• Journal of the Korean Ceramic Society
• /
• v.32 no.1
• /
• pp.17-24
• /
• 1995

The TEA complex polymeric sol was prepared by the alkoxide sol-gel method. The purpsoe of this experiment was to vefity the particle shape in the sol from the investigation of the rheological properties. TEA retarded hydrolysis rate by the reaction with alkoxide enough to make a stable transparent sol in the wide range of composition. From the results of the viscosity change with time, the optimum mole ratio for spinning was selected as 0.5 mole of TEA, 3 mole of H2O and the optimum viscosity was 104 cPs. The rheological behavior of the sol showed that the particle shape in the sol was linear, which was adequate for fiber drawing.

• Proceedings of the Korea Concrete Institute Conference
• /
• 1998.04a
• /
• pp.255-260
• /
• 1998

As a part of the study on the development of augered pile method, this study is intended to investigate the properties of fresh and hardened mortar with the proportion of expansion additives. With the increase of proportion of expansion additives, the fluidity of mortar shows a decrease while air content increases and setting time gets retarded. It show the satisfactory property in strength at 5% of proportion, and shows more expansion with the increase of proportion of expansion additives and sand/cement ratio. In conclusion, both of strength and expansion reveal appropriate at 10% of proportion of expansion additives.

• Proceedings of the Korea Concrete Institute Conference
• /
• 2003.05a
• /
• pp.781-786
• /
• 2003

This study has focused on the possibility for recycling tailings from the Sangdong tungsten mine as admixture for concrete. The XRD(X-ray diffraction analysis) and PSA(Particle size analysis) were performed to find mineralogical characteristics. As a result of XRD analysis, the tailings were composed of quartz, feldspars and muscovites, and C-S-H and quartz were found in cement mortar. As a result of KSLT for cement mortar mixed with tailings, most of heavy metals were determined as below the guide line for waste material. In addition, the setting time and compressive strength of cement mortar mixed with tailings were investigated. It was indicated that the initial and final set were retarded according to increasing replacement. The compressive strength of mortar was decreased with increasing replacement.

• Bulletin of the Korean Mathematical Society
• /
• v.37 no.2
• /
• pp.361-376
• /
• 2000

Our purpose is to seek that the reachable set of the semilinear system $\frac{d}{dt}x(t){\;}={\;}Ax(t){\;}+{\;}f(t,x(t)){\;}+{\;}Bu(t)$ is equivalent to that of its corresponding to linear system (the case where f=0).Under the assumption that the system of generalized eigenspaces of A is complete, we will show that the reachable set corresponding to the linear system is independent of t in case A generates $C_0-semigroup$. An illustrative example for retarded system with time delay is given in the last section.

• Journal of Pharmaceutical Investigation
• /
• v.18 no.1
• /
• pp.23-30
• /
• 1988

The sustained-release micropellets containing rifampicin were prepared by spray congealing micropelleting technique using gelatin as the embedding matrix, and hardened by treating with the formalin-isopropanol mixture. Dissolution of rifampicin from micropellets was significantly retarded, and greatly dependent on formalin concentration, hardening time and pH of the dissolution medium. It was found that this prolongation was more distinguished in pH 1.2 dissolution medium rather than pH 7.4, which might be attributed to the swelling characteristics of gelatin used in the dissolution medium. In-vitro dissolution kinetics indicated that the drug release followed the first-order process.

• Proceedings of the Korean Institute of Building Construction Conference
• /
• 2006.05a
• /
• pp.27-30
• /
• 2006

This study investigated influence of organic fiber type and contents on engineering properties of concrete. Test showed that increase of fiber contents decreased fluidity of fresh concrete and it was even worse in concrete adding cellulose fiber. It is decided that concrete containing more than proper level of fiber should be considered. In addition, concrete adding more fiber, nylon and cellulose, resulted in increase of air content but it was satisfied in aimed value. Bleeding capacity of concrete containing more fiber significantly declined and setting time of that was also slightly retarded. For the properties of strength, both compressive and tensile strength of fiber containing concrete were indicated at similar value to control concrete. However, it is clear that if those concrete containing fiber revised the value of increased air contents at fresh state, the strength value of that would be slightly increased.

• Advances in pediatric surgery
• /
• v.3 no.1
• /
• pp.77-82
• /
• 1997

The association of pyloric atresia and epidermolysis bullosa(EB) in newborn is rare and inheritant as an autosomal recessive trait. We report a newborn girl with pyloric atresia and epidermolysis bullosa. Blisters were noted on her skin at birth, especially in pressure-exposed area, and later on the oral mucosa. Junctional epidermolysis bullosa was confirmed by light microscopy and electron microscopy. Radiography revealed pyloric atresia. Segmental resection of 1.5 cm and gastroduodenostomy were carried out at 4 days of age. Protein loosing enteropathy developed after oral feeding. The frequency of episodes of nonscarred blisters and the severity and duration improved significantly with time. The protein loosing enteropathy was persistent, and at 1 year of age, her growth is markedly retarded.

• Journal of Plant Biology
• /
• v.29 no.4
• /
• pp.255-262
• /
• 1986

Developmental changes of chlorophyll-protein (CP)-complex and plastid membrane proteins during the greening of rape (Brassica napus L.) cotyledons were examined in order to investigate the effect of benzymladenine (BA) on plastid development. The formation of CP-complexes was slightly promoted by BA treatment in early greening stage, at 24 h and 48 h after illumination. However, BA inhibited the development of CP-complexes at 72 h after illumination. On the profiles of plastid membrane proteins with greening time, it was found that the 24 kd protein was increased and the 56 kd protein was decreased in both water control and BA-treated cotyledons. However, the above two traits were retarded under BA treatment, respectively. From the obtained result, plastid development of rape cotyledon during greening was partially affected by interaction between light and BA dependent on its physiological age.

• Proceedings of the Korean Society for Technology of Plasticity Conference
• /
• 2007.10a
• /
• pp.143-145
• /
• 2007

The correlation between crystallization and deformation behavior in the supercooled liquid region (SLR) of a $Cu_{54}Ni_{6}Zr_{22}Ti_{18}$ bulk metallic glass (BMG) alloy is investigated by compression tests, differential scanning calorimetry (DSC), electron energy loss spectrometry (EELS) and high resolution transmission electron microscopy (HRTEM). In the SLR, This BMG alloy was strongly depended on the deformation temperature and the alloy exhibits important change in deformation behavior after a given time which is directly connected to the development of crystallization. Compressive stress impeded decomposition and consequently retarded forming of nano-crystal, which led to enlarge the homogeneous deformation region of the BMG alloy in SLR during compression test.

• Journal of ILASS-Korea
• /
• v.22 no.2
• /
• pp.87-95
• /
• 2017

Recently, as the interest in environmental issues have increased around the world, the regulation on vehicle exhaust have been tightened in each country. To satisfy such tightened exhaust regulation, automotive manufactures are forced to equipped Diesel Particulate Filter (DPF) at Diesel vehicles. If DPF is used for a long time, DPF regeneration should be performed. The objective of this study is to research on post injection for DPF regeneration. The result of the study was that it was desired that retarding post injection timing, lower load of engine and smaller the amount of main fuel injection, for DPF regeneration. Oil dilution was tended to increase as load was lower, amount of post injection was increased, and post injection timing was retarded.