of the traditional band pass filter is at least 16. This strict requirement makes it difficult to measure short reverberation times of an acoustic room at low frequencies exactly. In order to reduce this strict requirement, in the previous paper, the wavelet filter bank was developed and the minimum permissible product of bandwidth and reverberation time was replaced with 4. In the present paper it is demonstrated how the short reverberation times of an practical room at low frequencies are successfully measured by using the wavelet filter bank and the results are compared with the traditional method using a band past filer bank.

• Transactions of the Korean Society for Noise and Vibration Engineering
• /
• v.14 no.2
• /
• pp.111-118
• /
• 2004

A number of researchers have attempted to measure the reverberation time of a passenger car, ut the reverberation time of passenger car is too short to measure with the traditional band pass filter. And if the reverberation time is very short, the product of the reverberation time (T) and the bandwidth (B) of the traditional band pass fitter becomes small. The low limit of BT product required for the measurement of reverberation time with the traditional band pass filter is 16. In order to overcome this problem, the wavelet filter bank was developed. In this study, this new wavelet filter was employed to measure the reverberation times of five different classes of passenger cars. The low limit of BT product required for the measurement of reverberation time with the wavelet filter is 4. The reverberation times of five passenger cars were measured successfully with the new wavelet filter bank. The reverberation times measured in most passenger cars was found to be around 0.04. Compared with general acoustic rooms like concert halls, this is a very short reverberation time

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2002.05a
• /
• pp.1077-1080
• /
• 2002

In building acoustics, reverberation time is an important acoustic parameter. However, it is often difficult to measure short reverberation times at low frequencies using the traditional band pass filter bank if the product of bandwidth (B) and reverberation time (T) is small. It is well known that the minimum permissible product of bandwidth and reverberation time of the traditional band pass filter is at least 16 ［F. Jacobsen, J. Sound Vib. 115, 163-170 (1987)]. This strict requirement makes it difficult to measure short reverberation times of an acoustic room at low frequencies exactly. In order to reduce this strict requirement, recently, the wavelet filter bank is developed and the minimum permissible product of bandwidth and reverberation time is replaced with 4 [S. K. Lee, J, Sound Vib. 252, 141-153 (2002)]. In the present paper, it is demonstrated how the short reverberation times at low frequencies are successfully measured by using the wavelet filter bank. In order to present this job, two synthetic signals and one measured signal are used for impulse responses of an acoustic room.

• Journal of Korea Society of Industrial Information Systems
• /
• v.11 no.3
• /
• pp.15-19
• /
• 2006

In shallow water active sonar environment, reverberation which is a non-white noise is one of the main source of performance degradation of target detection. In this case, the received signal is whitened before applying matched filter known as an optimum filter in the presence of white noise. However implementation of this method is very difficult because of the non-stationary characteristic of reverberation. Traditionally reverberation is assumed local stationary. In this paper, we estimate a range of stationary of reverberation signal, and then propose a pre-whitening method which improve the performance of pre-whitening block normalized matched filter in presence of non-white reverberation noise. Proposed whitener shows better whitening performance than traditional whitener because it use later as well as before reverberation of target signal. To evaluate performance of the proposed whitener, an actual measurement data sampled at the East-Sea is used for computer simulation. The target detector with new whitener is shown better performance than detector with traditional whitener.

• Proceedings of the Korean Society for Noise and Vibration Engineering Conference
• /
• 2001.11b
• /
• pp.1104-1108
• /
• 2001

It is a difficult and important task to measure the reverberation time of an acoustic room with a short reverberation time. This paper presents a new technique to measure the reverberation time of an acoustic room with low value of BT60. The digital signal processing technique used to do this is the wavelet filter which is very flexible to design the 1/n octave band filter and has no delay problem compared with the conventional IIR digital filter. This method is successfully applied to the measurement of the reverberation time at low frequency band of famous concert halls in Korea.

• Journal of the Institute of Electronics Engineers of Korea TC
• /
• v.45 no.12
• /
• pp.152-158
• /
• 2008

In shallow water environment, the detection performance of an active sonar using matched filter with LFM(linear frequency modulation) pulse can be seriously degraded by reverberation which is considered as non-white noise. To reduce the effect of reverberation, a whitening filter preceding the matched fitter, is usually adopted. In the conventional pre-whitening filter, it is assumed that local stationarity is preserved between detection block and its right ahead block. And then by using the characteristics of the reverberation of preceding block, the reverberation of detection block is estimated and whitened. According to the environment of shallow water, the stationarity of reverberation may be preserved for more blocks. In this case, the reverberation of the detection block can be estimated more accurately if more blocks are used. In this paper, the real reverberation signal which is obtained from shallow sea is analyzed and its proper region of estimation block is examined. And the performance of pre-whitening matched filter is compared and analyzed according to the region of estimation block.

• The Journal of the Acoustical Society of Korea
• /
• v.20 no.2
• /
• pp.58-65
• /
• 2001

Recently, a 5-degrees-of-freedom (DOF) reverberation model was proposed as a method of representing subjective perception of reverberation as objective measures[1]. This model approximates sound energy decay curve by five objective measures, widely used in which have been concert hall acoustics. However, it is note worthy that there can be infinite number of impulse responses which correspond to a selected 5-DOF reverberation model. There may exist some filters making very unnatural and unrealistic sound. In this paper, the limitation of the 5-DOF reverberation model when it is used as a filter design criteria is investigated. When a 5-DOF reverberation model is given, additional constraints to get natural reverberation are suggested. This is based on the listening tests for several quite different source sounds.

• The Journal of the Acoustical Society of Korea
• /
• v.20 no.3
• /
• pp.3-7
• /
• 2001

In active sonar system using CW signal, when the noise included reverberation has not the white characteristics, the CFAR detector estimates high threshold. Because of this reason it cannot detect targets and not resolve the closely spaced multiple targets. In order to solve these problems, we propose an adaptive reverberation rejection filter The proposed filter is composed of an adaptive filter and a fixed filter with its coefficients. To study the performance of the proposed adaptive reverberation rejection filter, various experiments have been performed under In moving active sonar environments. As a results, the proposed method has the improved performance than the previous methods.

• Proceedings of the Acoustical Society of Korea Conference
• /
• 1994.06a
• /
• pp.680-685
• /
• 1994

The acoustic phenomena in the actual sound systems involve a variety of compound problems. In this paper, the well-known Bayes' theorem is first employed and expanded into orthonormal and non-orthonomal series forms matched to the digital processing of lower and higher order statistical informations and the noisy observations. Proposed on-line algorithms of digital filter type are applied to the actual state estimation for a reverberation characteristics in a room under contamination of background noises.