• Aerospace Engineering and Technology
• /
• v.9 no.1
• /
• pp.28-34
• /
• 2010

All pixels of image sensor do not react uniformly when the light of same radiance enters into the camera. This non-uniformity has a direct influence on the image quality. However we can overcome it by calibration process under the special test-setup. Usually it is used the algorithm to get the correction coefficients under the specific illumination condition. But, this method has drawback in the very low or very high illumination due to pixel non-linearity. This paper describes the robust algorithm, which calculates the correction coefficients based on the pixel non-linearity model, against thew hole radiance. The paper shows the non-uniformity test results with the own camera and the specified test equipments as well. The results shows the best performance over the entire radiance when this method is applied.

• Korean Chemical Engineering Research
• /
• v.45 no.3
• /
• pp.234-241
• /
• 2007

To achieve safe operation and to improve economics it is imperative to monitor and analyse demand and supply of utilities and to meet utility needs in time. The main objective of motor/turbine processes is to manipulate steam and electricity balances in utility plants. The optimal operation of motor/turbine processes is by far the most important to improve economics in the utility plant. In order to analyse motor/turbine processes, we need steady state models for steam generation equipments and steam distribution devices as well as turbine generators. In addition heuristics concerning various operational situations are required. The motor/turbine optimal operation system is based on utility models and operational knowledgebase and provides optimal operating conditions when the amount of steam demand from various steam headers is changed frequently. The optimal operation system also produces optimal selection of driving devices for utility pumps to reduce operating cost.

• Journal of the Korean Institute of Educational Facilities
• /
• v.18 no.5
• /
• pp.23-33
• /
• 2011

To ensure the effective operation of a curriculum, facilities and equipments should be properly supported. Therefore, changes are required for educational facilities in accordance with the curriculum, revised 10 times in total from 1945 to 2011, but it's true that the facility and equipment laws, which are the standards of facility and equipment changes, did not adapt to the changes. After 'the Act on Standards of School Facilities' was repealed, 'the Act on Establishment and Operation of the Schools,' the corresponding law for the purpose of spatial configuration for teaching and learning methods, was enacted in Sept. 1997. This law has been active for 14 years and revised 11 times thereafter. It has also been decided to often revise the curriculum, so the 7th National curriculum has undergone 6 times of minor revisions. Among them, the most recently revised 2009 curriculum is to be applied for elementary school 1st and 2nd grade, middle school 1st grade, and high school 1st grade from the beginning of this year of 2011. Hereupon, the purpose of this study is to research on the revisions of the school facility and equipment standards which can support the curriculum revised in 2009 and thereafter by examining classrooms and facilities as the learning space that can respond to the changes of school functions and systems with curriculum transition, of teaching and learning systems, and of subjects.

• Journal of Biomedical Engineering Research
• /
• v.23 no.5
• /
• pp.385-390
• /
• 2002

Nowadays, there are many attempts to develop domestic medical-equipments. In this study, it is performed to developed a new vertebral fusion device. The basic models are a rectangular-frame type and a screw type which are generally used for the patients. The main purpose of the development of a new device is to reduce the amount of bone taken out for the insertion of a device to vertebral disc and this paper is focused on th concept of a new device shape. In the results, two types are devised. One is a folding type and the other is a separate-push-in type device both are in primitive stage. However, in a folding type there are mechanical pins and the analysis of pins and the lock system is still in study and needs some time. Therefore a separate-push-in type is introduced in this study mainly and a prototype and 3-D finite element model are made and experimented and stress analyzed. From the results it is considered that it is stable for the basic loading condition of vertebra, however, it is required to develop a supporting operational equipment for the convenience of the operation in practice.

• Journal of the Korean Institute of Illuminating and Electrical Installation Engineers
• /
• v.21 no.2
• /
• pp.46-53
• /
• 2007

Extension of the mobile communication and the rapidly developing services connected with wireless multimedia(W-CDMA, DMB, Wibro, and so on) need great many base station transceiver systems, antennas, and many signal transmission line to embody these services. The min communication appliances system is exposed always in danger of transient overvoltage by direct stroke or induced lightning surge flowing in through antenna because the antenna of base station transceiver system or relay equipment is combined with expensive communication network equipments through signal transmission line. Now, gas discharge tube(GDT) or narrow band stub arrestor which is used by the surge protector for communication use is exposing limitations as for lightning surge protective means of the communication facility with high speed and wide frequency band. Therefore, for improving performance of surge arrestor, we applied ceramic filter which can reduce lightning surge invading from antenna effectively, and proved that ceramic filter is effective in residual voltage reduction through the experimental research.

• Proceedings of the Korean Institute of Electrical and Electronic Material Engineers Conference
• /
• 2002.05a
• /
• pp.172-175
• /
• 2002

The technique of induced discharge by a pulsed CO2 laser is being applied to control electrical discharge path, material processing, triggered lightning for protecting the power equipments. In this paper, we have investigated about the characteristics of the induced discharge at atmospheric conditions by using a plasma channel, which is produced when a pulsed CO2 laser radiation is focused by a focusing mirror as a trigger source. A plasma channel produced by laser radiation has an effect on decreasing the threshold voltage and inducing the discharge in both needle electrodes. We have confirmed a delay time between a produced plasma channel and an electrical discharge after laser radiation. We provided the decreased voltage lower than the natural discharge voltage between electrode type of needles and was induced the discharge by forming a plasma channel between them. In this research we could understand the time delay of induced discharge by laser radiation, and the characteristics of the discharge cause by the decrease in the threshold voltage, and the polarity effect by changes of plasma channel positions between two electrodes.

• Proceedings of the Korean Society of Crop Science Conference
• /
• 1998.10a
• /
• pp.134-158
• /
• 1998

The objectives of this article are to identify the current status of agricultural infrastructure in North Korea and to suggest some cooperation measures among South and North Koreas and international agencies in order to develop the North Korea's agricultural infrastructure. The area of cultivated land in North Korea is 1,992 thousand ha (paddy field: 585 thousand ha: upland: 1,407 thousand ha) in 1997. Major water use facilities in North Korea are 1,900 reservoirs (included 100 big dams), 36,400 irrigation pumping stations, 1,600 drainage pumping stations, and 14'a,000 wells. In addition, there is 'two thousand Ri canal construction project' linking the rivers of Aprok, Daeryong, Daedong, Jaeryong, and Yesong. The unit of paddy land consolidation is about 1 ha which is regarded as rational for agricultural mechanization. The project of 'Darak' upland construction to create small size farmland, which has been carried out since 1976 has been unsuccessful due to the shortage of construction equipment. The area of farmland created by reclamation by 1995 is only 75 thousand ha although the potential project area is at)out 320 thousand ha along the western coast. It is due to the fact that civil engineering technologies and equipments are old and investment funds are insufficient. These are a few suggested areas of cooperation among South and North Korea and international agencies in order to improve North Korea's agricultural infrastructure : i) see land reclamation and land consolidation projects to increase paddy fields for rice production; ii) rehabilitation project in farm land areas devastated by flood; and iii) agricultural water development project which including diagnosing and rehabilitating irrigation and drainage facilities.

• Journal of Biosystems Engineering
• /
• v.34 no.2
• /
• pp.106-113
• /
• 2009

This study was carried out to test feasibility of a granule fertilizer applicator for rapeseed seeding in paddy fields. The metering plate of a conventional applicator was modified for rapeseed seeding. The modified plate had new three seeding openings with total area of $342mm^2$. Average target discharging rates ranged from 6.3 to 21.0 g/s and correlated with opening areas. Application patterns of the rapeseed seeding showed M-shape. The coefficients of variation of the application showed 70.5% at 0.99 m/s of forwarding speed and 14.3 g/s of a discharge rate, and 77.7% at 1.72 m/s of a forwarding speed and 8.23 g/s of a discharge rate. The coefficients of variation in the direction of transverse of the tractor ranged from 7.3 to 47.7%. In rapeseed seeding tests using the applicator, seed damages rates were less than 15% due to the agitator, the seed hopper and the seeding plate break. Therefore, improvements of the applicator blow heads and seeding equipments were required in order to apply rapeseed efficiently.

• Journal of the Society of Disaster Information
• /
• v.9 no.2
• /
• pp.153-163
• /
• 2013

The damage caused by natural and human disasters has been increasing year by year. While the damage from these disasters are unavoidable, reduction of damage level by proper establishment of control measures could be sufficiently achievable. Disaster prevention resources include resources introduced in the event of disaster, such as human, materials, equipments and facilities. Rapid yet proper inputs of these resources are the key factor to minimize any damages from the disaster. Currently, however, the standard and/or criteria for mobilization of the disaster prevention resources have not yet systematically established. Therefore, proper resource management as well as efficient resource input has not been in place. This research is an early stage construction of efficient mobilization resources, which had been irregularly loaded and applied before. Also this study has tried to provide a classification rule for efficient disaster prevention resource management and mobilization, and indeed, provide a foundation for efficient resource management system.

• Journal of the Society of Disaster Information
• /
• v.13 no.4
• /
• pp.422-441
• /
• 2017

Notifying emergency evacuation methods, accurate disaster location and evacuation route guidance can be very active alternatives to quickly minimize evacuation and casualties in disaster situation in the development of subway disaster prevention detection system that detects the disaster signs at the subway station early on the basis of Internet of things and leads passengers to evacuate. It's not easy to ensure perfect functioning of fire fighting facilities and equipments due to underground space structure with narrow exits. Therefore, we developed disaster provision EL Display integrated board that can induce the most efficient evacuation and the field experiment was conducted to examine the practical application in this study. Especially the applicability was verified by field application test because there is no case in which EL panels are used to evacuate disasters.